Having problems with your Dishwashers ?

Whirlpool DW is running but not washing a darn thing

\015 My Whirlpool dishwasher model DU810SWPQ0 is only 2 years old and it's already giving me headaches! It runs through a wash cycle like it's doing something but doesn't wash a one dish. When it comes time for the water to run there's this high pitch squeal noise, but no water runs. I've checked the little flow thing and it's clear so is the food catcher. Any suggestions???\015

Answers :

Does anyone know how to Reset thecontroller on Ariston AFA250
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Whirlpool DW is running but not washing a darn thing


Does anyone know how to Reset thecontroller on Ariston AFA250 ... Dishwashers

I have a whirlpool dishwasher Quiet partner 2. I am using cascade detergent, my dishes coming out spotty. I have tried running with a very light load and the same thing happens. I notice that there is a white film around where the water comes out during a wash. I am running a normal cycle with heated dry.


Your problem is hard water. the minerals dry on your glassware causing a white film or residue. go to www.dishwasherfilter.com. they have an awesome product designed for yo ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

My Whirlpool dishwasher stutters loudly during wash cycle. It's an intermittent thing, in the sense that sometimes when i run the dishwasher it doesn't do it at all. But also in the sense that when it does do it, it's for like a couple of seconds, then fine for a bit, then stutters again for a few seconds, fine for a minute etc etc. Sound is coming from inside, kind of like the power is turning on and off rapidly. It's a Whirlpool ADP-8540 Stainless Steel (Made in Germany)


A symptom like this is commonly caused by a failing wash pump motor. If you are having this problem and the dishes are not getting as clean as they used to, the motor is most likely the problem. ... Dishwashers

My whirlpool dishwasher type 280-2 detergent door will not open during wash cycle. Yes the compartment, springs and door are thoroughly clean. Will not open if I just close the door and remains empty. I'm wondering if perhaps I knocked off some random part that makes it open. So please tell me how darn thing opens and perhaps a pic of the parts so I could see if ones missing. Thank you for any help offered for this, its driving me nuts.


... Dishwashers

Hey guys, I am a dishwasher repair guy in barbados, the caribbean. I am having problems with a Hobart LX30H. the relay board is doing half the things right and the othrs not at all. I replaced it with a new one and the same results. At startup, the wash sump heater and wash motor are running, but the fill valve, drain valve and rinse booster are not running. Hence the startup operation is stalled. the funny thing is that the rinse booster and fill valve led's on the relay board light up at


Not sure what sort of problems (fault codes etc) you were having before you chose to go on the path of replacing the relay board.\015\012\015\012It might help to know what fault codes you have been noticing.\015\012\015\012One ... Dishwashers

Shu4302uc I have a Bosch SHU4302UC Dishwasher and the Regular Wash and the Clean indicator lights are always on. It just keeps running and running and does not seem to go through an entire cycle. I can choose any other cycle and it does the same thing---it continuously runs and the clean light is always on.


Hoe can you rate a question about a dishwasher that dose not work inappropriate????\015\012Please think before rating, or no one will give you advice, and you'll just have to pay the repair-man whatever he tells you it costs.\015\012I act ... Bosch 24 in. SHU43 Built-in Dishwasher

Whirlpool model DU960 - from 2001, I think. Stopped running mid-cycle and the cycle lights flash. Won't run. How to fix? If I press 'Cancel/Drain', it flashes that button light. If I press one of the wash cycles again, it turns on the pump for about 1 second, shuts off and the lights flash again. I tried turning off the circuit breaker and turning it back on, but it still won't run. Is this fixable? Do I need to call for service? Or, would I be better off just replacing it?


I have a whilpool du960 the rinse only light is flashing and the light wash light is also flashing. ... Whirlpool Dishwashers

I have the Whirlpool DU 1100 dishwasher and the clean light kept blinking. I did the heated dry, normal combination and got it to run through the diagnostic check and sure enough it cleared the lights and appeared ready to run. When I would start it up again it would run the water and then get to the soad wash cycle and stop. No more lights it just stopped. I have been through the diagnostic process 3 times and still same problem. HELP


... Whirlpool Dishwashers

Whirlpool quiet partner ii only runs the light wash


... Whirlpool GU2400XTP Built-in Dishwasher

Whirlpool Silent Partner 1 Dishwasher running too long in wash cycle


I feel sorry for next guy who sells you another appliance :) ... Whirlpool 24 in. DU1055XTPS Stainless Steel Built-in Dishwasher

Dishwasher problem Indesit 320 dishwasher will not run through the program. It fills up starts washing, & continues washing. Fills with water & will not empty or dry. I have checked & the waste is not blocked. Have had a good feel around the bottom (internally) & there do not seem to be any obstructions. Can anyone help? Could it be the "control module" if there is such a thing? Many Thanks


Try taking the drain pump off, easy job just tip machine back remove 3 screws from front of base then remove the single screw from pump and twist to remove check impeller is free to turn chances are its not and is probably jammed with broken glass or ... Dishwashers

After the wash & dry is complete, the next time I try to use it, won't turn on. I tried cancel and that starts and finishes but can't get any thing else to work. I turned off the circuit breaker but have to wait 6-8 hours before turning back on. Once this is done the machines runs normal again. I have to repeat this process every time I want run. Any suggestions on what might be causing this???


I have the same problem. The only temporary solution I have so far is \015\012to turn off the circuit breaker and wait between 10 & 30 minutes \015\012before resetting the breaker. The the dishwasher will work for one \015\012cycle. ... Whirlpool 24 in. GU1500XTLS Stainless Steel Built-in Dishwasher

Have Whirlpool dishwasher Gold Series, Model GU9805CGB1 which stops part way through wash cycle with the led indicator blinks on the normal cycle.....if we ope nthe door and shut ...it continues until part way through rinse cycle...stops again....led indicator blinks again.....we open the door & shut and it continues....but then continues to run through the normal wash cycle continuously.....until we open the door again.....what's wrong???


Sounds like the door is losing contact with the door switch, first thing i would check is the door strike.Metal strike plate located on the tub itself that the door latch catches as it closes. its a spring metal striker, i would try bending it down ... Dishwashers

Whirlpool - Quit Partner I - DU1048XTP: Start at the beginning - Dishwasher would go through most of it's wash cycle and stop and the 'Start/Resume' LED would start flashing. Would press 'Start/Resume' and wash cycle would start again and run non-stop. Would have to hit 'Cancel/Drain' to stop. Called local service tech and he said board would need to be replaced. First board he brought failed right away, second board was installed. Tech also replaced latch handle assembly because it was missing


Have you asked the technician if the water temperature is OK.\015\012\015\012Run it again and after 30 minutes cancel and see if water temperature is warm or not. If not warm enough, then likely causes are heater is faulty or if you are u ... Whirlpool Dishwashers

My sound conditioned Whirlpool dishwasher is real old. It fills up completely with water. It looks like it will overflow, so I stop it. I thought it always started washing from the start. Do they always fill completely up with water, then start washing. I never noticed. I am afraid the water will overflow. Can it? Last time I ran this, it had a real loud motor. I used to hear the motor running from the start, but now I don't, just water filling up to what looks like overflow if I let it. I baile


... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

Whirlpool DWF417W, Type 12155 A couple of weeks ago the machine failed to empty, leaving dirty water in the machine at the end of the cycle. Start a new program it emptied & all was then well. A couple of days ago we started a wash cycle as normal, shut the door, the pump normally runs for about 10 seconds then the cycle starts. However the pump just runs continuously?? After looking here there seemed to be a few links to the subject of water being in the base & the anti flood switch being ac


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons ... Dishwashers

Whirlpool quiet wash plus DU920GWGD4 runs after cycle is finished. Just hums, no blades turning. No sign of leak... If I turn circuit off then back on it is fine until it runs a few times again. ...any ideas


Water air lock problem. Check your inlet for free flow.Pour water from the front and mostly it will ease the problem. After this cycle it should work OK. The humming is due to water starvation in the motor. ... Dishwashers

Hello. I have a Frigidaire model GLD2250RDS0 that starts a wash cycle normally, then stops mid cycle with the 'washing, drying clean and sanitized' lights all blinking. There is no service sheet behind the panel so I don't have a dianostic to run. I have tried the normal things such as unplugging power and looking for obstructions.


This is going to be a electronic control problem. Part #154540101. art can be purchased online at foxparts.com ... Frigidaire Dishwashers

Whirlpool DU1145XTPPB7 Whirlpool DU1145XTPB7 model. Normal cycle light started blinking sometime during end of wash cycle. It will not do anything. Things I have already tried and not worked: 1. Unpluged and pluged unit back in. 2. System reset w/ heat-dry button, etc. Any help would be greatly appreciated


These dishwashers normally have a "Control Lock" mode.  It's in the manual.  It is provided for child safety.  It's often controlled by holding the "No Heat Dry" button for 4 seconds or more -- same procedure turns it on or off. ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

My Whirlpool is only a couple of years old too and it does the same thing. It stays on the wash cycle and the timer stays at 79 minutes. I have to cancel the wash to get it to stop and drain. Anyone know what is wrong with it?


If the timer does not advance. It is most likely a timer motor. ... Whirlpool 24 in. DU1050SS Built-in Dishwasher

Whirlpool quiet partner 980 series. Washer will not run a wash cycle. Can set a wash program up on control panel and the red indicater lights are appropriatly on.


... Whirlpool 24 in. GU3200XTP Built-in Dishwasher

Whirlpool quiet wash plus dishwasher, (DU915QWDB1) not sure if the model number is correct. Basically my dishwasher will not drain completely (smells bad) and spills water during a wash. I don't know what it is, if there is something easy to adjust inside the washer? Or If there are general troubleshooting tips that I need to run through in order to diagnose the problem? Help!?


... Dishwashers

We have a Bosch dishwasher model SHU5315UC/U06. When we ran a "Regular Wash" the dishwasher ran continuously and the timer did not count-down. None of the Delicate or Rinse and Hold buttons responded. The only button that works is the "Scrub Wash", but when we ran it did the same thing. Ran continuously and the timer moved one minute after running about five minutes. I look forward to your solution. Thank you. Jerry


My father-in-law has a Bosch and they had the same problem. The tech guy said it was not heating properly and that caused it to continously run because it won't tick down the timer if it doesn't reach a certain temp, so try turning your faucet as hot ... Dishwashers

Dishwasher repair Dear Guru, I hope you are well this evening. I have a Whirlpool Quietwash Plus dishwasher (940 Series) that will randomly have water sitting in after running through a washing cycle. In addition, some mornings there will randomly be a couple inches of water sitting in the bottom without every running the washer. Need assistance. Any help will be appreciated. Thank you for your time. J


Without model unablr to look up exact unit, but in genreral, either ther is a blockage/clog in oyour drain line not alowing complete drain of cycle, as far as never really washing, i would look into perhaps a faulty/ sloppy door switch assembly. if f ... Dishwashers

I just moved into a house that has a Maytag Quiet 300 dishwasher. After about 2 weeks, I'm hearing a VERY loud, almost grinding noise about 6-7 minutes into the wash cycle, then again near the end of the wash cycle. It sounds like a motor thing and I'm hoping to avoid a repair bill right now, the cost of the move wiped us out. Is this something that I can fix, and if not, will continuing to run the dishwasher with the noise kill it?


You can continue to run it. it may correct or else it will get worse.......then u can get back and i will help u decide what to do ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1412 seconds