Having problems with your Dishwashers ?

I have a GE Evolution Quiet Power Plus dishwasher its in very good condition but after a wash cycle it leaves about 2 inches of water in the bottom of the unit,this just started about a week ago,ideas on a fix appreciated.


Answers :

A serviceman just solved the problem in 10 minutes. It is the valve inside the dishwater at the back. It got worn after five years. Cost me 8$ plus the call.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a GE Evolution Quiet Power Plus dishwasher its in very good condition but after a wash cycle it leaves about 2 inches of water in the bottom of the unit,this just started about a week ago,ideas on a fix appreciated.


A serviceman just solved the problem in 10 minutes. It is the valve inside the dishwater at the back. It got worn after five years. Cost me 8$ plus the call. ... Dishwashers

Hello, I had a problem with my Bosch dishwasher not washing properly. I have fixed burnt out wires, replaced the water inlet valve, AND tested with a new control module. Nothing is helping. When I start the cycle, it completes the initial drain and water does flow into the unit for about a minute, maybe a minute and a half. I can hear the clicking of cycle changes but it is not washing. Eventually it will drain the inch or so of water in the bottom, but it never washes. Any help???


Hi,\015\012\015\012Welcome to Fixya.\015\012\015\012Can you hear the wash motor humming ? I`ve got a "pdf" I can send you regarding this if you want to contact me at ... Bosch SHU9925UC Built-in Dishwasher

I have a maytag quiet series 300. When it is done with any of the cycles in leaves about 1-2 inches of water in the bottom of the dishwasher. I can manually hit the start button twice and it will go through a 2 minute cycle and pump out the water. I have cleaned the filter inside the dishwasher where it drains and have checked the hose to the disposal and it pumps out fine. It just doen't pump itself at the end of the cycle. HELP!


Here it is - Maytag Quiet Series 300 Manual ... Maytag Dishwashers

Model#lds5811bb--started making noise coming from the water inlet area(bottom left). 3/4's of the way through the cycle, noise became louder and then an error code "le" came on. We tried turning breaker off, then we tried in the rinse only cycle, but 5 minutes into it the "le" code error came on again. I'm fairly handy, so I'm not sure what part I can replace to maybe solve the problem. I can't afford to spend a couple of hundred dollars for a repair man to fix it. I'll appreciate any suggestion


The LE code is a locked motor code. Something may have gotten into the pump impeller. I would take the screens and filters off and clean the and check the pump for something stuck in it. It could also be the motor going bad but I would check the obvi ... LG Dishwashers

My Dishlex global 300's rinse light is flashing after 5 mins use. About 2 inches of water stays at the bottom of the washer. Bought this second hand and it has not been used for a few months. Do I need to fill the reservoir under the washer or lean it at 45 degrees to dislodge anything in the sump. If you have had the problem of the washer starting its program and then stopping after 5 minutes and the rinse light flashing I would appreciate your advice. Cheers Hyph


The flashing rinse light is an error code. I am assuming that your control board is good because the lights are working. I'm also assuming that this model has two pumps. One for filling and one for draining. The rinse light flashing is probably i ... Dishwashers

Hotpoint dishwasher machine go's through wash cycle, through to the end, after dry cycle ends there is always 2 inch's of water left in it that doesn't drain out' but some water is added when new cycle is started, then throughout wash cycle whenever water drains it never drains completely, always leaves 2 inches of water before adding more water to begin rinse cycle. what do I need to do?


... Dishwashers

Ge Triton dishwasher GSD5500GOOWW was not cleaning like it used to- I cleaned screens at back bottom-very dirty- also-detergent cup stuck opne - took door apart and got it unstuck - it works fine now. - it seemed to do better but now it is cleaning poorly. It seems to fill and start a lot sooner than before - after 30-45 seconds it starts up. I tested the water temp and it is 90 degrees! Hot water coming in is at 105 degrees. Also - it is leaving a white residue on dishes - didn't do that be


Hi,The scum, film and white\012residue problems have started since the reduction of\012phosphates in dishwasher detergents.Here is a tip that\012will help you to solve the problem of films, residue, and scu ... Kenmore Elite Stainless Steel 24" BuiltIn Dishwasher with TurboZone Rotating Spray Jets 13103

I have a kenmore Ultra Wash Dishwasher, Model 15825691. We were recently hit by lighting. Once hit, the dishwasher started up. Since then, all cycles work, however, at the end of any cycle, the dishwasher continues to run and fill the bottom of the washer up to about two inches and then cuts off, so when we open the washer, there is approx 2 inches of water inside no matter what. I have pressed the "Cancel/Drain" button, in which drains the water after two minutes, but when that is finished, the


There must be a problem wit the fill valve. Check which valve the water enters. Check first the wiring to the valve of the water inlet or where the water comes out to fill the washer. Check for physical evidence of damage on the solenoid (or contr ... Kenmore 24 in. 16539 Built-in Dishwasher

Zanussi ZDT41 dishwasher leaves about a half inch to an inch of water in the bottom after washing , checked the filters and done multiple washes so the waters going somewhere just not this last little


... Zanussi 22 in. ZDT5895 Built-in Dishwasher

Our KitchenAid KUDS011JBS1 dishwasher sometimes leaks water on our kitchen floor. It seems to drip from the bottom edge of the door onto the floor. It's not a huge amount of water, but is enough to be a concern... it leaves a small puddle on the floor. What should I check and how do I fix this? I'm hoping it's an inexpensive and easy fix. Note that we've had this dishwasher for 8 years and have only noticed leaking during the past 6 months.


... Dishwashers

Water won't drain after cycle is done. Leaves 1-2 inches of water in bottom. Checked hose and its clear. Put hose going to disposal in bucket and water comes out when diswasher is cycling


It is easy track this path of water from bottom of m/c it will b afilter then small hoses to drain pump thenouter hoses <\015\012 thanks ... Dishwashers

I have a Bosch SHE44C02UC/46 that will finish all of the cycle but leaves a couple inches of water in the bottom. If I pull out the dishwasher and manually active the drain pump float it will drain the remaining water out of the dishwasher. I heard about a cold solder joint on the main controller board but I am not sure if this could be the issue. Please advise wat advise you can. Thanks.


... Dishwashers

Dishwasher works fine except that after the drying cycle, water slowly builds up in the bottom of the dishwasher. It did this a few years ago for several months, but then it stopped doing it altogether. I did nothing to fix it. Now it's started doing it again. I run the dial around to a point where it drains, let the water drain and then turn it back to off before the drying cycle begins.


Hello,\015\012\015\012This would mean that the dishwashers water valve has failed. This is a simple repair to make yourself. The lower access panel would need to be removed, four screws. You can purchase the part from the link below.\015\012 ... GE Dishwashers

Dishwasher repair Dear Guru, I hope you are well this evening. I have a Whirlpool Quietwash Plus dishwasher (940 Series) that will randomly have water sitting in after running through a washing cycle. In addition, some mornings there will randomly be a couple inches of water sitting in the bottom without every running the washer. Need assistance. Any help will be appreciated. Thank you for your time. J


Without model unablr to look up exact unit, but in genreral, either ther is a blockage/clog in oyour drain line not alowing complete drain of cycle, as far as never really washing, i would look into perhaps a faulty/ sloppy door switch assembly. if f ... Dishwashers

Indesit dif04 hi, dont use the machine that often but tried it today. It made the usual filling with water noise but then stopped working when there were a couple of inches of water in the bottom. This drained away when the machine was turned off. Same thing happened when repeated. Any thoughts much appreciated. Belinda


... Indesit 24 in. IDL500 Built-In Dishwasher

I have a Kenmore dishwasher model # 363.15222100. The water does not drain properly after the final cycle, leaving 2 inches of water at the bottom. I don't have a manual and can't find my model # on this web site. Can you help? Thanks.


... Kenmore Dishwashers

Hello, my Hoover D7610 dishwasher has developed a problem, I would appreciate your advice.On starting a wash it appears to be working OK through what I believe to be a rinse cycle but then after about 20 minutes water pours out from the bottom of the door. Manually clicking the timer-programer forward stops the leaking but the machine needs manual advancement except for the last 2 cycles when the timer seems to work OK. After the 1st cycle there is no more water leaking from the machine but all


... Hoover Dishwashers

Good morning! My Whirlpool dishwasher (I'm at work so don't know the precise number) leaves about an inch of water at the bottom after washing. I called a Whirlpool representative soon after my purchase (post Ike devastation of previous dishwasher that drained fully) and was told that this was rather normal for Whirlppol. I live on Galveston Island in Texas, and adding any more sources of water and humiditiy to my household seems counterproductive. Is there anything that I can do to cause


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons ... Dishwashers

The problem started with it not draining correctly and leaving water in the bottom - my husband took it apart and found a bolt in the drain. He removed it and now it won't start. It appears to not have power to the electrical panel- we have reset the breaker several times - left the breaker off for 10 minutes thinking it might erase the memory - I've asked for instructions to reset and I keep getting info that is very far removed from this model. I know it has a protocol because a repair


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012\015\012The reset on your dishwasher is as follows, ( I can't locate your particular model number...but its madw be whirlpool so there are only a couple of possible sequences ) however depending ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Water does not completely drain? Garbage disposal is functioning properly and hose from Kitchen Aid dishwasher to Garbage disposal is good. I ran the dishwasher a couple of times start to finish for rinse cycle and approximately 1/2 inch of standing water on the bottom. Any ideas? Please help. Thank you.


\012Hi,\012Here is a tip that I wrote that will help you with your dishwasher not draining problem...Dishwasher Problems - ... KitchenAid 24 in. KUDI01ILBS Stainless Steel Built-in Dishwasher

WATER DOES NOT COMPLETELY DRAIN FROM DISHWASHER. TOOK APART DRIN VALVE OTHER NIGHT AND PUT BACK TOGETHER AND IT STARTED WORKING FOR ABOUT 5 LOADS. NOW THERE IS ABOUT 1/2 INCH WATER STANDING IN BOTTOM THAT IS NOT NORMALLY THERE AT THE END OF THE CYCLES.


It is likely that the water pump is feeling its age. Replace the pump. ... GE 24 in. Profile PDW7800 Built-in Dishwasher

Leaving more water in than bottom than used to. I cleaned the silver cap on top of the sink (overflow or air)? Water comes out the cap which enters into the sink. Just a little bik. I recently replaced the old and my wife think started then. I install new host from dishwasher up to the plastic "Y" the silver cap sits on above the sink. Any suggestions Mdoel lokks like 665 but there i another number right below FH50022184


Hi, yes this Y and chrome cap is the air vent for the dish washer, If you have any water coming from this cap at all, you do have a blockage in one of the hoses. I'm not sure which one you replaced, but here is how the hoses work.From the dishwasher ... Kenmore Dishwashers

Water is not draining completely from the dishwasher. About 1-2 inches remain in the bottom. Seems to drain most of the water during the wash cycle, but a bit remains. Thoughts on how to fix this?


Either the check valve on the end of the drain hose that connects to the drainpump motor is closed shut or sometin is clogged inside the drain hose..... also maybe you pump motor assmbly is faulty... u prob need wet/dryshop vac and drain it out from ... Kenmore PRO 24 in BuiltIn Dishwasher with Ultra Wash HE Filtration 13173

New SHE4AM16UC, professionally installed eight months ago. Worked fine with very light usage until now. Dishwasher starts normally but stops and signals "clean" after less than five minutes on any cycle. One inch of water in bottom that (I think) drains when a new cycle starts. Soap tablets are not ejected from compartment. Bosch authorized repairman says he now has two client dishwashers with identical symptoms and is asking Bosch support for ideas (he's changed pump, control unit, and float sw


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If the clean light flashes, pauses, and then repeats.\015\012When the dishwasher doesn't sense a water t ... Bosch SHE4AM16UC 24 in. Built-in Dishwasher

Machine just started leaving dirty water in bottom of machine. cleaned filters,had machine apart,removed and cleaned waste pipe. pump runs and impeller feels ok.only time i could get any water to drain into bucket was when shook waste pipe very hard?


Check that the pump is clean and not loose. Make sure pump, impeller, and waste pipe are in alignment with each other and are clean. If it works when you shake the pipe, then there is still a clog inside or the pipes aren't aligned correctly and some ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1831 seconds