Having problems with your Dishwashers ?

Stack Dishwasher on top washing machine

\015 Hi,Moved into a new place, and there is no space for the dishwasher.The laundry is right next to the kitchen, but it also only has space for the washing machine, so, I was wondering...You get the kits to stack a dryer on top of the washer.Would this work to stack the dishwasher on top of the washing machine.I think it may not be possible, as the dishwasher is a lot heavier than a dryer, but I may be wrongAny opinions? \015

Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Stack Dishwasher on top washing machine

... Dishwashers

Gritty dishes My dishes are coming out of the wash gritty. It is as if food has been dried on them. As if the rinse water has particles in it and then they are left on every dish. I have used a dishwasher cleaner several times and I also use the rinse agent in the machine. Nothing is helping. It is getting worse.The inside of the dishwasher. mostly on the top, usually has food residue all over it at the end of every wash. Even the machine is dirty. I'm hand washing everything right now. Any

... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Leaking input to the top of the dishwasher. Pollypro pipe comes up the back and into the top centre of the machine.... This is squirting out water when on wash cycle. Have undone large plastic nut on iside.. that has rubber washer on it... but the input pipe does not seem to have a washer between this and the steel body of the machine... this seems to be causing the water to squirt out... please let me know whether the washer has disintergrated or whether I need to use some bedding compound t

\015\012By reading Your problem most probably due to disintegration of washer only. Try with new Washer \015\012\015\0121. First try to adhere some wax or gumming material where washer is distingrated...if it solves u r probl ... Dishwashers

I have a Frigidaire dishwasher and there is not any water coming out of the top wash arm. There is good water pressure coming out of the lower washarm. I pulled out the dishwasher and can see the water going to the top washarm through the tube and it goes up very slowly. I took out the "check ball" below the lower washarm and it worked good. I put the "check ball" back in and ran the machine on "Upper Rack" and it still does not have any water coming out of the upper washarm. It doesn't seem lik

Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. Please check that there is no gunk or mold\015\012behind the filter screen and under the cover at the bottom. N ... Frigidaire PLDB998A Built-in Dishwasher

My dishwasher barely cleans my dishes. i basically have to wash them before i place them into the dishwasher. also, once they come out there is usually residue of the dishwashing detergent especially on the top rack. another problem is that the wheels on the bottom are all warped and come off every time i use the machine. we have had this appliance not even for 5 years and it is driving me crazy! any advice/ solutions would be very helpful.

Sounds like the pump or drain is stopped up. is there water in the bottom after the Cycle is done? ... GE 24 in. Profile PDW8280JSS Built-in Dishwasher

I have a fisher & Pakel dishwasher and it appears to have brown a fuse inside the machine which means it does not work at all and the problem occurred during the wash cycle. This means the seal (which is a top piece that's lifted and lowered by two motors. When the seal is in the lowered position it creates a complete seal but it also locks the drawer (single drawer dishwasher) so it cannot be pulled out. I repaired the dishwasher two years ago. One of the lifter motors didn't work. I replaced t

According to the service manual there is no problem in manually forcing open the drawer in the situation where the power has failed part way through the diswasher cycle.\015\012\015\012The problem is that once you force the lid open, you ... Fisher and Paykel Dishwashers

I have a ADG 450 dishwasher, it has suddenlt topped completing the wash cycle. it runs for about an hour then sits and beeps. If i open the door, the machine is full of water and it looks as though it is trying to spray more water in, thn stops and beeps. If i turn it off and on at this stage and run the rinse cycle, the water clears and the dishes appear to have been cleaned. any thoughts? it happens with all wash cycles.

... Whirlpool Dishwashers

Smeg dishwasher After a wash cycle there are small bits of residue left on the dishes (mostly top shelf). I've cleaned the machine with a dishwasher cleaner, the filters have been done too, I've checked the rotor arms rotate - that's Ok as well. I have emailed SMEG but have as of yet not response. Any clues please.

Riff...not sure what the bits are...first, they may be food crumbs or the like. Dishwashers have macerators to grind up food particles but they have no really good way to get rid of them in the wash cycle. Scrape plates of any solids before loading ... Smeg DWI614 Built-in Dishwasher

My whirlpool dishwasher is not washing the dishes properly. when finished cycle, I still see the dishwasher tablet half used. The grey long piece at the back, seems to have come out of the two holes it fits into on the "floor" of the inside of the machine. I've clicked it back into place, but it still pops out. Sometimes the rotating sprayer at the top and bottom, don't move either when its out of place. please help.

... Whirlpool GU2400XTP Built-in Dishwasher

Hi, I have a bosch SGS43E02Z dishwasher that dont seem to wash clean. It would seem that some times the presure from the spinning washers arnt working well enough as it dont even move rice from plates stacked next to each other. i have checked all filters inside the machine and if you start a wash program the sprayers work and the water is splasing. please help with sugestions.

... Bosch Dishwashers

Have moved into a house with a Bompani Antilla BO 02014 model dishwasher. There is a control knob on the right hand side with settings and it seems like it controls the time the dishwasher is on (similar to top load washing machines). I do not know which settings to use or what they mean. Can you help? Thanks Terry

... Dishwashers

Hello! My 3 yr old Bosch dishwasher (I think it is a SHE 43) is doing two things: 1) leaving a serious white film on dishes and glasses 2) leaving grit inside glasses on the top rack (always on glasses placed on the far back right of the top rack) I've tried cleaning the machine with hot washes with no dishes, vinegar only, but no luck. Any thoughts? Many thanks for your help!

Hello. Since you have already cleansed the interior of your dishwasher, we must conclude that the problem is with the water itself. If you do not have a filter on your water, you may want to consider installing a dirt/rust filter, at least on the h ... Dishwashers

I have a zanussi tempoline dishwasher, I have loaded this as I usually do, turn the knob to the right and select the 2nd programme the light next to this comes on, I have pressed this to start the machine although it seems as if it is going to start this light flashes and the top arrow on the right of this flashes intermitanly, but the machine does not start the wash programme. The 3hr delay button if I had pressed this by mistake which I am sure I have not would light up. When I found it did no

Hi Ruth.The machine can be in error mode. In this case one or more lights in the control pad will stay on or flash and the cycle will not start.One of the most common fault in your situation, and at start of the cycle is no wa ... Zanussi Dishwashers

I need spares for a Hobart CS183 commercial dishwasher. Hobart no longer stock them . Does anyone have spares for the top wash arm in the main tank or an old machine that can be cannibalised?

... Dishwashers

Defy dishmaid dishwasher does not start wash cycle. Several attempts to reset dishwasher has been done. Machine has been unplugged for several days and switched on again and still does not work. The start/stop switch have been kept in for about 5 - 10 seconds to reset. When the machine is set to do washing, the water enters the machine and wash light shows green and machine remains like that with water inside the machine. The start/stop button is again pressed for 5 -10 seconds to drain the wate

... Dishwashers

My Frigidaire 4000 Dishwasher panel board is lighting up with almost all lights on/flashing. When the door is closed the pump engages and ther is no water in the machine. If we put water in it drains successfully. The following is flashing on the control panel: washing, drying ER, clean and s. Up top lighted up is china crystal and rinse only. What is going on?

... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

My Frigidaire dishwasher won't complete a normal wash cycle. It flashes "Err" trhen "uo"; I got some lame explanation about "too much chlorine in the water may have runined a gasket in the top right corner of the machine" when I called the help line. Come on, we've got Lake Michigan water!

... Dishwashers

Hi experts! The middle wash arm in the dishwasher (underneath the top tray) does not seem to be spinning resulting in dirty glassware etc. I have checked the arm for debris which is clear and clean. The only thing I can think off is there is not enough pressure being pushed through the pipe from the back of the machine. Unfortunately I do not know where to go from here? Please help! Thanks Paul

Hello,Welcome to FixYa,Based on your description... I`d suspect a plugged or really dirty wash pump. It could ultimately be a worn out wash ... Dishwashers

I have a Beko DWD5410W dishwasher. It has been working well for a couple of years now. Last week is stopped during a wash cycle and now when you switch it on, it fills with water to the top of the filters (as normal?) and stops. Nothing further happens no matter how long I wait unless I switch the machine to drain mode. Do you have any idea what the problem could be or how I can go about investigating further? Many thanks in anticipation

Hi, this is a control fault that is localized in the logic sector of the control board. the logic chip which holds all wash programing is damaged. you will need to replace the control asap if possible...thank u rate me ... Dishwashers

Hi There, the quality of wash on my Bosch dishwasher has reduced (especially on top shelf) to a point where it is almost not worth using. filters etc are clean and no issues with water enttering the machine. i am assuming it is the power of the spray which has reduced , what can i do? many thanks, Mark C

All the jets must be clean especially the drive jets at the ends of the wash arms, these drive the arms around thus allowing jets of water to reach every piece of crockery. ... Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher

Ignis ADL347 integrated dishwasher runs for a few seconds then stops, beeps and light flashes 6 times. I'm told this is due to water not getting into the dishwasher. it was working perfectly until we had a washing machine installed, can't see any pipes that are twisted or crushed but also don't have great access to the back of the washing machine or dishwasher. I have no expertise whatsoever. What should I be checking/trying? Any advice appreciated.

... Dishwashers

My Bosch dishwasher is Exxcel 5 prg model no SMS50E020GB. When you first open the dishwasher door after the washing cycle finishes there is no water in the bottom of the dishwasher but about 45 minutes later water slowly appears in the bottom of the dishwasher. I scoup out the water and there is about 3 litres. The machine is just over 2 years old. I had a plumber check the machine and he couldn't find anything wrong with the machine. Another plumber came out and put on the invoice: "disma

... Bosch Dishwashers

My KDI-21A Kitchenaid/Hobart dishwasher does not wash the top rack, but does fine on the bottom. It appears that water is not flowing to the top wash bar. Is is possible for only the top bar inlet to clog somehow? I've pulled the bar assembly itself and the main tube from the wall of the washer to the top wash bar is clear .

... Dishwashers

I have a Delonghi dishwasher, it's a stand alone, like a washing machine. The water inlet is connected to the hot water tap, normally used for a washing machine. When we first started using the dishwasher, we kept getting the E4 error message, we reduced the water inlet pressure by turning down the tap, that worked for a while. Just a while ago, we started getting the E4 error message again, not sure we can turn down the tap any further without cutting the water off completely. Do you have a

The E4 error message could be because the water pressure is too low rather than too high. Can you let me know the exact model number of your dishwasher and I should be able to tell you more.\015\012\015\012Regards,\015\012BElectric ... Dishwashers

Dishwasher Dilema Hi, Can someone help me solve this problem. Last time I had a problem with my dishwashers I was pretty successful in solving it on this site. I was running a reg wash on the top drawer of my Fisher&Paykel when I suddendly had to stop it in the middle of a wash to add more dishes (something I do all the time) suddenly both screens started beeping with an F1 along with a wrench. It sounds like both motors top and bottom are running full blast. I tried shutting the power for a few

You need to remove the bottom drawer and dry out the water with towels and a hair dryer when this is done it should operate normally. most likely when you pulled out the drawer the water sloshed back and out of the drawer making the dishdrawer think ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1973 seconds