Having problems with your Dishwashers ?

My Dishwasher starts, then stops after 30secs and won't continue draining. Everytime I turn it back on it comes up on the steam cycle and won't go to any other cycle, drains for 30secs and stops again. Power light is flashing. Have tried holding power button down for 10secs with no effect. Filter is clean, pipes are straight-no kinks. How do I get it to start working again? It is a whirlpool dishwasher, ADP5550.


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Dishwasher starts, then stops after 30secs and won't continue draining. Everytime I turn it back on it comes up on the steam cycle and won't go to any other cycle, drains for 30secs and stops again. Power light is flashing. Have tried holding power button down for 10secs with no effect. Filter is clean, pipes are straight-no kinks. How do I get it to start working again? It is a whirlpool dishwasher, ADP5550.


... Dishwashers

Hello, my Siemens integrated dishwasher no: SE64M359GB stopped working mid-cycle with 35mins remaining. It is displaying the red tap emblem. Usually the dishwasher starts when the dishwasher door is closed fully (having pressed the power button). However, it is making a noise as soon as the power button is pressed. I have checked the water supply and pipes and they are OK. The filters are also clean and OK. We have an electric de-scaler on our system so I imagine calcium build up should n


... Siemens Dishwashers

Neff dishwasher our dishwasher is six years old and have had no problems till now . there is power to it but when you push the on button the impeller starts up even when the door is open , and it wont go through the cycle , its asif there is no water going in and it is not draining away i have checked and cleaned the filters but nothing, then pulled it out from undre the sink and it started working . i put it back , it went through the cycle then the next day it would'nt work again . do i need a


You have a faulty door switch. It can be replaced and may be available at youre local appliance parts dealer. ... Dishwashers

I have an LG dishwasher, model LDS 5811ww. The machine fills with water, then stops filling when the error code IE comes on. I have cleaned the inlet filter and the whole inside of the tub, by taking apart the sump filter. There is good water pressure filling the tank. When I turn off the power and restart any cycle, the pump will empty the tank, then begin filling the tank again...until it is stopped by the error code IE again coming on. The other thing I notice is the water level in the tub.


Sounds like you either have a dirty or faulty water level sensor or water temp sensor. Most likely a dirty or faulty water level sensor ... Dishwashers

I have a Bosch SHU 3030 dishwasher that made a loud clicking noise and then stopped mid cycle. There was water at the bottom of the washer that I scooped out. I checked the filter and cleaned out any debris. There appears to be no power to the dishwasher. I spin the control dial and nothing happens; no lights, no sounds. The circuit was not flipped.


Pull the bottom kick panel and check the connections on the lower right, where the electric wires come in. Trip the breaker first, to be safe. ... KitchenAid 24 in. KUDI01TJ - Multiple Color Built-in Dishwasher

Our Maytag MJD3005 dishwasher got a couple of minutes into a cycle then displayed E4, stopped and beeped. I cleaned the filter basket out (which needed doing), powered down and up and restarted. Then a couple of minutes into the cycle E2 appeared as (I think) it doesn't enter the wash phase (fills OK). Repeated on different programs with the same outcome. Any clues?


... Maytag Dishwasher

Hello, my slimline, Hoover, HEDS 668, AAA class, dishwasher is playing up. During a wash cycle, my meter tripped. When I put the power back on, all the light were flashing and beeping. The beeping stops after a while and all the lights stay on. It sounds like it is trying to fill up or drain or something too, but that soon stops. The filters are clean. What could be the problem? Hazel Stenson-Pickles


... Hoover Dishwashers

My Thermador dishwasher DWHD64EP/54 does not get the dishes clean. We checked all the usual things--water to the dishwasher is hot, filters clean, spray arms working and not clogged, detergent cups working, proper amts of detergent etc. We find that no steam is produced during the cycles, we find that the when choosing a cycle and power boost incorrect cycle times are now displayed compared to previous usage when the dishwasher ran normal. Some of the longer cycles now show only 24 min


... Thermador DWHD64EP Built-in Dishwasher

I've had an ASKO 1996 dishwasher for about 9 years and in the last few days it has stopped cleaning effectively. The cycle seems to run normally but when finished, the dishes and glasses have a new film on them and generally feel and appear unclean. Is this just a filter problem? If so, how do I clean/replace it and why has it worked ok for so long? Thanks!


Hi, you may want to visit this link, but i will suggest to have a technician to check up on this . hope this helps ... Dishwashers

Whirlpool adp 5550 Dishwasher wont complete a cycle. The light in the start button flashes four times in a continuous pattern. Have pressed the start button for 3 -5 seconds to reset after which the machine seems to operate ok then it stops and the start button returns to flashing. Have cleaned the filter and checked the sullage pipe for blockages What do I do next?


... Dishwashers

Hi, I have an ASKO D3250 dishwasher and it keeps stopping during the wash cycle and flashing the heavy pots and pots symbol simultaneously. I tried cleaning the filter basket and found a little plastic part floating in there that has printed on it PP-T20. I don't know where this piece goes or if it's even the culprit. There is a little bit of water not draining from the filter area when I unscrew the outer filter basket, I cleaned it out, but when I re-run it, it still stops and gives the dual f


The part is a cap for the drain pump. You can put it back into position by removing the filters and placing it to the left of where the circular filter would be positioned. The part goes in with the part numbers on the bottom facing down. When posit ... Asko 24 in. D3530FI Built-in Dishwasher

Dishwasher not cleaning properly, and not stopping at the end of a cleaning cycle. I have used a dishwasher cleaner and all filters are clean what is the problem. Dishwasher model Beko DE 2431 F


Your fault is not the normal complaint. Question is, "are you sure it doesn't just keep on running during the heating cycle"?. My thoughts are the heating element is possibly not functioning which will disrupt the continuing of the cycle.. Check elem ... Dishwashers

Hi, The machine will not complete a cycle. I think it may have started when the power was turned off at the mains during a cycle. Symptoms are : - You can turn machine on, select a program, press start button, close door, machine appears to begin cycle as normal, water seems to load, then 2 minutes later drains, and 1 minute or so after that the machine beeps 3 times to indicate cycle is finished. Dishwasher tablet door never opens, dishes not cleaned. Have tried : - cleaning filters; - turn


It is likely the dishwasher is locked in some diagnostic program.\015\012If you provide the dishwasher model no. then I can try to find out the keys you need to press to get it out from it. ... Whirlpool Dishwashers

DISHWASHER WAS IN MIDDLE OF CYCLE... HOUSE LOST POWER AND NOW WASHER STOPPED AND WONT FINISH CYCLE NO LIGHTS ON BOARD DOES HAVE POWER TO UNIT HOWEVER NOTHING LIGHTS UP


Remove the rear panel. Gain access to the thermal fuse. (glass tube like fuse)\015\012This does have a tendency to go bad. A faulty door switch can also cause this. ... Kenmore Dishwashers

Miele Diamante G 2150 SCU Dishwasher problem ----The program cycle indicators "Rinse", "Drying" and "End" flash at the same time. The drain pump is running when the door is open. I have reset the power and cleaned the drain pump and non return valve and Spun the propeller several times in both directions to check for obstructions. Still has the same problem. Water is being drained continuously even with power switch on dishwasher turned off.. Had to shut the breaker off to get it to stop. A


Hi\015\012\015\012Plugged system or a jammed drain pump can cause these issues, also make sure the drain hose is not blocked. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remo ... Dishwashers

I have F&P DD603 with problem with bottom draw. Once a programme is selected and door is closed, the dishwasher beeps three times then tries to start itys cycle. It then starts but stops every 1-2 minutes (like pause botton has been pressed). If you press start again it starts for 1-2 mins then stops again. I have tried turning off the power and totally cleaned out the dishwasher but no change? Any suggestions?


Hi \015\012When you pull out the drawer, pay attention to the bottom near the bottom front panel, you will see a little tab. this tab is at both sides of the drawer, press these tabs in and pull the drawer fur ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have the Bosch SGS43A2GB27 Dishwasher. Today suddenly it has stopped working. 1st problem i faced was that water was coming out from the dishwasher. Then i cleaned the filters . Then i restarted the dishwasher again. Now the problem i am facing is that the dishwasher is not workign. Whatever cycle i put....the time remains the same. If i put econoy wash...nad time is for 40 min. It stays for 40 min even after 20 min. Please help . I recently called a technician...culd not afford technician aga


... Dishwashers

Kitchen Aid Superba Selectra 21 Mod.: KUDS21SS1 MS S/N: FE 84757436 After whole house power outage, dishwasher began constant high pitch beep or whine. Machine controls unresponsive; display shows F. Cycling power has no effect {except noise stops and display goes off when powered down - of course). Any troubleshooting and parts availability advice would be greatly appreciated!


... KitchenAid Dishwashers

Dishwasher malfunction stops after approx 2 mins of any cycle, green light flashes 7 times then stops, 7 times then stops etc. does not appear to be taking in any water. have cleaned all filters.


BAD WATER SELONOIDE, OR BAD BOARD ... Dishwashers

She47c0 bosch dishwasher won't stop the rinse cycle. the dry or sanitize signal does not iluminate. cleaned all arm nozzles,filter system. let it run with rinse agent and dishwasher salt. Need help! no clue! thanks!! Kat


You're hosed.  This is likely a bad control board module that can run you in excess of $200.  Even if you're within Warranty, Bosch will gouge you for labor, as that is NOT covered by warranty.  Top that with abysmal customer service a ... Dishwashers

My dishwasher siemens se25a266gb purchased in 2003 will fill with water go through a wash cycle but does not pump out the water i have cleaned out the filters, checked the exit hose and all seems ok the only way to get the water out is bale out by hand. after this it will run through a wash cycle then stop and not pump out. how would i get to the pump and check it? any help appreicated regards Alan


\012Hi,\012Here is a tip that I wrote that will help you with your dishwasher not draining problem...Dishwasher Problems - ... Siemens 24 in. SE25A266 ExtraKlasse Free-standing Dishwasher

My Viking dishwasher (~2 yrs old) won't complete a cycle - it continues to run unless I run unless I turn the power off. It also doesn't drain when I change cycles like it's supposed to. I've cleaned the filters and removed the dishwaher to check drain line for kinks and to ensure it not clogged. Any other suggestions?


If is continueously running because the unit is trying to get rid of the water in this instance shut off the water and shut off the electrical breaker disconnect the drain hose and assure that there is nothing blocking the end of the hose that goes t ... Viking DFUD042P Built-in Dishwasher

The dishwasher is stopping half way through the cycle and water remains in the filter. iv cleaned the filter out and it says error 2 ?


... Whirlpool Dishwashers

My kitchen aid dishwasher model # kudpo1flss3 stopped near the end of a cycle and now it is not responding or indicating power at the control panel. It has a little bit of water left in the tub but must have been close to completion as the dishes were clean. The breaker is on & there is power up to the connection @ the appliance. Almost acts like a main fuse is blown or something....


You will need to have the mains plug removed and the power cord traced up to the control panel which is the main program controller unit. It seems that the program controller has failed and if so the fuse would have blown with a reason m ... KitchenAid 24 in. KUDS01FLSS Built-In Dishwasher

Stopped mid cycle with dirty water left on the bottom. cleaned filter and it worked fine, twice. This time it stopped and i can't get the power on. just moved in, with existing washer and have no manual. thanks in advance.


Hi,Here is a tip that I wrote that will help you with your dishwasher not draining problem...Dishwasher Problems - ... Bosch SHU5316UC Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2792 seconds