Having problems with your Dishwashers ?

Dishwasher has started leaking on the right hand side of the machine. Only thing around that region is the salt dispenser


Answers :

You want to take off the kick panel and look for the location of the leak If it's from the door- You want to adjust the units feet to make sure the unit is level and square. if you can adjust the door latch tighter try that. replace the door seals if needed.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher has started leaking on the right hand side of the machine. Only thing around that region is the salt dispenser


You want to take off the kick panel and look for the location of the leak If it's from the door- You want to adjust the units feet to make sure the unit is level and square. if you can adjust the door latch tighter try that. replace the door seals if ... Dishwashers

I have a 4yr old Smeg freestanding dishwasher. Model is DF612SDX. The problem is that a wash cycle will start but about 15 mins in it stops and 2 of the programme option lights (on the left hand side of the programme options), start flashing. If you open the machine the soap dispenser has failed to open. This problem has been a bit of a slow deterioration as we've had a number of washed that have managed to finish and then noticed that although the dispenser has opened it must have been to


... Smeg 24 in. DWF612SS Free-standing Dishwasher

Have a 4 year old Kenmore Dishwasher Model # 74382. No problems at all until last week I went to start it and it would not turn on. Lights on the control panel were on with exception to the start light. I opened and shut the door to make sure it clicked and pressed the start button again and nothing. I tapped around the panel with the side of my fist and pressed it again and it began working. Well today different story I went to start it and it did the same thing. I tapped all over front of the


The problem is more likely the door switch is failing or out of adjustment/loose. You will need to remove the door panel. This is easy to do. There is a video at ... Kenmore 24 in. 74382 / 74384 / 74389 Built-in Dishwasher

My pressure washer starts fine, shoots water OK. After running for 5-10 minutes cleaning siding I shut off machine. I go to start it again within a minute or two and the thing feels like it's just about seized. If i wait until the motor is completely cool, it will pull start freely and start right up. I think something is wrong with the pump, not the engine.


Your pressure washer may not have an ez-start valve installed from the factory. Without the ezstart valve, you will need to hold the trigger on the wand open to release the pressure to easily start your engine. This link will show you wh ... Briggs & Stratton Pressure Washers

My G832SC is not draining at the end of the cycle. It runs the entire cycle, and the dishes appear to be clean. The soap dispenser has opened and the dishes are rinsed. However, the dry cycle doesn't run because the machine doesn't drain at the end. The intake/drain light is flashing. If I reset the machine and start a new cycle, it will perform an initial drain and the water level does go down. We checked the tri-filter and the valve pump thing, rinsed both. Checked the hose under the sink. We


... Miele Slimline G832SCi Built-in Dishwasher

I have a Delonghi dishwasher model no. DW67S/W which is coming up with the E4 message. I had this once before and was told to turn it off and on and it righted itself. This time however I used the next bit of advice. I took everything out including the salt cap thing, tipped it on its side and drained all the water out, reconnected the hoses and when I turned it back on it seemed fine....no E4 messaage straight away. It drained out for a while and then starting filling. It has overfilled again


Hi.As you know E4 means overflow. If the problem occurs regularly there is either a problem with drain line, or a fault.Ensured that you have removed all the water from the inside and cleaned thoroughly the drain ... Dishwashers

Our Hotpoint Dishwasher BFI 680 will start up as normal on any program, take in water, heat it up then, we hear a bubbling noise, as though the hot water is just boiling and not being pumped around. Is this the pump? Thing is, the machine will then drain the water, with the pump presumably pushing the water out?


Install new pump kit ... Hotpoint 23 in. BFI68 Built-in Dishwasher

Maytag dishwater WU504 - Problem: the soap dispenser cover does not move. The soap dispenser is two sided with a cover which moves from one side to the other as the machine cycles to release the soap from both sides. The cover no longer moves, and I don't know what is wrong. I would replace the whole soap dispenser, but I am wondering if it is the dispenser or whatever triggers it to move. Any information would be helpful. Thanks


... Maytag Dishwashers

I have whirlpool diahwasher ,model DU1055XTSQ3,quiet partner -1. when i start the machine the folowings things happen: 1.the machine does not start . 2.Start /resume light starts blinking ,after few seconds ( 40-50 seconds), the pots and pans light also starts blinkng .after some time ( 1 minute ) the normal light also starts blinking .All three lights start blinking 3. I have done the following to rectify the problem from the book : alnernatively pressed heated dry and normal keys for


... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

My dishwasher started making a whirring sound around 20 minutes into its cycle. I took off the drain pipe to check for obstructions, however it was clear. I started the cycle from the start again, and it started the whirring sound from the start of the cycle. There was a small amount of water that drained into the bucket where I had placed the drain hose, however there was not much water in the machine to start with (I checked when it started whirring the first time and there was no water in the


Hi.\015\012\015\012A blocked pump in absence of water won't be noisy from start. Check that\015\012 the whirring sound is not given by the spray arms. Test without baskets\015\012 and check the spray arms assembly.\015\012\015 ... Fisher and Paykel DS605I Built-in Dishwasher

[email protected] Day E1 error. Opened up the filters to clean all possible blockage inside the machine. Water is pumped into the machine when starting, then there is a pause, then E1, then water is pumped out again, which does not inidctae a blockage. Opened both side panels, and flow of water is possible on the left side. What can be done next?


Thanks for your question!I'm sorry that you haven't received an answer yet.The response rate on FixYa FREE questions is usually over 80%, but sometimes questions go un-answered when:1. the question is unclear, incomplete, or poorly ... LG 24 in. LD-12BW5 Free-standing Dishwasher

WONT WASH CLEAN ALWAYS RESIDUE LIKE SAND ON GLASSES ETC. THAT IS ALMOST IMPOSSIBLE TO EVEN REMOVE BY HAND WASH ENOUGH SALT AND RINCE AID ALSO CLEAN FILTER EACH TIME NO OBSTRUCTION IN PUMP FILTER THOUGH HAS AN ORANGE COLOUR SALTLIKE SUBSTANCE INSIDE BRAND NEW MACHINE STARTED WITH BAD WASHING RESULTS AFTER COFFEE PLUNGER WAS NOT CLEANED PROPERLY AND GROUND COFFEE LANDED IN MACHINE ALSO POSSIBLY OUR HOUSECLEANER MIGHT HAVE USED ORDINARY TABLE SALT INSTEAD OF DISHWASHER SAL


Use CLR to remove any build up and then use LEMI-SHINE (walmart in dishsoap aisle) for the cleaning of your dishes. Works great for me as i have the worst well water on the planet. ... Dishwashers

I did not put salt in my new dishwasher just used a tablet. DIshwasher started up and then stopped saying water flow problem was this my fault? Rang service desk who were very rude and made a big thing about the salt which I did not think was a big thing since live in softw ater area.


Absolutly not your fault robert. nothing to do with salt atal. if its water flow problem could be a faulty flow meter in which case if ur dishwasher is under 28 days u can refuse a repair and demand a replacement.\015\012\015\012hotpoint ... Hotpoint Dishwashers

Salt Light Cannot get the salt light to go out. Had some problems with a crystaline Deposit on the left side of machine. we checked the inside of the dishwasher and made sure all was clean etc. After that the light wouldn't go out. Had machine serviced. Turns out we were using too much diswashing powder Only need to use about a Teaspoon (heaped) for a wash not the recptacle full.


The sensor in the salt chamber isn't reading properly. Try descaling the machine with solution and restarting. ... Miele Dishwashers

My Milee dishwasher indicated that I should add salt to the salt reservoire. I did this and then started to run a quick wash. However, the machine started to make a strange grinding noise. I turned it off immediately, tried again, but its still there. Please can you provide any advice?


Hi\015\012If noise occurs within first minute of starting program, then the is most likely something in the drain pump. Remove filter, On left of sump you will see a non return valve with a metal clip keeping it in place push clip ti centre of ... Miele Dishwashers

I bought a new kelvinator diswasher kd12mm1 - will not start, and shows E1 error. No water? but the connections are all done properly and the water is open. My previous machine had no problem with water pressure. I do not have salt yet... can that be the cause for the machine not starting? Please help


... Kelvinator Dishwashers

FDW60 dishwasher - taken apart pump and that is clear. Seems that dishwasher fills, and empties and heats all OK but water wont go around the machine ie the motor pump doesnt start - any idea how to take this out and replace without having engineer around? Taken small pump apart and its clear. First of all the Eco and fast light flashed, then we took it apart with some direction from online discussion advice. Now Eco and Pre wash lights are flashing. Machine empties water, then fills with


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Not operating my machine starts up as usual then stops and flashes A03 with the add salt symbol. There is more than enough salt in the machine, what do I do???


Yes ... Indesit 18 in. D41 Slim-Line Free-standing Dishwasher

Whirlpool dishwasher part #3385181. Machine had gone thru wash cycle and was starting to dry. Smelled electrical burning smell, opened washer door and washer was filled with smoke. Turned everything off, cleared smoke, and the washer water dispenser is very hard to turn. Washer has symptoms of burnt up motor that turns water dispenser. Machine is 12 years old. With cost of replacement motor and possible part (pump?) that might have clogged and caused motor freeze up, is it worth fixing or junk


... Dishwashers

Candy washing machine runs through programme and stops at the point where it drains the drum to start the spin. Have switched it off and turned timer to correct position and it drains and spins OK (1200 spin) Tried other programmes on timer but same thing, stopping at point where the pump drains and the spin starts. Have checked the pump and is OK any ideas please, I am quite capable of taking the machine apart for repair. Thanks in anticipation Pete


... Dishwashers

My ariston lsv 66 dishwasher will not start washing cycle. It makes the pumping noise as it normally does at the start of the cycle and some water enters the bottom of the machine but then it stops. I have checked to make sure that there are no leaks so the problem is with the filling up of the machine. I live in a hard water area and haven't used anything to help reduce the limescale so expect this to be playing a part. I have tried all the washing cycles but the same thing happens. Any advic


HERE I AM I LIKE THIS JOBE\015\012 PLEASE CHECK THE WATER INLET FILTER I FEEL FROM YOUR DESCRIBE IS IT\015\012 YOU NEED TO CLEAN IT BY ASMALL BRUSH >\015\012 THANKS ... Dishwashers

Maytag MDB7100AWW wire harness inside door replaced due to recall, the digital readout started halfway appearing and now the machine won't start at all, the drain is the only thing that will come on and it is for only a few seconds nothing else will start.


... Maytag Dishwashers

Model Ariston AFA370X - This query is for my daughter who is currently house sitting and can't find any manual for the machine. When switching the dishwasher on there are two red lights next to the on switch. One light indicates salt but it's the other light that is coming on with 2 stars above it and she doesn't know what this light indicates. She has used the machine once before and everything seemed fine but this time this light keeps coming up and the machine will not start. Please a


... Dishwashers

My Bosch Classixx (about 10 years old) dishwasher won't fill The problem has only started since I pulled it out and cleaned! The programme sounds are as normal but no water enters the machine. I detected a small leak on the inlet pipe and tightened that. The machine drains when I add water manually though it has made a lot of gurgling noises for some time now when draining. When tipped on its side water comes out of the bottom of the machine (not entirely clear but not dirty either). When upri


... Bosch SHU9915UC Dishwasher

FDB105OREC4 My dishwasher is not cleaning my dishes. I push the start button and water seems to be trickling in then it stops and no sounds protrude from the machine for several minutes. Eventually another loud motor seems to turn on and drain the water out of the machine. The soap dispenser usually opens and the soap block that usually dissolves is setting on the bottom of the machine. It seems the water is plenty hot but the rotating washer arms might not be moving. Please help me find the par


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1404 seconds