Having problems with your Dishwashers ?

I have a dishwasher drainage problem water always stand at bottom

\015 Whirlpool built in dishwasher\015

Answers :

Need model #......

But here are some generic helps....for wirlpool

1.The first thing I would check is the air gap (if any) on top of the sink.
\015\012
\015\012Remove the cover and the top piece and check for clog.
\015\012
\015\012If there is nothing wrong then the problem is a clogged check valve
\015\012
\015\012Remove all water from the dishwasher.
\015\012
\015\012Remove the bottom panel.
\015\012
\015\012Remove the drain hose from the check valve (be prepared for some water on the floor).
\015\012
\015\012Unscrew the check valve and make sure it's clean.

2. Check the drain pump. Remove the drain hose and make sure it's clean.
\015\012
3.Remove the lower panel and where the drain hose connects to the white\015\012tube on the motor... remove hose then the white tube unscrews out and\015\012you may need to just clean out the tube,,, the hole on the center is\015\012just 1/4 in, compared to the drain hose and does get blocked from time\015\012to time.. but be careful cut off power and be ready for some water...


Remember these are generic with no model # I can ot be more specific or provide any diagrams all of this was after a 2hour internet and my own database as well as a couple of my repair manuals.

I hope this helps...good luck and thanks for rating my effort...The Fang.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a dishwasher drainage problem water always stand at bottom


Need model #......But here are some generic helps....for wirlpool1.The first thing I would check is the air gap (if any) on top of the sink.\015\012 \015\012Remove the cover and the top piece and check for clog. ... Dishwashers

Whirlpool dishwasher: Model DU920PWKT0; 8 years old Lately, have noticed not full drainage of water at end of cycle... about 1 inch standing (thus 2 inches at the sump). Glasses have had noticeable film on them. Ran the rinse cycle a number of times to explore problem. When I interrupted the cycle, the water on the bottom was soapy, yet no new soap had been introduced. I even colored the water "left" in the tub to see if it was replaced by fresher water. Although it was going through t


Find the 'tech sheet' behind the front 'kick plate' of the machine. This doc will give you a troubleshooting procedure for that specific machine. Check drain line and make sure it's clear and not kinked. Is filter clean?Has machine ... Dishwashers

My kenmore dishwasher has standing water in the bottom. A week ago this happened and we cleaned out the grates/screen on the bottom - didn't fix it. then "snaked" the drainage pipe from the other side, and it drained. But same problem now.


... Kenmore Dishwashers

Drainage problem My dishwasher drains on every cycle except for the last rinse cycle, so I know it isn't clogged. I always have about an inch of water in the bottom of the dishwasher when it completes the last cycle.


My hotpoint dishwasher hda487a-01 is not pumping out the water ... Hotpoint 24 in. HDA3740G Built-in Dishwasher

After I run the dishwasher, water stands at the bottom and it smells. I have had the dishwasher for five years. The washer seems to be working properly it's just that water stands at the base of the washer. Is it normal for water to always stand there?


No it's not normal, you are probably having some cloge in the drain pipe, you could try with a pice of wire to pick it up or hose it down, or use some comercial unplaguners like mr. muscle or something like that, i think that this would do the trick ... GE Nautilus 24" Built-in Dishwasher

GE GHDA485N 10CS Dishwasher that has standing water in the bottom after the cycle completes. I pulled it out and reconnected power and ran a rinse cycle. I could see that water was pumping out the clear drain pipe but there was still about an inch of standing water in the bottom. Any thoughts as to what part has failed. Does the system use a water level switch or a timed drain cycle to determine when the water has pumped out. If it is a timed cycle could a slow drain cause the problem. Thank you


... GE Dishwashers

My Kenmore Elite dishwasher did not drain the water out of the bottom after the dishes were washed last night. Could I possibly have pushed a wrong button to keep it from draining, or do I have a problem? All the dishes were clean. Should I run it through another wash cycle? I've got water standing in the bottom of my dishwasher.


Yes , If the program controller has hung it would have skipped the drain cycle. So try to redo the cycle and see if the drain works, is not check the program controller and the drain valve/pump.- if there is food particles that have clogged and block ... Kenmore Dishwashers

Asko D3120 I have resolved the problem of pum always running by tilting the dishwasher but now I have a new problem of the pump not draining the water in the bottom of the dishwasher. I thought it was clogged so I removed the screen and filters but did not stick my hand in the hole to clean... I used the plunger for at least 30 mins. Then I tried to pour a little CLR because I have hard water. NOTHING please help me


In the bottom where the filter are, you can see a yellow 'thing'. Remove this and stick one finger in an try to rotate the pump wing. Try to remove particals that is blocking the pump.\015\012Or there is something in the drain hose. Try to drai ... Asko 24 in. D3120 Dishwasher

Hello we are having a problem with our Maytag stand up dishwasher. The water is not pumping out all the way and the water that is pumping out is pumping out slow. There is about an inch of water that is laying in the bottom of the dishwasher.


... Maytag 24 in. MSE760FAKS Free-standing Dishwasher

I have a single draw F&P Dishwasher and get the error F1, turned off the power and still same problem, but in the last 2 or 3 loads of washing dishes not all the water has been gone, always about 2cm of water left at the bottom of the dishwasher


Most likely you have a leaky drain hose.\015\012Have you checked if sink drain is clear (no back flow)\015\012Turn dishwasher power off.\015\012Empty all the water using a small container and towels.\015\012Get the drawer out ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Dishwasher - The dishes and glasses do not come out clean. There is approx 2 inches of soapy/dirty water that remains at the bottom of the dishwasher. I was told by the sales people that this was normal in order to keep the ... moist. I have since leared that this is not normal. The washer was purchased approx 1 1/2 years ago and was installed last January. Problem has always existed. I have replaced the Drain Pump because when I spoke to someone at GE that was thought to be the problem. NO


Your problem is to removed the clogged into the drain.. I'll post back again and post here the steps to removed the clog..Thanks ... Dishwashers

My Bosch dishwasher has had a problem since we had it installed. It smells like garbage after sitting for a few hours. This problem is there whether it has been run or not. Water is always standing in the large drain tube under the "filter" and it doesn't look clean. I contacted Bosch by phone as soon as this was discovered - in a matter of days after purchase - and was told by a rather haughty service person to leave the dishwasher door open. Not a practical suggestion even if it didn't sm


Was the drain tube that hooks into the sink drain passed over the partition between the sink area and washer area or through a low-level hole. If through a low-level hole, try rerouting the tube over the partition. This forms a 'trap area' to isolate ... Bosch 24 in. SHU43 Built-in Dishwasher

Fisher and Paykel Dishwasher, bottom drawer gets water in it. This drawer is seldom used and when used the water empties completely. However, it always has water standing in it. I run the rinse cycle and it gets all the water out but after time the water is back. It is enough to cover the large removable metal cover.


... Fisher and Paykel Dishwashers

My wife noticed there were smears on the dishes,glass and silverware as if if was not rinceing well. A couple days later we noticed standing water in the bottom that took appx. overnight to go down. Our dishwasher is not the fdb63 etc. allthough it is a frigidare ultraquiet III. My thinking is that this is a problem that mostly all washers would have. We have had this washer appx 5 years with no problem.


Hi,\012Here\012is a tip that I wrote that will help you with your dishwasher not\012draining problem...Dishwasher Problems - ... Frigidaire 24 in. FDB635RF Built-in Dishwasher

Wont drain? My dishwasher will not drain. I ran a load and now there is standing water in the bottom of the dishwasher. I had problems with my disposal earlier and think maybe it progressed down the pipe.


If you have an air gap on the sink from the dishwasher and water is leaking out here into the sink instead of the drain it is probably plugged from there to the disposer or "P" trap in the drain line,also check the sump screen and down in there for f ... Bosch 24 in. SHU43 Built-in Dishwasher

My dishwasher won't drain. It runs through the whole wash and dry cycle...and when I open it to unload the dishes the bottom is filled with standing water. None of the lines that I can see appear to be kinked, and I'm not sure what else to check. I inistalled the dishwasher myself becasue my husband was working out of town...this was about a year ago. Haven't had any problems with it until now. Thanks for any help or suggestions you're able to offer. Christine Fitzpatrick


If you hear the drain pump run after wash and rinse cycles then it is likely the problem is in the kitchen drain end. Have you got a disposal unit in the kitchen sink. Sometime it is full and causing a block.\015\012\015\012If you don't h ... Dishwashers

Our exectrolux dishwasher has moisture mainly on the door upon completion of usage. I have also noticed that I have to dry most of the dishes with a towel due to moisture. There is no water standing in the bottom. I have also checked water temperture as well as settings and still have the moisture problem.


... Electrolux Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

Leaking dishwasher The dishwasher leaks a stream of water at the base -bottom left corner whenever it goes into the final rinse cycle. It does not leak when it is in the wash mode. This leak just seemed to develop suddenly. There was no build up -ie a small stream of water. I just noticed a big puddle on the floor one day after dishwasher had completed its cycle water leak in the left side ,bottom ,husband states a small drip,drip and we do not know what to do or replace. No water standing


I just had this same problem and it was caused by a small plastic seal on the bottom of the door. My friend owns an appliance store and he said this is a common problem for this model of dishwasher. The part was $68 and the labor was $60. I could ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

The water doesn't drain and stays on the bottom of the dishwasher. Have had this problem before.  Dishes are always rinsed prior to loading.  Don't know why it does this, after only two years after purchase.


Probably the dump valve solenoid. ... GE Profile PDW9880NSS Stainless Steel Dishwasher

I have a GE PDW8280J00SS dishwasher that doesn't drain properly. After the cycle finishes there is about 1 inch of standing water left on the bottom. Any suggestions what the problem could be?


... GE Dishwashers

I opened the dishwasher while it was washing and later discovered water standing in the bottom. This happens now when I run a cycle. I have misplaced the manual and don't know how to reset, but think this might be the problem.


... GE 24 in. GSD4920Z Built-in Dishwasher

Had problem with outlets in kitchen, now dishwasher turns on, fills and then shuts off... standing water in bottom.


Since\015\012 the drain pump will pump the water out using the "cancel/drain" \015\012button, if it did not work then your problem is likely to be in the drain hose system or the \015\012garbage disposal downstream from the d ... Dishwashers

My GE TRITON XL dishwasher doesn't drain completely when done...no problem while running, but there is always some water in the bottom ....any suggestions>


I've had this problem too, and fixed it by cleaning the lower drain basket. But it could also be your pump or drain hose is clogged. \015\012 To clean the drain basket, I removed the lower rack and spray arm. To remove the spray arm, turn it coun ... GE Tritonr XL GSD6260JCC Dishwasher

My Jenn Air dishwasher has standing water at the bottom. Is there a filter that can get clog that may be blocking the drainage (?)


... Jenn-Air Dishwashers

Drainage problem My dishwasher wont drain the water at the bottom after it is done washing a load of dishes


I had similar problem and rerouted the drain hose like papps54 said. I still had the condition and decided to pull out the drain hose completely to see if there was any debris trapped inside the hose. There was! I removed the hose from the machine ... Jenn-Air 24 in. JDB1090AWS Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2477 seconds