Having problems with your Dishwashers ?

Admiral Portable Dishwasher - Fill and Drain Hook-Up Hose

\015 Hello there, \015\012\015\012I have an Admiral portable dishwasher which is approx. 4 years old. It was recently given to us. The attachment piece which is connected to the faucet does not have a stopper on the bottom. Once the water is turned on, the water continuously runs out into the sink. I believe we need to purchase new hoses... My question is: Where can we purchase these and can they be installed easily? Or would it be cheaper to have an appliance tech. repair it? We reside in Hamilton Ontario, Canada..... Please advise... Thank you for your time.... \015\012\015\012Regards \015\012\015\012Earl\015

Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Admiral Portable Dishwasher - Fill and Drain Hook-Up Hose


... Dishwashers

Dishwasher i need help either installing for troubleshooting my 18' portable frigidare dishwasher. when the dishwasher is turned opn and it starts to fill the water flows out of the bottom of the machine what is the problem and how dod i fix it is it the hoses ? it also hooks up to the sink it isnot a built in dishwasher so is the hose for the draining need to go in the sink or does it hook up somewhere under the sink?


I would put the dishwasher on its back so you can see underneath to check the fill and drain hose to make sure there not damaged in any way to cause it to leak. if it all looks good under there return it upright and remove the front lower kick panel ... Frigidaire 18 in. FDR252RB Built-in Dishwasher

Miele dishwasher makes grinding noise when turned on, there is a light on front next to inlet/drain. So I poured some boiling water into the dishwasher and then left it turned on and could feel the boiling water coming out of the drain hose so I am assuming it is an inlet problem, as it will drain but will not fill or otherwise work.There are a few small cracks in the outer hose of he inlet hose just below the grey box thing, could that be enough to cause the problem? They are only small so I di


... Dishwashers

I need the steps to change the hose assembly on my Whirlpool portable dishwasher. When I got it someone had cut the sink connections off so my son connected it to the water and drain with my washing machine which was in the kitchen. However, I have moved and want to use it as portable. I purchased the new hose assembly for the sink faucet, I just need instructions on how to take the dishwasher apart and connect the new hoses.....HELP PLEASE!


... Whirlpool 24 in. Portable Dishwasher Dishwasher

I have a moffat dishwasher MSD 2000 p00ww I checked the drain hose, ran water trough it had no problem, hooked it back on to the dish washer. I blew into the hose an could see the the air bubbles no problem in the dishwasher. But it still won't drain. Just wondering if you could hep me, on what to try next. Your help would be great.


... Dishwashers

Frigidaire Dishwasher I have a frigidaire dishwasher that won't drain. it run through the entire cycle, the dishes are clean but the dishwasher is filled with the dirty water. I have unhooked the hose and let the water drain out that way but when i connect evrything back it still doesn't drain.


A common problem with dishwashers is the non-draining machine. If you are having trouble, check to see if the drainpipe and sink trap are clogged. If you still have drainage problems after doing this, check your drain hose to make sure there are no k ... Frigidaire 24 in. FDB510LC Free-standing Dishwasher

Dishwasher hose is hooked up separtely from garbage disposal but still dishwasher not draining


Hi - Is the unit making a grinding noise? If so, contact a professional because you may possibly have a defective drain motor/pump. ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

My garbage disposal badger 1 was just replaced with the same badger 1 disposal. my dishwasher will not drain water anymore. the old one had a hole where the attachment to the dishwasher hose goes but ther isnt one for the new 1 but the hook up is there. Do i have to drill a hole in the new 1 for the water to drain out


I THINK NO :\015\012 THE DRAN PATH MAYBE BLOCKED\015\012 ALL YOU DO 1ST TO SURE THE PLUMPING IS OK OUT SIDE THE M/C\015\012 THEN IF IS OK BE SURE FILTERS INSIDE M/C AFTER YOU OPEN THE DOOR OF M/C PERIODICLY CLEAN AFTER E ... Dishwashers

We have a Whirlpool ADP962 Dishwasher that will not fill. I replaced the inlet hose as I thought the solenoid was faulty. It's gone a step further and now sounds like it fills (continuously) however it soon drains without any water entering the dishwashing compartment (this remains dry). I believe this issue was caused by running it through a cycle without the water mains turned on. Any ideas?


Hi.When you say inlet hose I think you are referring to the inlet valve, which has a built in solenoid. The inlet hose is only the rubber hose connected to valve and faucet.Rather than the hose the problem is likely overfill d ... Whirlpool 24 in. DP840D Free-standing Dishwasher

Replacing drain hose of Haier portable dishwasher HDP18PA


How do i get to the hoses on maytag portable dishwasher ... Haier HDP18PA Stainless Steel Free-Standing Dishwasher

Dishwasher wont fill with water. just before it stopped filling i was turning the dial (a lot) between the wash cycles back and forth to attempt to get it to fill and drain (I didn't let it go through a cycle). We also removed the hose from the machine as it had split and replaced it and we had the machine tilted on it's side. the dial still clicks round but it sounds like the pump is going and it doesn't seem to be filling with water. Help


Hi. I suspect that the timer mechanism will be the culprit here, but i recommended to inspect and test the water inlet valve, before replacing the timer. The valve is a known problem area, as well. Follow the valve inspection procedure below, careful ... Fisher DS603W / DS603B / DS603I Dishwasher

Whirlpool dishwasher will not drain. If the motor is tied into all fill and drain functions then the motor is good. I removed the drain hose and primed it with a total clear line I am in the dark.


Here is the schematic for your entire machine http://w ... Whirlpool GU2400XTP Built-in Dishwasher

I installed according to guide, but dishwasher will not fill with water. Pump sounds much too loud to be normal. Wiring was checked three times for correct connections. Water supply was checked twice for water getting through, no leaks and water supply on. Drain hose is connected correctly and is connected to house drain.


You state the water supply is on.\015\012Have you loosened the compression nut at the dishwasher ell to see if you have pressure to the water inlet to the dishwasher?\015\012Remember the dishwasher will always run a little to make sure an ... Whirlpool GU2400XTP Built-in Dishwasher

Bosch SHU3306UC dishwasher is slowly filling with water even though a) the drain hose is no longer attached and b) the dishwasher has not been turned on for several days. Suggestions on source of problem?


Hi,\015\012\015\012If water continues to enter the dishwasher when the power is off at the breaker, you most likely need to replace the water inlet valve/solenoid assembly. The valve is not closing fully allowing water to seep into the washer w ... Bosch SHU3306UC Built-in Dishwasher

Maytag portable dishwasher-won't fill with water. Sounds like it is going through the hoses but doesn't fill inside.


... Dishwashers

Gaggenau GM 915-710 UC6 dishwasher will not fill and wash. Close the door, turn lever. Empties water from sump. (drain hose was not clamped above disposal outlet nipple, fixed that) Machine empties sump, but will not stop after sump is dry. Will not initiate fill and wash. Manually stop machine. Can't get control board to do the diagnostic to get an F #. Pressing button 1 and 3 at the same time. A couple of the plastic tabs on the circuit boards plastic support housing that link the


... Gaggenau GI936-760 Dishwasher

I have a Delonghi dishwasher model no. DW67S/W which is coming up with the E4 message. I had this once before and was told to turn it off and on and it righted itself. This time however I used the next bit of advice. I took everything out including the salt cap thing, tipped it on its side and drained all the water out, reconnected the hoses and when I turned it back on it seemed fine....no E4 messaage straight away. It drained out for a while and then starting filling. It has overfilled again


Hi.As you know E4 means overflow. If the problem occurs regularly there is either a problem with drain line, or a fault.Ensured that you have removed all the water from the inside and cleaned thoroughly the drain ... Dishwashers

My dishwasher doesn't fill with water even though the hoses are properly hooked up. The dishwasher turns on, but the water doesn't pump in.


Hi,Here is a tip that will help you to find out why water will not come into the dishwasher... Dishwasher Trouble No Water entering Dis ... Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher

I got this dishwasher from a friend that had mice chew the hoses and i was told that it worked perfect before the mice chewed it. I replaced the drain and fill hoses plus the power cord. when i put everything back together and power on I get F1 on the top drawer and the rotor rotates and the heater plate turns on. The botton drawer does nothing with no display. I checked all the wires with a meter and found good continuity thru every pin. I replaced the main filter board. I even switched the


Did the F1 error in the top drawer disappear after you replaced the mains filter board? ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Have a shu 4322 dishwasher it fills with water and drains but the spray arms do not spray. have not tried anything yet.this dishwasher is not hooked up. it was given to me by a friend who replaced all his appliances.he also told me that the circuit board was recently replaced as part of a bosch recall. have you heard that there was a recall?


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012\015\012There was indeed a recall involving the control replacement nearly two years ago now if I recall.\015\012\015\012As for checking int ... Bosch 24 in. SHU43 Built-in Dishwasher

Whirlpool Dishwasher Model #GU940SCGQ2 waste water from sink drain entering the dishwasher. Drain hose drains into same pipe as sin drain. Drain hose is elevated and looped as high as the top of dishw


... Whirlpool Dishwashers

My asko d3250 thinks the drain hose is blocked. but when i pour water in the dishwasher to see if the water is being drained, the dishwasher is draining properly. Yet the dishwasher after it has drained the water, will shutoff and start flashing the Large Pot icon (drain hose is blocked error code). Is there a sensor that is faulty?


Yes, it sounds like it is to me. I'm not able to pull your model up on my data base,if I could I would be able to tell you where it is located. I would assume that it's located either inside the pump or close to it. Sorry I couldn't be more help. ... Asko Dishwashers

Older Portable Dishwasher


I bet this is it...go by model # inside door om Right side........\015\012\015\012http:// ... Dishwashers

My portable dishwasher hose that attaches to the faucet is to short for where I want my portable dishwasher to sit. I would like for it to sit in one spot. I am not allowed to alter or cut holes in the side of cabinets, I am renting. Is there an extension for the hose to the faucet? If not, what can I do to make the hose longer? If I really have to I will cut the two hoses that comes from the dishwasher to the faucet, but I would rather have an extension first.


You should be able to find extension or replacement hoses that you can use to extend the existing hoses at a hardware store. If you need to join two hoses that have female connectors, adaptors with two male connections are available. ... Dishwashers

Hose hookups My Bosch SHU43 dishwasher has no manuals. My problem is that I have one long hose that should be the discharge hose but no fitting to hook it to my disposal nipple. My other problem is there is another hose that exits the dishwasher about mid level but does not hook to anything. Should this hook to the supply?


The smaller hose should be 3/8" is the water feed the larger hose is the discharge. you can open the front panel (2 torks screws) and you will see the water inlet valve in the left towards the center the electrial box is on the far right ten determin ... Bosch 24 in. SHU43 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2158 seconds