Having problems with your Dishwashers ?

Have an oppotuntity to buy a Bosc SHU330UC/U06 dishwasher 2nd hand which I believe is a 2003 model. Can you tell me how long the wash cycle is, and is there an on line manual to read? thanks Valerie


Answers :

Yes, go to fixit.com they can help
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Have an oppotuntity to buy a Bosc SHU330UC/U06 dishwasher 2nd hand which I believe is a 2003 model. Can you tell me how long the wash cycle is, and is there an on line manual to read? thanks Valerie


Yes, go to fixit.com they can help ... Dishwashers

Model she44c02uc; 2 years old. no matter which cycle we pick, it just keeps on running..it gets down to about 15 minutes on the countdown timer, and then resets itself to 80 minutes or so and washes over again...if we manually turn it off and then push quick wash, it seems to finish, but doesn't dry the dishes.......we have tried all suggestions in the manual and cleaned both filters; the line is not clogged...the sink and disposal both work fine. thanks


Hi,gibpru,ngafm at your service,You said, no matter which cycle you pick, it just keeps on running..it gets down\015\012to about 15 minutes on the countdown timer, and then resets itself to\015\01280 minutes or so and washes o ... Bosch Dishwashers

Inglis MOD#IPU58460 Dishes not cleaned properly...thought that enough water was not being filled into tub because more water added manually and washes great! I checked inlet water valve operation and lines for possible lime buildup and timed "fill" time. All was good and time right to spec! Water level after fill is just to bottom of mesh screens. Under further trouble shooting I held door open slightly while holding door switch closed to observe wash cycle and found as pump starts water shoots


The sprayer arm may be clogged with debris.Here's a step-by-step troubleshooting guide. ... Dishwashers

I have a GU1500XTLB1, type-575-0 Whirlpool Gold dishwasher. For the last couple of weeks I've been getting the control lock on. I got the manual out, I hold the air dry button and it clears. My problem is now when I turn the machine on dosen't matter which cycle I hit (pots and pans, normal, or quick wash) it runs for about 5 minutes and it goes into a mode with the timer having lines going horizontal with the air dry button lit up and rinse button lit up. It sounds like it starts the cycle


Hi,There are Few Tricks to Reset this. Follow the below Tricks :-1. Try holding down heated dry key for 5 secs. I believe that is the control lock/unlock button on your model. IF not, look for the lock symbol and follow same i ... Whirlpool Dishwashers

I have a Bosch dishwasher that is about 4-6 years old (model SHU8805UC/U12). A few days ago I found clear water in the tub hours after the wash cycle had completed. I drained the tub by resetting the cycle as instructed in the user manual, but the tub gradually filled up with water again after several hours.. will replacing the inlet valve solve this issue?according to what I can tell for my model the water valve assembly (part No. AP3783031) is the part I need. How difficult and expensive


Just pulled mine out last night. You have a different model but it should be the same. Remove the bottom dress panel and detach your inlet hose from the water valve assembly (have a rag handy to catch a little water). Two torx screws on the front ... Dishwashers

Dishwasher i have a ge dishwasher i purchased two years ago. i have misplaced my owners manual. i can only tell you it is a ge quietpower 3. i don't even know the model since i've misplaced my owners manual. it started with the timer for speed cycle set itself between 50 and 60 minutes, and i knew that wasn't right. and then yesterday it did not drain all the water out. i know there is no food particles in it because i clean them before i put them in the washer and the drain line it is hooked up


Hi lilwing,\015\012\015\012I'm Harvey the Master Plumber.\015\012\015\012Your question is: you have a ge dishwasher you purchased two years ago. you have misplaced your owners manual. you can only tell you it is a ge quietpow ... GE 24 in. Profile PDW7800 Built-in Dishwasher

It seems that not enough water gets into the tub. There is no kink in the water line. If you manually add water it drains out before resuming wash cycle. The water doesn't get around to wash the dishes let alone rinse the soap off the door!


If the machine has stopped half way through due to switching off or power intruption this could happen.\015\012\015\012So allow the machine to complete the cycle. \015\012Do no worry running it empty.\015\012\015\012It s ... LG LDF6810ST Stainless Steel Built-in Dishwasher

I have a maytag dishwasher mdb5601awb. when I hit the start button nothing happens. I have found the instructions to do a manual test which is hitting the heated dry button 5 times and then the start button. Thinking it will run some test which I have no idea what to look for, it actually runs the machine's wash cycles and clean, dries and tells me it clean with the green light goes on. How do I reset/reboot the machine so it starts by just hitting the start button again?


... Maytag Dishwashers

I removed an old dishwasher and replaced it with this GE 24" Profile GSD533ODO1WW unit. It seems to run through the cycles like it should but it doesn't seem to run any water for some reason. I hooked up a new water line to it and turned it on. There where no leaks that I could see. Is there any installation manual that you could send me to make sure that I didn't miss anything or is there anything that you can tell me that I should look for? Thanks, Jesse


... Dishwashers

Our Bosch SGS 53E02 AU/30 Dishwasher has the Tap Light on all the time while the Dishwasher is filling up. It appears as though water cannot get through and takes a long time to fill. It also does not allow the wash cycle to start and the powder door does not open. Can you also get any Service manuals for this model?


... Bosch Dishwashers

How long is the washer go for it's been an hour and still is in the washing cycle. can someone tell me if its normal.


Yes, its normal....what causes more time is the temp of the water....avg run time is 1hr 20min for d/w on reg with no addition selection...be sure to run your hot water at your sink until it gets hot then start the d/w....hope this helps. ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

I have an Indesit d62 dishwasher, approx 10 years old. It gets stuck part way through a wash cycle and I have to switch it off and move it on manually for it to finish it. Could you tell me what is wrong and how much to fix?


... Indesit 24 in. D61 Free-standing Dishwasher

Blanco dishwasher Hi. Saw your answer on the Blanco dishwasher. We have same problem. Dishwasher makes all the pump sounds it used to, but does not start to drain at cycle start, and then no water comes in. read the manual again and think we may have been washing up - ie sinks plugged. Could this have triggered something. You mentioned something about a "micro switch" could you tell me where would this be?. We have a BFDW 650 S. Thanks, Angie


... Frigidaire 24 in. FDB126RB Built-in Dishwasher

My dishwasher skips the final drain cycle. The lines are all clean and there is no clog. It drains just fine in the beginning of the wash cycle. Every time I do a load of dishes I have to run the full cycle, then leave the machine open for 3-4 hours and start the cycle again and listen for the drain at the beginning of the wash to drain the machine from the initial wash and stop the machine after it is done draining so it won't fill up again. Sometimes we have to unplug it and wait about an hour


... GE Nautilus 24" Built-in Dishwasher

I have a new Frigidaire FDB1050RE diswasher. I ran it for the first time set on normal wash and pressing both the Hi-temp wash and heat dry button. This cycle is supposed to take a total of 89 minutes to complete including the drying cycle. After 89 minutes it was still in the wash cycle so I cancelled it to preserve sanity. In the instruction manual it states that the water temperature must be above 120°F. Our building's water heating unit is set at 110°F. Why there is a lower temperature


It should still work pretty well but you probably can't use the high temp wash because it will take too long for the dishwasher to heat up the water enough to satisfy the high temp washer thermostat. If the thermostat's calibrated closing temperature ... Frigidaire Dishwashers

Haier hdw101wh.The dishwasher starts when you turn the dial the pump discharges waterto the outlet it clicks to next cycle but remains washing will not cycle through the wash cycle it keeps on washing . You have to turn it manually to get it finished any info will be appreciated.


... Haier Dishwashers

Whirlpool GU2300 built in Dishwasher. It rather suddenly began shutting off in mid-cycle. If I cancel or open it, getting it to finish the cycle or even drain takes many tries.Once started, the cycle might take several hours with long pauses during the cycle. When it puases, none of the lights are on at all. If the cycle is disturbed, the normal wash light blinks, and if I hit cancel, the cancel light and the normal wash light blink.


... Whirlpool Dishwashers

I lost the manual for my dishwasher. I have two questions: (1) How does Light Wash differ in its cycle from Normal Wash? It seems it should be (but isn't) shorter. (2) When using the Light Wash cycle, should I put soap only in 1 of the cups for dispensing (leaving the pre-wash cup empty)?


\015\012We need the Model Number off the inside of the door to get you the manual please post this first so we can Help you Thanks ... Dishwashers

Several people have posted this problem with the Frigidaire Ultra Quiet 111, but I have seen no solutions. When it is set to wash without extra heat, it cycles normally. But when the extra-heat wash and extra-heat rinse are selected, then it gets stuck first mid-wash at the 7 o'clock position, and if it is manually advanced then it gets stuck again during the rinse cycle just before the 9 o'clock drying position. Both the wash and rinse thermostats have been replaced without solving the problem.


Hi,\015\012\015\012I know that you are going to think that this is dumb... but the only thing that it can really be is the timer....\015\012\015\012 ... Frigidaire 25 in. FDP750RC Free-standing Dishwasher

Maytag model mdbtt70aww. After the end cycle. open the door and found detergent tab on the bottom and the main wash cover is opened. Maytag diswasher model MDBTT70AWW. Put dishes and so forth in the dishwasher. Put detergent tab and jet-dry rinse agent in the pre-wash section. and close the cover. Start wash cycle after done over door and found the detergent tab on the bottom new the heater. The cover to the main wash is opened. Dishes are are clean. Wish someone would tell me


... Dishwashers

Hello, my Hoover D7610 dishwasher has developed a problem, I would appreciate your advice.On starting a wash it appears to be working OK through what I believe to be a rinse cycle but then after about 20 minutes water pours out from the bottom of the door. Manually clicking the timer-programer forward stops the leaking but the machine needs manual advancement except for the last 2 cycles when the timer seems to work OK. After the 1st cycle there is no more water leaking from the machine but all


... Hoover Dishwashers

I have mod. # FDB1050REB0 the top rack wash/rise arm is not turning at anytime during the wash cycle--- We are not covering the hole into which the water is being pumped---- the bottom washing is turning---- this leads me to to believe the line to the top arm is obstructed from the pump to the wash outlet (in the top of the machine)---- what can I do to check the line?


Hi\015\012\015\012Please check if something is blocked near the top spray arm\015\012and also make sure that all holes are open. Use a sharp metal pin to clean the\015\012holes on the top spray arm. Make sure the water pressure is not low ... Frigidaire Dishwashers

My dishwasher get's stuck during the cycle and just keeps washing. If I dont move the cycle on manually it will wash and wash for hours!! Can any one help??


This is probably heating issue. The cycle will not advance if the water is not up to the proper temperature.Next time you run a cycle, open up the door after a few minutes. A large ball of steam should roll out of the machine. No steam = ... Whirlpool 24 in. ADP5962 Free-standing Dishwasher

Dishwasher makes grinding noise during wash cycle (after pre-wash). noise persists for 15-20 minutes. It seems as though the inlet valve doesn't open during this phase of the cycle. adding water to the dishwasher manually eliminates the noise and water circulates through the wash arms. I'm trying to determine if this is a controller issue or a valve/pump issue.


Water-inlet valve\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012\015\012\011\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\01 ... KitchenAid Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1788 seconds