Having problems with your Dishwashers ?

Digital display stuck- machine wont work even after reset

\015 I have a bosch exxcel slimline dishwasher. the digital display has stuck on 48 minutes and even switching off at mains will not solve issue. husband has located the reset button- then we tried a quick programme, but display now stuck on 29 minutes and machine not working- any suggestions\015

Answers :

Disconnect power from unit. Disconnect ground. Reconnect ground and make sure it is a good ground check hot and nutural to ground and should be line (110 to 120 V) on line (Black to bare) and 0-4 (with a electronic Volt Ohm Meter) White to bare. And again 110 to 120V from Black to White. Reconnect and if ground is stripped make new ground point with new screw. Modern electronics is required to have a good ground and without one readings like yours can freeze. If this dosnt work the board going to the display is most likely broken.

When replacing the board always ground your self before removing the board from the box and plastic bag. This will drain off and static buildup and prevent discharge across the board. (not as much a problem in humid or warm weather).
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Digital display stuck- machine wont work even after reset


Disconnect power from unit. Disconnect ground. Reconnect ground and make sure it is a good ground check hot and nutural to ground and should be line (110 to 120 V) on line (Black to bare) and 0-4 (with a electronic Volt Ohm Meter) White to bare. And ... Dishwashers

Bosch sgs43eo2gb dishwasher. wash programme completes, water drains out, but machine goes on draining, forever, stuck at around 50 minutes on the facia clock. there is no leak on the machine and everything else has been cleaned and operates perfectly. ie,fills correctly,heats correctly and drains fully but won"t stop draining & refill. Cancel programme and reset and it works perfectly until end of wash cycle again, when it continues to drain even with the door open. There is no leak in the machi


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for\015\012using FixYa. Please once again check that the hoses are not kinked or drain pump and filter ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

Bosch Dishwasher SHV4313GB/17 Wont switch off ! The machine keeps running even when you open the door The pump is trying to drain water away (even though there is no water left in machine ) Have tried to reset it as instructed but to no avail. It has beeped like it has finished cycle but the pump wont switch off HELP PLEASE !


Introduction: This may work for your problem, but only if you're finding that you cannot get further water to flow into your machine. If your machine fills OK, then this ISN'T a solution to your problem. If your machine doesn't fill but your drain m ... Dishwashers

Looks like program in electronic dishwasher has locked into a cycle. the machine will not drain even after resetting it. Also it will not restart any program or cycle after resetting and recycling power. The machine is a classic electronic bosch dishwasher It has worked perfectly for three months


Im a old bosch tech . the problem is the module or the drain pump is stuck. if this helps please give me a 4 thumbs up post thanks. ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

Bosch Dishwasher model : SHV4313GB/17 The machine won't switch off and the pump is still trying to drain water ( there is no water left in machine ) The cycle seems to have finished as it has made the beep sound as if it has finished. The dishwasher is still working even when you open the main door. Have tried to reset it but to no avail. Even after turning it off at the mains it still starts up again as if in mid cycle ! HELP PLEASE


I have a SHV. My sink drain backed up, and the water accumulating in the sink then migrated to the dishwasher, through the drain pipe, causing the dishwasher to fill up and, it turned out, overflow a little. When I turned on the dishwasher, the wat ... Dishwashers

The led digital display on our Neff dishwasher is faulty. When the machine is started the display on the front is blank ( top of door display is still working). This is a S4409 modle, integrated stainless steel bought in 2006


... Neff Dishwashers

Hi. I have a Siemens SE65E331GB Built in Dishwasher with an aquastop system. The problem is that it seems to be stuck at the end of a cycle. The pump is constantly running when stitched on. I won't top after a reset and it continues to run even if you open the door. The water supply light also comes on indicating that there is no water getting to the machine. I have tried resetting the aquastop as per the advice in other threads. This has helped in that the water supply light now stays


... Siemens Dishwashers

Hi Dishwasher BOSCH SMS53L02GB start of program digital display shows all sensor working. Water not pumping in. All hoses and filters checked OK Machine pumps water out then completes cycle in 1 minute. Water supply getting to base of machine An E21 code shows up on fault finding cycle


... Bosch 607335 Water Valve Assembly For Dishwasher

My deceased parents have a GE dishwasher (don't know the model number - can't find it on the machine and can't find the paper work) that stops working shortly you start it and displays a message on the front panel that says "Blocked wash arm - check for wash arm obstruction - restart". We restart it and get the same message shorty thereafter. This happens when the washer is COMPLETELY EMPTY, even when we remove the bottom rack. It first started after several month of inactivity. We'll just t


Could be false sensor input, could be that the arm is not turning, I am not sure how old your machine is, but age could play a part if the arm is "in fact", not turning. If you are not mechanically inclined, I would suggest that a qualified repairma ... Dishwashers

My Fisher Paykel dw60cdw2 dishwasher stopped working mid cycle and I cant get it started again even aftre switching power off and pressing reset.. All lights on the console are working except the number display on the left side. What is the problem likely to be


Had the same problem and it was the microswitch that is behind the door skin which is associated with the lock mechanism. got a new one and away she went ... Fisher and Paykel Dishwashers

My Asko 1885 is stuck on F2 but the pump is still working (there was a water backup in the sink - maybe the cause?). It will not stop. Power cycling doe not help. How do I reset the machine? Thanks!


Press pause/cancel button twice ... Asko 24 in. 1885 Built-in Dishwasher

My dishwasher keeps blinking the "clean" light and will not start. I have tried turning off the breaker to reset the machine but it still wont start even after pushing all the buttons.


... Kenmore 24 in. 16049 Built-in Dishwasher

The program button wont work the machine is stuck on a program


... Smeg Repair Pcb / Module Dwi710 Dwi710e Dwi710e1

Hotpoint Dishwasher: HLD404M15SA. I installed the never used dishwasher and the Display Lights don't work. The unit operterates just fine. I tried the reset and powering off a few times, still not even a blink. It didn't come from a dealer, so I don't think the warranty would be an option.


... Dishwashers

Got a lound buzz type noise that I thought was a bad solenoid on the water valve. Tub also filled up & overflowed1 Replaced water valve ($30), but now dishwasher wont run thru cycles or fill with water to wash--seems to be stuck on drain even though digital counter counts down. What should I check next?


You may have dislocated the connection that controls the AquaStop circuit.\015\012\015\012This is linked to the inlet hose. Either the connector linking the inlet tap to the inlet valve is loose or the float switch has triggered.\01 ... Bosch 24 in. SHU53 Built-in Dishwasher

My sink got clogged and now my bosch dishwasher SHU43C05UC wont fill with water. I read on line that it most likely is the float is stuck and to access the front kickplate needs to be removed. Is there a diagnostic test that I can do that will display on the LED to make sure that this is the problem. How involved is it to unstick the float. Can it be done without moving the dishwasher and just working from the kickplate area?


It is most likely that you need to do the following\015\012\015\012Larger remnants of food that have not been trapped by the filters and have been left in the water can cause a blockage in the pump. The water is no longer pumped out of th ... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

My electrolux diswasher displays a code PF it wont reset even if i turn it off at the wall ??


... Electrolux Dishwashers

Fagor Innova Dishwasher 1VFU - 75IT model. Display lights wont turn off and machine won't work!! Tried turning off mains but no luck! Please help! thanks.


... Fagor LFA-073 IT Dishwasher

Fagor dishwasher Model 2LF-013SX-was working till last week. Now, putting on the main switch, a sound is heard at the bottom of the machine even without switching on the machine.The display is not coming on. Please advise on what to do. My e-mail address is: [email protected] bought in Dubai & I am at present residing in Bangalore, India


... Dishwashers

I have a Bosh Logic dishwasher SGS65L12GB/04 The other day it got to 1 min left and would not stop pumping out water and continued even with the door open. After 5 mins playing around it started working again for a further 2 washes. Now when switched on the pump for pumping out the water works continuously. Reset it time seem to count down but does not do anything reset time goes to 0 and beeps but still the pump runs even with the door open. all buttons seem to work fine but no washing and pu


Hi Jonathan,\015\012\015\012Welcome to FixYa.\015\012\015\012Your float may have got stuck or it's possible that you have water leaking into the bottom of the washer. In the bottom of the wash compartment, next to the drain yo ... Bosch Dishwashers

Maytag model MDB7609AWW2 wont work after reset sequence.


... Maytag Dishwashers

Model IGV 659.1 Dishwasher When switched on the 'time display' takes longer than 2 minutes to display the planned wash duration. The display works fine to set a delayed start. After cycling the start delay round to 0, or after RESET (buttons A and C pressed) the unit is then 'nudged' into displaying a time. After, at last, a time is displayed the unit works fine.


... Kuppersbusch Dishwashers

Defy dishmaid dishwasher does not start wash cycle. Several attempts to reset dishwasher has been done. Machine has been unplugged for several days and switched on again and still does not work. The start/stop switch have been kept in for about 5 - 10 seconds to reset. When the machine is set to do washing, the water enters the machine and wash light shows green and machine remains like that with water inside the machine. The start/stop button is again pressed for 5 -10 seconds to drain the wate


... Dishwashers

Dish Washer, Electrolux Home Products, Model FDB2510LCC0, Serial NO: 7H34962223 Machine does not drain or add water. The machine has been worked for a couple of years. I checked the following: 1. Overfill Protector not stuck 2. Motor turns on and the machine cycles correctly 3. Since the machine has been running correctly the unit is hooked up correctly: hoses, garbage disposal, knockout plug. Again everything has worked and the motor does cycle and the machine will perform the different cycles


... Electrolux 23 in. ESI602 Free-standing Dishwasher

Dishwasher PLD 3465 REC I cannot reset the display panel. I took the kickplate off which was supposed to have the code for the reset but it had nothing related to reseting the display panel. It is stuck on 94 min clean time. What is the code to reset? There is nothing in the Use & Care manual that tells you how to reset.


Putting the unit into service mode will reset the the display. Look at the instructions behind the front panel. If the unit fills and does not wash, the wash motor may not be working. ... Frigidaire 24 in. PLD3465REC Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1610 seconds