Having problems with your Dishwashers ?

It was blocked and now Error 4 keeps coming up on the screen. how do we fix it???


Answers :

Hi there,

you need to check inside your dishwasher there must be some clog in this.

better if you can provide me the company and the model number of your dishwasher.

post comments.
Thanks
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

It was blocked and now Error 4 keeps coming up on the screen. how do we fix it???


Hi there,you need to check inside your dishwasher there must be some clog in this.better if you can provide me the company and the model number of your dishwasher.post comments.Thanks ... Dishwashers

Hi,rn Hi, We are getting an "F4" error appear on our D3350 whenever we try to use it, (wash, rinse, etc). I can see water coming in from the side inlet, but the error seems to appear once it reaches the inlet for the sprayers. Perhaps the sprayer pipe is blocked? Is there anything that we can do to fix this ourselves? Thanks very much, most appreciated


Yes you need to reset dishwasher to time fill.turn off the power button wait 10 sec,push and hold the programme and start buttons then turn power back on.hold buttons down until display lights up then release them.press programe button until 4 shows ... Asko 24 in. D3350 Dishwasher

Bosch Dishwasher our disherwasher keeps coming up with the letter (F) on the front screen goes any one knw what this is. I have no water coming through the machine have checked the hoses the are not blocked. Help needed....


What is your model number? list it so I can look it up, also check to see if there is any water standing in the bottom pan,not inside where dishes go, down behind where toe plate is.Remove toe kick plate,remove panel behind kick plate.If there is wat ... Dishwashers

WE HAVE A SMEG DISHWASHER AND IT KEEPS COMING UP ERROR 1 MESSAGE ANTI FLOODING SYSTEM HAS BEEN TRIPPED HOW DO WE FIX


There is a water leak in your dishwasher. Need to find the source of the leak. Usually a cracked hose or water leak through door gasket.You can check this by turning off the water supply and mains power. Take dishwasher out from under bench i ... Smeg Dishwashers

We have a LG dishwasher LD-14AT2 and the rotating arm that is attached to the end of the lower wash arm keeps on falling off. a) how do we fix this? and b) would this be causing the dishwasher to come up with an E1 error code?


The lower arm is attached with a nylon nut to a nylon hollow shaft the water comes threw, u can try replacing the nut 1st then if it comes loose again you will need to replace the arm the that the spray arm connects to. as far as the E1 codee goes it ... Dishwashers

Hi I've got a Hotpoint FDD912 dishwasher that keeps stopping midcycle displaying the error code A8 and occasionally A10, neither of which are in the manual. Does anyone know if this is an easy fix - something blocked etc - or if it's broken completly? Thanks Nick


... Hotpoint Dishwashers

Smasungdishwasher DMT610RHS error codeCE showsup. eventhough the is not locked in, it still runs with error code CE, but the water is not coming in. but the motor is running. unless I plugged out, it keeps running. I shut off, but not responding power ONOFF.no response to any button on the control pannel. but keeps running.


... Samsung Dishwashers

LG Dishwasher My LG Dishwasher Model: LD 14AW2 Electronic stand alone keeps on coming up with an error E1? I am not sure what it is because we have no instruction manual. The dishwasher is about 2 1/2 years old. I am doing a standard (Normal) wash. It starts to put the water in side then comes up with the error.


I have same dishwasher first check the water is cumming in if not remove the left side cover.1) the bottom tray is full of water you have a leak . replace the leaking part . 2) you will see a foam float toward the back of ma ... Dishwashers

My Frigidaire dishwasher keeps showing the Er uo codo on the display. It used to would finish a load even though it would stop for a while when the error message came up, but now it will not run at all when the error message comes up. I read on this site that the Er uo has to do with the vent. I pulled the dishwasher out and removed the vent. I turned the dishwasher on and the vent opened and closed about three times when the cycle started, then it stopped and the error message came up. Is


Hi. This code is in reference to the vent assembly. This may also be a control fault, as well. To isolate the culprit, you will need to make sure that the vent assembly is not blocked. If it is blocked, it must be replaced. Restricted air flow will c ... Dishwashers

I have a whirlpool du1100xtps sudenly stop working when I plug the machine, the stop/drain button comes on, and about 15 seconds later turns off and the normal button comes on but blinking and after about 15 seconds the stop/drain buttom comes on too also blinking and then just keeps going on like that and nothing else happens??????? how can I fix it, or what is wrong with the machine?


... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

Zanussi DES 959 - AL5 warning keeps coming up indicating either the filters are blocked or there is no water coming in. Filters are clear and there is water coming in - what next?


... Dishwashers

I keep getting a washer arm blocked error.


I have had the same problem for a couple of years. When it tops without opening the door just press the start button and it will resume and finish the load. ... GE Profile PDW8400J Built-in Dishwasher

LD-14AW1 keeps coming up with OE error code


Hello,The most common cause of an OE error code on a modern LG dishwasher is: 1. Blocked drain hose 2. Obstruction in the sump area (beneath the filter, which needs to be removed to check for onstruction) 3. Failing drain moto ... LG 24 in. LD-12BS6 Stainless Steel Free-standing Dishwasher

Error code E:25 keeps coming up on my bosch


... Bosch Dishwashers

How do i fix an F5 error code on a Fisher & Paykel Dishdraw DS605. I have turned the power off but the error keeps returning?


I am assuming you have the DD605 double drawer dishwasher. Is the problem F5 on both drawers or just one?\015\012\015\012F5 code involves the drawer lid seal and will need a bit of effort to check and fix.\015\012\015\012Take ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Hi My fdw70 dishwasher blew and smoke started coming out > I replaced the fuse and it was fine for a couple of cycles and now keeps coming up with the A10 error code . what part shall I change where is it and what does it look like > Cheers James


... Dishwashers

I have a Baumatic dishwasher and the E4 error message keeps coming back. We empty the water in the base of the unit, check the float triggered switch OK. It works for a while then the error re-occurs as the sump fills up again. What could be the cause?


... Baumatic 23 in. BFD61SS Free-standing Dishwasher

Hi i have a whirlpool dish washer - model : ADP4731/5 , AAA class . I keep getting a F7 error message and it is not allowing me to turn the washer on , if i hold the start button down it allows the washer to go for 30 seconds before the error comes back up and it stops working again


... Whirlpool Dishwashers

I keep getting an E1 error on my LG LD-2120W model dishwasher, can you advise what this means so l can either fix it or get it fixed. Thank you


Leakage Error E1\015\012\015\012\015\012\015\012\015\012The excessive RPM of Washing Motor happened during Washcycle due to water leakage.\015\012\015\012Water leakage in ... LG Dishwashers

Model#lds5811bb--started making noise coming from the water inlet area(bottom left). 3/4's of the way through the cycle, noise became louder and then an error code "le" came on. We tried turning breaker off, then we tried in the rinse only cycle, but 5 minutes into it the "le" code error came on again. I'm fairly handy, so I'm not sure what part I can replace to maybe solve the problem. I can't afford to spend a couple of hundred dollars for a repair man to fix it. I'll appreciate any suggestion


The LE code is a locked motor code. Something may have gotten into the pump impeller. I would take the screens and filters off and clean the and check the pump for something stuck in it. It could also be the motor going bad but I would check the obvi ... LG Dishwashers

Asko 1375 unit will not wash drains and fills ok  motor at back of unit runs well. Suspect impeller   Does motor have to come off for impeller replacement?? My 1375 is leaking a bit, looks like the seal which was mentioned in the impeller repair case,may be the problem? The other problem I noted was a clogged screen at the bottom of the dishwasher which is on the suction side of the pump, the screen had calcium buildup etc. I cleaned it off with vinigar and reran the dishwasher seemed ot fix th


Do you mean to say that the washer does not go into the wash cycle at all, or washes poorly?An answer to both can be found HERE.This article ... Asko 1375 Dishwasher

Bosch Dishwasher Cycles will not stop running. They keep starting over. Help please!! Our 2 year old dishwasher will not stop running. It gets to the end of the cycle and starts over again. Plus, the cycles seem to have gotten longer. We called the Bosch repair number and they want $150 in cash to come out and look at it. Then they will come out and fix it!!!! Unbelievable!!!


Carry out a reset.\015\012This should reset the board back to factory settings,\015\012Deep Diver ... Bosch 24 in. SHU5305UC Built-in Dishwasher

I am getting an IE error on my control panel. It seems to start ok but once it starts to fill with water the IE error comes up and the machine shuts off. How can I fix this?


You do not list the manufacturer and model number, but it sounds like you own an LG dishwasher.The IE error indicates that the water is not entering the dishwasher or it is entering too slowly / with little pressure. It is important to c ... LG Dishwashers

Error i have a LD-14AW1 keeps coming up oe error can anyone help


The ?OE? indicates drainage trouble.\015\012It could be a clogged in the drain line. Often the problem is at the point where the drain line attaches to the garbage disposer or household drain line. You should remove this line and clear it form any d ... LG 24 in. LD-12BS6 Stainless Steel Free-standing Dishwasher

Samsung DMR57 We bought a Samsung in June and have been trying to get it to work properly ever since. It is very quite which is great, but like the other person wrote the thing keeps coming on even when the child lock is on. We have had a repair man out twice but it they haven't fixed it yet. The dishwasher is right under the counter we use to prepare food so we often rub up against the controls. The power comes and and it starts the machine on whatever cycle it used last, or rinses the dishes.


... Samsung 24 in. DB5710DT Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1138 seconds