Having problems with your Dishwashers ?

We have a Whirlpool ADG 7560 dishwasher which has recently started playing up. When switched on for a normal wash, after a short time the machine starts to beep. If you open the door the green programme light is on the pre rinse and the start light is flashing. After starting the cycle the few times eventually it works normally. Have cleaned all the filters etc.


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

We have a Whirlpool ADG 7560 dishwasher which has recently started playing up. When switched on for a normal wash, after a short time the machine starts to beep. If you open the door the green programme light is on the pre rinse and the start light is flashing. After starting the cycle the few times eventually it works normally. Have cleaned all the filters etc.


... Dishwashers

Whirlpool dishwasher ADG 7460 put on 30min programme - finishes early beeping start button green light flashing other light indicator now on pre rinse


... Dishwashers

I have Whirlpool dishwasher about 3years old it is the ADP7966 AAA 6th sense. When I put it on and turn the temperature knob, only the first temperature green light comes on althou I can turn the knob all the way round none of the other lights come on, my rinse aid and salt programmes light up thou ,and when I press the start button it flashes twice stops a bit then flashes twice again, and thats all it keeps doing. I would be very grateful if you help to solve the problem. Many thanks to you.


... Dishwashers

On my whirlpool ADP962 dishwasher the start light is flashing but nothing is working. I can change the programme type (ie rinse, wash etc) but the programme will not start. I can't select either half load or a time delay. By holding the start button it will start the pump but when this stops it goes back to a flashing start light. The programme progress lights are not lit. What is this telling me and how can I reset it?


... Whirlpool Dishwashers

I have an ADG7550 whirlpool dishwasher. Am experiencing a fault when placing on a normal 65 degree programme it starts to fill and then defaults to pre-rinse and the start button and light flash eleven times. Can you explain what type of fault this could be ? I have had a similar problem 12 months ago when it was described as a water pressure problem which again was in the winter and wonder if this is the same. I would add that if I re-set the start button by holding it down and then re-start


... Whirlpool Dishwashers

Dishwasher does not wash simply beeps continously and wont start the rinse cycle with green flashing pre rinse light. Have tried turning off at power and have checked all connecting pipes. Have emptied dishawasher also all to no avail.


If your dishwasher is a whirlpool or IKEA then maybe the answer given by emmanuelr in "Whirlpool dishwasher ADP5962 F7 error code" may do the trick. It certainly worked for me. Bit technical but if you are happy taking the sidepanels off the thing th ... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

Hi. IKEA Whirlpool DWFA10 dishwasher.Firstly, when switching on the machine to befin the programme the machine does not pump residual water away.It then begins its cycle (in this case the pre-rinse cycle).After 12 or so minutes,when the cycle finishes and the water should be pumped away,the machine stops and the green warning light keeps flashing 4 times intermitantly.


... Dishwashers

Have a whirlpool G2P DWI / 1 WH integrated dishwasher - when put on [70C] it seems to work ok and washes dishes but then after what seems to be the full cycle it just beeps continuosly - when opened the start button is flashing and the green light is on under the pre-rinse symbol. It's been in for about 5 years and have had no problems with it. Can't find instruction manual.


... Dishwashers

Have a whirlpool G2P DWI / 1 WH integrated dishwasher - when put on [70C] it seems to work ok and washes dishes but then after what seems to be the full cycle it just beeps continuosly - when opened the start button is flashing and the green light is on under the pre-rinse symbol. There are two bar codes down the side: 8542 347 15810 and 33 0451 014488. It's been in for about 3 years and have had no problems with it. Can't find instruction manual.


... Whirlpool Dishwashers

Whirlpool ADG 957. Light for rinse programme on but start light flashing intermittently. Cannot change programme, cannot start machine.


Mine was doing exactly the same. I turned off power, held down the 2 black buttons on right, switched back on and the start button flashes intermittently. It then allowed me to change programs, just testing it now!! It started, this was more then ... Dishwashers

I have a bauknecht gsx 4756 that beeps continually when I start it and the start light flashes, I reset it by holding the start button down and reselect the programme but it starts bleeping and returning to the rinse only programme. Can you assist me so I do not have to call out an engineer? Thanks


... Bauknecht 24 in. GSX7551 Built-in Dishwasher

We've got Beko DE 2542 FW Slimline dishwasher. Everything switches on as it is supposed to but nothing happens. Rinse aid and Salt indicator red light is not on, because we've filled them up. Switched on dishwasher, green light for "On" comes on. Selected programme level, pressed start. Green light comes on for "Wash" Nothing happens - we've left it overnight but nothing happens. What seems to be the problem? Look forward to hearing the solution.


... Beko DE2541FW 18 in. Portable Dishwasher

When cycle starts after about 1 minute bleeping starts and when door opens the machine has changed the programme to the 1st programme (rinse) the light is flashing 7 times then pause then starts again, it sounds like the water is not getting into the machine, we have checked the water pipes for blockage and cleaned the filters?? Model is ADG7440


... Dishwashers

Dial is stuck on pre rinse it will set at 60 but will jump back to pre rinse start light flashes. whirpool model ADP5540


Go to sears parts direct .com you will see the part that is stuck and you can order it fromthem. they onlyneed the model#. ... Dishwashers

I have a Kenmore Elite Dishwasher Model 665.172824000. We think it stopped part way throught the dry cycle. The green "Clean" light has been flashing since in 7 flash cycles non stop. I tried pushing the Cancel button, it starts the drain pump then stops and we are back to where we started. I tried to start a new wash cycle but when I close the door and push the start button it just give 3 quick red flashes and then nothing but the green clean light flashing again. I shut the breaker off fo


So sorry but the partsdirect site for sears locked down my computer. Check where the drain hose connects to your pump and see if there is a small device the hose connects to that has 2 wires going to it. If it does unplug the wires, turn power off, w ... Dishwashers

Prima dishwasher model LPR601 goes through cycle at end it beeps continuley when door is opened the programm light for rinse is lit and the start light is flashing.


... Dishwashers

Hi, I have this dishwasher and after I came home from vacation it is flashing a "Rinse Only" green flashing light and will not start


... Whirlpool GU1200XTLS Stainless Steel Dishwasher

I have a zanussi tempoline dishwasher, I have loaded this as I usually do, turn the knob to the right and select the 2nd programme the light next to this comes on, I have pressed this to start the machine although it seems as if it is going to start this light flashes and the top arrow on the right of this flashes intermitanly, but the machine does not start the wash programme. The 3hr delay button if I had pressed this by mistake which I am sure I have not would light up. When I found it did no


Hi Ruth.The machine can be in error mode. In this case one or more lights in the control pad will stay on or flash and the cycle will not start.One of the most common fault in your situation, and at start of the cycle is no wa ... Zanussi Dishwashers

The third green light (where the three green lights light up and red) flashes. The dishwasher will not start. When you press start it just flashes green.


... Electrolux Kenmore 24 in. Built-In Dishwasher with 5-level Precision Direct Water Delivery System Dishwasher

Flashing start light starts ok with prerinse programme then switches off having done nothing


Green light flashing ... Whirlpool 24 in. ADP5966 Free-standing Dishwasher

Hi there. I'm having problems with my dishwasher. Usuaully once loaded, i push the start button, the closest green light to the start button flashes and dishwasher fills/cycle begins. Now, when i push the start button, the furthest green light from the start button flashes, you can hear the motor running but no cycle begins. No water fills the dishwasher.


... Hotpoint 23 in. BFV62 Built-in Dishwasher

The third light (where the three green lights light up and red) flashes. The dishwasher will not start. When you press start it just flashes green.


Either the door switch may not be making proper contact will you shut the door or the float switch at the base is stuck making the dishwasher believe it is flooded and should not take anymore water. But generally the drain motor should also start in ... Electrolux Kenmore 24 in. Built-In Dishwasher with 5-level Precision Direct Water Delivery System Dishwasher

Quick Rinse light was flashing at end of cycle. Opened and closed door and pushed Start. Quick Rinse and Cancel/Drain light are now flashing and machine won't start. Turned off power supply (30 seconds) / turned on power supply and then tried again to start the dishwasher, but same problem. Control panel seems to be frozen at the Quick Rinse/Drain mode and will not cancel. Help! Thank you


Ok try this, open the door and then hit these buttons in the following combination. HI TEMP - DRY - HI TEMP - DRY...then close door and press cancel...then wait for the pump to shut down. you should be able to run a cycle after this...If this fails ... Dishwashers

I HAVE A BAUMATIC D/WASHER BHD5 TYPE DW-24E1,(ABOUT 8 YEARS OLD) IT IS A WHILE SINCE LAST USED THEN 1 NIGHT AS IF IT HAD STARTED BY IT'SELF IT STARTED MAKING A BEEPING NOISE ALL 4 INDICATING LIGHTS AS WELL AS SALT AND RINSE AID WERE FLASHING HAVE SINCE TOPPED UP SALT AND RINSE AID BUT ROUGHLY 1 MINUTE AFTER STARTING IT BEGINS TO BEEP AND ALL LIGHTS FLASH. COULD YOU TELL ME THE PROBLEM. MANY THANKS


... Baumatic Dishwashers

I have a Whirlpool ADF951, it has power to it and was working fine, the power light is on and the green light to the far right of the cycle lights is flashing, I can only get any response if I hold the start button in for about 10-15 seconds, The machine stops the light flashing and makes the noise like it is starting , that goes for about 20 secs then returns to the flashing light stage, any idea's please


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If the light flashes, pauses, and then repeats. When\015\012the dishwasher doesn't sense a water tempera ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1506 seconds