Having problems with your Dishwashers ?
Motor will run but no water comes into dishwasher
Hello, your problem is going to be with the inlet valve, there is a solonied on top of the valve that has shorted out, the way to test this diagnosis is remove the panel at the bottom of the dish washer..locate the inlet valve normally on the front left under the washer, remove the 2 wires from the valve (being sure to cut the power off to the dishwasher while you do this step) using a volt meter isert the probes into the connectors on the wire then turn power back on, now run a wash..after a minute or so you should see 110v on the volt meter...if this happens your valve is bad you will have to pull the dish washer out and replace the valve. Good Luck!!! If you have any other questions or concerns please feel free to comment again. Mike
Check for any kinks in the water feed hose. Also check that the water source (valve) is turned on completely. If you are using any type of water filter, check to be sure that it isn't clogged.
Repair Help & Product Troubleshooting for Dishwashers
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Maytag Dishwasher Model MDB4100AWQ When I start the Light Wash Cycle: Washer fills with water, heater comes on (I checked it with a volt meter--120 volts), timer runs, motor never runs, before the timer gets to "rinse" the heating delay light on the door comes on and the timer stops. The heater is still on (120volts) nothing further happens it just boils away on the water in the washer. Note: If I manually forward the timer to "rinse" the motor will kick in and run but does not pump out w
Most common d/w power is 120 volts, check for 120 volts with a ... Dishwashers
Had a clogged garbage disposal, once fixed, the dishwasher stopped getting water to it, sounds like its running, but no water coming to the cycle, Its a bosch dishwasher, motor seems to run, drain working,but no water to it.
If you didn't do the disposal fix yourself then there's a possibility that whoever did it closed the water valve to the dishwasher although there is no good reason to do that...\015\012\015\012I would check the valve then make sure that a ... Bosch 24 in. SHU43 Built-in Dishwasher
I have a CDA CW494 dishwasher, which is a rebadged Whirlpool. The pump has been changed by a service engineer, using a Whirlpool part instead of the original, apparently it is superior. It seemed to work OK, but now the main jets only squirt for a short burst when the motor stops or starts. The rest of the time the motor can be heard running, but no water comes from the jets. Could the motor be running in reverse?
I would check to see if there is any blockage in the area of the dishwasher where the water collects to be recirculated through the pump back into the washer. It sounds as though the water isn't being allowed into the pump enough to continue the was ... Dishwashers
After a power outage, that occured while the dishwasher was running, the lights come on and there is a high pitched noise. Then all the lights go off and the motor sounds like it is starting. However there is no water and the heating elemant comes on. The lights on the front; china/crystal, normal wash, clean and heated dry, all come on as if the computer is confused and trying to run them all simultaneously.
Sounds like the board was fried from a power surge ... GE Tritonr XL GSD6260JCC Dishwasher
When i turn my Viking dishwasher on the motor starts to run but no water comes out. It was humming along for several hours before i realized that nothing was really happening. I turned it of and then tried again but the same thing happened. It sound like a motor and/or pump working but no water enters the chamber. Thanks, Jonathan
It sounds like the Water Supply Solenoid is bad. I would change that and let all of us know what happens. ... Dishwashers
My 1yo slimline hotpoint dishwasher LST216 has developed a fault when trying to run the 'normal wash': washing stops after a couple of mins, the lights start flashing and the alarm comes on as soon as the water is being drawn into the machine. When I open the door I can hear a whirling/grating motor noise coming from the bottom of the machine. I have cleaned all filters and have run other programmes to check overall functionality and they all work as expected most of the time. I cannot unders
... Hotpoint Dishwashers
My Viking dishwasher won't fill with water. The motor seems to be running but no water enters the chamber. It's Sunday morning so I'm not able to get a repair person here. I got a response that said ''The ventilators are blocked. Turn it off and have the motor checked'' i was hoping for instructions on how to unblock the ventilators or clean it out. I have a house full of people for the weekend and would love to get this thing back up before Monday when a repair person could come. Any suggestion
... Viking Dishwashers
I have no enr number on my Bosch dishwasher just Maxx Classixx. Motor continues to run after programme finnished and comes on as soon as select programme before turning on. Only way to solve is to tip water out of dishwasher each time by tilting back until it comes out.
... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher
Fagor Dishwasher My Fagor DW suddenly has no water coming in but the motor is running. The cycle starts for about 3 mins then sounds a bit painful followed by all the warning lights coming on and beeping. I live in Spain and am not good with the lingo so am worried about calling anyone out. I've checked the water in pipe which is OK. Help!!!!!!!!!!!! (Please)
Ok if you have a volt meter then remove the bottom kick-plate locate the water valve take the connector off the valve set the meter to ac volts plug the leads into the connector turn the timer to fill if y ... Frigidaire 24 in. FDB126RB Built-in Dishwasher
Hi experts - My dishwasher won't drain properly. There's several inches of standing water in the bottom of the unit. During the drain phases of the wash, the motor underneath doesn't spin and a buzzing is coming out of the motor relay. During the wash and rinse phases, the motor runs fine and all appears well. Any thoughts? Thanks!
Either the water outtake or the pump are clogged - you will have to remove it to see where's the problem. ... Frigidaire 24 in. FDB679GF Built-in Dishwasher
Obtained this haier hdp18pa portable dishwasher, thought I would give it a try. The unit will not fill with water, turn the power on you can hear the motor or the pump running but no water comes in. THe 4 display lights flash and beep a series of times and then stop only to repeat the sound off in a every few second sequence. I have tried the remedies offered online, tilting the unit does not seem to work for me on this one. I changed out the water inlet valve but nothing changed and I got the s
HiYou need to clean the filter that is in the tube that gets water in the dishwasherin case you can not find it pls ask me to send you a diagram ... Haier HDP18PA Stainless Steel Free-Standing Dishwasher
When I turn my dishwasher on, the motor runs, but no water comes out. Last night I did a load and this morning there was water all over the floor. Lynne
Simple things first\015\012Is the pump discharge hose still connected.\015\012Pump impeller housing broken/ pump impeller housing discharge nipple broken\015\012Hole in ye old hose.\015\012Rusted out tub??\015\012and the ... Dishwashers
Frigidaire 24" FDB1050REB2 Dishwasher It will not allow water to come in. The pump works, the motor runs, but it will not fill up. Water valve has been replaced. Pleas help!!
Friend,ngfam1 At your service!You plain old need service ! I am not hands on from this side of the wire!How old is the appliance?If the appliance is 10 years old or more you may not be advisable to put good m ... Frigidaire Dishwashers
I was replacing my sink faucet today and in the process turned the water off to the dishwasher. Subsequently my girlfriend ran the dishwasher without the water on! Now when I go to run the dishwasher no water comes out (meanwhile I've turned the water to the dishwasher back on). Is there some kind of reset? I accidently touched the coil in the bottom of the dishwasher just after trying to run it and it was hot. What do you recommend? Thanks. Mark
Hi,You need to investigate the following :-\015\012\015\012\015\012\015\012\015\012Drain line/air gap\015\012\015\012A\015\012clog in the drain line or air gap (if there is one) is the usual reason\015\012that a dishwas ... Kenmore Dishwashers
I have a GE dishwasher model GLDL560N10SS. I noticed a burning smell coming from it the other day and then realized that although I can hear water running into the dishwasher when I start it, it never actually runs in the sense that the water is pushed through the various outlets to wash the dishes. I'm assuming that it is because the unit is dry and the heating element is still coming on that it is causing a burning smell. If I open the unit and reset it, it pumps the water back out into the si
The problem sounds like it is in the water inlet selonoid. Pull off the bottom panel and this is the part that the main water line hooks to there is a selonoid and it has a plugg inconnection to it unplugg it and check for power when the unit is supp ... Dishwashers
Bosch Dishwasher I currently own a Bosch dishwasher. One of the selling points, if I'm remembering right, of the dishwasher was it was supposed to super heat the hot water that is coming in from the tap. I have 3 problems. We have to rinse the dishes by hand before putting them in the dishwasher, Otherwise they won't come out clean. The dishwasher will run for four hours sometimes longer. It doesn't seem like it is heating the water any hotter than what comes out of the tap.
Your control board is bad. ... Bosch 24 in. SHU43 Built-in Dishwasher
The dishwasher has the normal and economy wash lights flashing and after we hold the start button down for 4 seconds the stop and then return to flashing? The washer motor runs when the door is closed and no water comes out and the system doens't stop trunning until the door is opened. The system ran for over 4 hours yesterday. Viking Professional
Hello, welcome to ... Viking 24 in. Professional Series VUD040 Stainless Steel (Premium) Built-in Dishwasher
Motor will run but no water comes into dishwasher
Hello, your problem is going to be with the inlet valve, there is a solonied on top of the valve that has shorted out, the way to test this diagnosis is remove the panel at the bottom of the dish washer..locate the inlet valve normally on the front l ... Dishwashers
Dishwasher repair Motor is running, but no water is coming in to washer.
... Bosch 24 in. SHU43 Built-in Dishwasher
My Dishwasher stopped working. When I switch it on there is a sound like a motor running, a kind of whirring sound. It sounds as if the machine is working normally but there is no water coming through it. Any ideas? Thanks, Paul
Hi There,\015\012\015\012That's the classic sign of water having leaked under the washing compartment/tub. This causes a "float" to rise, tripping the micro-switch which activates the anti-flood protection. This closes the water inlet val ... Bosch 24 in. SHE43C05UC Stainless Steel Free-Standing Dishwasher
Motor running, no water coming in - Maytag PDB3600A Built-in Dishwasher
\012Hi,Here is a tip that will help you to find out why water will not come into the dishwasher... ... Maytag PDB3600A Built-in Dishwasher
My Whirlpool Dishwasher ADP931 has stopped working. It stopped in the middle of the cycle with 2 to 3 inches of water on the floor of the compartment. I mopped out the water and tried to restart the dishwasher. The green "on" light now comes on when I press the start button. but nothing happens (no motor comes on,no water enters).Repeating the above action several times does not help the washer to restart even though the other function lights will come on when the knob is turned. saturn1914
Hi,Whenever you see such symptoms, Time for you to investigate it properly. Check the below guide :-\015\012\015\012\015\012\015\012\015\012Power from the house\015\012\015\012Is\015\012there power getting to the dishwa ... Dishwashers
Won't start After two months of no use my dishwasher won't work. I can hear motor running but no water. We tried cleaning by filling with water (priming motor) but nothing happens. Now the dishwasher if full with water, motor makes noise but nothing is happening. Help!!
It sounds like you have a food blockage or some blockage between where the water fills up and where it goes into the pump you need to take out the water wand (the rotating thing with water coming out) only the bottom one. You need to unscrew the wate ... Hotpoint 24 in. HDA1000Z Built-in Dishwasher
Champion dishwasher we have a champion freestanding dishwasher at my church. after the cycle is completed, the pressure guage behind the washer still shows 25-30 and it contnues to spray water. not forced by the motor, but more like a stuck open fill valve. if i turn off the water and run it, then turn the water back on, the valve is closed and does not let water freely in. butif i run it with the water on, it will continue to spray in freely after the cycle light goes out and you open the door.
If you turn the unit off from the circuit breaker will the water still run?if so the guts inside the solenoid valve are worn.you can call champion and get a kit to replace the worn parts and its not difficult to do.hope this helps. ... Dishwashers
Hello, I have a Neff Dishwasher S5453X1GB/74 and it's not draining the water out at the end of the cycle. I have unscrewed the filter and released the impeller. I have also cleared the waste pipe that runs to the sink waste and put loads of cleaner in the dishwasher. The pipes seem to be clear as water goes somewhere during the cycle but backs up at the end. A few times when I started a cycle the water did not spray out but I could here the drainer or motor? running. I jetted water through th
... Neff 24 in. S5453X1 Built-in Dishwasher