Having problems with your Dishwashers ?
Salt compartment not draining
\015 Hi,\015\012When I switch on my Beko DWD5410W dishwasher, it starts making immediate noise just like it's set on a wash program. However, it is not on a wash program. If I do select a program it makes no difference. It will just hum and throb forever.\015\012Additionally, when I unscrew the cap over the salt compartment, water floods upwards and out.\015\012Twice I have taken the dishwasher outside and turned it upside down, and both times it has worked thereafter, but only for a couple of days. Tonight I used an ultra-absorbent cloth to soak up all of the water in the salt compartment (rather than taking it outside again), however this has made no difference.\015\012I have tried holding down the Start button long enough to cancel any active program, but this is not relevant as no program is active.\015\012\015\012Can anybody help me?\015\012\015\012Thanks,\015\012Craig.\015
Repair Help & Product Troubleshooting for Dishwashers
Tips for a great answer:- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.
Suggested Questions/Answers :
Salt compartment not draining
My whirlpool dishwasher adp4407 is not washing properly when i open the door thinking its finished a wash the soap tablet has not dissolved and is on the bottom of the dishwasher and sometimes its not emptied the water also the red light is constantly on i did not know you had to put salt in a compartment on the bottom of the dishwasher how much salt are you suppoosed to put in this compartment.
Whirlpool ADP 5966 Dishwasher using the complete salt load in 6 washes and coating all the dishes in salt that would not rinse off. I filled the salt and 6 washes later it was requiring a new load of salt. We have had the machine for 5 years no trouble The problem is a complete overload of salt coating everything in the rinse water and drying on during the heated drying cycle. The problem is not caused by the following Cracked of failed seals on the lid to salt compartment N
... Whirlpool 24 in. ADP5966 Free-standing Dishwasher
Waterside water softener model MC250 Dear Sir, Salt level did not go down during regeneration. I poured 2 pints of warm water to break solidified tablet salt, I found moist salt, but very little water in salt tank. I regenerated. I hear water going down the drain. Please could you tell me which pipe brings water in the salt tank, and what level of water should be visible, How is the water replenished in the salt tank? and how that level is maintained. Would you be kind enough to give me a wate
The salt warning light came on (red) and went to put salt in but noticed it was filled with water. I have filled it with salt now and the warning light has gone off but now when I try to select a program it wont. I have drained the water in the salt dispenser but it still wont work! Help!
What is the make and model of the item? ... Dishwashers
My Hoover dishwasher HFI 3015 is not working. When you turn it on, the P1 and 'out of salt' light is flashing and bleeping constantly. I believe that it may have run out of salt yesterday, but I have filled it this morning and there is plenty of Dishwasher salt in the compartment now and it is overflowing with water. I have tried turning the machine on and off, but each time I turn it on I get this bleeping and flashing and can't stop it. Any ideas?
... Hoover Dishwashers
I have a brand new Blanco dishwasher but im unsure if it is a DWF6XP, DWF4X or DWIN7 model. It does not have a salt dispenser if that helps. Last night when running for the first time i had a plumbing issue where the drain pipe was not set high enough as it states it has to be 500 to 100cm of ground height. Also had a leaking sink drain pipe. Fixed all that and turned machine back on and it pumped all the water that was inside to drain. I have cancelled the program and restarted but now it is ru
Unplug it and wait 5 minutes. Plug it back in. This will reset the machine. Put it on full cycle and allow it to do a full cycle. It should work just fine. ... Dishwashers
What if -by mistake- I put more salt in the salt compartment than necessary? (I mean, refilling it two days in the row).
The risk here would be minimal. What can happen if your water gets too soft from the salt it could cause the glassware to become cloudy, but this would normally only happen if you washed the glassware in too salty of water for multiple loads. The oth ... Dishwashers
Put table salt in salt compartment - Bosch Dishwashers
... Bosch Dishwashers
I have a Delonghi dishwasher model no. DW67S/W which is coming up with the E4 message. I had this once before and was told to turn it off and on and it righted itself. This time however I used the next bit of advice. I took everything out including the salt cap thing, tipped it on its side and drained all the water out, reconnected the hoses and when I turned it back on it seemed fine....no E4 messaage straight away. It drained out for a while and then starting filling. It has overfilled again
Hi.As you know E4 means overflow. If the problem occurs regularly there is either a problem with drain line, or a fault.Ensured that you have removed all the water from the inside and cleaned thoroughly the drain ... Dishwashers
I have a candy trio 501 dishwasher with intergrated oven. When I put a cycle on it starts its first rinse then after 5/10 mins stops and beeps constantly. It's still full of water too. When I put it on rinse cycle it compleates the cycle so inlet and drainage should be ok. Ive removed drain pipe and made sure its not kinked and also clear. I've removed and drained the compartments that had water in and also blew down the pips to see if clear all ok. I've checked the heater element with meter and
Miele g892 scu plus, about 5 years old. when on, all it does is run some motor (humming sound) and flash salt or intake/drain. No program lights on. Sometimes can be reset so rinse light comes on and nothing blinks, but humming motor still runs and salt eventually blinks. I removed toekick panel; there is water in pan. I disconnect drain hose, only a little water came out. Any ideas?
... Miele G892SC SS Dishwasher
Hi... i got a kenwood automatic compact dishwasher...... and as much as i search - i dont find any compartement for SALT and/or WASHING POWDER or TABLETS..... can anybody please tell me where to put in the PODER and SALT thank you for your help herbert
... Kenwood KDW12SL3A Portable Dishwasher
I have a Bosch S610 dishwasher (still going strong).. Can I use salt pellets, made for use in household watereners (99% sodium chloride supplied by Aquasol), in my dishwasher salt compartment?
... Bosch Dishwashers
Hi My Siemens dishwasher doesn't always drain and the dishes taste salty all the time - the salt light is on all the time, even when I fill it up with salt. I have had this machine for a while - is it time to get a new one? Thanks a lot
... Siemens 24 in. SL34A006UC Built-in Dishwasher
I have a Bosch SD1306B dishwasher and cannot see the "normal" salt compartment. Does this model not need salt? Is the logo that looks like an eyelash the symbol for the descaler fluid for keeping the glasses shiny? The light is on there. Sorry for the simple questions but I have no manual for the dishwasher and its my first Bosch. Many Thanks Neil Fraser
... Bosch Dishwashers
Hello, I have a problem with our Miele G646SC Plus dishwasher. It starts its cycle OK, draining out any residual water, taking in fresh water and doing the initial rinse. After about 5 minutes it then stops with the "inlet/drain" red light flashing. The detergent is still in the holder and the water is still cold. The filter at the bottom of the compartment is clean, the drain pump spins freely. I've also checked for any leaks in the bottom of the machine that would trip the styrofoam/microsw
Hi\015\012\015\012 \015\012\015\012The light flashing means an issue while draining. You would need to check for air\015\012gap on the dishwasher, it may be clogged. It prevents dishwasher\015\012from drain ... Miele 24 in. G646SC Plus Free-Standing Dishwasher
The salt compartment in my dishwasher is full of water and also the compartment under the bottom set of blades is also filled with water. What can i do as the machiine is not cleaning anything properly??
... Bosch 24 in. SGS4072 Free-standing Dishwasher
Why is the salt compartment on our Danby dishwasher is filled with water?
... Danby Dishwashers
Left the lid off the salt compartment, does it matter?
Forgot salt compartment lid
Water in salt drain neff dishwasher
... Neff 24 in. S5443X2 Built-in Dishwasher
Dishwasher : accidentially put detergent(soap) into the salt compartment !!
You should be able to run it threw and not have an issue.Just dont add anything else. ... Neff 24 in. S5409X0 Built-in Dishwasher
Water is not draining from the hot point dish washer:it collects in the little hole inside in the rear of the compartment
When the dishwasher doesnt drain you must remove the lower front panel. then remove the drain hose and check for a blockage. if none there dis connect the pump [ which is what the hose is connected to and look it in. finally check the drain under ... Dishwashers
I have a credaplan integrated dishwasher with no manual it came with the house so is about 15-20 years old. I want to put salt in it. I have found a compartment with an 's' on it but just want to be sure that this is the right place. I have never owned a dishwasher before. Thanks in advance for your help.
... Creda 24 in. DWI34 Built-in Dishwasher