Having problems with your Dishwashers ?

Water is not draining out of the system for hda2000g02bb


Answers :

HI. check the following areas for faults.

1. Air gap / Drain hoses
If there is an air gap (located in the sink, near the faucet), check to see if it is clogged. Unscrew the top cap and see if there is anything blocking inside. Note: If there is no air gap installed, the dishwasher might not drain properly.

If the drain hose is clogged, the dishwasher would not drain. If there is an air gap installed, it is very common that a hose going from the air gap into the garbage disposer is clogged. Remove and clean the hose. Make sure to reattach the hose before starting the dishwasher.

Note: If you recently had a garbage disposer installed, it is common to overlook removing the drain plug.

2. Broken belt
Some dishwasher models use a belt to drive the pump. Replace the belt if found broken.

Note: Sometimes the belt would just come off the pump. Even though it might not be broken, it is recommended that you replace the belt, because it is probably too stretched out.

3. Pump
Some models have two impellers inside the pump - one, wash impeller, takes care of the wash cycles, the other, drain impeller, drains the water out. If the drain impeller is broken (broken blades, shaft), the dishwasher would not drain. Replace any broken pump components.

4. Drain solenoid
Some models (for example most GE dishwashers) use a drain solenoid to drain water out. Sometimes the solenoid gets stuck, preventing the water from draining out. Try to free up the solenoid. If unsuccessful, you might have to replace the pump assembly.

5. Motor
If the motor is stuck, it is sometimes possible to free it up by manually spinning the motor.

Replace the motor if defective.

6. Timer
Replace if defective (note: uncommon problem).
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Water is not draining out of the system for hda2000g02bb


HI. check the following areas for faults.1. Air gap / Drain hosesIf there is an air gap (located in the sink, near the faucet), check to see if it is clogged. Unscrew the top cap and see if there is anything blocking inside. Note: I ... Dishwashers

GE GHDA485N 10CS Dishwasher that has standing water in the bottom after the cycle completes. I pulled it out and reconnected power and ran a rinse cycle. I could see that water was pumping out the clear drain pipe but there was still about an inch of standing water in the bottom. Any thoughts as to what part has failed. Does the system use a water level switch or a timed drain cycle to determine when the water has pumped out. If it is a timed cycle could a slow drain cause the problem. Thank you


... GE Dishwashers

Recently installed a GE Merlin RO Drinking Water System. Flow of waste concentrate through the air gap faucet down the drain is considerably faster than the purified water. Adding a booster pump did not solve the problem. Neither of the local service provider listed for my area are willing to prvide help. Any ideas on what to do next? (It's not a dishwasher but water sytems was not listed as a category) Waste water should be stronger than purified water. This system needs at least 60psi to


... Dishwashers

CDA dishwasher model CW445, keeps draining will not run through cyscle as it thinks it needs to drain! Constantly making a "gargling" noise if I manually fill with water cysle starts but system drains water again, any help would be appreciated?


Ours did the same....last week. Would not work for a few days...in the end i took the spinning rotor arms off that spray the water. The nozzles looked blocked ...used tootbrush to clear nozzles. Put arms back on and it is now working. Wife thinks we ... Dishwashers

My Maytag dishwasher model MDB7130AWB started making a grinding noise tonight during drain cycle. We just had some work done on the sprinkler system and the water main to the house as well as the check valve for the sprinkler system have been turned off and on a lot the last two days. I noticed that we had some dirty water come out of a sink in a bathroom, after that repair. Don't know if that could be related to this problem but it was worth mentioning.


Shut off water to the machine, remove the hoses at the machine and inspect & clean the mesh filters in the water inlets. If dirt did get into the line, it would be from the water main work, not the sprinkler work.It doesn't hurt to clean the ... Maytag MDB7130 Dishwasher

I have a Hotpoint Dishwasher model no BFV620,hope anyone can help,the problem is 1(listed as pre wash) and 2(listed as wash) flashes rapidly when system starts to drain ,and the system does not drain completly ,still dirty water in bottom of the dishwasher,checked instruction manual and this lists any other forms of lights flashing but not the 2 mentioned,any advice would be greatly appreciated


... Hotpoint 23 in. BFV62 Built-in Dishwasher

I have a Miele G896 dishwasher. Drain light on. Washer won't work. Water clogged in drain area. Trying to remove triple filter system to clean it per owner"s manual, but handle stuck. Tried pressing down, turning both directions, technical taps to free handle, but no luck. How do you get triple filter system out to clean it?


... Miele 24 in. G656SCi Plus SS Built-in Dishwasher

My GE Profile Performance dishwasher (GSD 4910) doesn't drain. I hear the pump working, and water draining into the sink (not a disposal) as it should, but water is left standing in the tub about as high as the heating element. I have taken it apart and removed a few small items stuck in the system in various places, but that didn't affect anything. I have read here and there about the piston and nut assembly, but I don't think my model has that -- or maybe it does? Can you affer a


... GE 24 in. GSD4910X Built-in Dishwasher

Asko D3530 water inlet fault code, water valve is on, water comes in but after water comes in for a couple of minutes we get a (inlet water fault code) check power at circulating pump no 120v unit will not run reset system it will drain and start cycle again with same result


Hello,\015\012\015\012It is common for these valves to "appear" to be ok, meaning they begin to allow water into the unit, but then one of the two coils or plungers inside fail, or are clogged with mineral deposit from the water or other ... Asko 24 in. D3530FI Built-in Dishwasher

Is it common for Kitchenaid dishwashers to have water pooling inside them? It's almost like the valve for water coming in isn't shutting all the way...in the middle of the day, we'll find water inside the dishwasher...it drips out the front when you open the door...but when you turn it on, it doesn't have any problem draining the system...mysteriously, we find water in the bottom...what's up?


There is a rubber flapper valve that keeps water from running back into your dishwasher. It's a $5.00 part, but it's a bear to get to,\015\012\015\012You have to pull the drain pump to access this flapper.\015\012\015\012Also ... KitchenAid 24 in. KUDP02FRSS Stainless Steel Built-in Dishwasher

Overfill Hi Mark ,my Hotpoint BFI 62 at very first use ,takes water but in few minutes later water come out from floor and after that you can hear water drains out,Heavy Duty cycle light flashing rapidly,after some advice looked exactly source of water is from pipe connected to overflow system. That mean it is filling more than required,how it possible new Dishwasher never used before? Please help me to repair because we never try when I bought now is to late for company warranty. [email protected]


... Hotpoint 23 in. BFI62 Built-in Dishwasher

Recently installed a GE Merlin RO Drinking Water System. Flow of waste concentrate through the air gap faucet down the drain is considerably faster than the purified water. Adding a booster pump did not solve the problem. Neither of the local service provider listed for my area are willing to prvide help. Any ideas on what to do next? (It's not a dishwasher but water sytems was not listed as a category)


... Dishwashers

Just had a reveser osmosis system installed, #GXRM10G. Five blue lights appeared when the battery was installed. Water ran into it for 6 or 7 hours; however, a day later it continues to run water with the constant sound of water going down the drain. Is something wrong? Shouldn't it turn off when filled?


Dear customer,\015\012 check the following and see whether your problem is solved\015\012\015\012Inspect the seals for the main tub, float, heating element and blower diffuser \015\012 ... GE Dishwashers

Dishwasher cycles with timer, won't fill with water. Motor runs fine, drain and fill valves test fine, float switch tests fine too. Water pressure fine. I'm thinking the timer is bad and won't send a signal to the water valve to open. What do you think? The system here doesn't know what a GSD2030F00WW is, so I had to pic one with a computer board, mine is not that sophisticated.


Remove the toekick plate on the bottom of the dishwasher.Remove the wires from the water valve. Insert the leads from a volt meter into the water valve power wires.Turn the washer on. After the initial pump out cycle the timer sends power ... GE 24 in. GSD2030Z Built-in Dishwasher

Water won't drain - Electrolux Kenmore 24 in. Built-In Dishwasher with 5-level Precision Direct Water Delivery System Dishwasher


First check that there isn't anything blocking the drain area inside the bottom of the dishwasher. Sometimes plastic wrap, a small Tupperware, etc. top gets sucked against the drain and blocks discharge. If nothing is there, (look really good, by get ... Electrolux Kenmore 24 in. Built-In Dishwasher with 5-level Precision Direct Water Delivery System Dishwasher

I have the Triton Triclean Wash System Quiet Power II fro GE and it will not drain after the cycle. About 2/3 inches of water sitting at teh bottom. How do I get the dishwasher to drain?


... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

We have a hobart hsc300 water softener attached to our dishwasher and it is overflowing. how do we drain the water softener and re set the system


... Hobart Dishwashers

Ariston LS620A When running my dishwasher the dishwasher tablet is not disolving and entering the system. The dispenser is open but the tablet is stuck there??? I have cleaned the removable parts from the bottom of the system and put a new tablet in but the same problem happens again. This time when removing and cleaning the parts at the bottom there is water present and it hasn't drained is that normal? Or are there other parts there I have to remove....I have tried but nothing seems to budg


Hey, I experienced the same problem and I realized it happens when you block the water from the dispenser with a dish. Make sure that it is never blocked and the dishwasher is going to work fine ... Ariston Technologies LL64WNA Built-in Dishwasher

Upper spray arm is not turning round even though water is coming through. We have checked the internal system for blockages and the machine is filling / draining as normal. When a full programme is run, many of the dishes, particularly on the top shelf, are dirty and many have hardly been touched by water. Could a pump or other part be faulty?


I found the problem to be neither blockages of the upper arm or roof spray arm or the upper basket arm hitting the the back of the dishwasher. the problem was that the pump inlet where the food scraps are macerated was blocked with all manner of gung ... Dishwashers

I have a KitchenAid KDS-17E dishwasher, which has worked well since I acquired it second-hand in 1984. Last night it ran continuously, stuck in the prewash part of fullcycle, with water being pumped through the system, and was fairly warm in the morning. It drained normally when I pressed the Cancel/drain button. I tried the machine again in full cycle. After 20 minutes it was still stuck in prewash, with the water temperature about 42 C, so I stopped it. Machine is connected to cold wate


Your problem is a bad timer.and you really got your moneys worth on this dishwasher.The timers useally go much soon than this one 7-8 years is the norm.The timer gets stuck in one position is a good sign its loseing its ability to fuction normally, ... Dishwashers

I REMOVED AN UNDER COUNTER OSMOSIS SYSTEM AND HAVE THE HOSE COMING OUT OF THE TOP OF MY SINK WITH A CAP ON IT. WHEN MY DISHWASHER DRAINS THE WATER COMES OUT THAT CAP


Hello. Go back under the sink and take a look at the plumbing for the sink drain, trap, dishwasher drain hose etc. You will most likely have to rework the plumbing under the sink to eliminate all traces of that osmosis system where it was ent ... Dishwashers

Water comes out the top of the aeration spout into the sink. Dishwasher still works, but this doesn't seem right. Cleaned drain filtered at bottom of dishwasher, but problem continues. Is there a clog someplace else in the system?


Hi yes your aerator seal is probebly bad on your sink ... Kenmore Dishwashers

Our Asko 3530 dishwasher is giving us a 'water inlet fault' code. The machine goes through the pre-drain at cycle start then begins to fill, continues until it's full then kicks out the fault code. I have changed the inlet valve, reset the system to factory default and taken off the lower front panel, finding the overflow area to be dry. Is it time to call for service or is there something else to try before spending the big bucks?


Hi,This sounds like either the overflow sensor or the water control valve is stuck.Usually the valve is a solenoid valve that controls the entrance and fill of the water. If the overflow sensor is underneath, there may be wate ... Asko 24 in. D3530FI Built-in Dishwasher

Hi, I have a Kleenmaid Dishwasher and the anti-flood system is being triggered (when I tilt the dishwasher, water runs out onto the floor). I am quite sure the leak is coming from the pump as the dishwasher stops during a drain cycle. How do I take of the panels to check what the problem is?


... Dishwashers

SHE56C05UC - full of dirty water at end of cycle - filters and drain system seem not to be blocked


I would still try cleaning out the drain line behind the dishwasher, this is a very common problem with draining. If not that then might need a valve or if you have a new garbage disposal you need to punch out a peice of the plastic or it wont drain. ... Bosch Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1345 seconds