Having problems with your Dishwashers ?

I have a candy futura cdf322-80 dishwasher,done a load as normal then i put it on the next day and there was nothing no lights came on nothing, i checked the fuses and the socket they were fine,so i had an engineer out who said there was power going to the machine so he said it was the contol panel which is situated behind the temperature and programme buttons so i bought this part and replaced it but still there is nothing.


Answers :

I would check for myself if there was power going to the machine. If it acts the ways your does, then either the control panel or the power supply is at fault. Slight possibility a wire that runs between the two may be faulty, but not as common
Hi there,

If there was supply of power coming on the unit, you better check then also the power board if has no problem distributing the required electricity for the unit. It seems that your power board cannot supply anymore power on the unit.

Hope this helps
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a candy futura cdf322-80 dishwasher,done a load as normal then i put it on the next day and there was nothing no lights came on nothing, i checked the fuses and the socket they were fine,so i had an engineer out who said there was power going to the machine so he said it was the contol panel which is situated behind the temperature and programme buttons so i bought this part and replaced it but still there is nothing.


I would check for myself if there was power going to the machine. If it acts the ways your does, then either the control panel or the power supply is at fault. Slight possibility a wire that runs between the two may be faulty, but not as common ... Dishwashers

Ariston LSI 41 dish washer had intermitant problem of green light not coming on when main power switch turned on and machine not working, the circuit had beed repair before. I played around and got the machine to go through a full circle once then would not go again. So I have put a new circuit board with switch etc. still the switch panel light dose not come on, i found bad connection in connector which comes from small plug on circuit board, (two red wires )I have checked for power to board. W


... Ariston Technologies Dishwashers

My LG 24 in LDS 5811 ww quite working in the middle of a cycle. I have power to the machine, but no lights come on, nothing works. I turned off the power and removed the front pannel. The large brown wire and large orange wire that are plugged into the back of the control panel start to smoke. So does the large black wire and the large white wire. Any ideas, is this the heater or is the panel bad?


The unit will need a new Wire harness, Pump/motor assy, Main Pcb and inner door liner.\015\012Contact LG @ 1800 243-0000 they may help you out. ... LG 24 in. LDS 5811 Built-in Dishwasher

It has stopped working, There is power going into te machine. An engineer from Repaircare said it was the programmer, ordered a new on vcame to fit it said it was te wrong one. Ordered anoter one Whirlopool saaid it was out of stock, on back order. Waited 3 weeks engineer came with new programmer, fitted it it didnt work. Said maybe they can't fix it. Thew nachine is only two years old and a popular make. WHAT CAN I DO???


Hi,I am sorry to hear regarding the problem. You need to have some patience in order to find what's actually work with the Dishwasher. I cannot jump to the conclusion as there might be "N" number of reasons.Now, Fi ... Whirlpool Dishwashers

Cycle counter goes to 1, but continues to agitate, does not pump the water out, nor does it go to zero. The counter will stay on 1 indefinetly, if I use the pump button, there is soap residue in the bottom of the machine. I called the Sears repairman, he was here about 10 minutes, unplugged the machine from the wall and said that probably I had a power surge and that would solve my problem. It did not. I live in a very small town, I will have to take my dishwasher to Las Cruces (101 miles awa


Hello, welcome to Fixya.\015\012\015\012I`ll start by saying how unfortunate it is to have too many so called "pro`s" trying to diagnose appliances who have no business doing so if that is how the repair-person you spoke of e ... Bosch Dishwashers

When pressing any front button on the control panel nothing will light up or start up in any manner,does look like it did not finish draining,have water sitting in the bottom. Pulled off front access panels no signof burned wires or anything becoming disconnected? do have small childern in the house pressing buttons? power is good going to unit.??


1)check any fuse blown in board.\015\0122)check supply to the board. ... Kenmore Dishwashers

No power there is no power going to the control panel . It will do nothing . the dishwasher is a kenmore quiet guard 3


I am having the same problem.....where is the fuse? ... Kenmore 24 in. 15932 Built-in Dishwasher

The electronic panel on the top of the door doesnt light up anymore and is unresponsive, when the power is turned on, the machine makes a sound like its running or draining or something, but nothing is happening. This all started after a potential electrical disruption following a power outage. Perhaps there is a fuse or some relatively easy way to fix this? or am I screwed and should just call a repair man. Thanks for your suggestions, Brodie


... Bosch 24 in. SHX56B05 Stainless Steel Built-in Dishwasher

AFTER RUNNING MY DISH WASHER I OPENED THE DOOR THERE WAS ST HALF IN OF WATER IN THE BOTTOM SO I WAS GOING TO WASH AGAIN BUT HAD NO LIGHTS ON CONTROL PANEL HAD POWER TO THE DISH WASHER BUT NOTHING WOULD LIGHT UP? DONT HAVE 10 WASHES WITH THIS UNIT .? MODEL #655-13443K900


Hi Bennie, Try http://www.manualowl.com for free PDF for troubleshooting the issue you are having. I hope this helps. ... Kenmore Dishwashers

Dishwasher model en50242 after cleaning both filters and turning on the valve etc no water is going into machine. The control panel shows 2 lights one above the tap sign the other above the programe light. The pump runs for a few seconds then stops and nothing further happens. We are in a high water calcium area.


... Siemens Dishwashers

Beko dishwashe in new house . Power going to machine water valve open . Wash cycle set but nothing happens , any clue as to what to do next ?


... Beko DFN1000X Dishwasher

We have a service contract with Broward Factory Service. My GE dishwaher went out with eater in it, no power. Checked the panel box flipped switch, nothing. The service tech. said the rinse aid cup leaked and ate thru the wiring, and he had read a recall about this. I am checking to see if Model #GSD3610Z00AA, Serial #ZS782757B is on the recall list.


I was trying to find out if the dishwasher was on a recall list, and I did by calling GE direct. It was not, so the service I have is replacing the rinse aid box.\015\012Thank you, ... GE Dishwashers

Started dishwasher and then it stopped, still has power going to it but control panel does not respond. When less than a year old, the same thing happened and the repair man said it was a thermal coupler.. is that the same as a thermal fuse and does that sound like what it may be again?


... KitchenAid KUDD03STSS Stainless Steel 23 in. Built-in Dishwasher

Is there a fuse or a circuit breaker in the Kenmore Ultrawash, quiet guard4 smartwash dishwasher purchased about 3-4 years ago? There is no power going to the machine--the outlet, the circuit, etc are all fine--but no lights light up on the panel and the washer wont start. Any suggestions?


There is a fuse behind the control panle its white and 1 inch by 1 inch ... Dishwashers

My Frigidaire Dishwasher PLD4375RFC is showing 3 blinking lights at the same time when I flipped the power at the circuit breaker off-on: High Temp Wash, Air Dry on the touch pad and PF on the display. It would not respond to anything that I tried. All blinking lights are off and machine does nothing when I open and close the door. Flipped the circuit breaker off-on again to repeat the sequence. I replaced the controller board, as recommended by the appliance guy since he checked and said ele


... Frigidaire PLD4375RFC Dishwasher

We had a power surge and the guy who looked at it said my control board was fried. It looked to me like a plug in item easily replaced by anybody with a screwdriver to take the door panel off, however in trying to find the part nothing is called "control board". What is it>


Its called a pcb call ge and order a new pcb for the make and model ... GE 24 in. Profile PDW7800 Built-in Dishwasher

Kenmore dishwasher I have a kenmore dishwasher and in the middle of a cycle all my front panel lights went off. I have checked the power going into the dishwasher it is fine. I also checked the door latch it is fine. Not sure what else to check? Same exact problem model number 665.15934 We have had nothing but problems with all of our sears products - highly suggest to SHOP SOME WHERE ELSE before you get stuck too.


Check the continuity of the thermal fuse (part # 8193762). It's clipped onto the electronic control inside the console.Let me know if you need more help. ... Kenmore Dishwashers

Often the dishes are coming out with dried on food. tried using different dishwasher soaps, using jet dry - we are no longer using the machine because we can't tell when this is going to happen. dishwasher repair guy - said nothing is wrong with it. Densan


You can't put a cake in the thing like the maytag commercial, - DUH - . try to rince the dishes or even scrap them into the trash can, or if you have dogs, well just a thought. Good Luck! ... Dishwashers

Hi There, I have a frigidaire FDB1502RGCO dishwasher and I have power and water going to the macine however when I turn it on it will not start its cycle. Washing light is lit and all functions are lit up as normal on the front panel however the cycle does not start. Is there a simple fix or reset for this machine or will I need to call technical support to have a technician come to look at it? Please let me know. Thank you


... Frigidaire FDB1502RGC Built-in Dishwasher

Have a GE Quiet Power 3 Dishwasher. Went to reun it and when I closed the door no lights came on to pick a wash cycle. Nothing like it lost power. No buttons work, nothing. Opened door and removed inside door panel. Have power at door latch switch. Actually have power at all 4 connections and doesn't change when engaging switch as if door was closed. Switch does click but no power at front control panel. Whats up. I have my own Handyman/Home Remodeling business and I'm very good at fixing things


If your dishwasher is not running check the following \015\012\015\012You have already taken care of the 1st item.Power Supply The main power supply is the first thing to check. Also remove the toe ki ... Dishwashers

Nothing lights up on the electronic panel, will not turn on


Sounds like you have a defective Maytag repairman.. all kidding aside.. If you checked the junction box underneath the dishwasher and the wires are all correctly bonded together and power is there.. then it seems as if the control board may have been ... Whirlpool Dishwashers

Whirlpool gold quiet partner iii quit during a cycle. none of the lights on the control panel work. there is power going to the unit from the breaker box.


... Whirlpool Gold GU2275XTVy Dishwasher

I have a Whirlpool Gold Quietwash Plus (part # 9744480), due to a number of opening and closings of the door, the lights on the front panel now just blink. How can I reset the control panel.. I have tried power scour>air dry>power scour>air dry and only end up with both blinking instead of going into control diagnostics by pushing pots&pans. The unit will attempt to start then just go to blinking lights.. Thanks


I would cut the power to it for awile 5mi and try it that may do it ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Stops part way through programme water still in machine. Now no power to machine. Problem happened yesterday - cleaned filter and pump - power came back. Programme started but then stopped. No power - nothing happens.


Either there is a bad capacitor in the control panel, or the power supply has a faulty capacitor. You will have to get a multi-tester and test each component for resistance and current ... Dishwashers

LDS5811WW - machine will not power on??? When we push the power button, the machine won't turn on - we get nothing. Almost like it's unplugged - it's not, AND Yes there is power to the outlet. Front door leaks occasionally too.


Some newer d/w have a lockout feature to prevent littles from turning it on, often the kiddos accidentally activate the lockout during their explorations. Any chance it's locked?\015\012\015\012Also, I believe this type of unit has an adj ... LG 24 in. LDS 5811 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1409 seconds