Having problems with your Dishwashers ?

Washing machine Simpson top loader Model 805 No power/lights nothing, did test power point with another apliance and is ok. Has machine an inbuilt fuse? John.


Answers :

Hi,

\015\012\015\012\015\012\015\012\015\012No power\015\012\015\012Check\015\012to see whether power is getting to the washing machine. Is it plugged\015\012in? Has a fuse blown or is a circuit breaker tripped?

\015\012\015\012\015\012Lid switch\015\012\015\012If\015\012the lid switch is defective, your washer can't spin and may not\015\012function at all. The switch is inside the washing machine main housing\015\012near the door frame. Often you have to raise or open the top or front\015\012of the washer to get to the switch. If it's defective, you need to\015\012replace it.

Some machines have a special lid-switch fuse near\015\012the lid switch, inside the control panel. If this fuse blows, the unit\015\012won't fill with water until you replace the fuse.


Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Washing machine Simpson top loader Model 805 No power/lights nothing, did test power point with another apliance and is ok. Has machine an inbuilt fuse? John.


Hi,\015\012\015\012\015\012\015\012\015\012No power\015\012\015\012Check\015\012to see whether power is getting to the washing machine. Is it plugged\015\012in? Has a fuse blown or is a circuit breaker tripped?\015\012\ ... Dishwashers

I have a older simpson 3000 power washer, 11 hp honda,been a great machine, owned since new, seems like the pressure is building up to a point where it has blown 2 hoses, i turned the throttle down and started to wash, engine quit after about 15 min. it restarted and quit again, tried starting fluid , nothing, what might be the issue


... Honda Pressure Washer PSI 3000

KitchenAid KUDL03IVWHO Machine seems to stop after the initial water fill. There is power to the machine, the door latch circuity is working, all the buttons on the control pad light up. After selecting any of the wash cycles and pressing start, the washing light illuminates and the machine fills normally to the point where the fill valve stops the inflow of water. At this point the machine stalls, it does not start the cleaning process. I can press cancel and the machine drains normally. I e


Hi,\015\012\015\012You have got to the correct resolution. This is a circuit or most commonly called the board problem. Please find the bellow mentioned link which will help you to get one compatible for your washer.\015\012\0 ... Dishwashers

I have a Maytag MDB5601AWB dishwasher. all the switches except the heated dry switch are not working. I did the unlock thing and still nothing . Do I need to replace the switch panel or is there something I should try? I tested for power and have 120 volts coming into the circut board and through the door switch Comments: Aug 22, 2009 - I tested the door swich and I have power on both poles when it is closed. there is 2 switches on the latch but the one with power to it powers up the circ


... Maytag 24 in. MDB5600A Jetclean II Built-in Dishwasher

Stops part way through programme water still in machine. Now no power to machine. Problem happened yesterday - cleaned filter and pump - power came back. Programme started but then stopped. No power - nothing happens.


Either there is a bad capacitor in the control panel, or the power supply has a faulty capacitor. You will have to get a multi-tester and test each component for resistance and current ... Dishwashers

LDS5811WW - machine will not power on??? When we push the power button, the machine won't turn on - we get nothing. Almost like it's unplugged - it's not, AND Yes there is power to the outlet. Front door leaks occasionally too.


Some newer d/w have a lockout feature to prevent littles from turning it on, often the kiddos accidentally activate the lockout during their explorations. Any chance it's locked?\015\012\015\012Also, I believe this type of unit has an adj ... LG 24 in. LDS 5811 Built-in Dishwasher

Hi, our LG Dishwasher LD 14AW2 is not turning on. Worked fine yesterday. This morning when went to turn it on at power button, nothing happened. We tried turning off at the power point and on again, but still nothing. Please Help? Honor


Check to see if door is completely closed, check water supply lines for kinks or blockage. ... Dishwashers

We have a Maytag MDBH945AWW3 dishwasher. It is acting like there is no power getting to the machine (all buttons are unresponsive and no LED's light up), but there is DEFINITELY power getting to the machine. Ideas... or even a test procedure to help diagnose which item might be broken?


Where exactly is the power getting to? ... Maytag Jetclean II MDBH945AWS Stainless Steel Built-in Dishwasher

I have a maytag dishwasher mdb5601awb. when I hit the start button nothing happens. I have found the instructions to do a manual test which is hitting the heated dry button 5 times and then the start button. Thinking it will run some test which I have no idea what to look for, it actually runs the machine's wash cycles and clean, dries and tells me it clean with the green light goes on. How do I reset/reboot the machine so it starts by just hitting the start button again?


... Maytag Dishwashers

Jackson jp-24b purchased this machine used, cant figure out how to work it. I flip the auto cycle on, and then the power switch. The fill light turns green and i assume water is filling up in the machine. In the meantime there are two small red external hoses that hot water comes and i currently just have those hanging in the sink. At the same time, nothing is happening during the wash cycle, the wash gauge doesnt even move only the rinse gauge. Also when i try to drain it nothing happends (begi


It needs a new drain relay box 120 volt the drain is stuck open the jp 24 were not very good machines the red lines are drain lines if you plug up the drian lines at fillup the machine will wash but now it will never drain a new drain box is not c ... Jackson JP-24B Built-in Dishwasher

I have a kenmore 665.13719k601, i used the delay switch and now i found water in the bottom of the machine. the cycle most have stopped while i was away. when i returned there was water sitting in the bottom of the machine. The water is clean... I can not drain due to no access to power on the machine. I checked the breaker but it was on, so i reset it anyway... nothing.. any idea's


... Kenmore 13719 / 13712 Built-in Dishwasher

After dishwasher was started, and water stared to enter the machine, it was unlatched and left with the lever in the open position for some time. The control dial had automatically moved 5/6 degrees clockwise and left there. Now the machine does not want to start no matter what I do. Power is to the machine, latch is moved to the right, but nothing happens. What's next. Thanks for any help you can give.


Hi,\015\012 \015\012After the water stops coming in do you hear a humming noise? If so the motor may be stuck. Unlock the door to disconnect power from motor then turn the motor by hand a few times (should ... Dishwashers

I have a candy futura cdf322-80 dishwasher,done a load as normal then i put it on the next day and there was nothing no lights came on nothing, i checked the fuses and the socket they were fine,so i had an engineer out who said there was power going to the machine so he said it was the contol panel which is situated behind the temperature and programme buttons so i bought this part and replaced it but still there is nothing.


I would check for myself if there was power going to the machine. If it acts the ways your does, then either the control panel or the power supply is at fault. Slight possibility a wire that runs between the two may be faulty, but not as common ... Dishwashers

I have a Frigidaire FDB956rbc0 model. When the start/cancel button is pushed nothing happens. There is power and other buttons cause lights above what is pressed come on. Delay wash works but when it starts the washing light flashes. I have run a test on the cycles by pushing start/cancel and power dry button during power failure mode. all cycle run properly. Any thoughts?


... Frigidaire Dishwashers

My hotpoint aquaruis fdw60 won't power on. when I try this I get a flash on the power button and it trips my house contact breaker. i have checked the fuse, used another power point


You have a short in your circuit in the machine.\015\012Check the whole machine for wire damage or leakage of water.\015\012Or pump is burned through wich also can result in short.\015\012please check all ... Dishwashers

Whirlpool ADP6000WH No Power up We started a cycle , then all of a Sudden it shut off completely.... No error code at all and no lights or Display. No fuses in the House were thrown and i've tested the power point on the wall and all is ok. Just no response when pressing the Power Button on the Dishwasher??? Please Help :)


... Dishwashers

I have a 6th sense dishwasher purchased new October 2004. It has been working properly and then has just stopped the next time I tried to use it - it will not turn on no matter what buttons I push - no response. I have checked the power out let with another appliance and that works so it is not the power supply from the power point. I can only think it must be a fuse or the controller. Can you please advise best course of action? Thanks Helen


I rang the appliance man to fix the problem.\015\012\015\012Thanks anyway Helen ... Westinghouse Dishwashers

I have an AEG Oko Favorit 8081 dishwasher and it appears that there is no power getting to it [nothing light up] I have checked with a voltmeter and power is getting to the back of the machine. Is there a reset button/cct breaker/fuse somewhere in the washer.


There is no fuse or breaker in appliance.\015\012take outer door panel off and check for breakage in the wiring loom where it enters the bottom of the door. check also the door interlock is operating ok ... Dishwashers

Hi, I have a Dishlex Global 300 which has just stopped powering. The power supply is fine ( I plugged in other appliances and they work) but the machine is just dead, no lights, no sounds, nothing. The door closes OK. There have been no leaks, burning smells or any other problems with it. What to do? Please help! Thank you in anticipation.


Hello it,ll will be the on/off switch easy to replace and costs about 10-15 bucks youll probally see a char mark on the connector, where it over heated and shorted out. ... Electrolux Dishwashers

I have no power on my dishwasher. I ran an extension cord to another outlet that I know has power and still nothing. I don have any led lights or anything. Can you help. GE model # GHDA960K03BB. Thank you Clint


Few components may cause power failure to your Dishwasher.\015\0121. Disconnect your power plug from the socket outlet.\015\0122. Trace the cord to where it connected to your dishwasher. \015\0123. Tight those connectors firmly . ... GE Dishwashers

No power to machine, cord to outlet test positive for power


Check the internal fuse ... GE Adora GHDA656LSS Stainless Steel Built-in Dishwasher

We have a Bosch dishwasher SHX46A06 UC/21. It continually runs. We couldn't find a diagnostic test for our model, but we did for another model. We held down the power scrub and regular wash cycles then turned it on and pressed them again. The delicate/econo light started blinking. Looking at some of the blogs, most often it seems to be the heater or the control panel - does this diagnostic test help to pinpoint what could be wrong? Also, where can we find a good manual for our model - we're havi


Here is a link to the service manual http://cgi.ebay.com/Bosch-Dishwasher-Service-Repair-Manual-/250480379703. \015\012 ... Bosch 24 in. SHX46A02 / SHX46A06 Built-in Dishwasher

I have a JDB1090AWS about 3 years old. We noticed a smell and found cutting boards and plastic cups melted. Machine was off. Had to turn off the breaker. Checked both leads to element & have power even with machine off. Not sure if it could be the limiting thermostat; I assume that is to shut the heat down when it gets too hot. Element is on though when it shouldn't be to begin with. I did have to tighten the water supply. Had some water underneath, but all wires seemed dry. Any tests I should t


The heat element can only get so hot.It's timed so it doesn't exceed a period of on, exposing dishwasher contents to continuous high temps.Watch the timer and take note how long it broils your cookware.Good luck. ... Dishwashers

Hobart LX30 Hey I just bought a Hobart Lx30 and we don't have a power source that can handle the 50 amp requirement. We got it at an extremely good price so we are trying to work around it. I was told that disconnecting the water heater would allow it to work in a standard 120 volt outlet. I did that and now I have another issue. The machine wont run unless the water is 160 degrees. How do i disconnect the sensor that restricts the temp so that I can run the machine at a lower temp?


Hopefully you took the suggestion to run the correct 50 amp 208-240 service to the unit.Converting the unit to an LX30C has a couple of pitfalls. The LX30C is connected directly to the incoming water supply, which should run 120-140 degre ... Hobart 24 in. LXIH-3 Built-in Dishwasher

My LG 24 in LDS 5811 ww quite working in the middle of a cycle. I have power to the machine, but no lights come on, nothing works. I turned off the power and removed the front pannel. The large brown wire and large orange wire that are plugged into the back of the control panel start to smoke. So does the large black wire and the large white wire. Any ideas, is this the heater or is the panel bad?


The unit will need a new Wire harness, Pump/motor assy, Main Pcb and inner door liner.\015\012Contact LG @ 1800 243-0000 they may help you out. ... LG 24 in. LDS 5811 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1332 seconds