Having problems with your Dishwashers ?

Works well, drains all water etc. but while sitting after washing gradually water is filling up in the bottom of machine - could it be coming back through drain? What could be wrong!


Answers :

Probably the water valve isn't closing all the way and needs to be replaced.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Works well, drains all water etc. but while sitting after washing gradually water is filling up in the bottom of machine - could it be coming back through drain? What could be wrong!


Probably the water valve isn't closing all the way and needs to be replaced. ... Dishwashers

Model DE 6340 W water comes in but just fills the bottom of the machine and will not pump out until machine is turned off and back on again.


... Beko Dishwashers

My bosch dishwasher runs fine, cleans fine, drains fine....but after it has been just sitting for a while, the bottom very slowly fills up with water. Each time we run the machine the water level drains back to the normal amount in the bottom of the washer after the cycle is complete. The problem is if we are away for a few days, the bottom fills up and overflows onto the floor.


Water inlet valve isn't closing all the way closed. Need a new one ... Bosch 24 in. SHU53 Built-in Dishwasher

Miele dishwasher model# g868 could be 4 or u at end, customer complained water not coming into d/w ,when i got there water was coming in.for a few minutes then stopped filling ,drains fine, customer had not operated machine for a few days.i disconected the safety valve hose from under sink to see if water comes through does not when advancing cycle by hand, washes ok when water came in, thanks, Murray


... Dishwashers

Zanussi dw927 not filling inlet valve changed,supply to machine ok, calls for water solinoid activates for about 30secs shuts off and machine does no more. cleaned out two blue plastic pipes situated under a plastic cover which were both blocked, and put a hose jet wash thru where they were situated to clean housing out, put blue channels back still not filling up and now the inlet solinoid wont switch off when when it should and programme advances heater now comes on with no water in.manually


... Dishwashers

Hi, we have a Bosch Exxcel dishwasher which mid way through a cycle a button saying Check Water came on. we turned the machine off and opened the door and found loads of water in the bottom. my husband then scooped all the water out and cleaned filter in the bottom, where we did find some bits of plastic from the kids yoghurt pots, and took the water hose off the back and checked for blockages, which there was none. the water is certainly coming from the water pipe through the hose as we tested


Check your water level sensor. And also check to make sure that your pump is working correctly. It sounds like a couple of different things that need to be addressed. First check the water level sensor. It is a tube that is located from the back of t ... Bosch 24 in. SHU43 Built-in Dishwasher

My Bosch Classixx (about 10 years old) dishwasher won't fill The problem has only started since I pulled it out and cleaned! The programme sounds are as normal but no water enters the machine. I detected a small leak on the inlet pipe and tightened that. The machine drains when I add water manually though it has made a lot of gurgling noises for some time now when draining. When tipped on its side water comes out of the bottom of the machine (not entirely clear but not dirty either). When upri


... Bosch SHU9915UC Dishwasher

My plumber just installed a new water supply line for my dishwasher. Now the pump comes on but no water fills up in the machine. If I fill the bottom of the unit with water, it works just fine. Even though the water supply is ON, it does not pump water into the 'box'. Thanks, Art


You don't know how many times I've heard and found the shutoff valve off or partly turned off. Water entering DW is from line pressure not pumping. Items to suspect (again) the water supply valve (would'nt be the first time a new valve is bad). The ... Whirlpool 24 in. DU915QW Built-in Dishwasher

No water going in dishwasher, have checked water supply and small filter at the back of machine. water coming from bottom of the machine


This happened to a GE machine of mine once, and the problem was a stuck float..Inside the dishwasher tub, in the front-left corner under the silverware tray, there's a float that keeps the dishwasher from overfilling. If this is stuck in the " ... Bosch Dishwashers

I have a danby ddw496w that leaks water from the bottom of the machine when it goes into the drain cycle.it will start coming out the bottom as well as the drain outlet .Could it be a simple hose connection or is there something else that could cause this effect.the rear hoses are tight and it runs fine and does not leak untill it drains


Ditto- same issue, hoses are tight, just leaks through the bottom while draining. Anyone with advice? I just bought mine used, and the previous owner is willing to buy a replacement part, we just have to figure out what we need... ... Danby DDW496W Free-Standing Dishwasher

Dish-washer My dishwasher is not draining all of the water out of the dishwasher after it washes. I got someone to look at the drain pipes and he cleaned out the stuff and they still will not drain all of the water. I would like to know what I could do to get all of the water out of the dishwasher so that the water will come out of the bottom of the machine. Wanda


The problem is most likely that the pump empeller had been damage by pieces from a broken dish or a small piece of siverware. The only way to fix this is to take the dishwasher apart and replace the empeller. If you choose to do this yourself, you sh ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Whirlpool Quiet Wash Plus dishwasher Model DU920PFGZ3. Worked fine until I replaced the insinkerator and forgot to punch the drain plug leaving water standing on the bottom of the machine. I punched the drain opening, and pushed the cancel/drain cycle button. It drained fine but since no water comes from the spray arms. I have removed the arm all the way down..NOTHING!! Some research indicated it could be the water inlet valve. When the buttons are pushed, it cycles but no spray or water.


... Dishwashers

I have a GE potscrubber Dishwasher Model # GSD3630ZZ3WW it has been leaking from the bottom for about a week. I took the bottom off tonight and ran the dishwasher so that I could see where it is leaking from. It is not a hose but the leak seems to be coming from the back of the motor or pump fan where it goes into that plastic housing that attaches to the bottom of the dishwasher seems to be leaking in the very center of that housing where the motor shaft enters the housing. Water is just spray


... Dishwashers

I have a GE Triton XL dishwasher that is not spraying water onto the dishes. I just reset the power, and that didn't help. Putting it on the rinse only or wash cycle fills the bottom with water, but it sounds like a trickle vs. the spray. The heating element comes on and the soap door opens, but there's not spraying. I made sure there was nothing clogging the water line or other parts. What do you think is wrong?


... GE Tritonr XL GSD6260JCC Dishwasher

I have a LG Dishwasher LD 14AW3 it fills and runs for about 30 min. It then appears that when it tries to rinse it cannot get water and flashes "1E". I disconnected the unit and when I moved it out of its position water was leaking from the bottom of the unit. after cleaning out the inside filter & the hard water filter I re-connected and found it worked. I ran a dishwasher cleaner through it at high temp. After a few loads the problem has come back. It is now located in MY garage waiting for me


Found a leaking component that was causing the foam float located and attached to the inlet valve to shut down the water inlet and the water inlet Solenoid was also sticking. I found out this simply by tapping it while it was trying to get water for ... LG Dishwashers

Our haier, hdw101wh dishwasher is not washing properly. Water does not seem to be coming into the machine when it should and the water has not drained properly from the bottom. When we opened the dishwasher up mid cycle to see what was wrong the element was on, even though there was no water.


... Haier Dishwashers

I have a Kenmore model 15165 dishwasher. It suddenly stopped filling with water--no water comes into the machine at all. No exterior valves that could have gotten turned off. Is the problem with the float assembly?


... Kenmore 24 in. 15164 Built-in Dishwasher

G851 SC Plus started to trip GFI plug. Called Miele and they said there was nothing wrong with the dishwasher and the GFI was faulty. Unplugged from GFI and plugged into regular plug and it worked for a few days. Eventually stopped running. How wrong Miele was, it had everything to do with the dishwasher and not the GFI. It was only warning me a problem was coming. Appliance man came out, noticed water in bottom pan and order new pump, said seal probably gone. Came back, replaced the pump, put d


... Miele 24 in. Novotronic G851SC Plus Built-In Dishwasher

Brand new dishwasher, installed last week. When it is done there is quite a lot of water standing in the bottom of the tub. It has only been run 2 times since installed and both times several inches of water were left standing. Is this something we could check or do I need to have the installer come back, which will probably take a week at least. Oh-KitchenAid #KUDC031VWH


First was a new garbage disposal also installed? There is a knockout on the garbage disposal where the drain hose connects to.\015\012If that is not the problem make sure it has the correct high loop or also called air gap. If that is not right ... KitchenAid KUDC03IVWH Builtin Dishwasher

My Viking dishwasher won't fill with water. The motor seems to be running but no water enters the chamber. It's Sunday morning so I'm not able to get a repair person here. I got a response that said ''The ventilators are blocked. Turn it off and have the motor checked'' i was hoping for instructions on how to unblock the ventilators or clean it out. I have a house full of people for the weekend and would love to get this thing back up before Monday when a repair person could come. Any suggestion


... Viking Dishwashers

F1 error code. Clean water pouring out the back at the bottom where the pipes (clean and waste) exit. Could the pipe be loose inside the machine? How easy is it to get the back off to have a loo?


The F1 error code means the flood switch at the base of the drawer is activated.\015\012\015\012It is very likely the inlet hose is cracked or the actuator arm that holds the hoses from kinking when you pull out or push in the drawer is b ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Upper spray arm is not turning round even though water is coming through. We have checked the internal system for blockages and the machine is filling / draining as normal. When a full programme is run, many of the dishes, particularly on the top shelf, are dirty and many have hardly been touched by water. Could a pump or other part be faulty?


I found the problem to be neither blockages of the upper arm or roof spray arm or the upper basket arm hitting the the back of the dishwasher. the problem was that the pump inlet where the food scraps are macerated was blocked with all manner of gung ... Dishwashers

Middle and top spinners do not spin The pump is pushing water up the back delivery tube. There are no dishes in the unit and I was able to trick the door into thinking it was closed so I could watch what was happening. Or Not Happening The spinners are completely free of calcium or soap build up and both top and middle are easily spun with a finger. While the pump and bottom spinner were working, I pulled the top drawer out partially and there appeared to be a good flow of water coming out of


Hi,\015\012 Remove each spray arm and check it is clear of food particlesat the jets. The next problem may occour at the rotating joint . If the seal is not good, you can loose a lot of water out of this point.. If both of these seem reasonable ... Dishwashers

Dirty dishes Pump went on this machine about 6 months ago. Since the install of the new pump the dishes do not come clean. Particles finely ground or tomato seeds, sesame seeds etc. get blasted back on the dishes in the final rinse cycle. Repair guy has no clue... could there be a pinched line upon install that won't allow complete drainage, or the wrong pump? Is ther filter screen? I have done the vinegar reoutine plus a purchased cleaner to no avail. The machine is a bout 13 years old. Thank y


... KitchenAid Dishwashers

My dishwasher is now having a more difficult problem than leaving a white film. I plugged it in, started the water, lights come on the control panel, but it took a while for it to respond. Now it is not sucking water into the machine. What could be wrong?


... Kenmore 24 in. 17844 Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1980 seconds