Having problems with your Dishwashers ?

My dishwasher is making a lot of noise...sounds like its coming from the motor, It is 5 years old, does the motor go bad on these? If so, are they cheaper to buy a new motor


Answers :

Depends on the motor's priceHowever I would suggest that you replace the entire unit due to cost of repairman and motor itself. Good Luck hope this helped
\015\012
\015\012Dave
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My dishwasher is making a lot of noise...sounds like its coming from the motor, It is 5 years old, does the motor go bad on these? If so, are they cheaper to buy a new motor


Depends on the motor's priceHowever I would suggest that you replace the entire unit due to cost of repairman and motor itself. Good Luck hope this helped\015\012\015\012Dave ... Dishwashers

My GE trash compactor just quit working. A little over 1 year old. I opened it and found inside the motor frame a magnetic contact that is burned up. Nothing else is wrong. This part shouldn't cost more than $10 . I can't find it anywhere. Do I have to buy a new motor for $180 to replace a perfect motor with a burned up $10 contact?


Parts sadly, aren't as inexpensive as they used to be. Hopefully, you can get away with the $25 part.\015\012\015\012http://www.repair ... GE Dishwashers

I have a problem that appears to be a bad motor on a Whirlpool dishwasher. The motor costs $300 and the dishwasher is about 6 years old...Does it make sense to replace the motor or just replace the whirlpool diswasher (18 in unit = $600 new)...your thoughts?


Hello, W/D here.I try to work replacement vs. repair like this:If the cost of repair is greater than 50% of replacement, I always go for the replacement. My reasoning is that the remainder of the appliance is more likely to develop fault ... Dishwashers

My 10 year old Miele G 832 SC Slimline needs a new pump. If I have that part replaced, is it likely that the motor will be the next thing to go? Trying to decide whether to buy new or repair.


... Dishwashers

My dishwasher is 1 1/2 years old and the maintanence buy said I need a new motor. I looks like it is working just no water. I know that there has been recalls on motors could it be that? Georgette


Well if the motor is running not humming it needs water to work so prob water valve is not opening or their is a water safty switch that could be stuck it in the tub usually in the front ... Whirlpool Dishwashers

My Maytag Quiet Series 200 is making loud noises. It appears to be continuing the cycle. When we stop and start the washer, it sounds like the motor is working hard (high pitched sound). It sounds serious. I'd like to troubleshoot myself if possible. Also, what is the criteria for an 8 year old washer when it comes to the decision of fix vs buy new?


... Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher

The dishwasher made a grinding noise and then just hums. I assume the motor is the problem. Is it worth putting the money into the 9 year old diswasher or just buy a new one


... Kenmore 17822 Free-standing Dishwasher

KitchenAid dishwasher Hi I have kitchen aid kds 20 dishwasher around 25 years old it has a broken motor and I was trying to put a new motor in it,the old motor has 3 wires white,black and ground but no extra startrelay. the new motor (partno: 4171686 from whirlpool) has 4 wires white,black , yellow and ground , also in package was startrelay but no wiring info for this motor. I Need wiring info if someone can help. Regards. Bjorgvinj


... KitchenAid Dishwashers

10 year old Kenmore Ultra is leaking early in the washing cycle. Wondering if this is worth fixing or need to bite the wallet and buying a new one. I am worried about affecting the new cabinets even though the dishes seemed to be clean on the two occasions that the dishwasher has leaked. Only need a somewhat simple machine- I'd appreciate any suggestions as to what brands I should research if buy is the conclusion. Thanks.


At 10 years old I wouldn't put much if any money into it. Do check the water connections as it may be something simple that just needs to be tightened or a washer replacement. Replacing the valve is a simple and inexpensive fix but don't bother going ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Bad smell on dishes from new whirlpool dishwasher. Old washer was 20 years old and had no odors could it be the plastic the new one is made of?


... Whirlpool Dishwashers

Blown Motor DW is about 16 months old. Started making some real bad noise. Lasted about a minute and then had a death howl. Called in repair tech who says motor is blown. $399 for repair which includes $125 for the part. I've rebuilt car engines, so can probably replace a DW motor. Any insight on how to replace the motor? is it worth paying 275$ for labor? Just bugs the hell out of me paying $400 bucks for a repair when i can get a new one for $450.


I haven't changed that particular brand of dishwasher motor, so I cant give a step by step, sorry. I do know the other brands it is optional to get the motor alone or the motor with the pump assembly attached, so you may want to ask abo ... Maytag 24 in. MDBH950AWS Built-in Dishwasher

When the cyle is complete the dishes are cold and wet and greasy ones not washed properly. I think it needs a new heater but the person who came out to look at it said it was because it is in my garage (?). I have always had my dishwasher in the garage and never had this problem. If it is the heater, is it an expensive repair or would I be better off buying new. I have a six year old Zanussi de6754


At http://www.usersmanualguide.com/zanussi/dishwasher/de6754\015\012you wil find the user manual, if the dish washer is instaled proper it ... Dishwashers

DOOR REPLACEMENT I have a GE-Triton XL dishwasher model GSD6600G00WW in white that is only about 4 years old and I'm now redoing my kitchen and want to change to Stainless steel. Can the door of my dishwasher be changed to a new door instead of buying a completely new dishwasher?


On most dishwashers the front panel is removable/replaceable. You can try www.coastparts.com or www.marcone.com ... GE 24 in. GSD6660GSS Built-in Dishwasher

I have a Kenmore dishwasher Model # 665.1376 which has always been a quiet unit. This dishwasher is about 4 years old. Now the dishes still come clean, however the cycles have a loud hum to each except for the dry cycle. Could this be a bearing in the motor, and if so how expensive is a new motor?


... Kenmore 13763 Stainless Steel Dishwasher

Maytag MDBTT79AWW dishwasher fills and nothing else. Once filled you hear a click, followed by a humming sound for 3-5 seconds, then silence. This will happen two or three more times, and then unit will shut off. Motor doesn't start. Repairman says he thinks control board is bad, but he sounds like he is guessing. I performed a field service test , which indicated a fault in the high current motor circuit. Unit is seven years old. Don't know whether to attempt repair, or replace.


That sounds like the motor trying to start but being jammed it is shutting off via an internal breaker. Check for something in the bootom of dishwasher that might have gotten down there that could do this. You might have to take the sprayer off and s ... Dishwashers

I have an LG Dishwasher model LDF9810ST. Error code E1 keeps showing (Water Leakage Problem) NO water problems anywhere to be found. I have a hard time shutting down the machine. It has had a new MAIN BOARD, and a NEW MOTOR. This unit is not 1 year old yet. Any suggestions?


Are you draining the unit in the basement or under the kitchen sink?\015\012\015\012If you are draining the unit to the floor you will need a new drain hose with a syphon breaker. This drain hose is factory installed on all new LG dishwas ... LG LDF9810ST Built-in Dishwasher

Can't start the Honda GX160 5.5 HP Electric motor on my Chore Master 2400psi Pressure Washer. Got gas (checked through feed line), new spark plug, switch on, gas, choke ok, throttle a bit funky (about 12 years old on loan from a friend unused for 5+ years, no manuals). Recoil string sounds close to kicking over, but pretty half-heartedly ...


Is there an oil sensor unit if it is going bad it tells the engine the oil low and engine wont start. I had same problem with my pressure washer, i just unplugged the sensor unit and it started fine ever since ... Pressure Washers

The thermostat seams to have given up in my bosh dishwasher and it is taking over2 hours to do a load I was wondering if I could buy a thermostat and get some Instructions and diagrams on who to instal the new one . Must be 8 to10 years old. No one in my are fixes or can buy Bosh parts I was hoping you could help. Kind Regards Anthony Lee


Hello Anthony. Yes. For Bosch parts and parts diagrams go to this link RepairClinic.com\015\012\015\012Enter your model number and you will have access to 500 Bosch parts and more. I use this site daily and it is excellent. The part will c ... Bosch Dishwashers

Hello I'm looking for advise on my 11 year old dishwasher. It's a kenmore ultra wash model # 15812. The problem is that when you push the wash button nothing happens. The drain funtion still works and all the lights on the front panel work but no water is flowimg into the washer. Do I try to fix this or just buy a new one?


Hello there:To be honest with you i would first try these solutions and see if they work cause a new machine would cost a lot of money.But if you can fix yours it would cost a lot less so plese try these solutions that i have provid ... Dishwashers

My kenmore elite - model 8525879 is not getting dishes clean even with pre-rinse by hand. It is also leaving soap scum on glasses that is so bad, I had to hand wash my glasses with a brillo pad to remove the scum. The inside of the dishwasher is also covered with a white scum. The dishwasher is new. Not even a year old. I am using liquid detergent and rinse aid.


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... Kenmore Dishwashers

We have a 12 year old kitchen aid diswasher model kudpo1ilbs2. It is not cleaning the dishes. Everything is loaded correctly and the proper cycle and soap is being used. We have had no problems until the last 2 - 3 months when a greasy food film is now appearing on the dishes. Some food is left on but not a great deal. The question is what could be wrong and what kind of cost are we talking? We are trying to make an informed decision as to whether fix or buy new. Thank you in advance


... Dishwashers

My 12 yr old KitchenAid -Sculptura-Model KUDR24SE starts to fills with water and then does nothing else. It will eventually go through the cycles on the panel, but nothing is happening inside. End result is still dirty dishes with water sitting in the bottom that has to be baled out. Cups on top rack don't have any water on the indentations, so it's obvious that the thing filled with water and that's it. I had the motor replaced (supposedly with a new) one 2 years ago so I find it hard to bel


... Dishwashers

I have a Whirlpool DU1055XTSS dishwasher that completely stopped working. I took it apart, found the thermal fuse to be bad, ordered a new, then replaced it and it worked for 2 loads. Now the thermal is open again. What could be "taking it out"? Is the thermal fuse strictly a thermal or does it repsond to current? It's 2 years old, i have already replaced the heating element, the main control board, and now the thermal....twice.


Hi.If the thermal fuse is blowing, that means that there is overheating.Common causes for overheating are:Thermostat cutting off too late.Plugged element.Plugged element means that the element sta ... Whirlpool Dishwashers

I have a GE GSD3200 dishwasher about 6 years old, which had been working well until this past week. When turned to 'start' the motor runs but no water fills the tub. I then poured 4-5 pots of hot water into the tub and tried to re-start. As soon as it was turned to 'start', I could hear all of the water draining out. How bad does this sound :) ?


Look inside the dishwasher and there is a little round cup shaped thing in the bottom of the washer. It shuts the unit off if the water gets to high. Lightly push down on it to reset. It should fill with water now. You should look into why it was tri ... Dishwashers

My dishwasher is a Profile Quiet Power II and is 8 years old. There is one person in my household, so it has not had a lot or wear. The issue is that the flatware and glasses do not come out clean. The flatware is often smudged and the glasses are cloudy. I have changed detergent several times and adjusted the settings and hot water. There is a self-cleaning filter. I am contemplating buying a new dishwasher but wonder if I would benefit from a service call.


Hi\015\012\015\012White film deposits are observed if water is hard or when you are using more detergent than needed. It may also be due to mineral deposits on the heating element. Inspect the heating element for any deposit and scrub it ... GE Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0730 seconds