Having problems with your Dishwashers ?

Zanussi DW 908 door mechanism is faulty. The counter balance has failed. How can this be resolved?


Answers :

You need to remove both side panels to allow you to gain access to door counterbalance springs. Visually see what is broken or come off of allignment then rectify.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Zanussi DW 908 door mechanism is faulty. The counter balance has failed. How can this be resolved?


You need to remove both side panels to allow you to gain access to door counterbalance springs. Visually see what is broken or come off of allignment then rectify. ... Dishwashers

I have a Bosch SHY66 dishwasher. The detergent cup will not open. The rinse injector stoped working a long time ago. I removed the outer door and the mechanism for the detergent cup and rinse injector is exposed. I see a clear fluid inside. How can I determine if the detergent cup mechanism has failed or if it is a failure of the control signal? How can I remove the detergent cup assembly? I am willing to buy the service manual if you now where to find it. Thank you, Bruce O'Reilly


\015\012Bosch Detergent Dispenser \015\012It's not that bad to change. Remove door panel, remove two timer actuator arms (be careful of springs), pry down tabs on top and sides and push it out. Of course remove upper bas ... Dishwashers

We have a Kenmore Elite dishwasher. Recently when opening the door we heard something snap and the door fell open all the way. It appears some type of counter balance broke free. We would like to know what parts are needed to be replaced and how to do it.


The door is holded by the hinges.the hinges are connected to the machine as well as to the door.\015\012if the hinges are bent or get cracked or loose then it will not hold the door.\015\012\015\012To repair the door hinge as ... Dishwashers

Door hinges The dishwasher door appeares to have no counter balance and one hinge seems to be adrift, is there a parts kit for this repair?


Need brand and model number. Number can be found on dishwasher area exposed when door is opened. Around edge. ... Dishwashers

What keeps the door from dropping fast? Is there a retention devise to counter balance the door? What part(s) could break and cause this problem?


There is a spring at the bottom of the door on each side.Pull the dishwasher out a few inches and you should see it from the side. Parts 1,2 and 3 are the hinge and spring on this diagram. ... Frigidaire 24 in. FDB836GF Built-in Dishwasher

The door spring mechanism and/or balance has been repaired before on Model # KUDS02FRBL1 Kitchenaid dishwasher and is currently broken again. Any suggestions


... KitchenAid Dishwashers

The spring mechinism which automatically closes the door on my under counter Magic Chef dishwasher has failed. How to fix it?


Call your nearest appliance parts store with you model and serial # and ask them to look up the door handle/latch mechanism assembly and replace it. ... Magic Chef Dishwashers

Cant get the front door open on my kuds25sh no way to get at the screws that secure the unit to the counter i am very good with tools but i dont know the way the mechanism is set up please help my wife is driving me crazy cliff


... KitchenAid KUDR25 Dishwasher

My dish washer fills with water washes but fails to empty so when door is opened plates are washed but water is left in the bottom the pump must be working as it doesnt leak is the controller faulty on that phasae of the cycle


Hi,\012Here is a tip that I wrote that will help you with your dishwasher not drainingproblem...Dishwasher Problems - Waterwill not drain ... Bosch Dishwashers

Hi, I'm working on a KUDI02FRSS0 for my neighbor. She complained the door flew open one day during a wash and the door had been very heavy since. A quick check on the internet, and I thought it would be simple... I installed an 8194001 balance kit. Both cords had broken. However, the door was very hard to close, and once you did close it, it would tend to pop open by itself shortly thereafter. When the door popped open, thanks to the new balance kit, it would not fly open as it had p


Is it possible that the door hinges or springs are installed backwards or upside down? Just a guess. Good Luck to you. ... Dishwashers

Door opens without mechanical aid and drops too quickly


... Creda 18 in. BC20 Built-in Dishwasher

Door balance springs


... Dishwashers

I have a Whirlpool Quiet Partner I (DU920PWKQ0) that the detergent dispenser door is not opening to allow the detergent out during the cleaning cycle. So, the dishes are not being properly cleaned. I do not regularly run a dishwasher cleaner through the dishwasher like some sites recommend. Is this problem more related to cleaning than mechanical ..... If it is a mechanical problem, can I take the door plate off the inside of the dishwasher and get parts if needed??? without a service vist? Than


... Whirlpool Dishwashers

Code F2 I just replaced the door switch on an inoperable DD-602. My top drawer was working fine, but my bottom one has been offline for a while (door switch failed and I never got around to fixing it since I had the top). Well, my top finally failed too so I replaced both switches. Looks like everything is good on the top, but my bottom is erroring with an F2 code now. Kindof makes a thumping noise as it starts the cycle -- maybe 3-5 short thumps and then a 10 second delay, repeats. Any ideas? C


F2= \015\012The motor has not\015\012been sensed rotating\015\012\003 Foreign object has jammed the rotor\015\012\003 The rotor has failed\015\012\003 The hall sensor has failed\015\012\003 The electronic controller has ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I have a Jenn Air dishwasher and the door latch mechanism has been "locked" but teh door is in the open position, how do I unlock the mechanism. I have pushed the het button three seconds but this me


This happened to me. After replacing the board for $100, still happened. I messed with it myself...\012Reach under the counter to where the "catch" is. Mine is white plastic. Mine had a bit of movement side to side (like 3mm). Try sliding it to ... Jenn-Air 24 in. JDB1100AWS Built-in Dishwasher

KitchenAid Dishwasher KUDP01FL: Called repairman to replace balance link kit. Then door extremely stiff to open & heard loud pop when one of the ropes came off the roller. Repairman came back & put rope back on & replaced door seal, then the door won't close & he claims need a new door latch. When he left, door again extremely stiff to open & heard same loud pop when one of the ropes came off the roller. Now he says he can't fix it and to call someone else. I now have three problems: (1) The doo


May have bent door hinges,, need to check all alignment of door, hinges and latches... ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Dishwasher ''soft drop door'' mechanism came apart - door now drops


I had a similar issue as described by mc1bean. One day my Jenair dishwasher door just fell down. The right side spring was fine. The left side spring was still hooked into the door hinge but the cable was laying on the floor in 2 pieces. Over tim ... Dishwashers

I'm trying to fix a whirlpool du980qpdq6 dishwasher. The door on the soap dispenser won't open. I've checked the latch and it works...no blockage. I've taken the door apart and looked at the Wax motor in the door. Apparently that is what actuates the mechanism that opens the door. Does anyone know how to test the wax motor to see if it is functioning?


... Dishwashers

Door mechanism door has 2 springs on each side, on the right the spring works on its own. But come to the left side and it has a long belt type piece of metal,the spring and a hook type piece that makes up how the door opens and closes.this left side has come apart and dont know how it goes together,therefore the door just drops very sharply to the dismay of my partner.plz reply to [email protected]


Wind metal strap around plastic bush and hook above hinge ... Candy 24 in. CD622 Free-standing Dishwasher

The door release bar on our KitchenAid KUDV24SE is hanging loose and so the door won't open. According to the installation booklet, the dishwasher should be attached to the floor or countertop to prevent it falling over when the door is opened, so I can't pull it away from the counter for better access. How do I open the door from the front? Thanks.


Looks like a very tight spot to be in. Your best bet is to get the toe panel off (item 8) in ... KitchenAid 34 in. KUDV24SE Built-in Dishwasher

Kenwood dishwasher kdw8st2a replaced door lock mechanism, door closing properly and program selection available but none of the program's will start. When I shut the door I just have an intermittent beeb and no error message. Any solutions?? Been trying to see if I need to reset anything but can't find a solution. Thanks jo


... Dishwashers

My GE dishwasher's door is stuck shut ~ I'm assuming a broken latch. I was told to fix the latch, the dishwasher has to be taken out from under the counter top (in order to get the door open). My problem is: with the dishwasher door stuck shut, it's impossible to unscrew the dishwasher from the countertop... Any helpful hints? Pleeeeeeeease (all of my silverware is stuck INSIDE the locked dishwasher - LOL!)


Well I'll try to help you get this opened. I don't know how much space you have at the top side edge of the dishwasher. You need a long stiff rod like a metal clothes hanger straightened so it can reach from the side to a little past the dishwasher m ... GE Profile PDW9880NSS Stainless Steel Dishwasher

I have a Bosch dishwasher, model SHU9915UC/U11. The spring mechanism on the detergent door cracked, and I bought the part to replace it. I took the front cover off of the dishwasher to determine how to replace it. Two white plastic "things", maybe spacers, fell out. I need 2 things: a) how to gain access to the spring on the detergent door so that I can replace it, and b) how to put the door spacers back on. An exploded parts view would probably help a great deal. Michael J. Orr


Hello! This is Guru...Saailer...I have your information...Due to size limitations I'll need your e-mail address in order to send it to you...Send an e-mail to me and I'll send an exploded view diagram and parts list...Guru...saailer... ... Bosch SHU9915UC Dishwasher

Water leak have the Ge triton dishwasher (Model # GSD5320D02BB, bought it n 2001) and currently have very small amount of water leaking out of the door during a run cycle. I did check levels when running and that seems to be fine......meaning the dishwasher is level and not an over-flow problem. My next thought is maybe it is a faulty door gasket. So my question is, where is the door gasket located and how do I replace it? (and where do I order this part from?). Looked for diagrams to follow and


They are in the bottom left and right of the door opening. GE likes to use L-shaped, molded and ribbed seals on most of their models - hopefully also on yours. Typically these can be removed by hand and easily replaced without taking anything apart. ... GE Tritonr XL GSD6260JCC Dishwasher

Hello all, We have an Ikea Whirlpool DWF 416 that is a couple of years old and has never caused any problems. From today the door has stopped shutting properly. The electronics and internal mechanisms seem to be working fine, since when you turn it on the cycle starts - but only if you hold the door shut. Has maybe a catch gone? Any ideas for fixing a door-shutting problem like this? Thanks in advance! Dave


The catch is no longer working. Contact IKEA for the replacement part. I'm sure it's available through EBAY or something, but probably not guaranteed or as reliable. ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0854 seconds