Having problems with your Dishwashers ?

Problem lighting natural gas roomheater sunstar corcho 18,000 btu

\015 Problem lighting heater sunstar corcho 18,000 btu .pilot light comes on, but grates will not light \015

Answers :

Sounds like the thermocuple is bad, it is a small copper line coiled up with a larger end that sits in the pilots flame. it tells the control valve that there is a flame and it is ok to open the gas valve. You can replace them very easily you just have to match it up to the right one. they are conected by a tube fiting on the control valve and a screw or sometimes just a clip near the pilot flame. True value stores carry them
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Problem lighting natural gas roomheater sunstar corcho 18,000 btu


Sounds like the thermocuple is bad, it is a small copper line coiled up with a larger end that sits in the pilots flame. it tells the control valve that there is a flame and it is ok to open the gas valve. You can replace them very easily you just ha ... Dishwashers

I replaced the coil set, but that was not the problem. The ignitor will light the gas flame and it will blow for about 2 minutes, then the gas shuts off. Since replacing the coils, I have not tried the dryer with wet clothes inside. Is this gas shut off normal or do I need another part?


The gas flame will cycle on and off in response to the thermostat. Two minutes sounds about right for the dryer to warm up to temperature. The gas will shut off until the temperature cools down and then should cycle on again. Let the dryer run (ei ... Dishwashers

'Dead' DU1100XTP The dishwasher will not start - no lights at all - no indication that anything's working (although I confirmed the unit has power). I've seen numerous posts regarding the control board - is there a problem with these in general? My unit is just beyond the warranty (naturally!) so I'd like to know if there's been any concession made by the manufacturer due to the number of problems. I'd gladly replace the board if Whirlpool would send me one. Thanks.


This may sound simple but... make sure its plugged in all the way. ... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

Whirlpool Quiet II (DU110XTPB1)... Two problems (maybe it's one)... Start/resume light flashing and won't stop. I have tried on the different button combinations from this website and other websites and none of them seem to make a difference. The flashing continues. That's problem number one. Problem number two is that it seems to go into some sort of washing cycle in completely random intervals. When it's in one of the random washing cycles the following lights are on; Normal Soak and scour


Hope it's under warranty, maybe logic board, poor motor design causes main PCB failure ... Dishwashers

My wife opened door during cycle. When she closed door it would no longer run. Looking at problems and recomendations on similar models, I replaced the board. Did not fix the problem. I have checked the fuse and the door switches for continuity and all seem ok. The only lights on the panel that come on are: under cycle- Pots & Pans, Light. Under Options - Heated dry. No other lights work and the dishwasher does not operate.


Hi,\015\012\015\012First off, sorry to hear that you replaced the control board for nothing..in hindsight. So if I understand what you're saying is this, You cannot select any cycles and the unit won't start...because the start button is ... Dishwashers

Describe your MDB6709AW Builtin Dishwasher Problem Maytag MDB6709AWW Most lights are on some will Problem with the Maytag MDB6709AW Builtin Dishwasher Maytag MDB6709AWW Most lights are on some will not reset... Wash cycle starts in "DRY" ... all the "DELAY" lights are on. washer appears to run through the cycles properly


... Maytag MDB6709AW Builtin Dishwasher

Hi, I have a Miele G681 dish washer with an intake/drain light problem. I've read all posts about similar problems I could find both on this forum and others but I'm afraid I still can't figure my problem out. The intake/drain light starts blinking mid way into the dishwashing process. The dish washer fills up, rinses, drains, water is hot, everything seems to function just fine. Some time after the tablet drops from its door mounted container, and the time estimate reaches 46 minutes r


... Dishwashers

I have a Kenmore mdl. #16032. I have a blinking clean light. Due to this Light or problem the unit will not operate. Prior to this light the dishwasher was a little noisy. What do I need to do to resolve this problem?


I think this is related to the wash arm getting obstructed by either a pan or some spoon stuck at the bottom. That could be the noise you mention.\015\012\015\012\015\012I have seen people fix the clean light flashing with a sequenc ... Kenmore 24 in. 16032 Built-in Dishwasher

I have a kenmore DW model 16019. The clean Light stays on the light does not turn off. I have tried to disconnect and have taken the motort apart to make sure everything is clean. What Can I do to solve this problem? 1. Does the washer work at all? No it does not work 2. Does it display any codes or flashing lights other than the CLEAN LIGHT being lit? no other lights are on except for the green blinking light 3. Is the light solid or blinking? blinking Green light 4. Entire model # is necessary


Thanks for re-posting with all the info!!The model # is 665.16019403The cleaning light blinking is a fault code listed in the tech. service sheet, its usually a faulty heating circuit.The sheet can be found behind the ki ... Kenmore Dishwashers

I have used my Honda Pressure washer 3 times over a period of 1-2 years. I could not get it to start today. I did not drain the old gas but added some new gas (which was probably a few months old). I have never had problems with a lawn mower sitting for a few months; but my guess is, this is the problem? How can I repair this?


Check the oil level in the crankcase if it just spills out the oil fill hole it fine\015\012\015\012drain tank and drain float bowl and clean fuel tap make sure the carb is not green and blocked if so give it a good clean out ... Honda Pressure Washer PSI 3000

Replaced control board on my Kenmore dishwaser 665.13122k703. Still have problem with blinking lights and maybe one minute of operation, then stops and normal wash light blinking again. Cancle drain button only one that works, then normal wash blinks. I have another control board, however before I install it, should I be looking eleswhere the the problem ?


... Dishwashers

Check water light stays on rendering machine unuasable.checked water supply.all filters .googled problem told me to switch water supply on and off rectified problem for 10 minutes then check water light came back on. water remains in bottom of appliance.


... Bosch Dishwashers

Throttle problems Homelite pressure washer model UT80709A. bought it 10 months ago with no problems and stored it for last 9 months. Before doing so, drained gas, oil. Brought out of storage a few days ago, filled with fresh gas, oil, cleaned air filter. Starts great first try but after about 30 seconds the throttle starts visibly revving the motor a litlle at first then gradually faster and faster until it seems to flood and die. Then you cant start for about an hour and its the same story. Hav


... Homelite Pressure Washers

Bendix bdw55 dishwasher problem Put on as usual as a 'normal wash' program 2, and they to find it not filling up and the start light flashing along with the end light flashing 3 times in between???? Anyone know why? And what the problems are? Plz help asap Thank u xxxx


... Dishwashers

I have a Whirlpool DU1048 that started out with a blinking clean light. I reset the dishwasher by pressing the heated dry and normal buttons twice. That worked the clean light stopped blinking. The problem now is the dishwasher seem to be stuck in the wash cycle. I finally have to turn it off after over an hour washing. Is this possibly a heating element problem? is that user replaceable?


... Dishwashers

We have a Siemens dishwasher SE25M851. It had the check water light on, so we have checked all water flows which seem fine. There is what I think is an Aquastop connected to the water hose, which I have no idea if the problem is there, but when I now put the dishwasher on there is a burning smell coming out of it, so have had to turn off power supply. Can you shed any light to the problem?


... Siemens Dishwashers

I have a Maytag QuietSeries 300 dishwasher. My original problem was with the control panel lights not coming on. Another repair website recommended replacing the circuit board. We replaced the board, but it did not solve the problem & the dishwasher would not work. Replaced the control panel. Lights come on, but when the start button is pushed "21" flashes on the time display. What do I do?


HI,Just visit this link HERE and your problem will be solved.Goodluck,Please don't forget to rate the solution. ... Dishwashers

Hello! I have a Frigidaire (made by Electrolux) Gallery Professional Series gas range/electric oven, model #FGF379WJCA (manufactured in 1998). The appliance came with the house we moved into 2 years ago. I have the owner's manual and gone through the book but can't resolve two questions. 1) One of the burners will not light. When I try to turn it on, the other three burners' electrodes will flash, but the 4th one will not. I can light the burner with a lighter, so there is gas coming throu


\012The front controll pannel lights and clock are not on. \012There is power to the unit. \012Is there a reset botton somewhere? ... Electrolux Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

Maytag quiet series 300 problem model MDBH955AWB Set washer to run on Delay last night. All lights were go. Has worked in the past. It didn't run and now, no lights, and doesn't operate. No problem with electric box breaker switch


Same problem...seems this appliance is a piece of ****....i have read nothing but bad things about it....i have the choice to pay 250 to repair it...or replace it....easy choice.... ... Dishwashers

Miele Inspira G2180 SC SF dishwasher problem We start the Normal cycle and after the dishwasher fills up with water the units starts beeping, all six program lights start to flash, and the water drains out. The lights remain blinking. What might be the problem please? Dan


... Dishwashers

I have a whirlpool in counter dishwasher model # DU915PWPQ0 serial #FS2536586. The problem i have is the light cycle, green light is constantly blinking. When another button is pressed the heavy and normal cycle lights start blinking and the light cycle, light is illumanated constantly. I have left the power off for 24hrs and when turned on the light blinks again. it will not start any cycles.


Hi Mike...As I said..it flashes 4 times (not 5) 4 times then stops and starts flahung 4 times again. Also, the float is free moving in the tub,\015\012\015\012Any other suggstions??\015\012\015\012Thanks\015\012Dave ... Whirlpool 24 in. ADP5962 Free-standing Dishwasher

My dishwasher won't start (Series 300 purchased 14 months ago). The following lights are on: light wash,hi temp wash,sanitize, locked and the start /resume light is flashing put goes out when pushed and the machine does not start when closed. there has been an on going problem with the regular wash light not coming on when pushed.


Hi\015\012\015\012It may be an issue with heater circuit, door switch or wash pump. If yes then please reset the power to the dishwasher. After, 5 minutes check if you are still getting t ... Maytag 24 in. MDB9750AW Dishwasher

I have whirlpool diahwasher ,model DU1055XTSQ3,quiet partner -1. when i start the machine the folowings things happen: 1.the machine does not start . 2.Start /resume light starts blinking ,after few seconds ( 40-50 seconds), the pots and pans light also starts blinkng .after some time ( 1 minute ) the normal light also starts blinking .All three lights start blinking 3. I have done the following to rectify the problem from the book : alnernatively pressed heated dry and normal keys for


... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

Flashing light The 3rd light to the right keeps flashing. I cannot cancel the programme or move the indicator light to any other setting. When I close the door the machine does not come on, just the light keeps flashing. Any idea what the problem can be? There is no water in the machine and doesnt appear to be any blockage in the outlet pipe.


... Smeg 24 in. DWI612 Built-in Dishwasher

I'm having a problem with my Miele dishwasher G 879 SCVi I asked for assistance on 2/12/10 and paid $6.00. I have yet to get a response. Please let me know when I will as I need the problem addressed before Christmas Day. The problem again is that all the lights on the diswasher panel are all flashing at the same time when switched on. It may need to be reset somehow, as the power went off, which may have caused the problem. Your urgent assistance is required. Thank you


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1354 seconds