Having problems with your Dishwashers ?

Baumatic bd1631. where is the door tension adjuster please? manual shows picture but still cant figure out where it is.


Answers :

On the top front edge there is a white seal, lift it slightly and it reveals the head of a bolt on each side. You need an alan key to adjust it but I am having trouble getting it right. Let me know if you succeed.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Baumatic bd1631. where is the door tension adjuster please? manual shows picture but still cant figure out where it is.


On the top front edge there is a white seal, lift it slightly and it reveals the head of a bolt on each side. You need an alan key to adjust it but I am having trouble getting it right. Let me know if you succeed. ... Dishwashers

Whirlpool DU927QWDG1 Hi, The problem I'm having with my dishwasher pertains to the door cover for the area I place the soap. There is a small spring which helps the door pop open to release the soap when washing. I cant figure out how to place the spring so that the pops open.....right now when I run the unit the door stays latched and the soap doesn't get dispensed. Any ideas on how to repair this or where I could maybe get a parts manual??? Your expertise will be greatly appreciated!!!!


... Whirlpool GU2400XTP Built-in Dishwasher

Ffbd2406ns0a Cant get through a full cycle without it leaking...a lot. Ive only had it a couple of months and its only been used a handful of times. The door gasket/door wiper down on the bottom of the door has a gap in the center of it that is missing, but the pictures I have seen online show that it seems to be made that way?


... Frigidaire Dishwashers

DD603 upper drawer pump rotor will not turn - F2 error. Was completely siezed. Removed rotor and got the shaft to turn with pliers. However it does not spin freely and still shows an F2 error. Does anyone have a repair manual so I can figure out how to remove the pump? Lower drawer had an F1 error (due to the upper leaking/F2 error) and this website helped me fix that problem.


Maybe you dont have to remove anything else.. try the rotor from the bottom drawer first. If this works just buy a new rotor.. ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Water leaking from bottom of door. Is there a gasket I can replace? I cant seem to figure it out. Also a link to a parts manual Thanks Dennis


Check under door, should feel a rubber gasket. sometimes it gets pushed up by silverware. on each side of the door you'll see a small bit of plastic from the gasket, give that a push down and close the door, should fix your problem. ... Dishwashers

My Frigidaire is old, at least 15 yrs. Model # fdb635 or #fdbc45 , it is 29 x32 1/2 The detergent dispenser does not open. When I open the door and manually open it still does not wash right. Cups and glasses are not clean on inside, and leave spotting on glasses and other dishes. I'm not sure of my timeing of opening dispenser door. This is a white dishwasher. High energy . I do not have a manual to refer to I would appreciate your advice.


... Frigidaire Dishwashers

We bought an aeg favorit 50674 dishwasher ,last week and yesterday i went to open the door to get the dishes out and the door wouldnt open.i tried again but noticed that it had caught on yhe side panel and was bending the panel.not wanting to make it worse i phoned the comit store that sold me the machine they said it was not their fault and wasnt covered on the warrenty .i still cant get my dishes out cant you help.thanks caz ivey


... AEG Dishwashers

Inglis dishwasher the colour pannel on the door bulged and fell out. How can I put it back? We lost our user's manual that would describe how to change colour pannels and I am sure I could figure it out from there. could you explain the procedure or tell me where to find the user's manual on line?


Inglis dishwasher works well until it drains. It doesn't know enough to stop draining and begins to make a whining noise and will not stop. Like it doesn't know to go to the next stage. How do I fix this? ... Dishwashers

Dishwasher warning symbol, looks like dishwasher tablet symbol and is permanently lit for last week. I cant figure out what it is and cant find manual since we moved house 3 months ago!


... Dishwashers

Dacor millenium 24 condensation on door after wash, smells, leaky on the top of the door where you open dosent clean well we have been over the manual 100 times can't seem to figure out whats wrong.


... Dacor Millenia MDV24 Built-in Dishwasher

Model 01902 2350 psi . engine runs fine , sprays out nozzle but lower pressure and water sprays out plastic elbow on relief valve , that is supose to **** in soap if used , cant hold finger over spray from elbow , high pressure , took apart relief valve and plastic valves all orings are ok , brass pump seals look ok , all back together , still blows out elbow . ?? plastic spools were out by somebody else , not sure if they are in right , cant find picture to compare .


It sounds as if the non return valve in the elbow is the wrong way around .The o-ring normally goes in first then the ball then the spring. Try it and good luck. ... Pressure Washers

I bought a used 001355 asko dw. the front door panel and all under panels are naturally loose and I'm having trouble figuring out the reassembly order. And then as I was trying to install the main galvanized under panel, a short galvanized sheet metal part fell out of the door inside the unit. That's the part that now has me really stumped. Can I get a picture of the front of the unit, preferrably an exploded view? Thank you. Paul Cowden. (415) 777-9858 or (415) 302-0628.


... Dishwashers

The dishwasher stop during the wash cycle. It did finish draining the water from the tub. The machine is not showing a power signs, I check the circuit breaker and the fuse is not tripped. I open and closed the door and the door latch seems to be working fine. There is just no power to the washer. Usually when a machine breaks down, there still is power or buttons that light up on the front of the machine. I looked on the internet and many say that the fuse could be tripped. No where can I find


... Whirlpool DU912 Dishwasher

E24 showing on dishwasher model sn26m290gb/07 done all problem shooting tasks in manual but still showing


... Dishwashers

My power button cover broke on the dishwasher and I figured out the part number I needed, but when I put it back together I got the wires crossed on the board and door switch. Now the control lights up , but the dishwasher will not run a cycle. THe question is does the plug on the door switch have to be a certain way, because there are three wires and you can connect the plug both ways. I did turn the plug, but it still does not run. Did I break the switch? Bosch SHU9956uc/14


The wires do have to be a certain way on the door. Otherwise a door open can tell the board that's it shut and vice versa. The easiest way to do it, is test the switch with an ohmmeter, place the meter on the switch, push button in and see if the rea ... Bosch SHU9956 Built-in Dishwasher

I have a Kenmore dishwasher model 66574362K2. It has worked fine until tonight. I opened the door before the end of a cycle, closed the door, and pushed the cancel drain button. There was still water in the bottom but the dishes were basicly finished. Now I can not seem to get the dishwasher to come back on. The lock button seems to be on and it usually is not on. The manual says to push and hold the button for 4 seconds to turn it off. I did that. But now it is flashing between the Heate


Can you press the drain button to drain the water, then shut the unit off and restart??? I have exhausted all my resources to help, thought this may work. ... Kenmore Dishwashers

We have a MDB4651AWW dishwasher. It is very loud, we have the bottom front panel that seals the dishwasher at the floor but cannot figure out how to install it. One way it does not fit, the other way it won't let the door open and close properly. The noise is terrible and it has been that way for three years. We don't believe there is anything wrong with the dishwasher, figure the bottom panel will deaden the sound. can you show us how it goes?


... Maytag Dishwashers

I bought a used GE Triton XL d/w with no manual. It worked great but now it is not cleaning anything, when the cycle is over the soap cup is open but half of the soap is still inside of the cup. I opened the d/w during a cycle and the dishes are wet top and bottom racks so I know it's getting water but the dishes are still filthy. Why is the soap not working? It's like water is spraying everywhere but the door where the cup is!


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... GE Tritonr XL GSD6260JCC Dishwasher

I WANT TO INSTALL TWO CABLES IN MY DISHWASHER DOOR, I HAVE THE CABLES, JUST WANT YOU TO SHOW ME A DIAGRAM AS TO WERE THEY GO, MY DOOR TO THE DISHWASHER FELL DOWN, THE CABLE BROKE, MY DISHWASHER IS OLD BUT STILL WORKS GOOD


... Dishwashers

We are having water leak from the bottom of our Roper Dishwasher door. THe model # is RUD5750DG3. I have taken the inside door frame off and found a small white rubber seal had dislodged inside. i placed it back in the only sopt it fits but water is still leaking. I have checked to make sure the water is not leaking from any where else on the dishasher. This occurs when the water inside is spraying and eventually fills up on the bottom. We no longer have our manual as the dishwasher cam


Try to fix the rubber seal which has come out by fixing it through super glue or apoxy seal which will stop the water spill and leakage.\015\012Please give more details of you dwasher ..... the Make and model so that i can send you the manual f ... Dishwashers

Whirlpool DU900,09,10,11,15,20,30,DUL100 Hi, I'm not sure what exact model mine is, but those are the models listed on the manual. I opened the washer and the whole upper part of the wash tower was laying on the dishes! I took everything out, and began trying to think logically, and re-assemble the thing; nothing appears to be broken. page 17 of the manual is the only place that even shows this set up, but it's just a part description. As I am looking at the picture, I realize that the spray tow


... Whirlpool 24 in. DU920PW Built-In Dishwasher

My Asko D1606 doesn't seem to be filling/retaining enough water to pump actively through the swing arms. When I add a litre or so of water in manually and hold in the door catch, I can see it appear to start working properly. The tablet is still sitting on the bottom of the dishwasher after the cycle has ended and the dishes are still dirty. The pump sounds all right and it is emptying fine. Also, probably due to the lack of water, the cutlery basket has melted right through, and I am sure any p


Check to see it the dishwasher has been pushed back ever so slightly. The water coming into dishwashers and exiting are on timers and if the hose is pinched this can affect it. Your dishwasher may appear to be in the same place but just pull it forw ... Dishwashers

I have a Earthwise PSI 1850 Pressure washer and lost the manual for setting it up. my brother cant figure how to use


... Earthwise 1850 PSI Electric Pressure Washer

FDW70 dishwasher, starts to fill with water, shows pre wash on control panel, then pumps out within about 2-3 minutes, but has vertualy no water in it. Puts up code A10 on control panel, can still hear the pump going even when l open the door. Have replaced a burnt out heater tube with a new genuine unit, also have removed & checked fill valve & this works fine.


Hi,Try this few steps;Turn off the water supply to the dishwasher and remove the hose, turn\015\012on the machine for a couple of minutes in a fill position then turn off\015\012the machine, reconnect the hose, turn the ... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Cycle was coming to end, pump will not shut off. I manually shut off the DW and restarted it, pump came back on, now is running and I cant restart a new cycle, pump stays on even with door open.


Ther is poss water in plastic base or float is stuck. ... Bosch Evolution 800 SHE68M05UC Stainless Steel Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1381 seconds