Having problems with your Dishwashers ?

Dishwasher is not pumping water ,after putting program on no.2 it goes back to no.1 and doesn't pump any water


Answers :

    \015\012
  • Check that the water supply is turned on. The valve may be located under the sink. \015\012
  • Check the door latch \015\012
  • Test the door switch \015\012
  • Inspect the float assembly \015\012
  • Inspect the fill tube for kinks \015\012
  • Test the float switch \015\012
  • Check the inlet valve filter screens \015\012
  • Test the water inlet valve \015\012
  • Test the drain valve lever arm \015\012
  • Check the drain valve
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher is not pumping water ,after putting program on no.2 it goes back to no.1 and doesn't pump any water


\015\012Check that the water supply is turned on. The valve may be located under the sink. \015\012Check the ... Dishwashers

AT FIRST WITH JUST THE WATER ON (PUMP OFF) I SQUEEZE THE WAND AND WATER COMES OUT ABOUT 3 FT. THEN WHEN I START THE PUMP AND SQUEZE THE WAND ONE STRONG SQUIRT COMES OUT THEN GOES BACK TO ABOUT 4 FT. NOT MUCH PRESSURE. CHECKED THE CHECK VALVES, AND THE 3 PISTONS THEY ALL WORK. PUMP NO.AXD 3020


Hi, W/D here.Leave the water on, and hold the trigger down for about 5 minutes to get all of the air out of the system. Letting off of the trigger occasionally and then opening it up will help displace any air in the chambers. While still hol ... Comet Axd3020g Pressure Washer Pump 27 Gpm 2000 Psi

I have a whirlpool gold model GU1500 diswasher. When the rinse cycle ends the water pumps out into the garbage disposal like it should, but then water backs-up from somewhere into the bottom of the dishwasher. The overfill protection drain seems OK...the water doesn't overflow. It doesn't have a air gap on the sink. The drain hose goes directly from the dishwasher to the inlet on the garbage disposal. It appears to be properly installed per the installation instructions. The washer is about 4 ye


Seems you answered your own question here. You need to make an air gap in the drain hose - take as much slack as possible and make a curve (upside down U) under you sink as high as you can go. Make sure you clip ot to back of the cabinet to stabili ... Whirlpool 24 in. GU1500XTLS Stainless Steel Built-in Dishwasher

Belling Dishwasher IDW450. When turn on power button it starts bleeping. About 25 times. The you can select your program, it sounds like it is draining but then doesnt do anything else. Cant hear any water running in. I have turned the power off and back on. Water is connected


When you say you have turned the power off and back on. do you mean the switch on the appliance. if so turn off the power by removing the fuse from the fuse panel for the dishwasher. wait about ten minutes, put the fuse back in and see if that res ... Belling 24 in. IDW603 Built-in Dishwasher

Hi I am in an emergency situation with an ikea whirlpool dishwasher. I have no idea what model it is since it's built in and I can't find the manual in my rental apartment. The machine works normally until the part where it's supposed to pump the water out after rinsing. At this point it starts to beep, once, and then 3 times. On and on and on. If I open it, there is water stagnated there. If I try to turn it off and back in, it will go through a whole new program and then I get the same problem


Can you feel the pump operate during the last wash cycles? if not either theres a bad pump motor or lack of power to the pump during that cycle,if this is ok,then remove the drain hose to the main drain to see if this is plugged up with food debris ... Whirlpool GU2400XTP Built-in Dishwasher

Water stays in dishwasher goes through cycle but motor not going if turn propelers at back of motor pump kicks in for few seconds.is it pump motor ,is there brushes in these motors


Yes there are brushes in dishwasher motors it sounds like they are either worn out or stuck try tapping motor with the wooden end of a hammer at the rear of motor as brushes clog up as they wear hope this helps ... Tricity Bendix 24 in. BDW53 Free-standing Dishwasher

Hotpoint FDW85 will not start wash cycle. Takes water in and thats it. The timer goes up and down. no error codes displayed. press cancel and it pumps the water back out. if I leave it running then i can hear a boiling or bubbling sound.


... HP Dishwashers

Wash cycle goes on forever, won't pump water out, just restarts


... Dishwashers

Shu9925uc/14 bosch dishwasher leaves standing water in the bottom of the pump. The pump seems to be bad because it wont drain out the back hose. I have run the diswasher full cycle and put the drain hose into the sink to test. It wont drain at all now and I dont hear the pump. Perhaps unrelated: Pump seemed to stop working after the back hose disconnected itself from the back of the unit spilling water all over the floor. When I reconnected the unit to the wall the pump now seems to be disfunct


Hi Dishwasher not draining issue occurs due to kinked drain pipe, clogged drain filter or drain pump. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remove then turn off the dish ... Bosch SHU9925UC Built-in Dishwasher

I have a brand new Blanco dishwasher but im unsure if it is a DWF6XP, DWF4X or DWIN7 model. It does not have a salt dispenser if that helps. Last night when running for the first time i had a plumbing issue where the drain pipe was not set high enough as it states it has to be 500 to 100cm of ground height. Also had a leaking sink drain pipe. Fixed all that and turned machine back on and it pumped all the water that was inside to drain. I have cancelled the program and restarted but now it is ru


Unplug it and wait 5 minutes. Plug it back in. This will reset the machine. Put it on full cycle and allow it to do a full cycle. It should work just fine. ... Dishwashers

My dishlex dishwasher starts then every 2 minutes flashes 10 after restarting i have cleaned out discharge tube and pump no difference what could it be it does wash after awhile then goes back to beeping and flashing 10 water pressure all ok


... Electrolux Dishwashers

Hi, we have an aquarius hotpoint df61 and it goes through the cycle but does not drain out the last few inches of water and the wash is not as good as it should be, have unscrewed the plastic bit under the filter thing to see if there is a blockage there but nothing, have now taken off the top and side panel to try and get to the pump, currently on it's back but hard to access underneath and not sure how to remove the solid bottom of the dishwasher..please help!


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have a GE potscrubber Dishwasher Model # GSD3630ZZ3WW it has been leaking from the bottom for about a week. I took the bottom off tonight and ran the dishwasher so that I could see where it is leaking from. It is not a hose but the leak seems to be coming from the back of the motor or pump fan where it goes into that plastic housing that attaches to the bottom of the dishwasher seems to be leaking in the very center of that housing where the motor shaft enters the housing. Water is just spray


... Dishwashers

Good mroning after starting any program first the pump will run followed by water intake. After a while the machine stops and the light intake/drain starts blinking. Most of the time water will stay in the machine. After pressing the on/off bottom first switching the machine on again and starting a new program the machine pump start running emptying the water but than stops after a short water intake again. I opened the water stop but it seems to be ok. The filter inside the machine is cle


Good morning don't get shocked because ullu ki to abhi subah hi hui he ... Miele 24 in. G892SCU Plus Built-in Dishwasher

My dishwasher AEG favorit 525 worked perfectly but has been out of action for over a year. yesterday when I tried to use it, the on button is on continuously and no water is pumped into the machine. yes the water is on. the program button is also rotating as the programs change but no water comes in and I am not sure whether it will pump water out as I have not yet got there. please help.


Hi\015\012\015\012The issue seems to with the pressure switch that is bad and\015\012so won't allow the water to flow inside the unit. You can take it apart to\015\012check this. Hope this helps...please post back for further assistance. ... Dishwashers

Water stopped pumping so ordered new pump. Upon removing the old I discovered it had a few straws twisted up into the pump. Removed and reinstalled pump and it sounds great and throws water all over with force.rnPROBLEM: Now there is ZERO water coming through top tube to spray arm. Pulled pump back off and noticed what seems to be a "white diverter ball" that moves a little in front of the inlet for the upper water tube. Any guidance to where the ball should be prior to installing the pump o


... Kenmore 24 in. 16193 Stainless Steel Built-in Dishwasher

Water stopped pumping so ordered new pump. Upon removing the old I discovered it had a few straws twisted up into the pump. Removed and reinstalled pump and it sounds great and throws water all over with force. PROBLEM: Now there is ZERO water coming through top tube to spray arm. Pulled pump back off and noticed what seems to be a "white diverter ball" that moves a little in front of the inlet for the upper water tube. Any guidance to where the ball should be prior to installing the pump or i


... Kenmore 15529 Built-in Dishwasher

Water stopped pumping so ordered new pump. Upon removing the old I discovered it had a few straws twisted up into the pump. Removed and reinstalled pump and it sounds great and throws water all over with force. PROBLEM: Now there is ZERO water coming through top tube to spray arm. Pulled pump back off and noticed what seems to be a "white diverter ball" that moves a little in front of the inlet for the upper water tube. Any guidance to where the ball should be prior to installing the pump


... Kenmore 15529 Built-in Dishwasher

GE Dishwasher model PDW8200J03BB stopped draining. Removed the drain pump, checked with Voltmeter and there is resistance on ohms X10 of about 3. The flap is in place so water isn't shooting back into the sump inlet. Replaced the sump inlet about 6 months ago because it was deteriorated due to hard water. Pump worked fine after that. Checked drain hoses and air gap. Was able to blow water through. Pump only trickles water out at air gap. Does the pump need replaced?


Clear the line from the air gap to the drain,, if the rest is clear the only thing it can be is the propellers on the pump, i which case you will need to change the pump ... GE 25 in. Profile PDW8200J Built-in Dishwasher

Bosch dishwasher model shx36l fails to stop pumping. The drain was clogged. I cleared the drain. Dishasher backed up, water overflowed. Clog has been fixed. Dishwasher will not stop trying to pump water out. There is NO water inside dishwasher. I wish to run another load however unit fails to respond. Pump is operating even when front door to doshwasher is open. Turning the power button to OFF is the only remedy to stop drain pump from operating. How to fix?


... Bosch Integra® 500 SHX46A0 Dishwasher

Our Hotpoint Dishwasher BFI 680 will start up as normal on any program, take in water, heat it up then, we hear a bubbling noise, as though the hot water is just boiling and not being pumped around. Is this the pump? Thing is, the machine will then drain the water, with the pump presumably pushing the water out?


Install new pump kit ... Hotpoint 23 in. BFI68 Built-in Dishwasher

When dishwasher is turned on to the cycle mode - it fills with water - heater heats water to the proper temp - pump starts - washer goes through it's complete cycle - even pumping out the wash water and the drying cycle,then shuts down. the problem is that it does not circulate the wash water thru. the spray heads-even though the circ,pump is running.Even though the unit is 8 yrs.old and hasn't run for 6 yrs,my wife&i do our dishes by hand. our unit is a GU1200XTKB0 Serial# FL4617501


The impeller on the wash pump is worn out or the disposer screen is obstructed. Disassemble as needed to investigate the cause. ... Whirlpool 24 in. GU1200XT Built-in Dishwasher

I have a Blanco BIDW605 dishwasher, which when program selected and door is closed will not run as usual. Scavenge pump activates & water can be heard entering the system however the main pump does not seem to activate. Have tried all the other programs with same result. Checked water input filter & is ok.


... Dishwashers

Hi, I have a Neff S5457XOGB dish washer. The unit is programmed to start - but the pump just keeps empying water, even when the door is open. After approx 5 mins this can stop and thedishwasher enters its normal cycle - however there is no water. I have checked and clean the pump assembly I have filled the base with water - and the pump successfully empties the into the drain I have checked the filter that conects directly to the cold feed. - Any advice please? Many thanks.


... Neff 24 in. S5457X0GB Built-in Dishwasher

Troy-Bilt 2550 20293 pressure washer not producing pressure. Worked when last used 2 months ago. Pump pistons are moving up and down when engine is pulled through. Inlet water is flowing through pump but no pressure when engine is started. I have the same problem. Water flows thru the pump when not running, but no flow or goes in by-pass mode when I start the pump. The pump being Troy Bilt Model 020296-01. I replaced unloader valve even. Anything else I can do?


You replaced the unloaded valve. Are you positive you have the unloader screwed to pressure and not turned the opposite way? You will have no pressure if it is adjusted wrong. One other thing I have encountered is that the unloader has a ball bearing ... Pressure Washers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1667 seconds