Having problems with your Dishwashers ?

I replaced the coil set, but that was not the problem. The ignitor will light the gas flame and it will blow for about 2 minutes, then the gas shuts off. Since replacing the coils, I have not tried the dryer with wet clothes inside. Is this gas shut off normal or do I need another part?


Answers :

The gas flame will cycle on and off in response to the thermostat. Two minutes sounds about right for the dryer to warm up to temperature. The gas will shut off until the temperature cools down and then should cycle on again. Let the dryer run (either with or without clothes inside) and watch to see if the gas cycles on and off. If the gas does not come back on there may be a problem with the thermostat or auto sensor or the exhaust vent duct may be clogged.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I replaced the coil set, but that was not the problem. The ignitor will light the gas flame and it will blow for about 2 minutes, then the gas shuts off. Since replacing the coils, I have not tried the dryer with wet clothes inside. Is this gas shut off normal or do I need another part?


The gas flame will cycle on and off in response to the thermostat. Two minutes sounds about right for the dryer to warm up to temperature. The gas will shut off until the temperature cools down and then should cycle on again. Let the dryer run (ei ... Dishwashers

Washer won't start tried everything , I could think of changed spark plug tried new gas , Two things that bother me are . if i take out the spark plug and put my thumb over the spark plug hole theres no pressure and the wire that comes from the coil to shut off the pw it has continunity from the coil to the pin that sticks up to shut off the pw but it also has continuity from the coil to all parts of motor.


... Pressure Washers

Dryer will not heat when started. All other functions seem to be operating. There seems to be a cycling sound as if it is trying to ignite, but unsure. The vent is clear, the gas line is free of kinks and unobstructed. I have tried different heat selections and nothing has worked. It is about 2 years old. Model # WGD5600SQ0


Http://www.dryerpartsonline.com/686590-Gas-Dryer-Ignitor_p_275.html\015\012\015\012When they fail they won't let the gas flo ... Dishwashers

Constant Failure Bought the unit along with other LG products to furnish new home. Problem 1: After first few loads, noticed that the dishes were always wet, the repairman came and said he would try replacing some kind of sensor and that we should run it on the "Sanitary" cycle. Have done this ever since, but should you have to run on sanitary to prevent your dishes from coming out soaking wet? Problem 2: Noticed the inside of the door on the adjacent cabinet was changing colour, found out throu


Problem #1 solution.  Make sure that you are using a rinse aid.  All dishwashers require a rinse aid to assist in drying the dishes.\015\012\015\012Problem #2 and #3 suggestion.  Possible that the door is either warped or not clo ... LG 24 in. LDS 5811 Built-in Dishwasher

Speed queen gas dryer will not start up. When i try to turn on the dryer it causes the breaker to trip off.


My first thought is the motor start capacitor. This 'kicks' the motor up to speed. If it shorts, the unit will blow the breaker. \015\012\015\012Make sure that the drum turns easily by pulling on the belt. If not, find out why...that' ... Dishwashers

Engine does not start. I ran it about two weeks ago and it worked fine. I took the spark plug out and it was dry. I made sure there was gas in it. I tried some starting fluid by spraying into air intake and it start running for a short time until the starting fluid ran out. I removed the carb bowl and there was gas in it. However the inside of the bowl and the float had brown deposits and looks like rust. So I think the main jet has been clogged up with a particle. How do I clear it? Where do I


Try cleaning the carb with gumout spray and a little compressed air, be careful to reassemble the float and needle valve exactly as you found it. ... Northstar Pressure Washer 3000 PSI

Electrolux ESL6115 integrated dishwasher - for the last few months the tablet (i have tried every brand available with no difference) gets stuck inside the tablet dispenser and then does not dissolve correctly so my dishes remain dirty. the spring does click to release, if you put the tablet in the bottom or wait for the click and then manually flick it out of the dispenser it cleans fine. the inside of the dispenser is wet, drying it makes no difference, i think that the seal may have gone arou


... Dishwashers

My Bosch Classixx Dryer is not condensing into the collection try! can you offer me any assistance please? Regards, Adrian. (wet boxers!!)Sorry can't find the correct product listing in the "What product is it about"?so I just picked anyone!


Hi,\015\012\015\012If its like a bosch tumble dryer i had before there should be a pipe down the back, pull it off at the top and give it a good blow, dont know that this would work, didnt have this problem. But seems logical to think it ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

When the wash is complete the items are still wet and so is the inside of the dish washer have tried different temperatures but same problem have also left washer closed all night after wash has finished but still same problem


Either the heater unit or the dryer fan is faulty.\015\012\015\012Check that you have not been using the Eco wash cycles. \015\012\015\012Also make sure you are using the detergent and rinse-aid recommended in the dishwasher m ... Bosch 24 in. SGS43C02 Classixx Built-in Dishwasher

Put through entire cycle, standing water and dishes still wet, only 1 yr and 3 months old!WHY!!!!!!!!! It also has a musky or bad smell like food in the trash sometimes smells. 500 series 6 cycle stainless steel inside, black 24" in wall. Water is about an inch deep. Have tried it on pots and pans cycle, regular and auto, and have on sani-dry and have spot stuff in it. HELP!!!!!!!!!!


Take the drain hose into a bucket and see if it pumps out.\015\012if it does check for blockages where the hose goes to.\015\012\015\012most likely is a blocked pump, the pump is assesable from in side the sump, you may have to get ... Bosch Evolution 500 SHE45M06UC Built-in Dishwasher

Karcher 2400R I have not used my pressure washer for 6 months. It was left full of gas in the garage. I tried to start it but it would not fire up so I change the gas, oil, and spark plug, took apart the carburator and cleaned it out with carb cleaner. I went ahead and put everything together, pull the cord and wanted to start. While trying to start it after I sprayed starting fluid in the air cleaner I noticed that gas was coming back from the crankcase breather hose into the air filter choking


You have a poor signal to the spark plug usually caused by a rusty fly wheel found underneath the pullcord casing. clean it with releasing ajent such as wd 40. common when not in use for a while. ... Karcher 2500 PSI Pressure Washer

My Kenmore series 70 dryer heats up but takes 3 times on 70 minutes to dry the clothes. After every 70 minute period when i check the clothes i open the dryer and it is like a steam room. It is getting really hot but the clothes aren't getting dry?


Check your dryer venting for obstruction.  Take the vent hose off and run the machine,  If it works with the venting disconnected, It is between your wall and the outside of the house.  If it still has the same problem it is somewhere ... Dishwashers

Briggs and Stratton pressure washer will not start. I have a 6.75 hp pressure washer that is only a year old. when I pull cord it turns over but does not start. I changed plug and checked it, I have spark when pulling. I have 40-50 psi of compression when pulling also. gas was drained and is brand new. it was working fine last time it was used. I have tried starting it without the water line or spray wand hooked up and no difference. After about 10 or 15 pulls, can smell gas when I am trying to


Hello dave, the problem is compression to low,you need 60 to 130 lbs to run engine,check for blown head gasket,or bad rings,or a stuck open valve,hope this helps,, ... Briggs & Stratton Pressure Washers

I have a Knemore model # 16519201 Smartwash dishwasher. Everytime I wash dishes they are still wet. I have tried every setting on the dishwasher and they still finish wet. I have tried to look up this model # and I can't find anything can anyone please help. Thanks.


... Dishwashers

I have an almost brand new husky pressure washer (one of the big ones). It has been a life saver so far. just the other day it shut its self off. its gas powered so of course i checked the gas and oil. then tried to start it back up. but when I try to pull the pull string it wont come out more than about 3 inches. i payed 400$ cash for it to use on the trucks. does anybody know how to fix that? thanks


IT SOUNDS LIKE YOUR FLY WHEEL IS BAD OR NEEDS TO BE ADJUSTED ... Pressure Washers

Maytag gas dryer, gas shuts off after the 1st heat cycle.


As long as your ignitor is heating up enogh. The most likely cause is the valves are not opening. you can usually get just the solenoids on the valve which is much cheaper than the whole valve and easier to replace. Please rate my response. ... Dishwashers

I purchased my KARCHER G2500VH last summer. I used it one time for about an hour. I tried to start it today, seems like its not getting gas. I checked the gasline to make sure gas was flowing. I removed the sparkplug, poured a little gas into the engine through the plug hole. Replaced the plug, pulled the rope and it started for about two seconds. I also poured fresh gas in tank. Cannot get to start.


Have tried to start our BlackMax 2700psi pressure washer, it is not getting gas to the carburetor, what to do? ... Pressure Washers

Clothes come out wet.


... Dishwashers

Do4esnt clean My Bosch SHX33a05 dishwasher has a problem. It fills and drains well but nothing gets clean. It appears as if the arms are not rotating but the inside is wet when I look inside. I have put a bit on catsup on the inside door and even that is on at the end of the cycle. I have opend and clodes the door multiple times during the cycle and bot arms appear to not be rotating. Nothing is blocking them. I have clean the microfilter, the drain screen and open up the impeller to make sure t


... Integra SHX33 Dishwasher

The inside of the dishwasher used to sparkle & clean the dishes very good, now the dishes look dirty & inside looks dull with a white film. I have tried cleaning filters & taking arms offs to check for blockage, making sure the Jet Dry dispenser is properly filled, the hose going to the dishwasher does not appear to be kinked, how would I check inside the dishwasher to see if it's kinked there? Do you have any other suggestions? please help!!!!


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Bosch 23 in. SHU33A Built-In Dishwasher

Hello, We have a Candy Diswater that is just arround 2 years old. When it starts it takes water and then you hear the washer going into loop. It tries to do something els but doesn't seem so. If you open the door you can see water inside but no progress or heating. If you also try to change the program it doesn't change as well. Before it got to this point sometimes we used to unplug the power and tunr it off and then ON and then it works. However, now this procedure is not working an


Quite possibly could be the timer and could also be the main control board as well. Sometimes unpluging it will help for short times but if a serious problem persists it will only be a temp fix... ... Dishwashers

Have bosch she45 that stays wet inside after cycle completes. some of the dishes are wet also, how do I stop this


First of all, Bosch is my Favorite! Secondly, maybe your heated dry button is not on. Are you keeping the door closed until the dishes have had a chance to completely dry? This unit has a system that drys with the walls of the d/w as long as the door ... Dishwashers

Dryer not drying the clothes, runs through whole cycle and clothes are damp. THere is some heat though.


Sounds like the high heat thermostat has gone and should be replaced. ... Dishwashers

Smeg diswasher model numbe4r DF612SDX. Just coming up for two years old, various codes re error messages. E2, E5, E8. We have taken off the front panel where the buttons are - nothing obvious. We have taken the bottom off and tried to locate a reset button, but can't find one. We have cleared all the filters inside and checked the water intake and the filter there. Out of ideas, can anybody else suggest what we can try?


Any signs or sounds on the machine you here when the problem occur? ... Dishwashers

Hello! I have a Frigidaire (made by Electrolux) Gallery Professional Series gas range/electric oven, model #FGF379WJCA (manufactured in 1998). The appliance came with the house we moved into 2 years ago. I have the owner's manual and gone through the book but can't resolve two questions. 1) One of the burners will not light. When I try to turn it on, the other three burners' electrodes will flash, but the 4th one will not. I can light the burner with a lighter, so there is gas coming throu


\012The front controll pannel lights and clock are not on. \012There is power to the unit. \012Is there a reset botton somewhere? ... Electrolux Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0927 seconds