Having problems with your Dishwashers ?

Dish washer leaks water it comes from the inlet water hose, it dose not seal well, I thought about putting tape around the threed


Answers :

Absolutely, you should put teflon tape around the threads. that is a good, quick, and easy way to fix most water leaks. good luck
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dish washer leaks water it comes from the inlet water hose, it dose not seal well, I thought about putting tape around the threed


Absolutely, you should put teflon tape around the threads. that is a good, quick, and easy way to fix most water leaks. good luck ... Dishwashers

Door leak I have a small leak between the bottom of the dishwasher door the lower service panel on the dishwashere. I did replace the seal on the inside bottom of the door along with the other parts that come with the door seal. Could there be a gasket leak around the detergent dispenser or the vent at the top of the inside of the door. I did not check the water lever as was mentioned in a previous question on water level, but the float does move up and down quite freely. Any suggestions as to w


I had my dishwasher leaking alot at the bottom of the doo,r and found out that the steam vent was very cloged with gunk. After taking the vent cover off on the inside of the door and cleaning, then putting the vent cover back on NO MORE leaking. Th ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

Hi ..I have an Excell gas pressure washer model no. Exwgv2121-3 with Faip 2100 psi 2 gpm vertical shaft pump..the problem is that there is water leaking from every weep hole at the bottom of the pump when running. Oddly enough,the pump still puts out significant pressure but less than it should due to the leaking water. What is the most likely cause of this?..is it the high pressure water seal(s)? If so,how do I repair it?


... Pressure Washers

Water leak when the dishwasher is on rinse, it leaks water around the door.. I have replaced the door seal and it still leaks.. any suggestions


Check the gasket seating. It should be uniform.Hope the correct dimension gasket is used! ... Dishwashers

Hi _ We have a Stoves DW616 dishwasher which has started leaking water on filling from around the front door. The BGas engineer replaced the seals around the door with those from a Hygena which he said were the same and it worked fine for a few days and then a further deluge. He has now said there is a seal at the base of the door (just about invisible) and although he got a further Hygena seal this would not fit and he says that as it's obsolete the machine should be written off. Before I 'bin


... Dishwashers

I have a Bosch SGS43A22 Dishwasher approx 8 years old. When I start a cycle it fills, runs for about 15 minutes, then drops out about a litre of water from the bottom of the door, then completes the cycle without any more leaking. I have run the machine with the front panel off and can see that water bypasses the top of the seal and fills the well of the seal then pours out. It only happens the once. The seal is fitted correctly. Any solutions?


After 8 years service the seal may have perished, so you should feel for a crack by stretching the rubber where you noticed the leak. ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

The overflow air drain on top of the sink that is connected to two hoses under the sink is leaking. It leaks out the top onto the counter. I took it abart but am afriad I did not put it back together right. There is a rubber ring that I think must be for sealing and I put it directly on the counter and then screwed down the air valve over this and water s coming out of the air flow valve and all over the counter.


... Miele 24 in. Incognito G843SCVi Built-In Dishwasher

I have water leaking under my dishwasher (probably right in the middle). I put a paper plate underneath to catch the water during the cycle. There seems to be some "soap scum" on the bottom where it is leaking as well.


Hello there Here is several ideas that will help you also (fyi) type in search engine how things work and once it opens just enter dishwasher and it will bring you to the dishwasher section ok?here it is \015\012\015\ ... GE Nautilus 24" Built-in Dishwasher

How do I adjust top drawer height? The seal around top drawer appears to be leaking and there is a lot of dried residue around the top edge of the drawer. Water appears to be leaking from the top.


Not sure if adjusting top drawer height will fix the leak. The only way to fix the drawer seal leak is to take the drawer out and check what is wrong with the seal which is located around the top edge of the cabinet from inside.\015\012\0 ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

My Maytag PDB3600AWX isn't working. The motor hums as if its working but no water is in the tub. I did put a pitcher of water in the tub to see if it would pump out and it does. I don't know what else to check for. We have had lots of problems with this dishwasher, its never washed the dishes well and has flooded my kitchen to the point of having to replace flooring. I thought its was because we had just had new flooring installed and when they put the dishwasher back in the counter the hose was


... Maytag PDB3600A Built-in Dishwasher

I have a haier dishwasher model WQP12 AFM, I've replaced the wash pump motor and drain pump (they had been damaged with water after last repair person didn't put widget around drain hose which split and water accumulated on bottom). It well for about two weeks, then it would not go through it's cycle and I noted water not heating up. Have checked element with meter, thats fine, I replaced timersince it wasn't going through its cycle and that has not changed anything. Any suggustions?? Cheers


... Haier Dishwashers

Have a Kitchenaid Dishwasher, Model KUDJ230Y3, purchased in 1994. Still cleans well and seems to run fine, but has some rust around the soap dispenser, and leaks water from the left front. Wondering i


... Dishwashers

I have a Smeg dishwasher SA660 EB. Still like new . Hardley used but have problems with the timer switch not progressing past 5 and also had the thermostat replaced as a loud bang heard and the machine did not work. Since warranty on repair run out it sounds like water is leaking around the thermostat through onto electrics as loud bang noise heard again . I found the thermostat just pushes up into the rubber seal in the bottom of the dishwasher. I have taken out the rubber seal as this also loo


... Smeg Dishwashers

I have a Kenmore dishwasher 665.17799990. Not enough water was coming in so I thought that I'd check the screen inside the water inlet valve to see if it was clogged. It was. I cleaned it out,but mistakenly opened the wrong part of the valve looking for the screen and took apart the diaphram assembly. Bad mistake. Now I can't get it back together without it leaking like crazy. I can't remember how it was configured to start with. I put it together once,but it wouldn't shut. I can't afford to buy


... Dishwashers

I have a GE dishwasher (GSD4020Y70BB) new in 1996. I replaced the whole motor assembly in 2007, seal was leaking. My dishes are not getting clean now, dried food left on plates, coffee stains in cups not being cleaned. I removed main spray arm, found nothing, turned washer on and plenty of water gushing out. I took the cover off sump all clean. I removed the filter screen in the back, there appears to be a valve with some soft rubber around it. Water gushes out of this, does stop during the cyc


Have you checked the drain pump impeller and drain hose? I am curious if there is a back siphon from the drain hose or the waste outlet at the garbage disposal might be blocked or plugged with food debris.\015\012I wou ... Dishwashers

We have had this dishwasher for approximately 2 years. Dishes do not clean well. For example, I put a mixing bowl in that I just mixed brownie in--and the bowl did not come clean (simply a thick chocolate mix). Glasses do not come clean. They always have a fine residue on the outside (food). My husband just took the (blades) out that spin and dispense water and cleaned them. The water volume seems better now. Still, if I remember correctly, the dishwasher cost around $900. It definitely


Check if the water gets hot . \012\011check if motor spins enough to give pressure water on arms to clean dishes.\012\011clean the filter regulary . ... GE Profile PDW8480JSS Built-in Dishwasher

I have a candy cd622 dishwasher and it leaks !! when the water reaches the bottom of the door it starts to pour out, I have taken the door appart and cleaned all the crud and muck out, the rubber seals around the sides and accross the bottem are not perrished or broken but it still leaks !! please help


... Dishwashers

Leaking dishwasher I have replaced the rubber grommet around the soap dispenser latch and have double checked it for leaks.It is not leaking and I suspect that was never my problem.The water is coming from the lower right hinge area.I do not qualify for the maytag recall.I have never used the rinse aid dispenser but find it peculiar that there is no rubber washer in sight.Could I have a bad door seal? Maytag Model #DWU7402AAB


Hi there, dishwasher leaking might be due to either of these causes, check these:Main tub sealNote… If the main motor of your dishwasher is mounted vertically, beneath the center bottom of the dishwasher, the foll ... Maytag 24 in. DWU7402 Built-in Dishwasher

I have the two drawer model dish-drawer system. In the past the top seal leaked and since has been replaced with a new seal. Worked well for several years after but then the top drawer quit running. So we started to use the bottom drawer. That was fine for awhile althought it would pump waste water into the top drawer. Now neither drawer will work. The bottom drawer starts up and shuts down. I pulled the lower drawer and it is dry.


If your model has got an LCD display are you able to record what shows up on the display when the bottom drawer shuts down. If no display then are you able to note down the LEDs which are on inside the top of the drawer lid. It is likely there is no ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Hi. I have an LG LDF7810 dishwasher. I did a deep clean and ended up taking out a bunch of grease from the seal between the door-bottom and the tub. I even removed the door to get at the grease I thought was trapped back there. Since then it has been leaking water, sometimes a drip and a couple of times a few ounces have gushed out at the end of a fill cycle. Did I remove some factory grease designed to seal the door bottom? If so, what should I replace it with? If not, what else could the


It is possible that while you removed off the grease the water seal/oil seal was also damaged. Once the seal is taken out it can loose the sealing strength which can make it possible to leak.\015\012Hence it will be good to remove the seal and ... LG 24 in. LDF7810 Built-in Dishwasher

My LG dishwasher -LDF7810st has been a huge problem from the beginning. However I will just focus on the current issue. Previously it was leaking and I kept towels under the dishwasher. Then one night there was a deluge of water all over the place. One guy says the seal is bad then another no its the whole seal around the dishwasher is bad. No one seems to know and I dont want to spend $250 to find out. I remember a previous post that said their was a design flaw with a part of this but cannot f


... LG 24 in. LDF7810 Built-in Dishwasher

MDB9600AW leaking from the motor shaft. If you look at it from the underneath, it looks like water is dripping all around the motor. But only if there is enought water in the tub to cover the shaft. If I replace the motor seal, would it solve the problem?


Hi,\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101\012\012\012weratjguidsfiogf ... Maytag MDB9600A Jetclean II Built-in Dishwasher

I have a Hotpoint Super Plus dishwasher 7820. It worked well for a long time. Towards the end of the cycle it leaks a lot of water from the underside of the door, so it seems. I have fitted a new door seal. No success. What may be the cause?


The door seal has to be in a proper position completely around the door (including the bottom area of the door). If not, it will leak. Also, there are two black corner baffles/seals (located in each front corner inside the tub area) that may also b ... Hotpoint Dishwashers

WHEM I START MY IGNIS DISHWASHER IT STARTS TO FILL THEN FROM THE RIGHT HAND CORNER CLEAN WATER STARTS TO LEAK OUT . I LOOKED AT THE DOOR SEALS AND THEY SEEM FINE I HAVE ALSO PUT IN A NEW FLOAT SWITCH AND STILL THE SAME PROBLEM ! COULD IT BE THE INLET VALVE ? HELP THANKS MANDY


It sounds like it overfilling,it may be a preesure switch problem.if you turn the dishwasher off the valve should stop if it doesnt then its the valvle.you may have to try cleaning the sunp under the filter.it may be clogged with sludge stopping the ... Dishwashers

My zanussi dishwasher DE6854 doesnt seem to be heating up .Not been cleaning very well lately put in a dishwasher cleaner .The heat of the water didnt break the seal on the cleaner.


Hi, \012I have an older dishwasher also and recently mywife also complained about it not cleaning right... so me being the man I amtried in vain to clean the things... Bought new spray arms online and installedthem in minutes...now the thing works li ... Zanussi 24 in. DE6850 Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1778 seconds