Having problems with your Dishwashers ?

Whirlpool Quiet Partner II Model # 575-0 Only two of the cycle lights come on ( light and heavy ) and the start light does not work at all. Needless to say the machine doesn't work. Any ideas? By the way, the mother board has just been replaced


Answers :

Check the door switch,see if it has continuity threw the switch,when it is closed.Make sure there is 220 volts going to the machine,the breaker box might have two throws for this 220 circuit,and one on them maybe tripped,or off.
Hi,
\015\012
\015\012Try pressing the following sequence of button and this should reset your panel...
\015\012
\015\012 HEATED DRY, NORMAL, HEATED DRY, NORMAL
\015\012
\015\012This should reset your panel and make your dishwasher to work...
\015\012
\015\012If still you have problem, Often a blinking light is an indication of a stuck (shorted) key.Here is a tech sheet that shows how to test for this.
If a key is stuck the keypad (console) will have to be replaced.
\015\012
\015\012http://www.servicematters.com/docs/wiring/Tech%20Sheet%20-%208535431.pdf
\015\012
\015\012Please leave me comment, if you need further assistance
\015\012Rnj VINODKUMAR
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Whirlpool Quiet Partner II Model # 575-0 Only two of the cycle lights come on ( light and heavy ) and the start light does not work at all. Needless to say the machine doesn't work. Any ideas? By the way, the mother board has just been replaced


Check the door switch,see if it has continuity threw the switch,when it is closed.Make sure there is 220 volts going to the machine,the breaker box might have two throws for this 220 circuit,and one on them maybe tripped,or off. ... Dishwashers

Hi - My Electrolux ESL63010 dishwasher seems to be stuck mid programme. It was part way through a programme when we had a pipe burst. Pipe all sorted now but the dishwasher just makes a noise like it is asking for water but nothing happens. When you open the door, it makes three short beeps and the light flashes on the programme menu. Any ideas how to solve? It definitely is not the pipes as the washing machine feeds from the same pipe and is working fine. Help!


... Dishwashers

Hi there, The error code 'strong and economy light flicker fleetly' is showing. the manual says that this means too much inlet water. We have drained the machine, cleaned waste pipe and tried to operate with a reduced flow from the inlet pipe but it's still not working. I filled the base of the dishwasher with water to see if it drains properly. It seems to be draining, but also leaking out of the base as well..? Any ideas?.


Hi The issue seems to be with the float switch assembly that is bad and should be replaced. Float assembly is found inside the dishwasher's tub, on the bottom. The water that ... Baumatic Dishwashers

Frigidaire dishwasher can't get to work I have a little "lock" light on rinse hold that says 3 seconds and I can't get my machine to turn on? Any idea...


When my wife got home, she told me where she put the manual. After reading it, all you have to do is press the rinse button for 3 seconds and the lock light will go off. I am not going to take off any electrical panel. ... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

Flashing light The 3rd light to the right keeps flashing. I cannot cancel the programme or move the indicator light to any other setting. When I close the door the machine does not come on, just the light keeps flashing. Any idea what the problem can be? There is no water in the machine and doesnt appear to be any blockage in the outlet pipe.


... Smeg 24 in. DWI612 Built-in Dishwasher

FDW60 dishwasher - taken apart pump and that is clear. Seems that dishwasher fills, and empties and heats all OK but water wont go around the machine ie the motor pump doesnt start - any idea how to take this out and replace without having engineer around? Taken small pump apart and its clear. First of all the Eco and fast light flashed, then we took it apart with some direction from online discussion advice. Now Eco and Pre wash lights are flashing. Machine empties water, then fills with


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

My AEG Favourit F35080vl is behaving strangely. When turned on, the lights don't light and it doesn't work, but it emits a ticking noise! After an hour or so it works (until yesterday), and is ok, unless turned off. It was inadvertently turned off at the weekend, and now ticks whenever turned on and refuses to behave normally again. We got a local repair man out who replaced the logic board at a considerable cost, and it has made no difference. He says he doesn't know what to do next! Any ideas?


Try another repaiman one who does know ... AEG 18 in. Favorit 54750Vi Slim-Line Built-in Dishwasher

Hi there, I have a De Dietrich DVH610JU1 dishwasher, which has stopped working. Each time i try and set a program the machines makes noise as if its working but then stops with the 'End' light flashing blue very quickly and the 'Normal' program light lit up red. Any ideas? Regards Rosemarie


... De Dietrich 18 in. VW7451 Built-in Dishwasher

I have a Whirlpool ADF951, it has power to it and was working fine, the power light is on and the green light to the far right of the cycle lights is flashing, I can only get any response if I hold the start button in for about 10-15 seconds, The machine stops the light flashing and makes the noise like it is starting , that goes for about 20 secs then returns to the flashing light stage, any idea's please


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If the light flashes, pauses, and then repeats. When\015\012the dishwasher doesn't sense a water tempera ... Dishwashers

The dishwasher stop during the wash cycle. It did finish draining the water from the tub. The machine is not showing a power signs, I check the circuit breaker and the fuse is not tripped. I open and closed the door and the door latch seems to be working fine. There is just no power to the washer. Usually when a machine breaks down, there still is power or buttons that light up on the front of the machine. I looked on the internet and many say that the fuse could be tripped. No where can I find


... Whirlpool DU912 Dishwasher

Jackson jp-24b purchased this machine used, cant figure out how to work it. I flip the auto cycle on, and then the power switch. The fill light turns green and i assume water is filling up in the machine. In the meantime there are two small red external hoses that hot water comes and i currently just have those hanging in the sink. At the same time, nothing is happening during the wash cycle, the wash gauge doesnt even move only the rinse gauge. Also when i try to drain it nothing happends (begi


It needs a new drain relay box 120 volt the drain is stuck open the jp 24 were not very good machines the red lines are drain lines if you plug up the drian lines at fillup the machine will wash but now it will never drain a new drain box is not c ... Jackson JP-24B Built-in Dishwasher

Electrolux ESL 63010 dishwasher. This worked fine until the door catch broke. I replaced the catch but could not remember which way round the two electrical leads went (red and black). I tried both ways with the same result. The lights come on the control panel and I can change the programme, but on closing the door the house fuses blow. I have checked the earth cable is fine. Any ideas?


Red - is active powerblack - ground or neutral ... Electrolux Dishwashers

Kitchen circut was accidently turned off. Now whirlpool gold disher will not work(unit was not running and the door was not closed all the way when circuit was turned off, All circuit breakers are on) There are no lights on display when door is closed completely, and it appears to have no power. Worked fine prior, what could it be? The unit has not been removed from under the counter yet. Is there a fuse or circuit breaker on the unit? If so where is it located? Other troubleshooting ideas


Hello- Turn power off. Remove kick panel and cover for power wires. Check connections. If these are ok, most likely suspect is a fuse at the control. This is a little harder to get to. Remove inside door panel screws. Unplug wires and remove panel. F ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

Won't work When i turn the machine on the on/off button lights up but the program lights don't, any ideas??


I hant not seen this unit but what it sounds like to me is the control bord that controls the functions on the washer may be bad. you should try and find if there is a tech sheet somewhere in the cabinet or under the dishwasher. that will help you to ... Zanussi 24 in. DE6744 Free-Standing Dishwasher

My LG 24 in LDS 5811 ww quite working in the middle of a cycle. I have power to the machine, but no lights come on, nothing works. I turned off the power and removed the front pannel. The large brown wire and large orange wire that are plugged into the back of the control panel start to smoke. So does the large black wire and the large white wire. Any ideas, is this the heater or is the panel bad?


The unit will need a new Wire harness, Pump/motor assy, Main Pcb and inner door liner.\015\012Contact LG @ 1800 243-0000 they may help you out. ... LG 24 in. LDS 5811 Built-in Dishwasher

Miele dishwasher manual turbo thermic inlet/ drain light is on and the machine wont work, any ideas?


I believe the drian is clogged ... Miele 24 in. G656SCi Plus SS Built-in Dishwasher

My kitchenaid dishwasher is not working properly. The light above the button that says "Rinse Only" is flashing and there is no way to stop it or turn the dishwasher on. How can I fix it?


... KitchenAid KUDI01TBK Dishwasher

I have a GE quietpower 3 and I cant get the door to shut. There is a green light on that says clean. There are no dishes or anything in the way of the door. I have no idea what is going on and I really do not want to phone my landlord. Please help!


The door latch is probably in the shut position. you need to move it to the open postion. ... Dishwashers

Countdown display is flashing saying 2:10 but dishwasher does not respond to pushing any of the buttons (light stays on Power Scrub and does not respond to selecting other wash cycles). On'Off button works but none of the other buttons responds. Machine does not begin washing when door is closed


... Bosch SHE6AP0 Builtin Dishwasher

I have a Miele Turbothermic dishwasher which is nearly 3 years old. The Inlet/Drain (red) light is flickering and the washing cycle was not completed. I cleared the strainer but have not been able to clear the the dirty, stagnant water. I tried re-starting it with everything out of the washer but nothing has changed. Is there a way to clear the water and get this machine working again? Many thanks. Loretta


Please provide the full model number of the Miele dishwasher.\015\012\015\012Have you checked that there is no blockage in the kitchen drain especially if you use insinkerator (disposer unit) in the sink. ... Miele Dishwashers

New SHE4AM16UC, professionally installed eight months ago. Worked fine with very light usage until now. Dishwasher starts normally but stops and signals "clean" after less than five minutes on any cycle. One inch of water in bottom that (I think) drains when a new cycle starts. Soap tablets are not ejected from compartment. Bosch authorized repairman says he now has two client dishwashers with identical symptoms and is asking Bosch support for ideas (he's changed pump, control unit, and float sw


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. If the clean light flashes, pauses, and then repeats.\015\012When the dishwasher doesn't sense a water t ... Bosch SHE4AM16UC 24 in. Built-in Dishwasher

Cookworks wqp8-9239 slimline dishwasher. Start the cycle on setting 1-4 and half to three quarters of the way through it stops and starts beeping with the first 3 buttons of the control panel flashing. The manual says when lights begin to glimmer the machine is out of order? can i ficks this without sending for repair man?


... Dishwashers

Dishwasher faulty I have a ge dishwasher model ghd6310l15ss. Half way through the wash cycle the water stopped coming into the machine. The float seems to be working fine. Any ideas?


Hi\015\012\015\012\015\012\015\012Thanks for using FixYa. It seems that the float switch is about to go bad as\015\012switching it off and then turning the dishwasher back on is resetting it. The float ... GE Dishwashers

I have a dishlex global 300 and I had to take the door lining off a few questions first where does the r8 wire connect to and when I turn it on the eco rinse and super lights are on and the machine does not work aqny ideas


This can happen due to multiple reasons:\015\012check the following:\015\012Check If�Heater circuit problem:♦ Open heater.♦ Wire disconnected, open connection or component in heater c ... Dishwashers

The electronic panel on the top of the door doesnt light up anymore and is unresponsive, when the power is turned on, the machine makes a sound like its running or draining or something, but nothing is happening. This all started after a potential electrical disruption following a power outage. Perhaps there is a fuse or some relatively easy way to fix this? or am I screwed and should just call a repair man. Thanks for your suggestions, Brodie


... Bosch 24 in. SHX56B05 Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1097 seconds