Having problems with your Dishwashers ?

Door catch Door closes but latch inside door panel does not lock in place so door will not remain closed. Appears that plastic part in door catch recess will rotate but is not under any spring pressure and will not lock in place.


Answers :

Hi.

Usually the spring is not sold as a single part.

You will need to replace the door lock.

Regards.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Door catch Door closes but latch inside door panel does not lock in place so door will not remain closed. Appears that plastic part in door catch recess will rotate but is not under any spring pressure and will not lock in place.


Hi.Usually the spring is not sold as a single part.You will need to replace the door lock.Regards. ... Dishwashers

I have a Frigidaire dishwasher, FDB-1100RHC, that is not cleaning dishes. My fiance cleaned the trap at the bottom of the washer, removing both the small basket and the larger mesh grid. After replacing both, the washer doesn't seem to have enough water pressure to spin the lower and/or upper arms. If I interrupt a cycle and open the door, water is dribbling out of the upper arms, but they are not rotating and do not move from whatever position you place them in. Both arms are completely uno


Hello :)don't feel bad, I run into this kind of problem at least once a week.\015\012It does sound like the pressure isn't there so you're not getting water to the upper spray arm. What you need to do is take the pump apart, which i ... Frigidaire Dishwashers

I have a Bosch SHU8805UC/14 dishwasher. I took the front door panel off to install it better but ended up with two extra pieces that look like either part 935400 Door Guard, or 935526 Support. I cannot seem to find any place on the inside of the door where these pieces would fit. The dishwasher works fine but seems like it got noisier after I put it back together without these two parts. Can you help me locate the proper place for these 2 plastic parts?


Hello, \015\012\015\012Welcome to FixYa.\015\012\015\012I believe the parts you are referring to are likely the blocks in each corner of the outer door panel. These have been a sticking point for many I tech over ... Bosch Dishwashers

I have a 13-year-old Maytag DWU9906BAE. It has worked well but the door now opens too far - about 20 degrees lower than horizontal. I've taken the door apart and the reason is that the upright part of the two L-shaped hinge plates no longer catch on the back of the door jamb; for some reason they are now angled too far out and miss the catch plate on the back of the jamb completely. I'm no expert but they don't look warped, nor does the frame that they attach to. They're made of stamped


... Maytag Dishwashers

Whirlpool DU927QWDG1 Hi, The problem I'm having with my dishwasher pertains to the door cover for the area I place the soap. There is a small spring which helps the door pop open to release the soap when washing. I cant figure out how to place the spring so that the pops open.....right now when I run the unit the door stays latched and the soap doesn't get dispensed. Any ideas on how to repair this or where I could maybe get a parts manual??? Your expertise will be greatly appreciated!!!!


... Whirlpool GU2400XTP Built-in Dishwasher

Indesit d63 dishwasher, door locked shut. took top off+got to latch, the plastic catch wouldn't pull out of the latch. undid it all, all seems unbroken but cannot seem to arrange the latch so that it will allow the plastic catch to come out when levered. also not sure if the handle is supposed to click the switch to another position, or just tweak the switch as it opens the door. is a new latch supplied with the switch ?


Check with whoever you order the latch from, usually parts are individual for electrical parts and never assume that the screw or washer will come with new one, save every piece. ... Indesit 24 in. D63 Free-standing Dishwasher

Part of the locking mechinism will not let me lock the door? It is a straight latch that seems to not let the door close flush...????


Hi,If you look into the slot in the door, is the catch in the locked position?This can happen sometimes and when it does the latch cannot go any further in. If you find this has happened.Unp ... GE Nautilus 24" Built-in Dishwasher

Bosch Dishwasher I have a stainless steel Bosch dishwasher, I made the "mistake" to try to see if I could fix the jammed handle from the door. Unfortunately, (did not realize the top panel comes off without opening the entire door). I removed the screws from the door frame (Inside panel), and the door springs/latched got loose. I would like to put it back together, but I dont have any diagrams on the door to make sure all parts are in place to put the door back together. I have been havin


Hi ED,\015\012\015\012It sounds like a real problem here. If the springs are still in one piece, my best guess is to to remove the springs from the door. Then attach the springs to the dishwasher body first, then reattach the spring to the door. Not ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

Door latch I have this model and the door latch is not working....have hard time opening it now. How do you remove the tope part of the door that contains that latch so I can put in back in place????


The latch is fairly simple to replace. There are several screws around the inside of the door that hold the inside panel in place. You then will be able to slide the panel out of the way (it is attached by wires).You will then be able to ... Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher

Door interlock appears faulty on my whirlpool awm 321 . It wont allow program start when door closes . Needs a lot of coaxing , banging with palm of hand , knee etc .Door itself appears fine , catch looks ok , finishes and runs ok once we finaly get it started .Hve tried pressing the interlock slider in with a pencil , but cannot succeed in pushing the contacts into place and starting the program . HELP PLEASE


Only solution is to replace the interlock - it is just held in by 2 screws ... Dishwashers

When we open the dishwasher door, it produces a very loud metalicsqueeking sound- like something is rubbing or binding. The door is not catching on anything externally, and there doesn't seem to be resistance to opening or closing. I have lubricated all the external parts- pully, cable, etc, with silicon spray, but the sound continues. It is difficult to pinpoint the exact location- obviously at the bottom of door. What must I do to correct the squeeky noise? Thanks for your help!


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

The door lock has broken and won't open after washing. I see that I can get spares but it's a question of what's needed. Do I just need the lock mechanism or will I need any electrics too e.g. microswitches? If so where's the best place to get them?


You can go to sears partsdirect and they will take your model# and you will be able to see all the parts for your unit.then if you like you can order them direct from them. if this helps please help me by sending a 4 thumbs up post.Thanks! ... Dishwashers

We have Bosch SMS63M08AU - door won't close, child lock is not activated, seems that the little male part at top won't click into female component on door.


... Bosch Dishwashers

Hi there I have a Bosch SGV4313GB/17 Dishwasher the problem is there insuffient water pressure to feed the washer arm and they are not rotating Ihave cleaned the arms and circulation pump impeller with white vinegar ,I have also overriden the door switch and operated the dishwasher with arms removed and the circulation pump seem to be working but with insuffient pressure also the machine does not fill to the depth it did when it was fine! How does one tell if it is the impeller or the


Ours is a SHU3300UC/06 model, basic model which we bought in 1999 so have had 9 years of trouble free service.Recently\015\012we noticed that there was soap left in the soap dispenser after the\015\012machine had finished all the cycles. On fu ... Dishwashers

We have a Whirlpool mod# DU1055XTVD0 dishwasher .. the blue latch designed to keep the lid to the detergent dispenser closed after filling has come loose from the inside door panel and now will not stay in place to keep the detergent lid shut. We did find a small o-ring in the bottom of the tub that apparently is part of what helps maybe hold this latch in place, but obviously there must be something else that fits inside the hole the latch goes in that keeps it secure. This


... Whirlpool Dishwashers

Kudc10fxss4 I have a KitchenAid KUDC10FXSS4 w/o any power. Circuit breaker is on, and it's getting power. But there are no lights on the display. I called a parts place to see if I could order a thermal cut off fuse. But the representative stated there is no fuse listed for this model. Any ideas on what would be causing a loss of power? Seems odd/wrong to me that there wouldn't be a fuse. If there is a fuse, would it be located in the door (the control is built into the door, such


... KitchenAid Dishwashers

The silverware basket is on the door. there is a blue plastic latch that "locks" the door in place (pushes a wire rod down). the plastic latch came off. doesn't look broken. cannot get back on. Silverware Basket Item #1060509


... Whirlpool DU1301XTV Builtin Dishwasher

My Equator door hinge broke to. Where can I get parts for the little PLS602S? I ordered a door for it once before about six years ago. But do not still have the information on the place where I ordered it.


... Equator 20 in. PLS602 Free-Standing Dishwasher

I have an Indesit D63 and would like to know where I can buy the "catch" that fits in the top side of the door: A tenant removed this part and just left two screws so I do not know the part No. or what it looks like. I live near Gerona, Cataluna. PS the tenant did a bunk !!


Please refer this manual. It might be helpful if you can lead me to the part if it is visible in the illustrations o ... Indesit 24 in. D63 Free-standing Dishwasher

I have a KitchenAid diswasher Model KUDSO1FLWH1. Problem: When Iopen the door, it falls down. It does not feel like there are any springs holding it in place any more. My wife opened it tonight and the door fell on her foot..hard. Can this be repaired...if so, do you know the part number and where I can purchase it on-line? Thank you, Bill


Hi,\015\012Go to this page and look down part way for the door spring... that is what probably broke.. ... KitchenAid KUDM01FK Dishwasher

I have a Maytag dishwasher, model #MDB4100AQ. Is it possible to replace the door panel on this dishwasher? I see the relevant part number (99002109) in various online parts stores, but before I order it I want to make sure this is a do-it-yourself job. I can't see any screws or other hardware that's holding the panel in place.


You may not have to deal with the screws. Check out ApplianceArt.com to see if they might have a solution to fit your needs. I know they have stainlesss options, but also colors and designs. ... Maytag Dishwasher

I have a Philco dishwasher Svelta DWN17 which works well but has lost its spring or counterweight for the door. The door now drops open when not locked for washing. I am having difficulty finding a servicing firm for this machine and would try to fix it myself if I could find a part and get some details on how to go about it. Can you help, please? Alan Wright


... Dishwashers

Dishwasher will not start cycle it is locked and will not unlock. door panel suggestion says press and hold energy saver dry pad x3 seconds that is not an option on this model. what can we do.... the numbers 8573025 and the other is 8573030 the numbers on the door we also have additional numbers from our user manual that is part no 8269551


... KitchenAid Dishwashers

The door will not lock securely. The latch is not catching.


... KitchenAid 24 in. KUDS02FRSS Stainless Steel Built-in Dishwasher

SGV53EO3GB BOSCH DISHWASHER DOOR WON'T CLOSE AS CATCH NOT LOCKING


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1466 seconds