Having problems with your Dishwashers ?

Spots on glassware remain after washing. Henry


Answers :

Do you use rinse aid? If you do check to see if it is being dispensed. Fill it up and monitor it's level after a few washes. If it's not then it's likely the switch that opens valve. Once you have the inner door cover off it's pretty self explanatory.
Also pay attention to the heat coming out of the dishwasher once you open the door. It should be hot when its finished its cycle...steamy hot. If its not then you have a heating problem, best to hire someone for that. Hope this helps.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Spots on glassware remain after washing. Henry


Do you use rinse aid? If you do check to see if it is being dispensed. Fill it up and monitor it's level after a few washes. If it's not then it's likely the switch that opens valve. Once you have the inner door cover off it's pretty self explana ... Dishwashers

Poor cleaning Hi, This dishwasher is 1 year old and, until recently, has been cleaning well. Now, the dishes come out spotted and bits of food remain. Wash arms rotate freely. I have tried both liquid and powdered soap. Unit sounds like it is running normally. Water is hot and of normal flow rate. Are there any strainers to clean? Any other suggestions.


The problem is hard water. www.dishwasherfilter.com has a\012product to solve this problem once and for all. It filters the water going into\012your dishwasher and remov ... Whirlpool 24 in. GU3200XTP Built-in Dishwasher

Hello, My GE Spacesaver dishwasher is not getting dishes and especially glassware clean. Often, detergent is left behind after the wash cycle is done. Also, the central wand often remains up causing accidents when pulling our the lower rack. Should I repair or replace? Martin Healy


The problem is hard water. www.dishwasherfilter.com has a\012product to solve this problem once and for all. It filters the water going into\012your dishwasher and remov ... Dishwashers

I have an INDESIT LS12-EVO3 dishwasher and the "rince aid indicator light" doesn't come on no matter how many washing cycles we have done. Also as I have noticed there is hardly any consumption of rince aid liquid. The level almost remains the same in the dispenser. At the same time I have not noticed any water spots on the plates, etc. Can you help me in this?


... Indesit 24 in. D63 Free-standing Dishwasher

What temperature? the machine we have looks the same but the model no. is LS9P. the PNC is 9CGX50502214. what we need to know is on what temperature this machine washed the dishes on and what is the ideal temperature to wash cutlery as to insure no oil remains on them. after washing, our cutlery (forks and Knifes) remain to be somehow sliperry and oil traces can be felt. thank you and kind regards


About 140 degrees for proper cleaning and disinfection ... Zanussi 29 in. LS14 Free-standing Dishwasher

Problem - water remains inside dishwasher.......about 9 mins before any wash programme ends, washing machine shows E4 and bleeps......water remains inside, dishes clean but slimy. cleaned filters, hose checked, dishwasher cleaner used....still problem exists


... Haier ESD310 24 in. Dishwasher

Spotting glasses and silverware after washing the stains do not come off when washed by hand. Just started to happen. tried cascade then jetdry both do not clean glasses. the 12 holes in the wash arms are clear and the only lower arm does move. i have a Mod. # is DU84 CWDB4 s/s# FF4417254 Help


... Whirlpool Dishwashers

Defy dishmaid dishwasher does not start wash cycle. Several attempts to reset dishwasher has been done. Machine has been unplugged for several days and switched on again and still does not work. The start/stop switch have been kept in for about 5 - 10 seconds to reset. When the machine is set to do washing, the water enters the machine and wash light shows green and machine remains like that with water inside the machine. The start/stop button is again pressed for 5 -10 seconds to drain the wate


... Dishwashers

Replaced circuit board on my kenmore 665.13742k603 dishwasher,still all wash buttons,and start button will do nothing.ran test using sani rinse and heated dry buttons all lights come on but washing light does not,all lights remain on after test,unplugged,plugged back in,,still no wash buttons or start buttons work,can you help?


... Dishwashers

Haier hdw101wh.The dishwasher starts when you turn the dial the pump discharges waterto the outlet it clicks to next cycle but remains washing will not cycle through the wash cycle it keeps on washing . You have to turn it manually to get it finished any info will be appreciated.


... Haier Dishwashers

Hello, My Ariston LSI 68 A dishwater have a problem: During the washing in reduct mode,(the 3rd program from left) after about 1 hr , he does'n end the washing and blinking the second light from left. (the normal washing program). In the dishwater still remain about 1 inch of hot water, the drying never start. If you can send me the blinks codes of my dishwater i appreciate very much. Thanks Leonardo Italy


The Ariston dishwasher alarms should be in the user manual. However, I cannot find the manual for your model. \015\012\015\012But I have found ... Dishwashers

Hi, I have a Siemens SE24A230GB/17 dishwasher and it is not completing the wash cycle (any selected). It appears to be stuck on the 'wash' part of the program. I have done the reset actions as advised in the User Manual and tried another program, without success. I have found that the possible causes could be the timer or thermostat. The estimated time remaining display counts down, but the program does not complete the wash and move onto rinse and dry. Any help or advice you can provide would


... Siemens Dishwashers

When starting a wash cycle it pumps out the remaining water as usual. It fills normally but does not pump/wash the dishes. It continues to heat and when first noticed it seemed to have gone through the complete cycle but didn't wash. The detergent door had opened and the soap pack dropped out but it never dissolved. The dishes were extremely hot too. Is the same pump used to both drain the washer and wash the dishes?


Hi,\012Here is a tip that I wrote that will help you with your dishwasher not draining problem...Dishwasher Problems - ... Asko 24 in. 1805 Built-in Dishwasher

Kenmore dishwasher 16934 will not start up for me. I can push any button to set the cycle(pots & pans, china gentle, quick rinse, normal wash) and the time shows up in the display, but when I push the start, two red horizontal lines appear in the time remaining display. Cannot get the machine to start anything. All cycle buttons give me some kind of time remaining display but as I said, it ends up with 2 red lines. Thanks in advance. Mark


... Kenmore 24 in. 16934 Built-in Dishwasher

I have an SKT51 series (silver edition) Bosch free-standing dishwasher. The problem is that a few days ago, when the washing was over and I started emtpying the dishwasger I found in the dishwasher a grey plastic part with the number 5603000027 on it. Obviously, it got loose from somewhere, but I cannot find where it was. The washing quality since then is definitely lower, food remaining on the dishes, which are not properly dried. What could be wrong?


Hello. The best way to find that part is to get your model number. If you are not sure where to look for it go to this link\015\012\015\012 ... Bosch Dishwashers

Water is not draining completely from the dishwasher. About 1-2 inches remain in the bottom. Seems to drain most of the water during the wash cycle, but a bit remains. Thoughts on how to fix this?


Either the check valve on the end of the drain hose that connects to the drainpump motor is closed shut or sometin is clogged inside the drain hose..... also maybe you pump motor assmbly is faulty... u prob need wet/dryshop vac and drain it out from ... Kenmore PRO 24 in BuiltIn Dishwasher with Ultra Wash HE Filtration 13173

Kenmore elite dishwasher, 2003, won't count down during wash cycle past around 80, and just continues to wash (on any setting), and sensing light remains on - reset didn't help.


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. If the cycle doesn't\015\012complete, then the first thing ... Kenmore Dishwashers

After wash cycle a film remains on the utensils, glasses, and dishware. We have a Whirlpool Gold Quiet Powerwith AccuWash Sensor with seven wash cycles and a delay timer.


\015\012Dishes not cleaned properly....\015\012\015\012\015\012\015\012Check the water temperature. Should be 125 to 140 F.\015\012\015\012Check pump re-circulation. ... Whirlpool Dishwashers

Hi, in my Whirlpool dishwasher series 280-0, the dish-washing powder is not used, as it fully remains in the dish-washing box inside the door of the washer.


... Dishwashers

We have a Whirlpool Gold Quiet Partner IV model#GU1500XTKQ0,the normal wash cycle starts buts just goes into hang mode @ 76min remaining and just continues to wash, is it the control panel or the timer circuit board, all lights seem to work on the control panel


I replaced the heater element on mine and that fixed the problem. ... Whirlpool 24 in. GU1500XTLS Stainless Steel Built-in Dishwasher

My 3-yr old GE Profile dishwasher lost power soon after initiating wash cycle. Checked braker switch...fine. Checked outlet power...fine. Dishwasher power mysteriously came back on approximately 12 hours later. Initiated another wash cycle and lost power again after a few minutes. Water remains in bottom of tub. What's wrong????


First thing i would check is the actual wiring behind the toes kick\015\012you will seea wire box, shut the breaker off, open up the box and double check all your connections there,\015\012 the next step would be to check the voltage ac ... GE 24 in. Profile PDW8280JSS Built-in Dishwasher

The water is not draining out of the bottom during a wash. when the wash is done 2 inches of remain in the bottom. I tried the drain button on the dishwasher and nothing happened.


HI. check the following areas for faults.1. Air gap / Drain hosesIf there is an air gap (located in the sink, near the faucet), check to see if it is clogged. Unscrew the top cap and see if there is anything blocking inside. Note: I ... Dishwashers

Our Whirlpool ADP 6515 has a delay button. When the button is pressed and activated for a 3 hour, 6 hour or 9 hour delay, if we change our minds and want to wash immediately, we cannot disable the button!! How can we deactivate the delay setting to wash immediately? We have pushed the delay button over and over to turn it off but it will remain on the 9 hour delay setting. We are very frustrated. Please help.


Try switching the power off at the wall switch for a minute, then switch back on, to clear the memory. ... Whirlpool Dishwashers

AEG Favorit 80820 dishwasher tablet door opens as soon as switched on and door closed. When you put the power on and select a wash and then close the door the small grey dishwasher tablet inside the door can be heard to open as soon as the door is closed. Normally this door remains closed until asked to opened automatically by the dishwasher at the correct point in the selected wash program.


... AEG 24 in. Favorit 80820 Free-standing Dishwasher

The dishes come out dirtier after they're "washed"! The soap leaves a filmy residue and I have to re-wash all the dishes. I've tried liquid Cascade, the Finish tablets, and putting Jet Dry rinse aid in the allotted spot. Help!


Take out the botton dish rack and check the drain. Most likely there is a screen that is supposed to catch big debris and keep it from entering the drain. It's probably got a lot of gunck in it. Take the screen out and clean it and check under the sc ... Frigidaire 24 in. PLD2850 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1028 seconds