Having problems with your Dishwashers ?

Dryer tumbles but does not heat. We replaced the heating element, thermal fuse and the circuit breakers are okay.. why is it still not heating. Is it the controller? The dryer is a Kenmore and the model number is 96374200.


Answers :

Is the blower working and is lint chute cleaned out in the back of dryer?
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dryer tumbles but does not heat. We replaced the heating element, thermal fuse and the circuit breakers are okay.. why is it still not heating. Is it the controller? The dryer is a Kenmore and the model number is 96374200.


Is the blower working and is lint chute cleaned out in the back of dryer? ... Dishwashers

No heat . kenmore elite dryer. just had whole house vents and dryer vents cleaned to see if it would fix problem . still no heat.


Making sure the dryer exhaust vent ducting is clean is a major plus. However, if the dryer runs, but still does not heat, the following link may give you some advice on what to look for: ... Dishwashers

We have a kenmore ultra wash dishwasher. i am unsure of the model number. i believe it was bought in 2001. the NO HEAT DRY button was blinking, so we replace some panel under the door. now the QUICK RINCE light is blinking. i tried the sequesce of WATER HEAT, NO HEAT DR, WATER HEAT, NO HEAT DRY, but that did not help. any other suggestions?? we have a family of 4, and it STINKS not having a dishwasher! litterally sometimes : )


... Kenmore 15129 Built-in Dishwasher

Dishwasher: Kenmore ultra wash sensor quiet guard plus. I'm in a rental so I don't have the manual or model number. A few days ago it just wouldn't start the wash cycle. When you press normal wash then start the no heat dry and lock lights flash every other second or so but nothing happens. I can hit the cancel button and it will make sounds like its trying to drain, and after about 5 minutes stops. I've done the heated wash/ no heat dry sequence to try to reset but no luck. Also tried turn


... Kenmore Dishwashers

My Kenmore model 665.16022401 has the problem w/ the clean light flashing. I tried the bottom combo of hi temp wash, heated dry, high temp wash, heated dry and it re-set my dishwasher but then after I tried to run a new load it doesn't seem like it finishes all the way through because there is still soap left in the soap dispenser and the dishes arn't all clean, plus the green clean light begins flashing again. Don't know what to do.


... Kenmore 24 in. 16022 Built-in Dishwasher

Sir, I have a Kenmore Dishwasher, model 363.14455690. The dishes when dry still come out slightly wet; most everything still has to be wiped dry. Can I increase the heat some how??


It is a comination of fully fully rinse agent compartment and hot water. the rinse agent helps with the drying and the steam from the hot water is the finisher . check that first .i this helps you then help me by sending me a 4 thumbs up post. thank ... Kenmore Dishwashers

I have a kenmore dishwasher model #655.1374 or 655.1384 which is only about a year old. I am having a problem with the controls. It will not allow me to use smartwash. The only control that can be used is quick rinse. I reset it by pushing Sani rinse and heated dry. All the lights come on and it seems to do a test. But after that still the same thing except if I push start resume it goes to normal wash which stays on a long time and periodically the cancel drain light comes on as well as the 4


... Dishwashers

I have the Kenmore Dishwasher model number 587.1525 which is not starting as well as the Dry Heat indicator green light is ALWAYS ON !!! WHY is this ??? Should we call for a technician or you can help us solve this problem without him coming out ??? Reply could be send to my email as well as my physical address : Jennifer Cao 7442 Hazeltine Ave 303 Van Nuys CA 91405


... Kenmore Dishwashers

I have a Kenmore Type 575-0 Dishwasher, model number 665.16033401, Style 16033. It runs trough the cycle, once the cycle is complete the clean mode light is on but most dishes are still dirty. I had someone here to repair this about a year ago. All he did was press alternating two buttons, which I have tried, it resets and lets you start a new cycle. However, the problem remains. Last time there was only button pressing involved, no need to replace anything. So, I would hate to have to pay ag


You need an electronic control and heating element ... Dishwashers

I have a power washer, craftsman &.0 horsepower, 2900 psi, 2.3 GPM model number 580.752410. i was starter to wash my car, and stops? i change the spark plug, andput new oil in there. still do not working. some one helme in this problem.


... Craftsman 3000 PSI 27 GPM Briggs Stratton Powered Pressure Washer

I have a Kenmore dishwasher model 66574362K2. It has worked fine until tonight. I opened the door before the end of a cycle, closed the door, and pushed the cancel drain button. There was still water in the bottom but the dishes were basicly finished. Now I can not seem to get the dishwasher to come back on. The lock button seems to be on and it usually is not on. The manual says to push and hold the button for 4 seconds to turn it off. I did that. But now it is flashing between the Heate


Can you press the drain button to drain the water, then shut the unit off and restart??? I have exhausted all my resources to help, thought this may work. ... Kenmore Dishwashers

Kenmore dishwasher model 363.1410691, approximately 18 yrs old... Wash cycle was on, unlocked and opened door to add silverware, shut and locked the door, but water did not (and will not) come back on. Appears heating element and timer still works...any ideas?


Check your water valve. if know water goes in normally that is the culprit. disconnect the wires and ohms it out with a ohms it out. if this works then you can help me by sending me a 4 thumbs up post thanks! ... Kenmore Dishwashers

My kenmore dishwasher isnt changing cycles just washing over n over. model# 587.15173400 put new heat sensor but still not changing


... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

The water does not run into the dishwasher, though the heating element works, and it goes through the cycle. The dishes are not getting washed. Also the ON light is not working. model number Kenmore 6651676569.


Hi,Here is a tip the will elaborate on your problem more, but the bottom line is that you need to replace that fill valve...Dishwasher ... Dishwashers

I have a Kenmore Elite dishwasher, model number: 665.17263. The clean green light is blinking and unit work work. I had this problem before and the service guy showed me how to press the buttons in a certain sequence which fixed the problem. It was the heating element.


All I had to do was to press the heatdry and normal wash buttons until all the lights went on. This happened before...Gingko was fantastic!! ... Dishwashers

I have a Kenmore Elite, model number 665.17263. The clean button green light is flashing. This happened once before and it was the heating element. The service guy showed me how to put a series of presses on the buttons in the front and it was fixed. I lost that paper. Can you help


You may just need to reset your control board. Go to the link and it will explain how to reset the control board as well as explain what might cause the issue and how to fix it.http://www.appliancerepairlesson.com/dishwasher-2/dishwasher ... Dishwashers

I am an electrician, and have been called to repair a faulty Hobart comercial dishwasher. I didn't note the model number, but it is the same shape as the one pictured. The problem is that nothing happens when the lid is closed, like it has a faulty switch or sensor. When I got to site, the dishwasher had been drained, and would not automatically refill. I filled it with a bucket, it heated the water to the correct temp, but still nothing happens when the top is closed, and I have to have it


Hello Pat. Here is the link to the hobart line of kitchen equipment. It has all of their manuals as free downloads. If you have a laptop and internet access you can get the correct manual once you know the model number. Based upon what you said t ... Hobart AM15-5 Dishwasher

May tag jet clean model number DWU 9921. Dishes not coming clean soap dispenser opens but soap soes not come out. Disges are still wet after heat cycle


Sounds like you have the stripped emacorator and pump head..\015\012http://www.appliancepartspros.com ... Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher

I have a Kenmore dishwasher, model 665.16039. Over the past month (we were on vacation 8 days over Xmas, but I assume it would have happened then, too) it has required rebooting using the Normal Wash - Heated Dry reset about 4-6 times. It would then do a couple loads okay, then need resetting. Now, however, it's refusing to reset to a point at which the Start buton will work. When I reset it, it flashes all the lights (incl. Start), and it fills, sprays, empties, etc. just as though it works


Make sure there is no water damage. ... Kenmore 24 in. 16039 Built-in Dishwasher

I need a heating element (i think) for my whirlpool quiet partner 1 dish washer, but i need the model number and I dont have it with me, do you know the part number for the heating element that I need or do I have to know the model of my dishwasher? it started with DU and was either DU1100 something or DU1050 something?


Your Whirlpool Quiet Partner 1 should have its model number inside along the left side. Mine is DU1010XTXT1. Your heater part is original Manufacture # W10518394. Can be purchased for about $38.00 at \012 ... Whirlpool Dishwashers

Our Kenmore dishwasher model number 665.13163K701


Please follow the next steps and fix it. God bless youFloat Switch\012\012\012The float switch may be hung up and this can cause the dishwasher to be stuck in a cycle. ... Dishwashers

My kenmore HE diswasher, model number 665.1312 won't dry


Is your heating element was working?,if working check the blower if working too. ... Dishwashers

Kenmore Model 587.1514* and cannot find the remaining portion of the Model number


Those are all the numbers you need - the remaining numbers are just the color ie: 587.1514 is the model 587.15142400 means its white ... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

Customer bought house with a Viking Dishwasher already there. He has no user manuals or documentation with the model number listed. None of the stickers on the side of the door have a Viking model number. This unit is a Quiet Clean System with Auto Water Heating and is (he thinks) about two years old. How can I find out what the model # might be or better yet how do I find out the part # to fix the main control board / interface. It just keeps blinking.


Check the back of the unit for a tag.... otherwise - removing the clock... it should have a part number on it.\015\012\015\012Thanks! ... Dishwashers

I have a GE Monagram dishwasher 1999 /- model ZBD 5900/5700 It is stuck on Heated Dry cycle. Would not drain for along time, than it finally drained but still stuck on Heated Dry. Turned breaker off and on several times did not help. Still stuck on Heated Dry no other buttons work


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0982 seconds