Having problems with your Dishwashers ?

My 13 year old Maytag washing machine has been running fine. Tonight, I loaded the machine, it filled with water, but now will not run.


Answers :

The most common problem to check is the lid switch. Depending on the model you may have a safety switch also and a fuse. If the fuse is bad the safety is prob. bad. Please rate my response. If you have more questions please include model #.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My 13 year old Maytag washing machine has been running fine. Tonight, I loaded the machine, it filled with water, but now will not run.


The most common problem to check is the lid switch. Depending on the model you may have a safety switch also and a fuse. If the fuse is bad the safety is prob. bad. Please rate my response. If you have more questions please include model #. ... Dishwashers

Maytag model # MDB9601AWB - when the cycle is selected; door is closed; the machine fills up and shuts off - the cycle does not run. Water remains in the bottom resevoir but does not run. we have attempted a number of cycles but same thing happens, machine does not run at all. This machine is less than 6 months old - it was installed by a licensed plummer recommended by Keidel's appliances in Kenwood Ohio.


Has it ever worked.. sounds like a wire could have been pulled off the motor...if only 6 months old... call a service company the is factory it will be covered under WTY ... Maytag Dishwashers

Kenmore Limited Edition Ultra Wash Dishwasher. Model 665 15892100, Ser. FL4910642 E71195, Stock #15892. Loaded dishwasher, started it, and went to store. When we came back, it appeared cycle had not completed (greasy and wet dishes) and the dry cycle had definitely not run. Bottom of dishwasher is filled with water. Tried to cancel/start the machine but control is completely blank and does not respond.


Hello,Welcome to FixYa.The issue with your dishwasher is more than likely the "thermal fuse" inside the control panel...it is all too common with those machines unfortunately.I've at ... Dishwashers

AEG Diswasher Model / Favorit 44080IM PNC 911925601/01 (located in UK) Wash cycle finish light flashes 5 times in sequence then starts again - please advise the meaning of this error signal ? History Machine started running immediately door was closed before any programme selected filled with water and main was motor runs and circulates water Water is not heated and detergent door has not opened Machine will continue to circuluate water until turned off If reset used then


1 blink is machine is having major power supply problem.the power supply board needs replacement.\015\012-----------\015\0122 blink is CCU error.that control board problem.\015\012-----------------\015\0123 blink is the CT error.that is ... Dishwashers

I have an avanti dw 18 dishwasher . the problem i am having is the when i turn the on button on the motor goes on however no water fills up. The motor is only humming. But; when i press down the float from inside the machine the water fills up and the machine starts to work. after the water drains again the motor continues to run and hum and the dial does not move. when i manually move the dial nothing seems to change . the motor continues to only hum. Even when the dial is in the stop position


... Avanti Dishwashers

I have a Bosch SGS43A22 Dishwasher approx 8 years old. When I start a cycle it fills, runs for about 15 minutes, then drops out about a litre of water from the bottom of the door, then completes the cycle without any more leaking. I have run the machine with the front panel off and can see that water bypasses the top of the seal and fills the well of the seal then pours out. It only happens the once. The seal is fitted correctly. Any solutions?


After 8 years service the seal may have perished, so you should feel for a crack by stretching the rubber where you noticed the leak. ... Bosch 24 in. SGS43C12 Classixx Free-Standing Dishwasher

My bosch dishwasher runs fine, cleans fine, drains fine....but after it has been just sitting for a while, the bottom very slowly fills up with water. Each time we run the machine the water level drains back to the normal amount in the bottom of the washer after the cycle is complete. The problem is if we are away for a few days, the bottom fills up and overflows onto the floor.


Water inlet valve isn't closing all the way closed. Need a new one ... Bosch 24 in. SHU53 Built-in Dishwasher

Our Kemore dishwasher is leaking water onto floor, and the water valve continues to pour water when machine was turned off, but is not leaking water now. There is also standing water at bottom of tub from running machine last night. Can I test to see if it is fill valve or the overfill float? Are these easily replaced?


You just need to clean the pump area in the bottom of your unit :)try to take spray arm out if you can and then open pump cover clean it good but watch for broken glass in it ...and thats it :) ... KitchenAid 24 in. KUDS25SH Built-in Dishwasher

No water coming into machine. Programme not running because the machine is still trying to fill. If I add water the machine does drain. Was cleaned with a good dishwasher cleaner only last week. Nothing to moved or changed yesterday before it stopped working properly.


Turns out that the dishwasher had a leak in the bottom. No water could be seen leaking out because Bosch machines have a cut-off valve that means if a tray in the bottom of the machine fills up with water, the float valve doesn't allow anymore water ... Dishwashers

Maytag Dishwasher Model MDB4100AWQ When I start the Light Wash Cycle: Washer fills with water, heater comes on (I checked it with a volt meter--120 volts), timer runs, motor never runs, before the timer gets to "rinse" the heating delay light on the door comes on and the timer stops. The heater is still on (120volts) nothing further happens it just boils away on the water in the washer. Note: If I manually forward the timer to "rinse" the motor will kick in and run but does not pump out w


Most common d/w power is 120 volts, check for 120 volts with a  ... Dishwashers

My dishwasher fills with water even though it is not on. when it fills enough, water runs out of the door onto the floor. i have to bail out the water. maytag brand


HI. this is a inlet assembly issue. The water inlet valve can be identified by the water hoses connected to it. One hose will lead from the valve to the pump/motor assembly in the center of the dishwasher. Check that the hoses are securely connected ... Dishwashers

Dishwasher will not fill with water. I've already checked the float assembly, that seems to be working fine. The water just doesn't seem to run into the machine. Little history on an unrelated problem: I want to mentioned that not to long ago my brother tried to put a bunch of celery through the garbage disposal. The sinks and pipes got all clogged up and we had to take them apart to clear up. Immediately afterwards the dishwasher stopped filling with water. I don't see how the two can be r


Hi,\012Here is a tip that will help you to find out why water will not come into the dishwasher... Dishwasher ... GE 24 in. GLD5500L Built-in Dishwasher

After cycle completed, opened door and found water did not drain. i removed the screen at the bottom and used wetvac to **** all the water out. i was also able to hear suction from hose to sink P trap. i'm confident there is no blockage. i attempted to run again only to find out the pump was running but, no water was filling the machine. Yes! the valves are open! two different issues? one other thing; due to the no thought behind this, the name plate was stuck to the inner part of the door whi


Possible that the drain pump needs a closer look , clean and check if the pump is working. If there is voltage to the pump during the drian then the pump is faulty.\012The second issue if the inlet chocking , check the inlet filter , check the ... Bosch SHU9915UC Dishwasher

Smeg dishwasher model DI 612 C type 12053 good morning After selecting a program and shutting the door the drain pump starts and runs for 2 seconds then stops. The machine makes a bleep noise then the drain pump starts again running for 2 seconds then stops again and the cutting in and out process continues and the machine never reaches its selcted cycle. No alarm lights are displayed. I have filled the machine with water so that the filter is submerged and the level is


... Smeg Dishwashers

My kitchenaid KUDI01DL dishwasher began making a lot of noise while running, then subsequently decided not to circulate the water around to wash the dishes. It sounds like the motor is running (maybe) but there is no washing action going on. The machine will fill, drain and heat the water but nothing else. Is it likely that the pump/motor assembly has ceased to function properly? thanks...


The problem is very likely in the chopper and/or somewhat possible in the impeller. The chopper is replaceable from the front. Disassemble the pump, the chopper will be on its left side under a cover. That cover is kinda tricky to remove (remove all ... KitchenAid 24 in. KUDI01DL - Multiple Color Built-in Dishwasher

Dishwasher does not fill with water. Moter or pump is running but machine will not fill with water.


The first thing to check is the float. Remove the lower rack, in the front right corner there is a plastic float that looks like a hat. Check to make sure something like a spoon is not stuck under it. The float should move up and down about 1/2" free ... Whirlpool GU2400XTP Built-in Dishwasher

I have a three-year-old Sears Kenmore Elite dishwasher. I find that despite the fact that we scrape and rinse our dishes before loading the machine, after each three months of use (two loads a day) or so, I have to take the machine apart (spray tower, racks, bottom impeller, bottom screen housing, food grinder cover) and clean-out the food grinder area, for it fills-up with sludge. The sludge restricts the water flow and there isn't enough flow to turn the impellers via that steering jets.


Have you tried different detergents? Some detergents after getting wet and going through the wash cycle with the debris from the wash turns into a grease substance that grimes up in some dishwashers. Try running the machine with hot water this someti ... Dishwashers

My Maytag MDB5600AWB quiet series 100 dishwasher starts, fills with water and then makes three "clicking sounds", after the third click the machine stops and turns itself off. I can get the water to drain by restarting the machine and pressing start/cancel. Anyone have any ideas?


... Maytag Dishwashers

So i have a maytag jetclean eq plus MDB7100AWW not sure how old it is as it was in my condo when i moved in 6yrs ago and there was no paperwork with it. The dishwasher worked fine until a couple days ago. The last load that i washed came out with a white film on everything, i checked the jetdry it was empty so i filled that and ran another load, everything was still covered in the white soapy film. So I tried running a dishwasher cleaning product through it, that didnt help, i tried running it w


... Maytag Dishwashers

I have a De Dietrich DV640JE1 built in 45cm Dishwasher, working fine for over 3 years. After replacing the connection under the sink to fix a leak it has stopped working. But I dont think this is related. I run a cycle and it fills water in the bottom of the machine, it drains it out in the end but the 2 arms are not rotating and no water comes out. I checked the arms and they are not blocked. A faint clunking sound can be heard at some part of the cycle. I did also run a cycle with the dr


Hello Benny,\015\012\015\012It's highly unlikely that replacing the connection under the sink is related to this problem.\015\012\015\012From the symptoms you describe, it's almost certain that the circulation pump motor has f ... Dishwashers

E1 fault code Dishwasher runs for about 5 minutes. Water fills up at bottom of unit and then machine seems to pause then fault code E1 appears then water is pumped out from bottom of machine. There are no leaking pipes and drain is installed correctly. I installed a new wash pump and fault still appears.


Hi,\015\012I think both the heater and thermostat / trip switches need to be checked.\015\012If water is going in and out ok, then it seems to be waiting to heat the water. It sees a fault - so just clears out.\015\012Heating elemen ... Dishwashers

Frigidaire FDB750RCC1 Dishwasher Machine, has a humming sound when it should be filling or draining. Replaced the fill solenoid with no luck. Machine will run if I dump a gallon of water in the cabinet and then turn it on. Any ideas?


I have the same problem (I think). Did you ever find a solution? ... Frigidaire Dishwashers

SHX46B I have a 4 year old Dishwasher that filled up with clean water on it's own and leaked on the floor. There appears to ba a float switch switch on the very bottom of the unit that runs the pump if this happens. It won't stop until I remove the water caught in the plastic base on the very bottom of the unit. Drain is clear and this machine has worked fine until now. I'm thinking it may be a bad or leaky fill valve but how can I check?


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

Maytag MDB6000AWB runs good. Steam coming out from under counter in back of machine. Machine is installed in a peninsula. Can't find a break in supply line. no evidence of water when unit was pulled out to look for water leaks.


Called repair man ... Dishwashers

Maytag 300 series dishwasher growls like a bad bearing and runs a few minutes then pumps the water out having restart the load. finally after several restarts it will run and finish the load growling every now and then.


This is your pump making noise. It could be the impeller is loose or possibly a bearing. The pump is relatively easy to replace if you have the desire... ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1197 seconds