Having problems with your Dishwashers ?

How does the top sprinkler fit to the back rack on the BDW6SL


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

How does the top sprinkler fit to the back rack on the BDW6SL


... Dishwashers

I had renters in my home and they lowered the top rack and now I do not know how to raise it back up. It is so low my plates do not even fit in the bottwom! How do I raise the top rack?


Look on the sides of the upper rack, if you see tabs press them in while lifting the rack. If you see no tabs look at the side rails, if you see 3 sets of wheels then pull the rack all the way out and set it on the next set of wheels. Good Luck ... Dishwashers

The top level is not getting clean. We think the passage to the top water jet is clogged. There are two holes in the back that the washing arm fits into, depending on what level the top rack is set at, and one of them is stuck open. We have not been happy with this dishwasher from the start and are trying to decide if we should get it fixed or just buy a new one.


Sometimes it is not worth the headache.dishwashers are a dime a dozen,if you want to happy,just replace it,most dishwashers are unrepairable.no matter what the maytag man says. ... Dishwashers

Our top rack is not getting cleaned at all-- although the rinser seems to spin freely when pushed, and fits correctly into the hole back. We were using powder detergent, and a little residue was always left in the compartment. So we tried liquid detergent, to see if it would help, and now it seems like almost none of the detergent is dissolving out, at all. The compartment's full and a goopy mess after each cycle. So now the bottom rack isn't very clean, either! Please advise. Thanks!


Welcome to FixYa,Based on your description... I`d suspect a plugged or really dirty wash pump. It could ultimately be a worn out wash impeller/chopper assembly, but I'd certainly try my suggestions before considering that. ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

I have a Kenmore Elite 665 that is almost two years old. Suddenly, last week, the top rack is not getting clean. We use a regular cycle, no heat dry. Glasses and bowls stay on the top rack stay dirty, everything on the bottom rack is clean. Is there a gasket that fails on the top rack sprinkler?


It appears your jets or riser is clogged with sediment in this instance.For replacement parts - head on over to PartSelect.com or RepairClinic.com and enter in your full model number for a full parts listing.I recommend both sites b ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

The handles on the top rack of my meila dishwasher keep falling off how do I put them back on


... Miele Inspira Series Dishwasher w/ 6 Programs and 5 Temperatures - G2120 / G2120BL - Blac 24 in. Built-in Dishwasher

There is alot of "crud" left on the top rack dishes. i have cleaned the dishwasher and replaced the hose that goes from the back of the machine to the top rack to the top spray arm - still have problems


Hi, \012I have an older dishwasher also and recently my wife alsocomplained about it not cleaning right... so me being the man I am tried invain to clean the things... Bought new spray arms online and installed them inminutes...now the thing works li ... KitchenAid 24 in. KUDS01FLBL Built-in Dishwasher

GE Dishwasher GSD4030: I had to take the top rack out. Now I can't get it back in. Can you tell me how to reinstall the top rack and where to attach the small rack clips?


... Dishwashers

The top rack of our Asko dishwasher spontaneously slides forward when we open the door and pull out the bottom rack. I can't get it to catch and stay back. This seems to happen regardless of whether the top rack has items on it or not.


... Asko 1385 Dishwasher

I have Bosch SHU9915UC/U12. A spayer arm has fallen off. It is not the one on the bottm, it must have come off the top or the back of the. I can not figure out where it goes. It does not look like anything is broken. When I try to put it back on the top or the back it does not seem to fit.


Hello, welcome to fixya.\015\012\015\012The piece your speaking of I suspect is the spray arm from the upper rack. \015\012\015\012The image I scanned and attached just below here will hopefully help ... Bosch SHU9915UC Dishwasher

My GE PDW7880G doesn't clean items in the top rack. The dishes on the bottom seem fine. I do make sure to push the top rack all the way back so it engages.


Removed the sprayer. the part that spins under the top rack and check that the holes arent clogged. ... GE 24 in. Profile PDW7880G Built-in Dishwasher

I can't put back the top dishwasher rack. The railing does not seem to hold it, even though there is no damage in the railing. The top rack could not be held by the rollers


There should be plastic stops at either end of the rail that prevent the rollers of the rack from coming out of either end. ... Maytag Dishwashers

Hello! My 3 yr old Bosch dishwasher (I think it is a SHE 43) is doing two things: 1) leaving a serious white film on dishes and glasses 2) leaving grit inside glasses on the top rack (always on glasses placed on the far back right of the top rack) I've tried cleaning the machine with hot washes with no dishes, vinegar only, but no luck. Any thoughts? Many thanks for your help!


Hello. Since you have already cleansed the interior of your dishwasher, we must conclude that the problem is with the water itself. If you do not have a filter on your water, you may want to consider installing a dirt/rust filter, at least on the h ... Dishwashers

My Kenmore Elite dishwasher 630.1630 9400 (possibly made by Bosch) has a bottom rack spray arm a top rack spray arm and a missing sprinkler on the outlet at top of unit (ceiling it the cavity was a room). What part number is it? Can I post a picture? thank you


... Dishwashers

I have a Maytag model DWU9502AAM dishwasher, took out the top rack (easy) to wash furnance filters, and cannot get the rack back in rightly! Where are the rollers on each side supposed to be placed to hold the rack? Do the snap supports face up or down on the rack? I broke two of the roller snaps and replaced them, still no luck. Does anyone have a schematic??? Maytag has nothing on this I can find. Thanks!


Hi there,\012Well you can try from upside face...... there are some plastic lock type grips... for more information you can download the repair manual, please follow the below link -http://cgi.ebay.com/_W0QQcmdZViewItemQQitemZ ... Bosch SHU9915UC Dishwasher

Thumping noise as top rack washer bar spins around underneath the top rack tray.


Make sure the connecting tube is seated properly, then use a self tightening plastic strip to secure it to the upper basket..they are available at hardware stores ... Dishwashers

I have a Bosch SHU3307. Looking in the Owners manual I see an"extra tall sprinkler head" that plugs the opening at the back of the unit when the upper rack is removed. I'm looking for this sprinkler head. any idea on a part number, where to order, etc.


... Bosch 23 in. SHU3307UC Built-in Dishwasher

The top rack on my dishwasher won't stay back like it did when it was new. It keeps slidding out making loading the bottom rack difficult. Can I replace the wheels or something else?


... Maytag MDBH985AWB / MDBH985AWS 24 in. Built-in Dishwasher

How do you remove the top of the S510 dishwasher? We have laid new tiles and it will not fit back in the space with the top on. Thanks Loraine


Check whether you can adjust the machine legs. Removing the top, it depends on the design. If removable moulded or laminate top is provided :Watch for the fixing screws at the back of the machine. If screws are there remove them. Slide th ... Bosch SHU5316UC Dishwasher

The top rack in my dishwashers gets stuck at the second set of caster wheels. The bracket that holds the rack clears the first set very well but for some reason doesnt fit through the second set unless you force them.


... Frigidaire Dishwashers

I need to replace my top rack on the Kitchenaid dishwasher KUDA220T. Where can I get it or what other rack would fit?


You can order it from Kitchen Aid directly. The part number is 9741982Their phone number is 1-800-422-1230 ... Maytag MDB3100 Dishwasher

When the cycle is finished the dishes arent washed, in particular the ones on the top rack. Ive removed the arm that carries the water to the top sprinkler to see if its blocked and it seems to be OK.The dishwasher is just over two years old and is an LG LD1415M......Thanks


Being from the US, I have not worked with this LG dishwasher, not any down under.\015\012\015\012But the first thing to do is use only a name brand dishwasher detergent powder. Don't use gels or tablets, ever. Many cleaning problems are resol ... Dishwashers

The spray arm, above the top rack, keeps unscrewing during the wash cycle. Just the arm comes off leaving a round plastic part attached to the top. This can be unscrewed and inside is a white 'washer'. The arm can be clipped back but comes off again in the next wash. The plastic 'washer' has to be turned over to allow re-attachment. Is a washer missing from inside?


Could the arm be mounted upside down and rotating the wrong way? Just an idea... Some of these can fit either way and the retainer will fit either side of the arm. ... Frigidaire 24 in. PLD2850 Built-in Dishwasher

I have a Frigidaire dishwasher and there is not any water coming out of the top wash arm. There is good water pressure coming out of the lower washarm. I pulled out the dishwasher and can see the water going to the top washarm through the tube and it goes up very slowly. I took out the "check ball" below the lower washarm and it worked good. I put the "check ball" back in and ran the machine on "Upper Rack" and it still does not have any water coming out of the upper washarm. It doesn't seem lik


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. Please check that there is no gunk or mold\015\012behind the filter screen and under the cover at the bottom. N ... Frigidaire PLDB998A Built-in Dishwasher

My whirlpool dishwasher is not washing the dishes properly. when finished cycle, I still see the dishwasher tablet half used. The grey long piece at the back, seems to have come out of the two holes it fits into on the "floor" of the inside of the machine. I've clicked it back into place, but it still pops out. Sometimes the rotating sprayer at the top and bottom, don't move either when its out of place. please help.


... Whirlpool GU2400XTP Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0507 seconds