Having problems with your Dishwashers ?

Leaking from somewhere in the back. - Dishwashers


Answers :

Remove the lower panel(s), get a flashlight and look where the water is coming from. You may have to run the dishwasher for it to leak. Water leaks can come from several places so it is up to you to find where it is comming from.
\015\012
\015\012Hope this helps.
\015\012
\015\012Ken
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Leaking from somewhere in the back. - Dishwashers


Remove the lower panel(s), get a flashlight and look where the water is coming from. You may have to run the dishwasher for it to leak. Water leaks can come from several places so it is up to you to find where it is comming from.\015\012 ... Dishwashers

KUDS30 leaking my kitchenaid dishwasher (about 1 1/2 years old) had a leak bottom left side and had gasket replaced. It worked well for approx another 6-9 months without any leaks and now the same problem is back. The dishwasher isn't overloaded. A repair person came last week and ran the dishwasher empty and it didn't leak when she was here. The 2 loads after continue to leak approx 2 cups of water each cycle.


... KitchenAid 24 in. KUDS25 Built-in Dishwasher

I have a GE potscrubber Dishwasher Model # GSD3630ZZ3WW it has been leaking from the bottom for about a week. I took the bottom off tonight and ran the dishwasher so that I could see where it is leaking from. It is not a hose but the leak seems to be coming from the back of the motor or pump fan where it goes into that plastic housing that attaches to the bottom of the dishwasher seems to be leaking in the very center of that housing where the motor shaft enters the housing. Water is just spray


... Dishwashers

Leaking dishwasher My GE dishwasher leaks when running a load of dishes. The leak seems to be coming from about the middle of the tub about halfway back. I can't see exactly where it's coming from, but it appears to be dripping right behind the motor. Could it be a poor connection? I would appreciate any suggestions. Thanks, Bob Engle I do not seem to be able to find the model number


Probably a leak at the motor seal where it enters the tub. Best to remove the motor if you can and inspect the seal. ... Dishwashers

We are having water leak from the bottom of our Roper Dishwasher door. THe model # is RUD5750DG3. I have taken the inside door frame off and found a small white rubber seal had dislodged inside. i placed it back in the only sopt it fits but water is still leaking. I have checked to make sure the water is not leaking from any where else on the dishasher. This occurs when the water inside is spraying and eventually fills up on the bottom. We no longer have our manual as the dishwasher cam


Try to fix the rubber seal which has come out by fixing it through super glue or apoxy seal which will stop the water spill and leakage.\015\012Please give more details of you dwasher ..... the Make and model so that i can send you the manual f ... Dishwashers

My 14 yr old Magic Chef Model DU4K seems to be leaking (it is dripping into the basement just under where the dishwasher is located). it started when the arm at the bottom of the dishwasher did not seem to be moving so my husband took off the bottom "grill" to see if maybe there was something under there preventing it from spinning. It started to leak when he put it all back together (the bottom arm is still not spinning)


Being 14 years old I dought if spares are still available for this machine personally at 14 I would rather replace the unit if you are not in a possition to replace it you could advise from your local appliance repairs as to weather parts are availab ... Dishwashers

Dishwasher fault had leak,when opened bottom plate, could not see any obvious leak problem,hand dryed what componets i could. made sure no wires were loose then screwd back bottom plate,turn power back on but power button flashing continuously know,any advice plz


The flashing power button is a bad sign. You may have flooded the circuit board out or there may be a bad component as a result of the flood. Difficult to know from here.\015\012\015\012Most flooding on dish washers is caused by a faile ... Dishwashers

We have a bosch dishwasher model shx43c and water is dripping on the floor from the area of the supply line, taking the supply line fitting out and re taping it and re tightening it has not helped, could the valve be leaking back this way, instead of the more common leaking into the dishwasher itself?


If the supply line is leaking it could be a 3/8 supply line maybe the rubber washer built in the line is shot try replacing the supply line.they are about 15.00 at home depot.do not over tighten the new line you could damage it.some times people cros ... Bosch SHU9925UC Built-in Dishwasher

I turned on the dishwasher tonight and noticed nothing was happening, but I was getting a clicking sound. I moved the dial back to off and started over. Some water went in, but then nothing happened again. I clicked forward one click at a time. Sometimes water came in. THEN WATER STARTED LEAKING OUT. I clicked back to off. After water stopped leaking, I opened the door. There is still water in the bottom. What do I do???


Hi \015\012\015\012Thanks for using FixYa. As the water is not draining and clicking is\015\012coming from the bottom so the issue seems to be with the drain pump solenoid. Usually, these issues are related\015\012to ... Kenmore Dishwashers

Leaking my hobart dishwash is leaking. I have taken the back panel off & there is a plastic water tank at the back - it keeps overflowing! How do I fix it? Please help.


... Hobart LXIC-6 Dishwasher

Whirlpool GU1100XLTQ1 dishwasher, 4 years old is leaking water during cycle. I cannot see exactly what is leaking by looking up through the acess panel in front...there are what appear to be plastic support ribs for the tub and water is leaking through several of them to the left of what appears to be the motor in the center...please help! I don't think I can run the washer and tilt it back at the same time as the water supply line only allows me to pull it out just enough to clear the counter t


Hi,\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101\012\012\012wahgfadh ... Whirlpool GU1100XTLB / GU1100XTLQ / GU1100XTLT Built-in Dishwasher

Maytag jetclean dishwasher leaks: Water leaks underneath. I don't see the source of the leak but see water running out on the left side about midway back on the bottom. Could it be related to the little plug inside the unit on the left side halfway up?


... Dishwashers

Leak My dishwasher Danby 22 in. DDW396 is 3 years old. Recently it started to leak from the rear. The water came out slowly from the back but I couldn't tell where the problem is - it leaks when it runs and when it stops working.


Hi there, dishwasher leaking might be due to either of these causes, check these:Main tub sealNote… If the main motor of your dishwasher is mounted vertically, beneath the center bottom of the dishwasher, the foll ... Danby 22 in. DDW396 Free-standing Dishwasher

I was an idiot and put dishsoap in the dishwasher because I ran out of regular dishwasher soap. Now the dishwasher keeps overflowing with bubbles. I keep wiping all the bubbles and extra water out but when I turn it back on it is again overflowing with bubbles and bubbles are leaking out the bottom. What can I do about this?


You must rinse all the soap out the best way is to make the drain hose lower than the tub of the washer and run the garden hose into the drum and slowly rotate the drum as you rinse it out after a complete rinse you should run a rinse and spin cycle ... Dishwashers

I have a bosch dishwasher SHE43C06UC22 (non-LED version). It's stuck in the drain cycle and continues to run even when opening the door (it should stop, but it doesn't). As a test, I poured a large glass of water in the bottom of the dishwasher and it drained it into the sink as it should, but it continues to run in the drain mode with no water in it. I've heard I either have a float stuck or an emergency drain switch or leak somewhere causing the dishwasher to continue in the drain mode. Ho


Hello,\015\012\015\012Welcome to FixYa.\015\012\015\012This can be caused by either faulty door switch or indeed the float you mentioned.\015\012\015\012This is where to look for the switch and test it ... Dishwashers

I have just bought a Kenwood KID60S10 dishwasher. I have used it a couple of times with no problem. However I realised it has been leaking from the water pipe at the back so pulled the unit out to tighten and readjust the pipe. However when I tried to run a cycle it won't after this to check if it was still leaking it won't. When I choose a programme non of the lights light up (except the power on/off light). I had left the washer out of the cavity to ensure the pipe wasn't leaking anymore. It i


... Dishwashers

I have a GE GSD4130 Dishwasher. Started leaking today. Not sure where yet. Looks like somewhere around the door. Suggestions on best place to start diagnosing where it is leaking?


... Dishwashers

I have a Kitchen AId dishwasher (8573025) and it is leaking about mid-cycle. I can't tell where (in terms of front, back, or side) the leak is originating. Any guesses?


... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Hi, We have a Frigidaire dishwasher machine 1500 series with fully electronic control. It is a new unit, has been installed nearly 4 months ago. The other day, when I went to take the dishes out of it, I notice that the rubber gasket that seals the door had come off somehow. Along with it I saw, sitting on the bottom, two pieces that looked like part of the seal, but I didn't know where they came from. I put the rubber gasket back on, but now the pieces and now the dishwasher will leak when runn


... Frigidaire Dishwashers

The pressure tower came off. I don't know where it came from, nor how to put it back on! It's so tall, it looks like the racks won't close once it's in somewhere. I have no idea how to put it back inside the dishwasher.


With a model # it's hard to give good help but when they ware out the can blow the tower . . you can replace the tower assem ( if ge it will come with lower wash arm other brand it will not .. mm hope this ... Dishwashers

Bosch dishwasher 9000 007 279 (8401) Water leaks back into the dishwasher after it has been switched off


... Bosch Dishwashers

Hi I have a fisher paykel double drawer dishwasher that is displaying F1 code for flood alert ie a leak somewhere,we cannot however find how to remove the dishdrawer? The plumber has the runner located but it doesn appear to want to give, any ideas? Should this pehaps be seen by a local dishwasher expert? Many Thanks


... Fisher DS603W / DS603B / DS603I Dishwasher

I have a aeg 43070 vi dishwasher It keeps tripping the circit breaker on the house fuse box . I have reset the leak cutout by dipping the dishwasher back and stopped the warning sound,but went for about a minute and then trip the electrics again . any ideas whats wrong ?


I assume you are refering to the earth leakage circuit breaker. This trips when a earth leak fault has occured. The normal cause for this could be\015\012A) Water leaking via a pipe at the bottom comming in contact with one of the electric moto ... AEG 23 in. Favorit 44070Vi Built-in Dishwasher

How do I remove the back of my fisher-paykel dishwasher? The draining pipes have been kinked resulting in a back flow of water and now leaking. It is no longer under warranty.


I decided not to open the back of the dishwasher and just cut out the kinked pipes and rejoin them. I haven't used the dishwasher yet so I am unsure if this will fix the leaking problem.  ... Dishwashers

I have a LG Dishwasher LD 14AW3 it fills and runs for about 30 min. It then appears that when it tries to rinse it cannot get water and flashes "1E". I disconnected the unit and when I moved it out of its position water was leaking from the bottom of the unit. after cleaning out the inside filter & the hard water filter I re-connected and found it worked. I ran a dishwasher cleaner through it at high temp. After a few loads the problem has come back. It is now located in MY garage waiting for me


Found a leaking component that was causing the foam float located and attached to the inlet valve to shut down the water inlet and the water inlet Solenoid was also sticking. I found out this simply by tapping it while it was trying to get water for ... LG Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1273 seconds