Having problems with your Dishwashers ?

I removed the top cover on the of my dishlex global 300 and a black wire became disconnected i don't know where it goes the wire is made of two one wire has what dots (short lines) and then a continuos line the two wires go into a slightly transparent cover which has a small round opening for it to be plugged into something the wire comes from the cercuit board that controls the start/stop and mode


Answers :

The wire that came disconnected goes to the door switch. If the wires came out of the switch then you need to replace the hole switch. If you still have some wires coming out of the switch then you can just wire nut them back together.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I removed the top cover on the of my dishlex global 300 and a black wire became disconnected i don't know where it goes the wire is made of two one wire has what dots (short lines) and then a continuos line the two wires go into a slightly transparent cover which has a small round opening for it to be plugged into something the wire comes from the cercuit board that controls the start/stop and mode


The wire that came disconnected goes to the door switch. If the wires came out of the switch then you need to replace the hole switch. If you still have some wires coming out of the switch then you can just wire nut ... Dishwashers

The dishwasher is leaking from the inside front left corner. it ahs two small covers over this valve. underneath it has two electrical wires. when you turn it on, it leaks from that valve to the floor.


HI. this is a inlet assembly issue. The water inlet valve can be identified by the water hoses connected to it. One hose will lead from the valve to the pump/motor assembly in the center of the dishwasher. Check that the hoses are securely connected ... Dishwashers

I had a draining problem, clogged line, fixed. Does the small in line rubber valve under the dishwasher in the transition piece to the hose have any real need to go back? and which direction it is cupped slightly. Also are there any assembly instructions? I cant seem to get it back quite right, or a white washer has split. not sure which.


... Whirlpool 24" Built-In Dishwasher - Black-on-Black

My costomer has a miele G841 dishwasher the rats chewed through the supply line this has an outer plastic covering with a hose inside and an electrical wire how do i get a new line and then replace it if possible


... Miele 23 in. Novotronic G841 Built-In Dishwasher

Dishwasher was cutting out intermittently,totally dead no power then after 15mins or so,finally went bang this am,smoke etc,took insection cover off at bottom swit6ched on again to see spark dead short on unknown unit with four wire block connector attatched,two white to same connector and two purple,left disconnected and workin fine,hot water,inlet and outlet both working fine so what does that unit do?


... Bosch 18 in. SRS43E02 Slim-Line Built-in Dishwasher

Im replacing a frigidaire with a whirlpool and the problem I'm having is the electrical connections. My old Dw had two elec cords running to it. One small one that runs in the same direction as the drain and water hose runs the other is a slightly bigger elec cord that runs straight out the back of the cabinet unit and I cant tell where it goes. But it has on it anaconda w dutrax type nm 12/2 with grounding 600 volts.Do I need both elec cords for the new whirlpool or just one? All the online vid


Hello. Older houses offer all kinds of challenges. In the long run though, that is part of the joy of life. \015\012\015\012You need three things to hook up a typical dishwasher:\015\0121. The hot water source which goes to fee ... Dishwashers

Little black tube goes where? it comes from some sort of switch with two wire leads, its not the water supply line, where does this thing hook up


... Whirlpool DU943PWK - Multiple Color Built-in Dishwasher

Ran the dishwasher and the water didn't drain completely. Checked the drain line for clog - it was clear. Scooped out the remaining water (barely covered the flat wire mesh filter in bottonm of the machine) and cleaned off the canister mesh filter and carefully relocked the filtyer in place. Tried to run the machine last night. Soap tray opened but apparently no water cycled through the machine as all the soap was in the bottom of the machine. The heat never turned on to dry the dishes and


Hello Ramona Doug,\015\012 Try disconnecting power from your dishwasher for a few minutes to clear the memory and then reapply power again. Start a wash cycle without dishes on the hottest water setting and after a few minutes.. pause the wash ... Bosch Dishwashers

How to put together an Honda Motor evaluate and Honda in two weeks and adjusting steering and ignition for all inside of Mounts in a 96 small sedan Honda low price of of auto glare top to bottoms Mounts put together a Motor and adjustments it into steering and ignition wiring


... Honda 8 HP Engine

I purchased a diswasher (Hotpoint)about 1-1.5 years ago. It's model # is HDA3400G02CC and its SS# is TH887451Y. I don't think I registered it. No Matter, Two days ago, my garbage disposal stopped working. I checked the outlet. It had power. The switch to the Disposal was next to the outlet. I assumed that the switch was wired from the outlet. It wasn't. Bottom line, the switch nut was loose. I tightened it and problem solved. When I turned on the dishwasher, nothing happened. It acts like


I purchased your service (telephone support) and the dishwasher expert contacted me. We discussed the issue, he made recommendations. I followed his advise and solved the problem. Before I could recontact him, he called to follow up on my progress. ... GE Dishwashers

The pump doesn't seem to put out enough water pressure to turn the various revolving heads/nozzles in the washer - all washing heads are operable (ie unblocked) while the S shaped nozzle at the base and the small round nozzle at the top/ceiling of the cabinet do revolve slightly or slowly - but the two main nozzles spout water but not enough to revolve Is this a defective pump or a partially blocked pump ? - or something else - I have checked everything else and they appear to be functioning


It will be helpful to know the make and model number of the dishwasher to diagnose the problem you have.\015\012\015\012Generally this is attributed to a blocked chopper assembly in the wash circuit but hard to be sure if your model has o ... Dishwashers

Drain pump runs non-stop. Continues when dial is in Stop position. When disconnected for hours, drain pump starts immediately when power restored. In any wash cycle position, drain pump runs and cycle never commences. Small amount of residual water in drain line when impeller cover removed. Board? Switch?


Sounds like the flood switch has activated.\015\012\015\012You will have to drag the dishwasher out from under the counter after turning off the power to it. Tilt to one side so that any water collected under it is expelled. This will fre ... Miele 23 in. Novotronic G841 Built-In Dishwasher

Ariston LSI 41 dish washer had intermitant problem of green light not coming on when main power switch turned on and machine not working, the circuit had beed repair before. I played around and got the machine to go through a full circle once then would not go again. So I have put a new circuit board with switch etc. still the switch panel light dose not come on, i found bad connection in connector which comes from small plug on circuit board, (two red wires )I have checked for power to board. W


... Ariston Technologies Dishwashers

I have a Bauknecht dishwasher GS 835 S purchased in 1986. Since moving it while having kitchen refit there are two small leaks. One is from the hose that goes into the bottom of the machine towards the front, and the other is a drip that comes down between the front facia panel and the machine door. Possibly the door seal is slightly perished? I do not want to pay the earth for callout charges etc; if spares are not available. If they are where can I get them, and will they be very costly. I


Hi there,you can get the spare parts for your dishwasher on ... Bauknecht Dishwashers

KitchenAid Dishwasher (KUDP01FL) - unable to remove two wires from thermal fuse box. Help


... KitchenAid 24 in. KUDP01FL Built-in Dishwasher

I purchased a new dishwasher on 2/22/07 at the Home Depot in Parksburg,Pa. I first had to have it repaired on 4/28/08 for wires stuck to inner door. They repaired two broken wires and added insulation so wires do not stick to the door. The second repair was a little more than two months later. On 7/18/08 they had to install a new motor because the motor locked up. Both times I waited several weeks due to not having money and appliance center being busy. I used J.B Zimmerman in Blue Ball,P


Hel1Dav2,\015\012\015\012I understand your frustration with having to deal with major repairs to a new applaince. However, I don't belive this is the correct forum that you need to use. I have found a helpful link that you may try in th ... Dishwashers

Hooking up the electrical wires for the dishwasher, I have a black,white,copper & two tone green wire. Where does the two tone green wire go to?


... LG LDS4821WW 24 in. Built-in Dishwasher

Bosch APEXX model number SHY99A05UC/14 lost power. Power input line appears to have arced (white power line and wire nut show signs of stress). The power breaker did not throw at the junction box. Already cut back wire and re-attached new wire nut along with replacing the breaker at the junction box. Still no power. There are no other visible signs of power stress or water damage underneath the unit or inside the doo panel.


I do not have access to the user or service manual for this model.\015\012However, such symptoms could be result of heater element or thermal overload fuse blowing. Do you remember having a very hot dishwasher when the it lost power.\015 ... Bosch Dishwashers

Have a 15 day old Thermador Dish washer direct wired to the circuit breaker, replacing a DW that was there for 10 years. Wiring is the same age. The unit will not turn on and I took the cover off the electric cover the hot wire had melted the connection. what's going on? model DWHD630gcm


... Thermador DWHD630GCP Dishwasher

Whirlpool dishwasher: two loose wires need to be reconnected. Unable to determine which termings to reconnect the two loose wires.


If both wires go too the same switch/componet and these are the only two wires that connect to this componet it doesn't matter which wire goes where. ... Dishwashers

I have a hotpoint dishwasher model# HDA1000G00WH. until recently never noticed rinsed water not drained after washing/rinse cycle completed. water level just above the drain cover. i removed the cover to see if i might find something clogging the drain screen but found nothing. i removed the plastic water "return" line & it was not plugged. thinking about pulling the dishwasher out, disconnect the plastic line connected to the bottom of the dishwasher, then remove the "bowel-like" container wher


Take out the pump. You should find a broken rubber flapper indide blocking the outlet tube. Cheap to repair. ... Hotpoint 24 in. HDA3740G Stainless Steel Built-in Dishwasher

I have a DW475 delongi dishwasher, the water system has gone on it, I have the replacement part, what I want to know is for the wiring does it matter which side on the terminal block the red and pink wires go and the single pink wire, there is a terminal on the terminal block with a blue line underneath it is that for the red wire or live wire?


I might be able to help you out if you can link a picture of the terminal block. however, based on your description i would say it's for the red wire. ... Dishwashers

My LG Dishwasher LDF7932ST has White, Black and Green wires coming out of the unit, no problem there, however the ALL Grey Cord that was in a separate bag does not help me identify which wire is white and which wire is the black, I can only see that the green wire is in the middle of the three attached to the grey cord as I can just see a little bit of green, how am I suppose to know which ones are the other two? I tried pullilng back the grey rubberized cord to see if it was show me ... but no


Hi,\015\012\015\012There is a simple way to tell is to look at the plug end of the cord...\015\012The blades on the plug will be two different sizes...\015\012The blade that is the larger of the two will be the white wire... ... LG LDF6920ST Stainless Steel 24 in. Built-in Dishwasher

Need the wiring diagram for the front panel/door of the dishwasher. The wiring diagram in the owners manual does not provide adequate description of which wires connect where. My problem is that, in taking off the door, two wires became disconnected and I cannot tell where they should be reconnected. I called Viking and they are unwilling to provide this (they prefer I call an authorized repair person). Does anyone know whether a repair manual exists for this and where I might get ahold of one.


This is all I could find go to this address www.specsserver.com/CACHE/FILE5412.PDF at the very end is wiring diagram but its not in detail ... Viking DFUD042 Built-in Dishwasher

My Indesit dishwasher needs to have the micro switch aquastop replaced but not sure which wire goes on which contact on the switch. Two wires , one pink and one brown.


... Indesit 24 in. DI67 Free-standing Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0431 seconds