Having problems with your Dishwashers ?

I am not getting any power to my dishwasher? Checked the breaker, the outlets. all good there


Answers :

You need to take the very bottom panel off the dishwasher. This panel is located at the floor and is held on with 2 philips head screws once the panel is removed look for an electrical plug located under the dishwasher(use a flashlight for the best look) What you are looking for is a "pig Tail" which is a small section of what looks like an extension cord which should run into a small metal box (make sure your breaker is off before going any further) Now remove the screw holding the flap to this metal box and look to see if the cord is connected to the proper power feed to the dishwasher, should be wire nuts on the ends of the wires. untwist the wire nuts and make sure the wires are properly twisted together black to one wire off the pig tail and white to the other side. Follow the wiring back to the plug to insure that the end of the pig tail is plugged in. That should cure your problem if you are getting power to this metal box then the problem is internal in the dishwasher itself.

Hope this helped
Dr Berry
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I am not getting any power to my dishwasher? Checked the breaker, the outlets. all good there


You need to take the very bottom panel off the dishwasher. This panel is located at the floor and is held on with 2 philips head screws once the panel is removed look for an electrical plug located under the dishwasher(use a flashlight for the best ... Dishwashers

8575637 Brand new dishwasher installed about a month ago. Its been used about 10 times and in the middle of a wash cycle, completely stopped with no power. Have checked the plug, outlets, breakers. Cannot get any of the buttons to light up, have checked to make sure it wasn't locked out - no power at all. Manual is not helpful. Any ideas?


... Whirlpool GU2400XTP Built-in Dishwasher

Wash cycle stopped with water in the bottom. Seems like there is no power. Can't get lights on cycles buttons to turn on. Power button does nothing. Checked circuit breakers. All are on. Lights and outlets around dishwasher area are working.


Check the wiring in the units junction box. Its located at the bottom right corner. You will likely find melted connectors. If so, you need to cut the wires back and replace these connectors. Make sure you turn the power off before doing any of this ... Bosch 24 in. SHX46A05UC Built-In Dishwasher

I have a shu43 bosch dishwasher and the whole machine is dead. No power. The circuit breaker is good but I would have to pull the dishwaher out to check the outlet. Is there an internal fuse?


There is no internal fuse (at least I've not seen or replaced any) on Bosch dishwashers. The most typical problems for Bosch are: 1) one of the power cord connections to the internal wiring is corroded and doesn't make a contact; or 2) the power butt ... Bosch 24 in. SHU43 Built-in Dishwasher

An electrical panel breaker switch was replaced after the microwave and dishwasher both lost power. The microwave works after replacing the main panel breaker. However the dishwasher will not show any power. Checked the internal circuit board, no burned areas, cannot find an internal GFI reset, what can I do to get power restored to the main control panel or even the unit itself? Rick C


1)check any fuse in the circut board.(blown off)\015\0122)check any loose connection of neutral (or)phase wire to the machine(or)in the switch. ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Frigidaire dishwasher model-GLD2445RFC0- PF code came on and then lost power to dishwasher. No power to dishwasher for 3 days now. Outlet is good and has power and circuit breaker is also OK.


PF flashes \015\012 if the washer loses power during a running cycle. If you have PF code and machine has power, \015\012 just press START to continue the cycle from the moment that power \0 ... Dishwashers

MDBH945AWW maytag dishwasher panel lights will not light up. checked breaker and was not tripped. Hardwired circuit. will check tomorrow to be sure power gets to dishwasher. Suspect have panel control failure. In which case should I box it up for the local dump.


These control boards do not have fuses on them. I opened mine up when the front panel touch pad stopped working and the LED indicators were anemic. This is a sign of the ribbon cable connections have oxidized. The ribbon cable connects the touch p ... Maytag MDBH945AWW / MDBH945AWQ / MDBH945AWB Built-in Dishwasher

MY BOSCH DISHWASHER MODEL #SHU43C06UC/17 WILL NOT START. NONE OF THE LIGHTS TURN ON AS IF THERE IS NO POWER GETTING TO IT. I HAVE CHECKED THE POWER CORD AND THE BREAKER BOX AND EVERYTHING IS O.K., BUT I STILL CAN NOT GET IT TO TURN ON. AT ONE TIME THE LED LIGHT LIT UP FOR A BRIEF SECOND, BUT NEVER AGAIN. ANY OTHER SUGGESTION?


Hi-Check if there is a fuse at the back of the unit or inside of it. Replace if there is any.Keep us updated, thanksHope this helps ... Bosch Dishwashers

Miele Diamante G 2150 SCU Dishwasher problem ----The program cycle indicators "Rinse", "Drying" and "End" flash at the same time. The drain pump is running when the door is open. I have reset the power and cleaned the drain pump and non return valve and Spun the propeller several times in both directions to check for obstructions. Still has the same problem. Water is being drained continuously even with power switch on dishwasher turned off.. Had to shut the breaker off to get it to stop. A


Hi\015\012\015\012Plugged system or a jammed drain pump can cause these issues, also make sure the drain hose is not blocked. Check the drain hose for any visible clogging, remove if present. If no visible lint is present then remo ... Dishwashers

I have a Bosch SHU5315 dishwasher that doesn't turn on. I checked power getting to the machine, reset power at circuit breaker box and door lock appears to be working. Is this the power supply or computer brain motherboard?


Be sure lock at door is not loose switch at door if not closed wont come on ck door close switch ... Bosch 24 in. SHU5305UC Built-in Dishwasher

My Maytag dishwasher stopped working during a cycle. It looks like an electrical problem. I checked the breaker and looks OK. Looks like no power is getting to the dishwasher. Can you help ?


Your maytag dishwasher should hav a free inhome service\015\012\015\012http://www.bobvila.com/OnTheLevel/Maytag-Dishwasher-Reca ... Dishwashers

I have a Bosch SMU2046Uc/14 about 15 years old. Sometimes it works, sometimes not, for the last couple of months. Now it has stopped working completely as if no power. Checked the breaker. Another problem - one of our kids just today jammed the door lock on it and we cannot get the door to latch at all. Can you help with any one of these problems? How do you fix or reset the door latch??? What else can we check to troubleshoot the dishwasher? Thanks!


... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

Where is the reset button on a ge dishwasher ? GE dishwasher won't start up no power is getting to the machine..checked breaker and plug in all ok is there a reset button located anywhere ?


... GE 24 in. GSD2000Z Built-in Dishwasher

I got this dishwasher from a friend that had mice chew the hoses and i was told that it worked perfect before the mice chewed it. I replaced the drain and fill hoses plus the power cord. when i put everything back together and power on I get F1 on the top drawer and the rotor rotates and the heater plate turns on. The botton drawer does nothing with no display. I checked all the wires with a meter and found good continuity thru every pin. I replaced the main filter board. I even switched the


Did the F1 error in the top drawer disappear after you replaced the mains filter board? ... Fisher and Paykel 24 in. DD603H W Built-in Dishwasher

Kitchenaid dishwasher # kudp01flss doesn't power on . Checked the unit is getting power from the outlet.


There is a thermal fuse located inside the control panel of the dishwasher. The part number for the thermal fuse replacement kit is 8193762.There were some noted problems with certain model dishwashers where the wire gauge on the thermal ... KitchenAid 34 in. KUDP01FLSS Stainless Steel Built-in Dishwasher

Dishwasher I have had above integrated dishwasher which is intermittently tripping the mains fuse. Power is getting to dishwasher and the washing cycles work until a certain point (not the same time) where a loud bang can be heard and the main fuse is tripped. Reset the main fuse and power still gets to the dishwasher and it works again. It has just started to trip the fuse when its not running any cycle (just when power is getting to it). I've checked the fuse on the spur and it looks ok. I hav


Its quite common for the interferance filter to fail on these models its situated in the base of the dishwasher connected to the mains block usually when they fail you can see black dust around it, ... Neff 24 in. S5456 Built-in Dishwasher

Whirlpool dishwasher DU1015XTXBO Stopped working during cycle, acts like don't getting any power. Checked the plugin and it works. No lights or anything coming on the dishwasher. Its like it just


... Whirlpool Dishwashers

Quit mid cycle - no apparent power issue - house breaker OK - Outlet OK - Will not do anything - Checked the one fuse I could find in the control panel area - it tested OK. Is there another fuse/breaker in the dishwasher that may be the issue?


There may be a thermal fuse in the rear of the machine. If the door switch is faulty (which is common) then the machine won't do anything either. You can test the power from the power inverter to the control board with an ohmmeter to see if there is ... Whirlpool Gold GU2475XTV Builtin Dishwasher

We have this dishwasher at our firestation and have no power. We have checked the plug, and the plug is good. There are no lights, and we cannot get the machine to come on.


Hi,\015\012\015\012Welcome to FixYa.\015\012\015\012If you pull the kick plate/toe panel off you should see the junction terminals. Make sure there are no wires burnt up or loose. Let me know and we can go forward from there.\015\012\015\012Regards,\ ... Viking VDB450 Dishwasher

I have a GE Quiet Power 3 that has completly died. I cannot get a light to come on or anything to beep when pressing buttons. I checked the circuit breaker and outlet and they are both working fine. I tried pressing and holding the reset button on the front control panel and nothing. It seems to have just died at 2 years old. Anyone have a solution? GE wants $80 just to look at it.


A dead set simply means a cut off of power supply. Open the back cover of your dishwasher . Locate the area where the AC cord is located and look for the plastic fuse holder which is usually installed in one of the AC cord line open it and replace t ... Dishwashers

We have a 6 year old Jenn Air dishwasher model JDB2150AWP We had a cracked door close unit which we replaced but got a short while restoring connections I am wondering if there is an internal circuit breaker, relay or fuse on these machines that we need to check and possibly replace since we cannot get it to run at all. No power or lights at all. I believe all connections are secure and we replaced the door close unit with new parts.


... Jenn-Air 24 in. JDB2150AWP Built-in Dishwasher

Maytag 6 yr old Dishwasher - Model LR111721 Standing water in bottom of unit. Front panel lights do not come on. Checked circuit breaker in basement & it is getting power. Last time we used it it seemed to make a bit more noise than ususal.


... Maytag Dishwashers

I have a dishwasher (whirlpool) no computer or digital but when we close latch nothing happens , no start of anything, we check power and it is good to outlet, any suggestions?


Hi\015\012\015\012\015\012\015\012Thanks\015\012for using FixYa. Following are the main reasons due to which this problem\015\012occurs---\015\012\015\012\015\012\015\0121. Door is not latching properly. ... Whirlpool 24 in. ADP5966 Free-standing Dishwasher

Control panel will not light up, the dishwasher was running and now it has stopped mid cycle and will not do anything. I just replaced the control panel (black plastic with buttons, not control circuitry). was running the diswasher and it seemed to be working fine, then stopped. water is standing in tub, I checked the float, I don't think the float is the problem. There is power to the outlet, no tripped breakers. But control panel will not light up.


I have a kitchenaid dishwasher model # KUDC10FXBL1 I went to start it and none of the buttons were working. I have checked the breaker and the wiring and everything seems to be in order. ... KitchenAid 34 in. KUDP01FLSS Stainless Steel Built-in Dishwasher

My ge pdwt 280vss will not turn in, breaker is good and power to dishwasher itself is good as are wire connections


... GE PDWT280VSS Profile Stainless Interior Built-In Dishwasher with
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1727 seconds