Having problems with your Dishwashers ?

Our asko dw 1875 it stuck on F2 and we cannot clear it. I have clean the pump which did have a olive pip stuck in it but once cleared the machine starts in F2 and stays there.


Answers :

Hi,

(F2-Water Fault) It means there is water in the pan underneath underneath the unit. this is usually caused by over sudsing..either to much dishwasher detergent or someone put in hand soap..or my personal favorite is someone is washing a sponge or brush they used to clean the dishes with. This will cause oversudsing and will leak into the pan underneath. With power removed (breaker) you will have to remove the bottom panels and use a wet dry vacuum to remove all excess water from underneath and it will begin to restart to work again. Now if there really is a problem then you will know cause it will do the same thing again and will more then likely need a motor were they are known to leak.

Let me know, if needed further assistance.

Hope i helped you.

Thanks for using ' Fixya ' and have a nice day!!
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Our asko dw 1875 it stuck on F2 and we cannot clear it. I have clean the pump which did have a olive pip stuck in it but once cleared the machine starts in F2 and stays there.


Hi,(F2-Water Fault) It means there is water in the pan underneath underneath the unit. this is usually caused by over sudsing..either to much dishwasher detergent or someone put in hand soap..or my personal favorite is someone is washing ... Dishwashers

We have started experiencing a problem with our Kenmore Elite 655.15982 dishwasher. Each time we close the door, NoHeatDry lid would go on immediately. It would stay as is of would go flashing. If you touch any button, LockOn lid would go on. Then no other buttons would respond. And often both NoHeatDry and LockOn indicators would be flashing... We tried turning machine for an extended time on the fuse, etc. At times it would work for some time and then cycle get stuck again at the same p


These errors are due to a faulty control board and needs to be replaced. If its still underranty get it fixed before it expires as it is a costly repair to replace. ... Dishwashers

I have a new FDB520RHS2A Frigidaire dishwasher which remains in the wash cycle after I've started it. It sounds as if it is changing cycles but the wash light stays lit and never switches to rinse. The machine continues to run for hours if I don't stop it. We've checked the drain to the garbage disposal and it is clear. the water temp seems to be hot enough but how do I check that? Any ideas on what we should check before we bring it back to the store? Your help is much appreciated. Thanks!


... Dishwashers

Good mroning after starting any program first the pump will run followed by water intake. After a while the machine stops and the light intake/drain starts blinking. Most of the time water will stay in the machine. After pressing the on/off bottom first switching the machine on again and starting a new program the machine pump start running emptying the water but than stops after a short water intake again. I opened the water stop but it seems to be ok. The filter inside the machine is cle


Good morning don't get shocked because ullu ki to abhi subah hi hui he ... Miele 24 in. G892SCU Plus Built-in Dishwasher

My dishwasher started making a whirring sound around 20 minutes into its cycle. I took off the drain pipe to check for obstructions, however it was clear. I started the cycle from the start again, and it started the whirring sound from the start of the cycle. There was a small amount of water that drained into the bucket where I had placed the drain hose, however there was not much water in the machine to start with (I checked when it started whirring the first time and there was no water in the


Hi.\015\012\015\012A blocked pump in absence of water won't be noisy from start. Check that\015\012 the whirring sound is not given by the spray arms. Test without baskets\015\012 and check the spray arms assembly.\015\012\015 ... Fisher and Paykel DS605I Built-in Dishwasher

BF41 Dishwasher with a leak stuck in mid cycle Hi, I have a 'general domestic Appliance Ltd' BF41 (95+G709394) dishwasher which recently started leaking at the door. After replacing the seal the problem seemed to ease, then recently the problem started all over again and the leaking got worse. A couple of day ago I couldn't stop it leaking and now it's stuck in mid cycle and even though the water is washing inside the machine it never gets hot inside or finishes the cycle. Ive tried stopping and


... Dishwashers

I have a Bosch SHU43C06UC/14. A few weeks ago it was making a loud terrible noise during the entire cycle. We figured it was on its last leg but it was still cleaning the dishes properly. Then with no explaination the noise stopped and the machine sounded normal again. Today when I started the machine it makes the normal sound when starting, but it acts like it is stuck at the beginning and does not fill with water. The timer also does not count down.


... Bosch 24 in. SHU43 Built-in Dishwasher

Have whirlpool gold dishwasher made in Mexico, the control lock light stays on, when i push it and hold it just blinks three times and then stays on steady and then does the same over and over, before it did this I noticed the lights for different cycles flashing randomly, and even pushing cancel button once in a while would start the machine up....I have tried to unplug the machine and then plug back in, but nothing is helping....any ideas??


... Whirlpool Dishwashers

I have a Bosch SHU43C06UC/14. A few weeks ago it was making a loud terrible noise during the entire cycle. We figured it was on its last leg but it was still cleaning the dishes properly. Then with no explaination the noise stopped and the machine sounded normal again. Today when I started the machine it makes the normal sound when starting but it acts like it is stuck at the beginning and does not fill with water. The timer also does not count down.


... Bosch 24 in. SHU43 Built-in Dishwasher

Viking dishwasher M# DFUD142-PSS drains a little bit only then starts refilling, start button is blinking. When pressing the 2 buttons to drain have to press several times until responding then it drains just fine, also no push button light is on when pressing for drain. After doing all this machine worked fine for one wash only, then the same problem again after the wash cycle the water stays in the machine. Please help, thank you


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. Dishwasher not draining properly or not draining at all issues\015\012can arise due to different reasons ... Dishwashers

FDW60 dishwasher - taken apart pump and that is clear. Seems that dishwasher fills, and empties and heats all OK but water wont go around the machine ie the motor pump doesnt start - any idea how to take this out and replace without having engineer around? Taken small pump apart and its clear. First of all the Eco and fast light flashed, then we took it apart with some direction from online discussion advice. Now Eco and Pre wash lights are flashing. Machine empties water, then fills with


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

I have a Whirlpool GU1100 built-in diswasher that will not clear the pot & pans selection. It is stuck with the pots & pans and the cancel buttons lit and blinking. It will not start or clear. I have tryed to shut the power off for awhile and this has not helped. Other buttons can be pushed and will light but the other two remain blinking. If the clear button is pushed it will clear the other button but not the pots & pans or itself. Is this a problem I can fix myself?


... Whirlpool Dishwashers

My Bosch Classixx (about 10 years old) dishwasher won't fill The problem has only started since I pulled it out and cleaned! The programme sounds are as normal but no water enters the machine. I detected a small leak on the inlet pipe and tightened that. The machine drains when I add water manually though it has made a lot of gurgling noises for some time now when draining. When tipped on its side water comes out of the bottom of the machine (not entirely clear but not dirty either). When upri


... Bosch SHU9915UC Dishwasher

I have a Miele Turbothermic dishwasher which is nearly 3 years old. The Inlet/Drain (red) light is flickering and the washing cycle was not completed. I cleared the strainer but have not been able to clear the the dirty, stagnant water. I tried re-starting it with everything out of the washer but nothing has changed. Is there a way to clear the water and get this machine working again? Many thanks. Loretta


Please provide the full model number of the Miele dishwasher.\015\012\015\012Have you checked that there is no blockage in the kitchen drain especially if you use insinkerator (disposer unit) in the sink. ... Miele Dishwashers

I have a kitchen aid dishwasher that is stuck on the clean cycle. It will drain water, but no water seems to be getting into the washer. If i push the start button, cycle will not start. The clean light is the only light that will stay on. the other lights will go on, but they eventually go off without starting the cycle. Is this the thermal fuse???


... KitchenAid Dishwashers

Hi there There appears to be no water entering the machine. Have checked the inline filter + the main machine filters, all clear. Machine all lights up as normal but will not start cycle


... AEG 24 in. Favorit 44050 Built-in Dishwasher

I have a whirlpool DWH B10W. Last week the main drain outside blocked and none of my service machines were working (not draining). The main drain has now been unblocked and every machine except the dishwasher are now working fine. The plumber has checked the drainpipes again and says all are now clear. When I try to use the dishwasher, after the initial drain it stops and starts beeping at me. I have also noticed that no water is going into the machine. What's happening?


The error most likely indicates a Long Drain Sequence (Drain Exceeds 8 Minutes) - Select 'cancel' twice to clear error code. \015\012 \015\012 \015 ... Dishwashers

My Asko D1996 Dishwasher will not start. The control panel has 3 lights staying on - position #1, 6 and 7 and are unresponsive no matter what buttons are pushed - even after turning the power off at the breaker, the outlet and the on/off button.I've tried holding down the start button for several seconds to reset but this did not work. I have also cleared the drain, filters and removed any water and pushed and held the Start button to reset.


... Asko Dishwashers

Kenmore dishwasher 665.17534202. something is wrong with either the timer or the motor. On a normal cycle it starts at 78 minutes and gets down to 48 minutes and it stays stuck at 48 minutes for appro


Http://www.allrepairmanuals.com/kenmore-dishwasher.htm?model_number=+665.17534202 ... Dishwashers

3sec light stays on and the machine wont start


... Amana ADW662EA Built-in Dishwasher

Hobart lx-g HI there, I have a weird problem with my dishwasher... when I press the off buttom, instead of staying off... it restarts by itself. Also, when it starts filling up, water overflows from the machine ( when it filling up the temperature rises alot more then usual it reaches 190f) and then i turn off the machine to stop the flooding... can you help?


The problem with the machine restarting is with your keypad, the on button is stuck on and needs to be replaced or you can continue unplugging it. Your other problems are most likely caused by lime build up, is the inside of your machine white. I ... Hobart 24 in. LXIH-3 Built-in Dishwasher

I have a Kenmore Ultra wash Quiet Guard 3 dishwasher and the green flashing light that states its clean stays on and stays flashing. I can not even get it to start a wash cycle. please help. What is the button sequence that everyone is talking about that clears this? Thank you.


Hi\015\012\015\012\015\012Thanks for using FixYa. To resolve this you will have to reset the console. Do this by closing\015\012the door and press these buttons in sequence...\015\012\015 ... Kenmore 24 in. 15689 Built-in Dishwasher

Water will not pump out of the dishwasher and there is a grinding type sound. Some broken glass fell into the machine a day before this started happening so some may have stayed in machine after cleaning it up.


Hello & Welcome to FixYa \015\012Dishwasher not draining completely problem usually occurs due to clogged/blocked dra ... Miele Dishwashers

Dislex dx103wk dishwasher has problem with start up.With door closed and dialed to any wash preset.ei pots for example.with start pressed and both lights onthe machine stays on initial drain setting and will not commence wash.


... Electrolux Dishwashers

I have a mh65m2 moyer diebel dishwasher at the resturant and some days it works great and other days it doesnt but here in the past two weeks it hasnt been going threw all the cycles one day it stays in the rinse cycle and other days it stay in the soap cycle is there anything i could do to restart the machine or fix it because it is really starting to cause the restuarant trouble? please help me if you can.


... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1290 seconds