Having problems with your Dishwashers ?

My Zanussi ZFX6066 model runs for a short while

\015 My Zanussi ZFX6066 dishwasher model runs for a short while then trips the circuit that it is on. If it means a call out I am inclined to buy a new one but would love to know if there is a quick fix?\015\012\015\012Tom\015

Answers :

Call the repairman, only him can tell you if is a quick fix or not. is hard to tell you from your few words who told me. is more wise to call an expert to see live the washer. I repair evry day professionall washer's and i know that is more exacly to see whit own eyes before you can tel what repair is needed. (sory my bad english writing)
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Zanussi ZFX6066 model runs for a short while


Call the repairman, only him can tell you if is a quick fix or not. is hard to tell you from your few words who told me. is more wise to call an expert to see live the washer. I repair evry day professionall washer's and i know that is more exacly to ... Dishwashers

For Miele Dishwasher G2470SCVI Need help with remaining water in the bottom. Model# G2470 SCV1 SF Type-HG03. Runs through the entire cycle,long,short ect..everything is clean and dishes look great but


See this causes and fix it. God bless you\012 \012 \012 \012 \012 Belt, Water Pump\012 \012 \012 \012 \012 \012 \012 \012 \012 ... Dishwashers

Whirlpool dishwasher model GU2-400-XTB7 Problem started with display cycling through delay times. (1 hr, 2hr, 3 hr and so on.) Was able to cancel that for short periods and then it would repeat the cycle. Was able to run dishwasher by pressing different buttons. Then it would start a cycle but did not run full cycle. Now control panel doesn't work at all. When buttons are pushed, lights do not light up and nothing happens. Is stuck in lock mode.


... Whirlpool GU2400XTP Built-in Dishwasher

My Bosch dishwasher, model SHX46A05UC/30 has been working fine. I ran it once today on the Power Scrub Plus cycle (always use this one). Shortly after unloading the dishwasher I needed to run it again with more dishes. Within a few minutes of running the dishwasher I heard loud, almost grinding noises. Nothing appears to be stuck. Any ideas on what to do? This dishwasher has always been quiet up until today.


... Bosch 24 in. SHX36L05UC Stainless Steel Built-in Dishwasher

I have a Kenmore Elite dishwasher (model 665.1315), and the dishwasher will run through the wash cycle as expected, but when it gets to the heated dry cycle , it doesn't appear to dry. It will then flash a fault code 81 (8 short flashes of the 'clean' light, pause, and then 1 more short flash of the 'clean' light, longer pause, and repeat the code). The dishes seem to be somewhat dry, but there is certainly water on the dishes and on the tub (there is never any water standing in the tub, and t


Hi,Check your heating element.. \012A bad heating element causes many problems in dishwashers...Dishwasher Problems The ... Kenmore 24 in. 15932 Built-in Dishwasher

Kew power washer,model Alto Force E. Will run for about ten minutes, then stop, often for days. Appears to run on two settings - occasionally gives bursts of real power, then reverts to adequate. Stops shortly after wards


... Pressure Washers

We have a 6 year old Jenn Air dishwasher model JDB2150AWP We had a cracked door close unit which we replaced but got a short while restoring connections I am wondering if there is an internal circuit breaker, relay or fuse on these machines that we need to check and possibly replace since we cannot get it to run at all. No power or lights at all. I believe all connections are secure and we replaced the door close unit with new parts.


... Jenn-Air 24 in. JDB2150AWP Built-in Dishwasher

After installing the new Kenmore model 665.13293k I tried to run a short cycle. Nothing happened and the selector lights timed out. Checked water supply and filter screen - OK. Panel lights so power is on. I don't hear any sound from the electronic water valve when door is first closed.


... Dishwashers

I have the dishwasher model number FGHD2433KF, I have noticed the last few times I try to run the short cycle that after a few minutes it jumps to 99+. What could be causing this and how do I fix it?


Sounds like the control board is having a communication error. Reset the unit at the circuit breaker and retry. If it happens again contact the manufacturer for a repair. ... Frigidaire FGHD2433KF Builtin Dishwasher

Model idl530.just put new drain pump on and worked ok for two short cycles.now it will not run up at all .got one of the green lights flashing ,seems to me problem with main motor


... Indesit Dishwashers

We have a three year old dish washer model fdb1200, it will run for a short time and stop !


... Frigidaire Dishwashers

I have Craftsman 6.75 horsepower pressure washer model no. 580.7527000 I starts and then shuts off.have change spark plug. still runs a short time and dies.


Replace the gas, check the air filter is not clean. ... Craftsman 2500 PSI Briggs Stratton Powered Pressure Washer

Zanussi dishwasher model ZDF 221 anti flood lights flashing


... Zanussi Dishwashers

Diswasher will start and run for a short time but then stops,it seems to take the water in then runs short cycle then pumos the water back out and then it turns its self off


... Asko 24 in. D3120 Dishwasher

Hi there, Ok, i think i'mHi there, Ok, i think i'm getting close to solving this problem. I have an LG dishwasher- Model # LDS 5811ST. I have stripped it down and clean all hoses etc. It is running fine through all the cycles. The only problem is that it has no water pressure. In other words water is pumping into the More Hi there, Ok, i think i'm getting close to solving this problem. I have an LG dishwasher- Model # LDS 5811ST. I have stripped it down and clean all hoses etc. It is running fi


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. In\015\012this case you’ll need to check the water inlet valve. Disconnect the power\015\012source to dis ... Dishwashers

How do you run the diagnostic on a bosch dishwasher model # SHE44C06Uc/22. it counts down to one on the timer and runs forever. can't find it model # diagnostics anywhere. thanks


Resoldering the relay, regardless of how proficient one is at soldering, will not be a long term solution. The melted/burned solder joint is a secondary result of the initial failure, which is the relay itself. There is a solution that is more perman ... Bosch 24 in. SHE44C02UC / SHE44C06UC / SHE44C07UC Built-in Dishwasher

Hello, I have a Kitchen Aid (model # KUDMO1T JWHO) dishwasher that runs the motor in all cycles, with water fill & drain working fine, but the pump is not pumping water during any cycle, as the spinners and the inside of the washer are dry when I open the door, except for the water sitting in the bottom. Also, no normal swishing sound of water when the motor runs in any cycle. Looks to me like a mechanical break in the pump drive. How do I check the pump drive on this model? Do you have any


... KitchenAid Dishwashers

Our dishwasher came with our house. Brand new. It is 2 yrs old now, warranty gone. The problem is when you shut the door the machine starts running immediately and keeps running and running and running. You can push the stop button, delay button and it still runs. Also, doesn't clean. model# FDB1050REC4


... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

I have a craftsman Pressure washer Model 580-725400 the unit has ran great until today. I last used the unit 1 week ago with no problems but now I have to run the machine almost full choke to get it it rev up and run smooth. The engine oil is clean and filled to the proper point. The spark plug is new and gapped proper. The air filter is new also. And the gas is 97 Oct and fresh. When it choke it to crank the engione I move the choen to run and the engine struggles to run. When I move the choke


... Craftsman Pressure Washers

Our ESD310 has a message of OP on the screen. It will come on and run on its own if the door is shut, counting down from 2. When I can get it to turn on and start a cycle it runs a bit, skips a bunch of time, runs a little more, and then skips time again counting down from 2. The high temp wash button will light up on it's own while running. The cancel button does not work. It acts as if it has a short, makes funny noises, and I'm afraid it's going to catch on fire.


... Haier ESD310 24 in. Dishwasher

My problem is with a Eurotech Model ED254EG timer will not continue running thru the cycle properly. i.e. In "Light Load" position the timer starts with 59 minutes but actuall runs for 2 1/2 to 3 hour


... EuroTech EDW242C Stainless Steel Built-in Dishwasher

Maytag Dishwasher Model MDB4100AWQ When I start the Light Wash Cycle: Washer fills with water, heater comes on (I checked it with a volt meter--120 volts), timer runs, motor never runs, before the timer gets to "rinse" the heating delay light on the door comes on and the timer stops. The heater is still on (120volts) nothing further happens it just boils away on the water in the washer. Note: If I manually forward the timer to "rinse" the motor will kick in and run but does not pump out w


Most common d/w power is 120 volts, check for 120 volts with a  ... Dishwashers

I have a Bosch dishwasher model shx43c05uc. When I turn it on the drain pump is running, but the water does not run. We opened up the panel on the bottum and jiggled the run-over switch (the red one). That did not help.


... Bosch Integra 300 Series SHX43C0xUC Built-in Dishwasher

I received a second-hand as-is Akso D3530 (model #107353001) dishwasher. It washes perfectly fine, but at the end of the cycle, it keeps running. It does not seem to be the drain that is running, but rather the circulating pump. I have fully emptied the pan of water (there was only a little in it (you couldn't see it until you removed the sieve) using a turkey baster and it keeps running. I also checked the float sensor in the bottom. The float sensor is not tripped, and when I manually trip it,


Hi.The float switch is not a water level switch, but an overfill switch. The control board uses the input from the pressure sensor to decide when to stop the pump.When you open the float switch circuit the machine 'thinks' that ther ... Asko 24 in. D3530FI Built-in Dishwasher

I have a Kitchen Aid dishwasher. IC Series. Model # KUDN230YWH. The dishwaser fills and runs but it does not cycle past that. It will run until we shut it off. I can hold the button in and it will click and to get it to the drain cycle and it will drain but it will not do it on its own. It just fills and runs. Thats it. Thanks


Hi\015\012\015\012Thanks for using FixYa. If the cycle doesn't\015\012complete, then the first thing that should be checked is the Timer and then the\015\012heating element. Timers don't often ... KitchenAid 24 in. KUDP02SRSS Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1046 seconds