Having problems with your Dishwashers ?

The machine floods as there is no water going out


Answers :

Clogin the hose. disconnect and drain . put something like a pot to catch water
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hi i have a zanussi electrolux zdf601k dishwasher and the anti flood keeps kicking in, it happened after the inlet water pipe froze but it now ok and works fine when i tip the water out of the overflow tray, the machine then runs fine but i am having to tip it everytime i go to use it to reset the anti flood


... Dishwashers

Dishwasher flooded dishwasher has flooded now the water wont go in to the machine ?


These 2 things that may happen \015\012\015\0121.- the cycle was interrumped \015\012\015\012to find out if this was the problem let the dishwasher go full cycle with out opening.\015\012\015\012If this won't solve ... Hotpoint 23 in. BFI62 Built-in Dishwasher

Dishwasher Water is not going through upper and lower spray arms. Checked overfill protector switch, inlet valve, inlet valve screen, pump blades move freely, Pumb motor is working , Water enters into machine but does not go throught spray arms. Water heats up, Machine will go through all cycles but without water going through spray arms. 650 / 690 series gldb656jso


... Dishwashers

We just installed a Fisher & Paykel DD603 dishwasher. Intially it would not drain correctly. And, proceeded to flood the bottom and set off the F1 error code. I dried out the bottom to get the F1 code to stop, which it did. After adjusting the leveling the dishwasher drained both drawers correctly, once. A few minutes after the rinse cycle had finished and the drawers were empty of water the F1 code started again. Now it will not go away unless I unplug the machine. I dried out the bottom very w


HI. The original code(f1) is in reference to a overfill condition. This may be a clogged drainage Assembly. This condition will usually cause the control sector to short out if not corr ... Dishwashers

Machine floods water does not go out via exit hose


Clogged in hose .disconnect from hose put something to catch the water then drain unit ... Dishwashers

The machine floods as there is no water going out


Clogin the hose. disconnect and drain . put something like a pot to catch water ... Dishwashers

Hi I have a Neff built in dishwasher s5453X1GB/70 about 4 years old. Never had a problem before. Came downstairs last night to find the kitchen floor flooded. Water also still in machine. But must have been near end of cycle as plates all clean. I have read other links and opened pump compartment in centre of machine and syringed out all water and cleaned fan. When i switch on machine it is still making odd humming noise (emptying cycle?) I have read about anti -flood valve etc. Any more tip


... Dishwashers

Dishwasher flooding Hi my Asko D1716 Super Cleaning System Dishwasher has started to have a flooding problem. When the cycle finished last night it seemed fine then in the morning the machine was full of water, I scooped out the water and by this evening the machine had flooded onto the kitchen floor. I tried other solutions I found on this website but they didn't suit my dishwasher as it doesn't have the appropriate buttons. Any suggestions would be appreciated!


When you say that you tried other solutions.. it's hard to know which you've tried and which you haven't so I will suggest some basics first.. ( if you've tried them, then disregard)...\015\012Have you checked or addressed the following:\ ... Asko D1716 Built-in Dishwasher

I have an Electrolux dishwasher model ESF489, and I can't get water to go into it.the water goes as far as the machine then the inlet hose just pressurises up.I know the hose is clear .The machine tries to go through its cycles but because the water will not flow,it just cuts out after a few seconds.????


Assuming the control card is working ok, the most likely problem is the water inlet valve which may have a faulty solenoid. Do you not get any indication of beep or fault lights on the dishwasher.\015\012You can find a possible replacement at ... Electrolux Dishwashers

Dishwasher wont fill with water. just before it stopped filling i was turning the dial (a lot) between the wash cycles back and forth to attempt to get it to fill and drain (I didn't let it go through a cycle). We also removed the hose from the machine as it had split and replaced it and we had the machine tilted on it's side. the dial still clicks round but it sounds like the pump is going and it doesn't seem to be filling with water. Help


Hi. I suspect that the timer mechanism will be the culprit here, but i recommended to inspect and test the water inlet valve, before replacing the timer. The valve is a known problem area, as well. Follow the valve inspection procedure below, careful ... Fisher DS603W / DS603B / DS603I Dishwasher

Turn the machine on it makes all the right noises but there doesn't seem to be any water going into the machine. the hose that fills it is ok and water is coming through it . i just dont know where its going once its supposed to come out of the wash bars as they seem to remain dry please help Jenn Air Quiet Series


Hi\015\012\015\012 \015\012\015\012Thanks for using\015\012FixYa. It means that the water inlet valve has gone bad and needs to be\015\012replaced. Please do\015\012accept the solution if the issue is resol ... Jenn-Air JDB6510 Built-in Dishwasher

Turn the machine on it makes all the right noises but there doesn't seem to be any water going into the machine. the hose that fills it is ok and water is coming through it . i just dont know where its going once its supposed to come out of the wash bars as they seem to remain dry please help


It sounds as if your inlet water valve or it's solenoid has failed.Please reply with the make & model # of the dishwasher.Thanks!!nc ... Dishwashers

Turn the machine on it makes all the right noises but there doesn't seem to be any water going into the machine. the hose that fills it is ok and water is coming through it . i just dont know where its going once its supposed to come out of the wash bars as they seem to remain dry please help


Your inlet valve has a screen on it.This is probaly clogged, it does happen. At the bottom of your dishwasher ther will be 2 - 4 screws holding the front panels on. UNPLUG FIRST! Remove the panel/s. TURN OFF WATER TO DISHWASHER! you Will have a cop ... Jenn-Air JDB6510 Built-in Dishwasher

Bosch dishwasher = machine on but no water, so the lower basin has water in it and because of it the FLOOD CONTROL SWITCH IS ON, so how do I drain the rest of the water so the FLOOD CONTROL SWITCH goes off? A plastic cover with a seal is stopping me from drain the water below?


If you can see the water use a shop vac if not you will have to pull the unit out and remove the left side panel after removeing the water you will need to find the leak that caused the bottom to fill with water ... Bosch 24 in. SHU66C05 Stainless Steel Built-in Dishwasher

No water going in dishwasher, have checked water supply and small filter at the back of machine. water coming from bottom of the machine


This happened to a GE machine of mine once, and the problem was a stuck float..Inside the dishwasher tub, in the front-left corner under the silverware tray, there's a float that keeps the dishwasher from overfilling. If this is stuck in the " ... Bosch Dishwashers

I HAVE A MIELE G646 SC DISH WASHER AND IT KEEPS LEAKING WATER INTO THE LOWER TRAY AND CUTTING OUT BECAUSE THE FLOOD SYSTEM KICKS IN.I HAVE THE MACHINE IN THE GARAGE WORKING UP ON TWO WORK MATE WITH THE UNDER TRAY OFF FOR THE FIRST FEW CYCLES THERE WAS NO LEAKING THEN WE FOUND IT LEAKING DOWN THE FILL PIPE.THE WATER IS LEAKING FROM AROUND THE AREA THE FILL PIPE FITS TO THE WATER SOFTNER BUT NOT ALL THE TIME.AN ENGINEER FROM MIELE SUGESTED IT COULD BE THE VENT INSIDE THE SIDE OF THE MACHINE BUT EV


Have you made sure the water sofener filler neck locknut is tight to the bottom of the dishwasher?i have had experience with one machine where spilled salt was not rinsed away after the softener was filled and this corroded a very small pin *** ... Miele 24 in. G646SC Plus Free-Standing Dishwasher

Washer Dishwasher fills with water, wash cycle does not start up. The machine continues to go thru the wash, rinse, cycle, discarding water, filling again, etc. but no water sprays in the machine, Thanks for any help !


If I'm not mistaken, these dishwashers are built by Asko for Viking. If thats the case then you probably have a bad circulation pump. Under Asko's warranty (not sure if Viking is the same) these pumps are covered parts and labor for 3 years from inst ... Viking 24 in. Professional Series VUD040 Stainless Steel (Premium) Built-in Dishwasher

Hi I have a Nemo Dishwasher and the top spray arm is not turning. The bottom one is going fine and there is certainly plenty of water getting into the washer as I opened the door with the washer going and it flood me. I can see the water getting into both spray arms - the bottom one has a excellent upward spray and turns - the upper spray arm has water getting into it but it will not turn. I have cleaned the dishwasher out and any internal parts that I could find so it is spotless - this is so f


... Fisher and Paykel DS602 Dishwasher

I have a whirlpool ADG 7550 dishwasher. The water is going in and it heats and appears to go through its cycle but the dishes are just the same as when they went in. I don't think it is spraying the water inside the machine it just seems to fill up at the bottom with water


Hi If you are noticing that the dishes are not clean, then there are a few things to check for. Check the soap powder if it's kept in a dry environment. Also try replacing the powder with something like a gel or liqu ... Whirlpool Dishwashers

We have a problem with our Miele G851 SC Plus dishwasher. We have not operated it for over three months as we were away on vacation and also because there were other issues in the kitchen due to some water flooding . Yesterday we switched on the machine and notice that the machine flashes the intake / drain light after a few minutes into the cycle and stops working. we have checked the drain pipe for blockages and also the water pressure is good. I disconnected the machine drain from the


Www.miele.ca/miele/canada/OperatingInstructions/.../G851%2005431311.pdf\015\012\015\012\015\012\015\012 ... Dishwashers

Water is not going into beko dishwasher de2542f .you can hear and feel water going through the pipe but is not going into machine


My BEKO dishwasher is turned off but there is a constant dribble of water running in to the machine. If I open the door when this has happened, it leaks water all over the floor. This means I have to keep turning the machine on to drain the water a ... Beko 24 in. D3731F Free-standing Dishwasher

We installed a Samsung DMT 300 and gave it a test run. All went well. The next time the lady used it it would not pump water into the machine. We went back and checked and there is water to the machine but it will not go into the machine. Any ideas? Thanks.


... Samsung Dishwashers

Water not entering machine water connected and going into cold tap but not into machine Internal filter ok Machine pulled out from wall so no kink in ipe


Hi,Here is a tip the will elaborate on your problem more, but the bottom line is that you need to replace that fill valve...Dishwasher ... Indesit 24 in. IDL700 Built-In Dishwasher

Hi can you help me please I have a Zanussi DX6453 dishwasher which has stopped working. Having used the diagnostic facility it has come up with anti flood device, I have done the usual rocking the machine back and forth no sign of water. I have taken the machine apart and looked at the anti flood switch and this is bone dry and by lifting the float you can hear the switch clicking on and off. When I reassemble the fault is still there I'm begining to think the switch is faulty but not sure, do


... Zanussi 23 in. ZDT6255 Built-In Dishwasher

I HAVE A 2 YEAR OLD BOSCH DISHWASHER. WATER WILL NOT PUMP INTO THE MACHINE. IF I POUR WATER IN IT PUMPS RIGHT OUT. THE DOOR WILL NOT LATCH AND CAN PUSH RED DIFFERENT CYCLE BUTTONS ONE AFTER ANOTHER. YOU USE TO HAVE TO SHUT THE MACHINE OFF TO GO TO A DIFFERENT WASHING CYCLE LEE


Hello thereThere are a couple of reasons why a dishwasher will not pump water into the machine or even work once the water is in the machine i will post the possiable reasons and some troubleshooting tips for this in 2 different post's ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1408 seconds