Having problems with your Dishwashers ?

Dishwasher does not have any power. Breaker and wire are fine .


Answers :

You have to check the terminal box at the power source. see if the wire there are burnt or arced . let me know if i was correct with 4 thumbs ups post
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Dishwasher fills with water and then stops. No lights are on at all. I cked wiring and circuit breaker and no issues there. I then flipped off circuit breaker over night. Got up next morning and flipped breaker back on. Dishwasher lights were on and when I pushed Start button, it ran fine. Now it is doing same thing except circuit breaker trick dont work like last time. THERE is NO issues with wiring or connections to dishwasher.


... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

Completely dead. breaker is fine. have live power at dishwasher. ???? Replaced heater, pump and check valve last year. No obvious burnt or disconnected wires.


There is a thermal fuse located behind the operator console on nearly all Kenmore or Whirlpool manufactured dishwashers. There were some noted problems with certain model dishwashers where the wire gauge on the thermal fuse was too small and would he ... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

Dishwasher does not have any power. Breaker and wire are fine .


You have to check the terminal box at the power source. see if the wire there are burnt or arced . let me know if i was correct with 4 thumbs ups post ... Dishwashers

Have an electrical circuit that has stopped working. Romex circa 1930. The breaker is fine. There are 4 ceiling lights and 3 outlets on the circuit. There is power through the hot wire leaving the breaker. Tried wiring to a different breaker to be sure. Still no power


If there is power leaving the box, you have a broken/damaged wire somewhere.If all the lights and outlets do not work - the problem is with the common (return) (white) or a broken/damaged wire before the first item in the circuit.If the b ... Dishwashers

When exterior breaker panel was replaced, my Frigidaire dishwasher (model FDB989GFC2) was accidently wired to 2 breakers and briefly took a 200v load. It started, then immediately showed a Power Failure code and shut off. The wiring has since been corrected but the dishwasher now shows no signs of life. Is it terminal or can replcement parts solve the problem?


Hi\015\012\015\012\015\012Thanks for using FixYa. You’ll need to check the following things--\015\012\015\0121. Fuse (blown or tripped).\015\0122. Check the wire fasteners at dishwasher junction box. ... Frigidaire Dishwashers

My ge pdwt 280vss will not turn in, breaker is good and power to dishwasher itself is good as are wire connections


... GE PDWT280VSS Profile Stainless Interior Built-In Dishwasher with

My dishwasher so my dishwasher seemed to have quitworking during a cycle. like breaker triped or something. i checked the breaker and thats fine. it seams like its hard wired in though. Would that be right? and is there a fuse or something that could/would blow during a wash? I dont know what model it is or anything it was in the house when i got it. The dishwasher is built in and it seems decently old its a kenmore ultra wash and it has like 10 buttons for the differend cycles on the left and a


Sounds like the fuse on the control blew. you can replace the fuse for\015\012around $20 or you can cut and splice the wires for free. If that doesnt\015\012work then you may have a loose conection in your junction box under the\015\012dishwasher. ... Kenmore 24 in. 15932 Built-in Dishwasher

When I push the power button on the dishwasher, there is now no power and the dishwasher does not turn on and there are no lights generated. The circuit breaker has been checked and that is not the problem. Dishwasher was working fine until a week ago.


Try a fan or light where the washer is plugged in. Suspect a bad power plug connection if the test works. The next suspect is a faulty microswitch connected with the door latch mechanism. You will likely need a test meter to track this down. Good luc ... LG 24 in. LD-12BW5 Free-standing Dishwasher

My Frigidaire fghd2433kf1 starting flashing PF occasionally. I would open and close the door and it would go away. It became more frequent until two days ago when the dishwasher stopped mid cycle and flashed PF. When I opened and closed the door, everything went dead and the dishwasher no longer works. It acts like it has no power coming into it. I checked the breakers and the wires connecting the power into the dishwasher. No luck. I replaced the control panel, but not the control board. It did


... Frigidaire FGHD2433KF Builtin Dishwasher

No power I went to use my dishwasher today and it wouldn't come on. it's like there is no power. it was working fine. this is all of a sudden. the breaker is fine, it is pluged in. is there something else that i should check like a reset button or something?


Perhaps you should check the fuse in the plug and in the breaker,if there is still no power maybe a circuit has blown in which case you should call yhe manufacturers for qualified technicians. ... Frigidaire GLD2445RFC Stainless Steel Built-in Dishwasher

Maytag MDBH979AWS dishwasher - there appears to be no power coming in to it. The dishwasher will not turn on and there are no lights on the control panel. I checked the power in the breaker box and it works fine. Any suggestions what to do next?


Maytag MDBH979 power sensor will not turn on dishwasher. The other buttons and lights turn on when pressed but not the power button. Please help. ... Whirlpool MDBH979AWS Builtin Dishwasher

Bosch Dishwasher I have a Bosch Dishwasher that is a little over a year old. Loaded it up and ran it last night. Got up this morning to unload it, and load it again. Got it all set and went to start it but there is no power. The circut breaker looks fine. But no power to the machine. Not sure what is going on, or what needs to be done. Thanks....


... Bosch SHU3306UC Built-in Dishwasher

I have a GE Quiet Power 3 dishwasher that was working fine last week. Over the weekend I ran it and we could hear a banging noise, so my boyfriend opened it three or four times in a row (during the cycle) to figure out what it was. The fourth time, it went dead. I checked and it had tripped the breaker. I reset the breaker and the dishwasher seemed to be working again, however the lights on the front were flashing (they hadn't previously), and now it will run for about 10 minutes but no water ru


Were you able to figure this out? We have the same problem here! ... Maytag Dishwasher

See below This is a post that I just copied to this space "I have a whirlpool Quiet Partner II, Model GU2400XTB1, that just suddenly will not start, as if the power was cut. Circuit breaker is fine. from the little Internet research I've done it looks as thou it could be a thermal fuse problem. How easy are these to replace, assuming that's what it is?" Mine is quiet partner III ... there is power to the connection box at the dishwasher it self (checked w/ light tester) ... but there is no power


Have you tryed leaving the power cord out of the socket for an hour or so sometimes they don't lose the memory until they have been left disconnected for a while ... Whirlpool GU2400XTP Built-in Dishwasher

Circuit breaker failed, installed new circuit breaker, power restored,when I plugged in line from dishwasher no lights, nothing, had been working fine prior to replacing circuit breaker.


Hi\015\012\015\012The\015\012issue is with the control board of the unit that has gone bad and should be\015\012replaced. It seems that when the circuit breaker failed a component went bad\015\012due to the power surge caused by failed ci ... Dishwashers

The dishwasher stop during the wash cycle. It did finish draining the water from the tub. The machine is not showing a power signs, I check the circuit breaker and the fuse is not tripped. I open and closed the door and the door latch seems to be working fine. There is just no power to the washer. Usually when a machine breaks down, there still is power or buttons that light up on the front of the machine. I looked on the internet and many say that the fuse could be tripped. No where can I find


... Whirlpool DU912 Dishwasher

GE 2200 Dishwasher-no power at all, circuit breakers are fine, switch works


With your volt/ohm meter check for power going to the dishwasher. the power supply is located under the kick panel. the power wire may be shorted out due to poor installation. if you are not comfortable testing power, I would advise calling a profess ... Dishwashers

I can not turn my dishwasher on. It is acting like there is no power. Model number gu2275xtvq0 I have checked circuit breakers and wiring to dishwasher. Any suggestions?


Check timer and power, motor ... Whirlpool Gold 24 in. Built-In Dishwasher Dishwasher

I just bought the Kenmore Ultra Wash Dishwasher model # 665.1389. It worked about 4 times then before the it finished it lost power while it was running. Now it won't turn back on at all. I done everything in the trouble shooting manual and nothing worked. It's not the circuit breaker either. Everything else on the same breaker works fine. What could it be?


... Kenmore PRO 24 in BuiltIn Dishwasher with Ultra Wash HE Filtration 13173

GE Quietpower 3, GHDA480N10WW. Need help. Dishwasher has worked fine. used it last week. Today, when I pushed the buttons, it did not turn on. The power is hooked up, breaker has been checked and re-set but buttons do not activate at all. Acts as if there is no power at all after a week of no activity. Any help would be appreciated. thank you in advance.


... General Electric Adora GHDA670N Built-in Dishwasher

Dishwasher was cutting out intermittently,totally dead no power then after 15mins or so,finally went bang this am,smoke etc,took insection cover off at bottom swit6ched on again to see spark dead short on unknown unit with four wire block connector attatched,two white to same connector and two purple,left disconnected and workin fine,hot water,inlet and outlet both working fine so what does that unit do?


... Bosch 18 in. SRS43E02 Slim-Line Built-in Dishwasher

Two days ago my LG dishwasher model lDF 7810BB worked fine. Yesterday I loaded it and the display panel will not light nor show any sign of power. I check the circuit breaker several times and all other electrical items work fine in the kitchen. The 2 year warranty expired 9/08/08


Check for voltage with a multimeter at the wires very near the front, just behind the kick plate. Follow the incoming electrical wire in and remove the little plate the covers the wires/wire nuts. I have seen wires that appear to be connected prope ... LG 24 in. LDF7810 Built-in Dishwasher

Breaker is on yet I get no power to dishwasher, that was working fine just days ago. is there a reset switch on the dishwasher itself?


Open your control panel. Inside the panel on the right side is a thermal fuse.part # 8269213.Replace it. ... KitchenAid Dishwashers

Frigidaire dishwasher I have a 3 year old dishwasher, when I went to turn it on nothing happened. No lights on control panel or anything. My wires, breaker and power source are all good. Where should I look next? Thanks Stan


Next thing to look at--considering all the power is good--although that's what I'd check on again, would be the door switch. May have to remove the control panel cover or the door interior.\015\012\015\012Try ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

I have a Whirlpool dishwasher, model DU943 that's under 7 years old. I went to use it last night and it won't power on. I tried selecting all of the cycles, but the dishwasher never came on. I looked through the troubleshooting tips in my manual (like checking the circuit breaker for a tripped fuse, which was fine) and I still have a problem. what else can I try? thanks.


Hello- This unit has a thermal fuse inside the door panel on the control. This part is replaceable. If it is bad, replace.- and would suggest not using heated dry as this is most common cause of fuse failure. Let me know if this info helps- have more ... Whirlpool Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1428 seconds