Having problems with your Dishwashers ?

I have a Dishlex Global 450 dishwasher and have a faulty seal to replace. The original door seal had a foot on each side and the replacement I received has 45 degree cuts and no foot. Also the bottom seal replacement appears to be a screw-in type where the original was slipped behind a fold in the door. I have been assured by the supplier that I have received the correct replacement parts. Could you confirm the these parts are in fact correct and if they are which way should the seal lip an


Answers :

Hello Tony. I am as concerned as you are that this is not the correct replacement part. The key to getting the right part is the model number which is on your machine, if you know where to look. Do this, go to this link to properly locate your model number:
\015\012
\015\012http://www.repairclinic.com/0089.asp?apptype=9
\015\012
\015\012Then go to this link to order the correct part:
\015\012
\015\012http://www.repairclinic.com/
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a Dishlex Global 450 dishwasher and have a faulty seal to replace. The original door seal had a foot on each side and the replacement I received has 45 degree cuts and no foot. Also the bottom seal replacement appears to be a screw-in type where the original was slipped behind a fold in the door. I have been assured by the supplier that I have received the correct replacement parts. Could you confirm the these parts are in fact correct and if they are which way should the seal lip an


Hello Tony. I am as concerned as you are that this is not the correct replacement part. The key to getting the right part is the model number which is on your machine, if you know where to look. Do this, go to this link to properly locate your mod ... Dishwashers

Model # PLD2850RDC2 has a leak at the bottom of the door. i have replaced the gasket in the vent. Had to remove door cover and seal at bottom of door. Had difficulty replacing bottom seal. How do I replace seal correctly? It is still leaking. Could it be something else?


The side baffels are bad. look on each side on the bottom in the corners and that is were their at just pull them out and get new ones ... Dishwashers

Hobart Kitchen Aid dishwasher KDS-58. This washer is a champ. Recently it started leaking water from the lower left corner of the door, while the washer is in the wash mode. I replaced the lower seal, below the door, the seal is installed correctly. Not sure what to do next?


... Dishwashers

How do fix a replacement lower door seal on an Ariston LSV66 dish washer, the replacement part is not the same as the original and I'm unable to workout how the new clips securely hold the seal in place


... Dishwashers

How do i fit replacement bottom door seal to indesit d61 dishwasher as it is different to original and is supplied with thee metal clips


... Dishwashers

Hello, I have a Frigidaire FDB510, after a few minutes of running water starts pouring out of the bottom of the door.I have replaced the wiper or sweep seal at the bottom of the door, the gasket does not seem to be bad, (it actually does not wrap around the bottom of the door anyway). Am I not draining correctly i.e. float,pump, etc. I sure could use some advice. Thanks


Ckd spray arm be sure it is not binding on something also ck for possible split in spray arm look close some are almost invisable ..when water is pushed through spray arm the seam will sometimes separate..also watch for oversuds ... Frigidaire Dishwashers

I just received a replacement door seal for a Frigidaire dishwasher, model # MDR251RER0 Do I need to cut the seal to fit? It appears to be a few inched too long.


No let the extra over hang evenly on both sides. ... Dishwashers

Kitchenai Dishwasher Replacement of "Inlet Air" (lower door seal)


... KitchenAid Dishwashers

Door seal Hi i have just brought a new seal for the bottom of the door but it has a peice cut out of the seal about 8inches from the end is this correct the door does not seam to have any thing that would fit in this missing peice if it is correct which way would the shortest edge face


Generally the notched out section fits around latch hope this helps ... Dishwashers

I have Whirlpool ADP 962 dishwasher. The front door is leaking when washer is running. I can feel a rubber seal at the bottom of the door, when I open the door, which seal is wavy and corrugated. How do I replace the seal, and what is replacement part number. Thanks Trevor H


Hi,\012Here is a tip that I wrote about dishwashers and them leaking.Leaking Dishwasherheatman101\012\012\012\012q4w5ifgf ... Whirlpool 24 in. ADP5966 Free-standing Dishwasher

How do i fit a replacement lower door seal on a dishwasher


Try here for help \015\012\015\012or contact them direct..\015\012http://www.devicemanuals.com/guide/Dishwasher/Indesit-man ... Dishwashers

My dishwasher, a Whirlpool DWF B10, is not cleaning properly. When the cycle has finished, there is always a block of undissolved dishwasher tablet/powder left behind. My guess is that the seal to the powder door has gone and allowing the tablet to get wet too early and part dissolve before the door opens - is this likely to be right? If so, can I get a replacement seal or do I have to replace the whole powder & rinse aid containers ??


... Whirlpool Dishwashers

I have a Maytag DWU8250BAX and the thing leaks like crazy. I just replaced the door gasket, but that is not the problem. When I took a closer look at the door it seems as though the water is getting up and into the door through a space in the bottom of the door. It seems to me like there should be another door seal to fill a gap that sits between the door hinges. If anyone knows if there should be a seal here and then what the part number might be that would be great. Thanks!


There is an airgap under the door..it should spray up and run down the door not spray up under it..look for crack or hole in spray arm..if there is the wrong soap in it it will flood out with lots of bubbles..just have to flush it out. lastly, if you ... Dishwashers

Hi _ We have a Stoves DW616 dishwasher which has started leaking water on filling from around the front door. The BGas engineer replaced the seals around the door with those from a Hygena which he said were the same and it worked fine for a few days and then a further deluge. He has now said there is a seal at the base of the door (just about invisible) and although he got a further Hygena seal this would not fit and he says that as it's obsolete the machine should be written off. Before I 'bin


... Dishwashers

KitchenAid Dishwasher KUDP01FL: Called repairman to replace balance link kit. Then door extremely stiff to open & heard loud pop when one of the ropes came off the roller. Repairman came back & put rope back on & replaced door seal, then the door won't close & he claims need a new door latch. When he left, door again extremely stiff to open & heard same loud pop when one of the ropes came off the roller. Now he says he can't fix it and to call someone else. I now have three problems: (1) The doo


May have bent door hinges,, need to check all alignment of door, hinges and latches... ... KitchenAid 24 in. KUDI01FLSS Stainless Steel Built-in Dishwasher

Door leak I have a small leak between the bottom of the dishwasher door the lower service panel on the dishwashere. I did replace the seal on the inside bottom of the door along with the other parts that come with the door seal. Could there be a gasket leak around the detergent dispenser or the vent at the top of the inside of the door. I did not check the water lever as was mentioned in a previous question on water level, but the float does move up and down quite freely. Any suggestions as to w


I had my dishwasher leaking alot at the bottom of the doo,r and found out that the steam vent was very cloged with gunk. After taking the vent cover off on the inside of the door and cleaning, then putting the vent cover back on NO MORE leaking. Th ... KitchenAid 24 in. KUDS25 Built-in Dishwasher

Smeg dishwasher leaking through the door ive removed the lower door seal but dont know how it should go on happened all of a sudden and there was a desert spoon in the bottom of the dishwasher . im hoping it leaked because it dislodged the seal the seal came out easily from the outside of the dishwaser. can any one tell me how to replace it and which way it is supposed to sit model number sa425 smeg


... Dishwashers

I have a Neff built-in dishwasher and sometimes there is a heavy leakage of water from the front right-hand side. The unit is 3-years old and there is a build up of scale around the rubber seals. The long seal at the bottom of the door seems to have receded slightly behind the metal panel on the inside of the front door. Is the seal easy to replace ?


Hello,\015\012Check the rubber seal in the bottom of the door has not perished or split,also check the bottom spray arm has not split on the ends as this will direct the spray directly onto the door,causing it to leak.\015\012\015\0 ... Neff 24 in. S5443X2 Built-in Dishwasher

Dishwasher leaking We bought our dishwasher in Sep/07, it was fine for a year, then started leaking out the bottom of the door on the left. We had the seal on the door replaced (didn't work) and then the door gasket replaced. That worked for less than a year, now it is leaking again in the same place. What could be going on? Have already put $400.00 repairs into this machine and am reluctant to put more money in to have it break again the same way. What do you suggest?


This sounds like a hinge problem to start with.\015\012\015\012Test the seal by dragging a strip of paper through it with door closed. Probably that left hinge isn't holding door close enough which was probably the original cause. As se ... KitchenAid Architect? II S SERIES KUDS03FT Stainless Steel Built-in Dishwasher

Hi. I have an LG LDF7810 dishwasher. I did a deep clean and ended up taking out a bunch of grease from the seal between the door-bottom and the tub. I even removed the door to get at the grease I thought was trapped back there. Since then it has been leaking water, sometimes a drip and a couple of times a few ounces have gushed out at the end of a fill cycle. Did I remove some factory grease designed to seal the door bottom? If so, what should I replace it with? If not, what else could the


It is possible that while you removed off the grease the water seal/oil seal was also damaged. Once the seal is taken out it can loose the sealing strength which can make it possible to leak.\015\012Hence it will be good to remove the seal and ... LG 24 in. LDF7810 Built-in Dishwasher

I have a SHU8805UC/14 BOSCH DW and need to replace the inner door panel. I ordered the part, but there are no instructions on how to replace the door panel. I want to make sure I do it correctly, so


Go on line with Bosh company and look up dishwashers giving your model. Request technical assistance to install the panel... ... Bosch Dishwashers

My frigidaire dishwasher leaks from the bottom right of the door. It forms a puddle while running a load of dishes. Looks like the seal is gone underneath the door on the right side. Any idea how to replace this seal? Thanks.


One possible solution to your problem could be as follows... Could have been little regular soap or something put in that made it suds up causing it to leak out of the front and sometimes not to drain all water out. Pouring vegetable oil into the dis ... Frigidaire 24 in. PLD2560LCC Energy Star® Built-in Dishwasher

I have a dishwasher (cdu8000v) and it's leaking. Its leaking around the bottom of the door. It looks like the black seal is has a grove in it from door shutting. Can I replace the seal or is there a different problem. thanks! Toby


... Crosley Dishwashers

My dishwasher is leaking from front bottom left side when on. have checked the door seal and it is worn about 3" up on left. there is also a rubber seal on the door itself running along the bottom. can this also be replaced and if so where can i get one?


Hi,\015\012Yes, they can both be replaced...this tip will also tell you how to purchase them...\015\012\015\012Here is a tip that I wrote about dishwashers and them leaking. ... Indesit 24 in. IDL500 Built-In Dishwasher

How to replace the door seal on a Simpson Silencio 850 Dishwasher Model No. 82B850WH. The part No. that I have for the door seal is 0208400158G & is Electrolux part number


The around the tank seal just pushes into the groove. make sure that you copy the way the old one comes out. The bottom of the door seal is a bit awkward. Thsi has some screws that are difficult to access. Take the door liner off and possibly two of ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1195 seconds