Having problems with your Dishwashers ?

Not draining It hyas on OE coming up and the book says blockage. I can't find any blockage anywhere in the hose where i can see it


Answers :

Check for blockages in the air gap vent at the top of the sink. You'll have to disconnect the hoses and remove the small cap inside the vent cap. This item can prevent water from flowing over to the hose that allows the water to empty into the garbage disposal or drain pipe.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Not draining It hyas on OE coming up and the book says blockage. I can't find any blockage anywhere in the hose where i can see it


Check for blockages in the air gap vent at the top of the sink. You'll have to disconnect the hoses and remove the small cap inside the vent cap. This item can prevent water from flowing over to the hose that allows the water to empty into the garbag ... Dishwashers

I cant get me dishwasher to start i have tested the overflow switch and its fine i have also tested the water inlet valve and its is fine. but it will not fill the dishwasher with water i have even removed the hose to see if there was any blockage in the line come out from the what inlet valve. the button light up on dishwasher and the cycles work a long with the start button, i have left the door open to see if the door senor could possibly bee an issue and it tested good and function correctly


Hi.If there is no voltage to valve, then parts that can be responsible are only and all the following:Overfill switch or overfill device.Door switch.Electronic control Wiring.If the overfill switc ... Dishwashers

Hi, we have a Bosch Exxcel dishwasher which mid way through a cycle a button saying Check Water came on. we turned the machine off and opened the door and found loads of water in the bottom. my husband then scooped all the water out and cleaned filter in the bottom, where we did find some bits of plastic from the kids yoghurt pots, and took the water hose off the back and checked for blockages, which there was none. the water is certainly coming from the water pipe through the hose as we tested


Check your water level sensor. And also check to make sure that your pump is working correctly. It sounds like a couple of different things that need to be addressed. First check the water level sensor. It is a tube that is located from the back of t ... Bosch 24 in. SHU43 Built-in Dishwasher

Water left in the bottom of beaumark dishwasher.there is a rubber gasket valve on the out put hose ,it seems to big . but i cant see any blockage. there is a # 572D0282 th


... Dishwashers

I have a dishlex global 500, will not draw water in, comes up with error code nf. I have taken all hoses and filters apart, cleaned them, still no luck. I cannot find a blockage. ps, the dishwasher tripped my power off , then error message came up when I reset power


... Dishwashers

Our Asko D3112 was not draining, so we had maintenance drain the hoses to clear any blockage but it did nothing. They said it must be our pump not working. I ran one more cycle to see if things went back to normal, however now our pump won't shut off. We have to unplug the machine just to get the pump to stop. We had a repair technician come to look at the dishwasher and he says that it is a problem with the control panel/computer system. Something tells me it is a merely a loose wire and that w


Check your manual to see if you have a drain pan at the bottom of the unit, and a 'float' that checks for water collecting there. On at least some Asko models, water collecting in the pan causes the float to rise, which then changes the operation of ... Asko 24 in. D3112 Free-Standing Dishwasher

There are two hoses coming from my Bosch SHE45M06UC dishwasher. One is obviously the drain coming from the back of the unit, and the other is attached to the side looped and not connected to anything. I went online to the Bosch website for a installation manual and it describes this hose as a air venting hose. Does the end attach anywhere or does it just hang loose on the unit. My husband detached it from its original position and thought it was part of the water line. HELP!


Many people realize the dishwasher connects to a little hose on the sink, it is called an air gap. However, many people wonder " The air gap is there to prevent the water from being siphoned out of the dishwasher. When water flows through the drain ... Bosch Dishwashers

I am trying to install a new Maytag MDBH945AWB Dishwasher and have to run the drain hose under the machine in order to get it to the sink. Each time I try to use the hose that comes with the machine it snaps in two and breaks. I have tried to look for a replacement hose that would stand up to the abuse but all I can find is the original. Is there a replacement I can get that is more flexible than the one that comes with it? At this point I am rather embarrased about going back to Home Depot


Hi...home depot sells clear PVC hoses, They come in various lengths up to 100 ft. You can use hose clamps to connect it to the T-fitting. ... Dishwashers

- the dishes and glassware on the top rack are not coming out clean - I checked the course strainer to see if it is being blocked but don't see any thing there - I also took out the spray arm that sprays up into the top rack and ran water through it with a hose - it also appears to be free of clogs. - I don't see the spray arm spinning when I open the door during the wash cycle - - lastly, it may be unrelated, but the dishes are not coming out of the washer as hot as they used to be any i


... KitchenAid 24 in. KUDI01DL - Multiple Color Built-in Dishwasher

Frigidaire dishwasher (Electrolux FDB750RCB0) does not move water through the hose to the upper wash/spray bar. The lower wash/spray bar has pressure enough to turn. With the dish washer out from under the counter I can see the water rise very slowly up the translucent hose. If I remove the check ball under the stem assembly in the motor in the bottom of the tub, water flows, but I'm not sure if the top bar turns then (with the door open I see water coming down from the top, but never saw


... Dishwashers

No water pressure coming out while ingine is running. hoses/ attachments not clog. Pulled and opened pump, didn't see anything broken although noticed pump was filled with oil/lubricant but about 1/4" below top surface. Is it suppose to be filled to the top? What kind of oil is used on the pump? And how come there's no water pressure coming out while the motor is running and handle trigger engaged?


If you can find the model # then you can call tech support for free advise.\0121-888-279-9274 ... Karcher Pressure Washers

Miele dishwasher model# g868 could be 4 or u at end, customer complained water not coming into d/w ,when i got there water was coming in.for a few minutes then stopped filling ,drains fine, customer had not operated machine for a few days.i disconected the safety valve hose from under sink to see if water comes through does not when advancing cycle by hand, washes ok when water came in, thanks, Murray


... Dishwashers

Why cant i get h2o to come out of my honda pressure washer? i disconnected hose, and no flow..was just workin fine other day


... Troy-Bilt 020528 Gas Pressure Washer

Leaking dishwasher My GE dishwasher leaks when running a load of dishes. The leak seems to be coming from about the middle of the tub about halfway back. I can't see exactly where it's coming from, but it appears to be dripping right behind the motor. Could it be a poor connection? I would appreciate any suggestions. Thanks, Bob Engle I do not seem to be able to find the model number


Probably a leak at the motor seal where it enters the tub. Best to remove the motor if you can and inspect the seal. ... Dishwashers

I have a smeg dishwasher and E7 comes up, water is not draining, i have checked for blocks and cant find one? I empty all the water added salt etc.... but the water comes back and E7 returns, any ideas of what else i can do? thanks


... Smeg 18 in. DWF410SS Slim-Line Free-standing Dishwasher

Hobart LX30 Thank you for your help earlier. I figured out a way to get the machine running on 220. Now my problem is finding the intake for the sanitizer and detergent. I have looked all over the machine and I cant find tubes anywhere. The guy I bought it off of tells me that when the water temp is over 170 you don't need any cleaning products. I just want a second opinion. I feel that our glassware is not as clean as we would like. Any thoughts?


I'm not sure I'm comfortable with the direction your seller is leading you. I assume this machine is installed in some type of place where you are serving food to the public. If this is the case, then the local health inspector will expect to see a w ... Hobart 24 in. LXIH-3 Built-in Dishwasher

I have a Kitchenaid dishwasher, Model KUDW03CTBL3. The wrinse aid is not coming out of the dispenser. This is an intermittent problem. When it happened the first time, I got a tech in and he couldn't find anything wrong. Then it seemed to rectify itself and has been working properly for a long time, but has suddenly done the same thing again. Probably it is clogged up, but I can't see where it is supposed to come out. Any suggestions?


... KitchenAid Dishwashers

My dishes come out of the dishwasher with a white film on them that makes them look dirtier when they come out than when they went in. I have tried clr in the dishwasher and jet dry dishwasher cleaner. Neither of them worked. I was told the check the filter but we have started to take the pieces apart and cannot find a filter anywhere. Can you help?


Www.dishwasherfilter.com will solve your problem. it is your hard water and not your dishwasher. ... Maytag MDB9600A Jetclean II Built-in Dishwasher

Electrolux built in ESL4115 Dishwaser:- Starts the programe briefly but stops with two intermittent audible signals when you open the door the cycle has not really started and there is water at the bottom of the dishwasher(when u refer to manual says the sink spigot is blocked or water drain hose has not been correctly laid or is bent). I have had this for just over 1 year working ok up to this point, tried to see if there is a blockage, taken pipes out doesn't appear to be any blockage also th


... Electrolux Dishwashers

Do you put the clear hose in the bucket with the cleaner to get it to come out of the spray nozzel? If you dont use the low pressure attachment will the cleaner still come out or not? I cannot find an owners manual for my model


You must use the lowest pressure nozzle with the clear hose in the solution or you will not get soap. Make sure you use only the solutions approved for your pressure washer!. ... Briggs & Stratton Pressure Washer Projectpro Spray Nozzle

I have a dishlex global 270 i cant find a model no i only have a serial and manufacturers no. What i wanted to find out is does this model have an element that heats the water. I only have one hose and when i used it with cold water it didnt heat up so i am using hot water.


Hi\015\012\015\012\015\012Thanks for using FixYa. I hope you understand that no one can tell you what are the specifications of the product until you provide the model no# however, dishlex usually have element in their dishwa ... Dishwashers

I have a Comet BXD 2525 G pressure washer pump which is giving me some problem. (Maybe) I hook the water up to pump and the pressure hose up to the pump, turn on the water and the water sprays out of the water connection at the pump. I check the hose to see if it was clog ok and the next was a the water connection ok. It's like the water is not going int the pump. When i start the pressure up the water come out of gun but no pump running like it should. The next thing i was going to look at i


The water inlet needs a gasket like all hose connections. If its gone the pump may be starving for water. ... Comet Pressure Washers

Hotpoint fdw70 error code A10 have replaced the inlet water valve but still have an error code flashing A10 hoped to find a reset button but cant find it anywhere can u possibl advise.


... Hotpoint 24 in. FDW60 Free-standing Dishwasher

Top dishdrawer wire hose hangar has come free. Cannot see where to hook it back onto the hose system...


There should be a white plastic tag about half way down the hose (the tag holds together the inlet hose, drainhose, and wiring harness).\015\012The tag has a hole at one end, which the wire clips into- it can be a little tricky getting the wire ... Fisher Dishwashers

My dishwasher will not drain after cycling. I have check the drain hose connected to the disposal. All is in good order the hose is not cinked and the air hole is unblocked. I have also checked the screen at the bottom of the dishwasher, there is no debris or blockage here either. I can run the dishwasher on normal, it cycles but I still have stagnat water left beneath the bottom rack. How do I check my pump to see if it is working or could it be a short of some kind? It is a Kenmore Quite


The problem is a solenoid under the unit. It is a small black cylinder that operates a valve to change from the wash cycle to the drain cycle. You can probably order a new one from Kenmore for pretty cheap. ... Kenmore 24 in. 15252 / 15254 / 15259 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1180 seconds