Having problems with your Dishwashers ?

Hi, my whirlpool ADG7560 dish washer does not have any water passing through the spray nozzels, they are all clean, could this be a pump problem? the machine is only 3 years old


Answers :

Yes , if the pump under the spray arm is broken and not spinning with the motor it won't spray. Need a different model number for more help.
Dishwasher- Inside the doorjamb on the top, left or right. On the door edge top left or right. Portable models on the back.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Hi, my whirlpool ADG7560 dish washer does not have any water passing through the spray nozzels, they are all clean, could this be a pump problem? the machine is only 3 years old


Yes , if the pump under the spray arm is broken and not spinning with the motor it won't spray. Need a different model number for more help.Dishwasher- Inside the doorjamb on the top, left or right. On the door edge top left or right. Portable ... Dishwashers

Dirty dishes Pump went on this machine about 6 months ago. Since the install of the new pump the dishes do not come clean. Particles finely ground or tomato seeds, sesame seeds etc. get blasted back on the dishes in the final rinse cycle. Repair guy has no clue... could there be a pinched line upon install that won't allow complete drainage, or the wrong pump? Is ther filter screen? I have done the vinegar reoutine plus a purchased cleaner to no avail. The machine is a bout 13 years old. Thank y


... KitchenAid Dishwashers

Hi I have a Neff built in dishwasher s5453X1GB/70 about 4 years old. Never had a problem before. Came downstairs last night to find the kitchen floor flooded. Water also still in machine. But must have been near end of cycle as plates all clean. I have read other links and opened pump compartment in centre of machine and syringed out all water and cleaned fan. When i switch on machine it is still making odd humming noise (emptying cycle?) I have read about anti -flood valve etc. Any more tip


... Dishwashers

I have a Kenmore Quietguard dishwasher, only a few years old, and it won't drain. I pulled it out and checked the drain hose, could not find a clog. I took the basket and sprayer out, couldn't find any clogs there. It seems to be making a little bit of a different noise but does still clean the dishes. Does the motor pump the water out and could that be the problem?


I have a Kenmore Quietguard portable that won't stay connected to my kitchen sink faucet. Checked all I can and continues to spray the wall and me without staying attached securely to the faucet adapter. Help!! Any ideas? ... Kenmore 24 in. 15162 Built-in Dishwasher

Our 4 year old machine has just stopped pumping clean suddenly. I have checked the flow rate directly from teh machine and it is little more than a trickle. The filters in the machine are clean. Is tehre another filter or is the pump accessible?


... Bosch 24 in. SGS57E02 / SGS57E08 Exxcel Free-standing Dishwasher

I have a 13 year old Siemens SE64630GB. It isn't cleaning items in the upper basket and I believe it's due to lack of water pressure in the upper spray arm leading to little or no rotation of the arm. Have cleaned out the drainage pump and removed and cleaned both the water feed pipe to the upper arm (a lot of gunk in there) and the spray arm itself (which also had blocked nozzles) - no apparent blockages now. Could there be a blockage in the circulation pump and if so how do I access this pump


... Siemens Dishwashers

8 year old maytag, clean lime build-up 2 times a year and all the spinning parts look clean and no wear but all of asudden the washer does not clean the dishes very well. Plenty of hot water, soap is dispenced, cleaned screan in bottom, don' really see anything out of place. what could the problem be? Thanks Rick L.


Hi,\012In you case check the heating element first...\012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... \012 ... Maytag Dishwashers

Dishlex DX450 has been working OK for years - suddenly not washing - white deposits and cutlery looks greasy - but machine clean and all filters and arms clear of debris. Have removed pumps and hoses - all clean - no obvious problems. Seems to complete a full cycle - but the problem is consistent every wash - independent of the dishes. Welcome any insights - thank you, Richard


... Electrolux Dishwashers

My Bosch Classixx (about 10 years old) dishwasher won't fill The problem has only started since I pulled it out and cleaned! The programme sounds are as normal but no water enters the machine. I detected a small leak on the inlet pipe and tightened that. The machine drains when I add water manually though it has made a lot of gurgling noises for some time now when draining. When tipped on its side water comes out of the bottom of the machine (not entirely clear but not dirty either). When upri


... Bosch SHU9915UC Dishwasher

I have a model 665.1576 or 1676 my paperwork does not have the number on it and no part number on he machine, but I ordered parts from the catalog which matched. about 7 years old, stopped draining, so I changed the Seal kit, pump base seal, impeller, plus drain cover gasket but not the pump gasket could not find it, reinstalled, pump works but much slower and times out, have to hit drain button to get all water out. Keith


... Kenmore Dishwashers

I have a Kitchenaid dishwasher. Mod # KUD102CRBS1 which is hardly 2 years old. The door keeps separating from the trim and water seeps out, I fastened the trim, this took care of the problem for ca 6 month, now it is leaking again from the door, has anyone the same problem? I am steaming mad, this was an expensive appliance, which could only clean dishes somewhat with one brand of detergent, all other brands leave a gray film, and now this! MY previous dishwasher was a rel. basic GE but it got t


This is a fairly common one... I always use a silicone sealant/adhesive to make sure it stays put. A thin film does wonders. ... Dishwashers

We have a leak on the pump around the manafold and the gearbox. Has anyone had this problem that you know of? Could it be that the packing has gone out? The washer is 2 to 3 years old and runs great just need to repair this problem to put it back into service.


Usually when water is leaking from in between the manifold and the oil side of the pump, the high and low pressure seals (a.k.a. packings) are worn out. ... Northstar Pressure Washer 3000 PSI

Maytag Model No WU202 is running through all cycles but is not pumping out the water from the tub. I can hear the pump running and a gurgling sound. Could it be the micro mesh filter that is plugged? Any detailed drawings available of the lower wash assembly and instructions to take it appart? This machine is more than twenty years old.


Hi,It sounds like your belt broke. Open the bottom access panel below your door and check. The part is :-http://www.repairclinic.com/SSPartDetail.aspx?PartID=2814&PPStack=1If you take off the front ... Maytag Dishwashers

Cutlery is cloudy and dirty, some food is dried onto knives and forks. Cups and glasses are cloudy and not clean on inside. Coffee or tea stains are not removed. Plates and soup bowls seem OK , and water is draining properly. We have tried with less soap, more soap, gels, tablets and powders but to no avail. The dishwasher does not clean dishes etc, as as it once did. There doesn't appear to be any problem with the 'cycle'. The machine is about nine or ten years old, and has run fine until ve


Don't know much about Dishwashers but have you tried a descaler.Is the water spraying out as normal.Is the water actually getting hot, could be a heater element problem.If you look here you may get some other ideas just by loo ... Dishwashers

I have a bosch dishwasher SGS4332GB/29, 10 years old ,problem is no water in machine? pump running and water ok to machine?


... Dishwashers

Dishes are no longer coming out as clean as they used to, especially bowls or utinsiles with dried on food. The machine appears to function ok, but is about 8 years old. The machine just seems tired. Am I looking at a worn out pump or something else?


Hello,\015\012\015\012Those are common issues with dishwasher's as they age, and very good questions. The Asko dishwasher however is a very good hi-end machine and typically good for much more than 8yrs. That being said, 8yrs. is subjective isn't it ... Asko D1706 Built-in Dishwasher

I have a Hotpoint dishwasher that is at least 25 years old. The powder soap in the cup is hard and dry at the end of a cleaning cycle. Therefore the dishes are not very clean. Could you please help me solve this problem! I have been using Cascade. Model #: HDA 780-02 AD Serial #: LF 623631 X Thank you very much. Dianne Cheseldine


Make sure your water temperature for your hot water heater is turned up enough. If this machine is 25 years old, the heating element may be wearing out causing the water not to get hot enough to wash the soap out. ... Hotpoint Dishwashers

Cutlery is cloudy and dirty, some food is dried onto knives and forks. Cups and glasses are cloudy and not clean on inside. Coffee or tea stains are not removed. Plates and soup bowls seem OK , and water is draining properly. We have tried with less soap, more soap, gels, tablets and powders but to no avail. The dishwasher does not clean dishes etc, as as it once did. There doesn't appear to be any problem with the 'cycle'. The machine is about nine or ten years old, and has run fine until ve


They must have changed the way they treat the water in your area. those spots are caused by hard water. www.dishwasherfilter.com has a product out for this problem. it filt ... Bosch Evolution 300 SHE43M05UC Stainless Steel Built-in Dishwasher

SMEG STX dishwasher does not complete the wash cycle, stopping after 3 minutes on all cycles displaying error code E1. The machine seems to start with the usual whirring noise but then stops after 3 minutes without pumping in water. The machine is a few years old now but has needed 2 new control panels already although this does not appear to be the problem this time. Any suggestions? Thanks DW


... Dishwashers

I have had this dishwasher for almost 4 years. It used to do a great job but last few months it has been doing a really poor job. Leaving food on dishes and also a film on them. I have taken everything apart and cleaned it good. I have tried different detergents, ran several diswasher cleaners in the machine. Even ran vinager in it because thats what i do for my coffee pot when it needs cleaning and it works great. We have very hard water here so I thought that could be the problem. Its frustrat


... Frigidaire GLD2445RF Built-in Dishwasher

I was given a low hour, 10 year old, CH PW205002LE 6.5 HP gas vertical shaft 2000 PSI/2.5 GPM pressure washer with a Lavor pump. It did not work - no pressure. I found a broken o-ring on the brass unloader valve and replaced it with a ring as close in size as I could find as the part break down doesn't state size. Everything was very clean. I coated everything with silicine grease and reassembled, seating the brass piston? as deep as it would go. I had to press the trigger in order to get the mo


My personal experience is that 40% of all the sellers I dealt with on e*** exaggerated their products or worse. If you decide to go the e*** way be sure you put it on a good credit card so you can get your money back if it's a bust. Don't use your ba ... Campbell Hausfeld Pressure Washers

I have a Maytag dishwasher quiet series 300. It is one year old. The problem I am having is this. After running a cleaning cycle, there is water in the bottom of the machine. If I push the start button, then cancel a few seconds later it will drain. Any idea? Thanks, Terry Roose


Hi Terry, Welcome to FixYa, I am Kelly. \015\012 A few things can cause this. Most of the time it is drain related with the Air-Gap being the culprit that is restricting drain flow. If the dishwasher drain has a restriction ... Maytag Dishwashers

SHX46B I have a 4 year old Dishwasher that filled up with clean water on it's own and leaked on the floor. There appears to ba a float switch switch on the very bottom of the unit that runs the pump if this happens. It won't stop until I remove the water caught in the plastic base on the very bottom of the unit. Drain is clear and this machine has worked fine until now. I'm thinking it may be a bad or leaky fill valve but how can I check?


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

I have a Whirlpool GU2500XTPQ3 dishwasher that is about 5 years old. The dishes in the top basket do not get clean. I checked the water tube that feeds the upper spray arm and the top spray and there aren't any obstructions. Our water pressure and temperature are suitable. Could the pump be plugged or otherwise lose its ability to circulate enough water to adequately feed the upper sprayers? How can I check on that?


Hello,\015\012\015\012Welcome to FixYa,\015\012\015\012Based on your description as well as all you`ve done on your own I`d suspect you`re on the right track with the plugged pump suspicion.\015\012\015\012The plac ... Whirlpool 24 in. GU2500 XTP Built-in Dishwasher

Bosch Dishwasher Dishwasher is about 6 years old. It recently stopped cleaning the top rack of dishes. It is getting water to the top propeller, but not with enough force to make it spin. I have checked the tubes running up top and they are not clogged. Could the pump be going bad?


Your filters need to be replaced. it's a 10 minutes work ... Bosch 24 in. SHU43 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1594 seconds