Having problems with your Dishwashers ?

KitchenAId KUDK02CR does not fill in water . Neither switch nor motor sound coming out of the unit


Answers :

1.Check main water inlet.

2. Check filter located near the machine body hose pipe inlet.

If these are OK Solinoid valve inside the machine to be checked for functioning.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

KitchenAId KUDK02CR does not fill in water . Neither switch nor motor sound coming out of the unit


1.Check main water inlet.2. Check filter located near the machine body hose pipe inlet.If these are OK Solinoid valve inside the machine to be checked for functioning. ... Dishwashers

My KitchenAid dishwasher (model KUD101TJWH0) suddenly is making noise from the motor area while inputing water into the unit, whether in the rinse or washing cycles but makes no noise in the draining cycles. I have pulled the unit out while still connected, cleaned any debris from the filter screen below the lower water spokes and can hear the noise very plainly by the motor but I know how sound can travel with the piping. Is the sound only coming from the electric drive motor attached to the


... KitchenAid Dishwashers

For my Kudi01dl model dishwasher, the rinse light is on, but the unit will not respond to any buttons being pressed and won't turn on. When I press any buttons, two horizontal lines show in the front, but go off as soon as I let go of the button. Is there a ways to reset the unit? Everything was functioning fine the last time I used it. I use it about once a day. The problem started when I heard sounds coming from the unit, very loud motor sounds. The door was closed but I had not turned


... KitchenAid 24 in. KUDI01DL - Multiple Color Built-in Dishwasher

Bosch shu8806 Hello, I aquired a shu8806 recently and it doesn't work. It has power and water. I push wash cycle, indicator light comes on, shut door and nothing happens.  So the door switch seemed like a good place to start. Since I am an electrician I thought I would give it a shot. When plugged in, the wire from the motor is 120V but when jumpered to the neutral(common on the door switch), motor doesn't operate. Although, I have heard the motor turn over momentarialy when trying to run unit e


The pump may be clogged, or the motor start capacitor may be bad or some units have a fill switch wired inline with the motor so it won't start unless the unit is full ... Bosch 23 in. SHU 8805 Built-in Dishwasher

My Dishwasher stopped working. When I switch it on there is a sound like a motor running, a kind of whirring sound. It sounds as if the machine is working normally but there is no water coming through it. Any ideas? Thanks, Paul


Hi There,\015\012\015\012That's the classic sign of water having leaked under the washing compartment/tub. This causes a "float" to rise, tripping the micro-switch which activates the anti-flood protection. This closes the water inlet val ... Bosch 24 in. SHE43C05UC Stainless Steel Free-Standing Dishwasher

Obtained this haier hdp18pa portable dishwasher, thought I would give it a try. The unit will not fill with water, turn the power on you can hear the motor or the pump running but no water comes in. THe 4 display lights flash and beep a series of times and then stop only to repeat the sound off in a every few second sequence. I have tried the remedies offered online, tilting the unit does not seem to work for me on this one. I changed out the water inlet valve but nothing changed and I got the s


HiYou need to clean the filter that is in the tube that gets water in the dishwasherin case you can not find it pls ask me to send you a diagram ... Haier HDP18PA Stainless Steel Free-Standing Dishwasher

Model KUDS30FXSSO, Unit attempts to start. Blue light on the front of the door comes on indicating the cycle is starting. Pump runs a few seconds as normal. Then the maching sounds like it trying to start the next step three or four times. The blue light goes out. The washing cycle then switches to cancel/drain, ( I opened the door to see which control lights were on.) runs the drain pump then stops. The green light on the front panel does not come on indicating the cycle was completed.


... KitchenAid 24 in. KUDP01FL Built-in Dishwasher

Sounds like there is a piece of broken glass in motor section upon start of cycle and any other time water enters. Just started happening. Noise coming from bottom of unit. Do we need to have unit serviced? Thank you, lauri


... Miele 24 in. G653 SCVi Plus Built-In Dishwasher

Dishwasher is reading "overfilling", but no water is in unit. Door can open, noise of motor or pump continues and will not shut off even with the Power switch. Only way to stop noise is to turn off the circuit breaker at the electrical panel. What does this sound like to you?


HI- The flood switch has been tripped. It is located under the unit and is not really accessible except by a Tech. The most likely cause it poor draining; if there is a little water left over from each part of the cycle then eventually the water ... Asko 24 in. D3530FI Built-in Dishwasher

My dishwasher is making a loud motor noise when pumping water for rinse. This is not happening when draining. I've opened it up, cleared any dishes and the drain. It sounds like it's coming from underneath the unit.


... Frigidaire 24 in. FDB750RCC Stainless Steel Built-in Dishwasher

The unit is a 4.5 hp gcy 135; Engine 135 1AB.The motor starts does not appear to have any unusal sounds however the water pressure coming out of the hose is only at approximately 50%? Let me know if you can help to correct thanks


... Pressure Washers

Maytag MDBTT79AWW dishwasher fills and nothing else. Once filled you hear a click, followed by a humming sound for 3-5 seconds, then silence. This will happen two or three more times, and then unit will shut off. Motor doesn't start. Repairman says he thinks control board is bad, but he sounds like he is guessing. I performed a field service test , which indicated a fault in the high current motor circuit. Unit is seven years old. Don't know whether to attempt repair, or replace.


That sounds like the motor trying to start but being jammed it is shutting off via an internal breaker. Check for something in the bootom of dishwasher that might have gotten down there that could do this. You might have to take the sprayer off and s ... Dishwashers

Hello. I have a Kitchen Aide KUDG255HWH1 that will not start from a cold state. The "Energy Saver Dry" and "Normal" indicator light/ switches failed to operate about 1 month ago and since then I have needed to use the "High Temp Wash" and Soak & Scrub" cycles to get the unit to run. Now these two indicator kight will illuninate but the unit will not start when I depress the "On" soft switch. When I depress the cancel switch the unit starts with what sounds like a pre-start cycle. Pleas


Hi\015\012\015\012\015\012\015\012\015\012\015\012Thanks for using FixYa. To reset the dishwasher switch\015\012off the dishwasher from the power socket and mains for five minutes and then\015\012switch it back on. If still the issu ... KitchenAid Dishwashers

Our dishwasher was purchased two years ago last Feb. with very little use. We are experiencing louder then normal sound coming from under the unit were moter is. Vibration is also present. The loud sound & vibration comes during the wash cycle. No problems during drain cycle.


Problaby a peace of glass get into the impeller or anything else ... Dishwashers

Model #363.14232100 dishwasher. When you turn the switch to on, it will not come on. If you keep turning the knob slowly you can hear the dishwasher trying to start up,but it doesn't. Keep turning the knob and its the same thing, sounds like it will start, but it doesn't. It did fill with water, but once it was opened it didn't start up where it left off. The lock switch was in position, and still nothing. Now I have water in the bottom but can't get the thing to come on. Any suggestions? Help!


... Kenmore 24 in. 16539 Built-in Dishwasher

Asko 1375 unit will not wash drains and fills ok  motor at back of unit runs well. Suspect impeller   Does motor have to come off for impeller replacement?? My 1375 is leaking a bit, looks like the seal which was mentioned in the impeller repair case,may be the problem? The other problem I noted was a clogged screen at the bottom of the dishwasher which is on the suction side of the pump, the screen had calcium buildup etc. I cleaned it off with vinigar and reran the dishwasher seemed ot fix th


Do you mean to say that the washer does not go into the wash cycle at all, or washes poorly?An answer to both can be found HERE.This article ... Asko 1375 Dishwasher

Motor problems? I have a fisher paykel DS6031SS -top drawer dishwasher that the motor makes a loud sound when cycle first starts. Sound seems to be coming from the front of the dishwasher. It is 7 years old. Anyone else have this problem? I llive in a small town in Washington state (Lacey) and have been told the closest place to get parts is Seattle! Thanks.


... Fisher and Paykel DS603SS Stainless Steel Built-in Dishwasher

Have a karcher 1750 psi pressure washer. when you turn the on switch on the motor pulses instead of asteady motor sound. when squeezing trigger it sounds fine. can it be the unloader?


... Karcher 1750 Psi Elec Pressure Washer

Asko 1375 unit will not wash drains and fills ok  motor at back of unit runs well. Suspect impeller   Does motor have to come off for impeller replacement??


Kenmore quite wash making loud screaming noise-was told it could be something stuck in impeller. Could this be true and if so how can I check/fix this myself? ... Asko 1375 Dishwasher

When the unit switches from Pre-Rinse to Wash, the Drying Light comes on blinking and the unit beeps. The unit continues to run for about a minute, then stops. Previous to cabinet installation, the unit worked fine for about 4 complete cycles.


... Danby DDW1809W Builtin Dishwasher

Hi, ^The GE dishwasher (PDW788000SS) will not fill in either "rinse only" or "normal wash" modes. The control panel lights up with all functions. After selecting rinse only or normal wash and pressing/holding the start/reset button down for several seconds to reset the unit the drain pump comes on for approx 90 seconds as advertised. Checked the float switch and there is no continuity in any position of the little switch arm and the switch arm has no spring on it. Seems like this is a faile


Hello there:If there's no water entering your dishwasher in these cycles as you described, check these:\015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 \015\012 ... GE 24 in. Profile PDW7880G Built-in Dishwasher

My Maytag Quiet Series 200 is making loud noises. It appears to be continuing the cycle. When we stop and start the washer, it sounds like the motor is working hard (high pitched sound). It sounds serious. I'd like to troubleshoot myself if possible. Also, what is the criteria for an 8 year old washer when it comes to the decision of fix vs buy new?


... Maytag 24 in. MDB6600A Jetclean II Built-in Dishwasher

My dishwasher is making a lot of noise...sounds like its coming from the motor, It is 5 years old, does the motor go bad on these? If so, are they cheaper to buy a new motor


Depends on the motor's priceHowever I would suggest that you replace the entire unit due to cost of repairman and motor itself. Good Luck hope this helped\015\012\015\012Dave ... Dishwashers

Hi experts - My dishwasher won't drain properly. There's several inches of standing water in the bottom of the unit. During the drain phases of the wash, the motor underneath doesn't spin and a buzzing is coming out of the motor relay. During the wash and rinse phases, the motor runs fine and all appears well. Any thoughts? Thanks!


Either the water outtake or the pump are clogged - you will have to remove it to see where's the problem. ... Frigidaire 24 in. FDB679GF Built-in Dishwasher

After a power outage, that occured while the dishwasher was running, the lights come on and there is a high pitched noise. Then all the lights go off and the motor sounds like it is starting. However there is no water and the heating elemant comes on. The lights on the front; china/crystal, normal wash, clean and heated dry, all come on as if the computer is confused and trying to run them all simultaneously.


Sounds like the board was fried from a power surge ... GE Tritonr XL GSD6260JCC Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1221 seconds