Having problems with your Dishwashers ?

Diswasher propelors not going round

\015 Diswasher propelors (rotary) not going round machine therefore not washing\015

Answers :

Hi,
I found a lot of stuff built up in the spray arms and replaced them...wife is happy again... :-)
Here is a tip that I wrote about your problem...

http://www.fixya.com/support/r4319937-dishwasher_maintenance

heatman101
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Diswasher propelors not going round


Hi,I found a lot of stuff built up in the spray arms and replaced them...wife is happy again... :-)Here is a tip that I wrote about your problem... ... Dishwashers

I have Frigidaire FDB956RBC1 diswasher. I have to turn off the water to fix the faucet. When I turned the water back on, water did not go to the diswasher when I used it. The diswasher runs normal except with no water going into it. The water runs find at the facet. There is separate water supply underneath the sink for the faucet and the diswasher. I wonder if there is a mechanism with the dishwasher that stop the water from going into the dishwasher after the water supply been turn off. I did


FRIDG... EXPERT HERE \012\012\012Welcome to fixya\012\012Hello\012\012 \012\012 ... Frigidaire FDB956RB Built-in Dishwasher

Edesa practica 10 years old can i get a programmer the dishwasher is going but the programmer does not go round it is 10 years old can i get a new part in spain


... Dishwashers

Clean light Our diswasher runs fine and the clean light comes on, but will not go back off after the door is opened and closed. No buttons will work and the clean light will not go back off.


You have an issue with the door latch assy, something inside it snapped, and its not recognizing you opening the door.. it still thinks the door is shut and is waitin g for you to open it, a swtich must of gone bad, the console will reove with a few ... Frigidaire 24 in. FDB1050RE Built-in Dishwasher

Just brought a new inlet solenoid valve and there are two wires going to it both black does it matter which way round they go


HI no it does not either way works.\015\012\015\012\015\012Sean ... Dishwashers

I have a purple rubber band looking seal and a clear round seal laying in the bottom of my dish washer...where do they go? The clear round seal looks broken. thanks


... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

Salt Light Cannot get the salt light to go out. Had some problems with a crystaline Deposit on the left side of machine. we checked the inside of the dishwasher and made sure all was clean etc. After that the light wouldn't go out. Had machine serviced. Turns out we were using too much diswashing powder Only need to use about a Teaspoon (heaped) for a wash not the recptacle full.


The sensor in the salt chamber isn't reading properly. Try descaling the machine with solution and restarting. ... Miele Dishwashers

Dishwasher wont fill with water. just before it stopped filling i was turning the dial (a lot) between the wash cycles back and forth to attempt to get it to fill and drain (I didn't let it go through a cycle). We also removed the hose from the machine as it had split and replaced it and we had the machine tilted on it's side. the dial still clicks round but it sounds like the pump is going and it doesn't seem to be filling with water. Help


Hi. I suspect that the timer mechanism will be the culprit here, but i recommended to inspect and test the water inlet valve, before replacing the timer. The valve is a known problem area, as well. Follow the valve inspection procedure below, careful ... Fisher DS603W / DS603B / DS603I Dishwasher

Water is going in in, and it will drain but does not wash, arm not going round


Hi,Here is a tip that will help you with how to clean that dishwasher up and get it smelling good again... ... Bosch Dishwashers

It is 3 years old and 2 months ago I had to have a new motor fitted. 2nights ago I put it on and in the morning it was still going. I have tried again and it just keeps going. The water is slushing round but it is cold. Also the soap dispenser didn't open. It doesn't drain or dry.


The control circuits of the unit is malfunctioning. It is probably a bad capacitor in the unit that has to be replaced. The control unit is the brain of the system. It will have to be replaced.Before doing so, check to see if you have any ... Siemens Dishwashers

Kenmore diswasher rubber insulation round the door fell off


... Kenmore 24 in. 16032 Built-in Dishwasher

My Electrolux Dishles DX 303 Diswasher is displaying .50 on the led display after stacking and going to start it. It will work for a short time and then this code will display. What does it mean and


... Dishwashers

Water won't drain after cycle is done. Leaves 1-2 inches of water in bottom. Checked hose and its clear. Put hose going to disposal in bucket and water comes out when diswasher is cycling


It is easy track this path of water from bottom of m/c it will b afilter then small hoses to drain pump thenouter hoses <\015\012 thanks ... Dishwashers

I have a whirlpool dishwasher ADP 5540 and the top 2 blades dont seem to go round...Any ideas?


Check botton sprayarm for crack, hole clog up an make sure the tower is under upper sprayarm ... Whirlpool 24 in. DU915PWP Built-in Dishwasher

The spray arm in my single drawer dishwaSHER was not turning freely When I removed the racks I found that the little blue impeller at the centre of the base plate was jammed. How do I release the baseplate so that I can see what's going on there seem to be two locking rings round the impeller--but I cant shift them. Any advice? Or do I need a techy?


You will need a special tool to relese the 2 rings at which point the impeller will come loose. Not sure if you can purchase one over the counter. Possibly a set of snap ring pliers may do the trick but not 100% sure. I you dont have any availbale ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

I removed the top cover on the of my dishlex global 300 and a black wire became disconnected i don't know where it goes the wire is made of two one wire has what dots (short lines) and then a continuos line the two wires go into a slightly transparent cover which has a small round opening for it to be plugged into something the wire comes from the cercuit board that controls the start/stop and mode


The wire that came disconnected goes to the door switch. If the wires came out of the switch then you need to replace the hole switch. If you still have some wires coming out of the switch then you can just wire nut ... Dishwashers

Spring broken in soap dispenser Neff dishwasher. How do you fit new spring. One of the spring arms is stepped-does it go certain way round?


... Neff 24 in. S4456 Built-in Dishwasher

My DISWASHER, a Whirlpool Quiet Partner Plus, is stuck in the "glass express" mode. This light keeps flashing and will not go out. I threw the circuit breaker. Did not do a thing. Suggestions?


Hi,Unfortunately the flashing light you see is an indication of a failed user interface/keypad control. If the electronics under that button fail the LED that is controlled by that button will flash indicating a 'stuck key'. I ... Whirlpool Dishwashers

Where does the jet dry go in a kenmore quiet guard 3 dishwasher? I see a round screw in cap that says "rinse aid indicator" - should I pour the jet dry in there? Thanks.


Yes ... GE 25 in. Nautilus GSC3400J Free-standing Dishwasher

Where does the second front cover on my diswasher go?


The second cover goes just behind the front one. It has slotted holes in it so that one can adjust to the floor hight and the front on is at a fixed location. The 2 screws go thru both of them ... Dishwashers

My bosch excel dishwasher has the following fault: start the cycle, water starts to fill but then check water light comes on and it then starts to empty again. Pump then keeps going. I have checked the hose and even swapped it round with my washing machine one but this makes no difference. I have cleaned all the filters and taken off the cover to check the 'propeller' as sugested in the instruction manual. But no joy - check water light still illuminated and willnot continue with cycle. - Help!!


This unit im sure has a water flowmeter that measures the water intake.. if this cannot read then the unit shuts down to avoid flooding.. \015\012it needs replacing... it is attached between the valve and the side tank or attached to the tank d ... Bosch Dishwashers

Maytag MDBH965AWQ I have a Maytag dishwasher model number MDBH965AWQ. A few weeks ago the clean and sanitized lights would not go off after the door had been left open for over 30 seconds. Then last week, the diswasher would shut off in mid cycle and all lights would turn off with water still in the dishwasher. Today, I noticed that I am able to open the dishwasher door while the dishwasher is running and it will continue to run like the door was never opened. Now it is starting to trip the brea


2 items in need of testing are the door switch - and the main controller board/timer unit.CLIC ... Maytag 24 in. MDBH965AW Built-in Dishwasher

Fan not going round on oven. Does 1-2 turns then stops. Fan moves quite freely.


If it is still heating then it looks like a siezed fan motor ,that will need replacing... ... Dishwashers

Bottom water sprayer is not going round


Hello Joannekirk9,I used to work at Miele in the technical services department. The most likely cause of your problem is the jets on the spray arm are clogged with soap build up or debris. Solution - Try cleaning out the bottom spray arm ... Miele Slimline G832SCi Built-in Dishwasher

We just bought a house that has a Kenmore diswasher model# 587.15173400. I started a load of dishes and the dishwasher ran for 1 1/2 hours. It stayed on the wash cycle and the sensing light would come on occasionally. I am not sure what is going on. Any suggestions?


... Kenmore 24 in. 15173 Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0372 seconds