Having problems with your Dishwashers ?

My Whirlpool dishwasher is not cleaning dishes in the top rack. I don't think the wand is spinning. There may be a blockage in the water pressure line. How can I check this?


Answers :

Hi,
Here is a tip that will help you...

http://www.fixya.com/support/r4319937-dishwasher_maintenance

heatman101
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My Whirlpool dishwasher is not cleaning dishes in the top rack. I don't think the wand is spinning. There may be a blockage in the water pressure line. How can I check this?


Hi,Here is a tip that will help you...http://www.fixya.com/support/r4319937-dishwasher_maintenanceheatman101 ... Dishwashers

Low Pressure with no hose attached, pressure is good, attach hose without wand and pressure drops 50%. Have had pump apart 10 times, have checked bypass valve, have even removed bypass and filled passage way so water could not bypass wihout any change. Am down to thinking pump casting is cracked allowing bypassing to happen. Does each of the three piston chambers have a check valve so one piston is not pumping back into another piston chamber?


I worked at a tool rental while attending college and had the opportunity to work on a variety of pressure washers, however, they were of the commercial type. Commercial washers are slightly different in that they usually have seperated components fo ... Karcher 2500 PSI Pressure Washer

My pressure washer doesn't start/work when I attach my wand to the trigger. It works fine when I take it off, but there is no pressure, just normal water coming out. I'm thinking I may need a replacement wand?


... McCulloch FH160G Pressure Washer

I have a Neff built in dishwasher - I think it is the S4443N6. I've tried all the cycles- quick wash/intensive/eco/etc but none seem to wash although the machine appears to go through the motions. The powder draw does not empty properly and the powder is hard after the cycle finishes. Water does not seem to be coming through with enougn pressure although I have checked for blockages in the pipes and cleaned filters.


... Neff 24 in. S4443N6 Built-in Dishwasher

AT FIRST WITH JUST THE WATER ON (PUMP OFF) I SQUEEZE THE WAND AND WATER COMES OUT ABOUT 3 FT. THEN WHEN I START THE PUMP AND SQUEZE THE WAND ONE STRONG SQUIRT COMES OUT THEN GOES BACK TO ABOUT 4 FT. NOT MUCH PRESSURE. CHECKED THE CHECK VALVES, AND THE 3 PISTONS THEY ALL WORK. PUMP NO.AXD 3020


Hi, W/D here.Leave the water on, and hold the trigger down for about 5 minutes to get all of the air out of the system. Letting off of the trigger occasionally and then opening it up will help displace any air in the chambers. While still hol ... Comet Axd3020g Pressure Washer Pump 27 Gpm 2000 Psi

Same problem Hi, I have the same problem there is water in the filter basket of the dishdrawer, I have watched the draining process when itgoes to error F1 and there seems to be a cycle of draining then pushing the water back through again. I have checked for blockages as advised above with a wire, no blockage, I have also blown through the outlet hose to the drain and there is no blockage. I am thinking the blockage maybe in the contained section of the pump as the previous man has explained. T


Hi, \015\012Below is the service manual. Use the FU (fill water) function in the diagnostics and then use P2 to drain the water. Open the drawer and watch will testing.\015\012Good Luck\015\012 ... Fisher and Paykel 23 in. DD-603SS Built-in Dishwasher

Hi. We have a Bosch 4072 6301 which is about 9 years old and has always worked well. Recently is has begun to leave dishes unclean, particularily on the top shelf but also on the bottom. I have checked the water jets for blockages, checked the drain (as far as it is accessible). The heating element stills works as there is steam when the door is opened. If I open in the middle of the cycle I can see water coming out of the jets correctly, I can't tell if the pressure is correct. Any th


... Bosch 24 in. SGS4072 Free-standing Dishwasher

Water does not spray out at high enough pressure. does water fill work on volume of water or timer. i think my fill valve may be partly blocked


I think you need to check your gaskets o rings that are where the water pipe comes in onto the sprayer (which is the part that rotates and sprays water ) somewhere thee lays your problem .Check for clogs also like a clogged pump suction as at the bas ... Whirlpool Dishwashers

Cannot start my pressure washer. Checked the spark plug - ok. Air filter - ok. Gas - ok. Choke - on. On/off switch - on. water - on. Trigger on wand - depressed to release pressure. Still won't start. Ideas?


The Oil Level? ... Pressure Washers

Husky ran great for couple of hours. Now no pressure at all. Water comes thru for suds, but no near enough. Engine runs fine but will not build pressure. Checked for trash blockage-all clear. Thanks, Ed Kent---ke[email protected]


Same old problem... water admitance valve sticking.\012\012Remove the valve spool and clean the bore with crocus cloth on a dowel rod.\012\012Replace O rings and lube lightly with plumber's grease. Reassemble... good as new! ... Honda Pressure Washer PSI 3000

Ge profile dishwasher not draining Model no. pdw9280n20ss I checked the drain line at the garbage disposal. No blockage. Line is clear. The back flow loop is high and not kinked. Only a small trickle of water comes out of the disposal drain at the end of cycle. No forceful pressure of water like before. I removed the smaller grill drain area and cannot feel any objects down in there. I do not know how to remove the larger fine mesh grill on bottom. Any suggestions?


Did you ever figure out how to remove that large mesh bit? I am stuck at the same spot and would love a hint. ... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

I have a Craftsman 2700 psi pressure washer with a Briggs and Stratton 850 engine (80 year anniversary special addition) . It is about 2 years old and used very little and will not start. I filled it with fresh fuel and checked the oil. I also replaced the spark plug and air filter. I checked the fuel line thinking it may not be getting fuel, but there is no obstruction from the tank to the end of the fuel line. I am out of TS options short of taking it to a service center.


Here is the long answer with everything we learned while using a power \015\012washer twice a day for years::\015\012It sounds like could be one of the problems listed below or a \015\012combination of those things.\015\012\015\0121 ... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

Briggs and Stratton pressure washer will not start. I have a 6.75 hp pressure washer that is only a year old. when I pull cord it turns over but does not start. I changed plug and checked it, I have spark when pulling. I have 40-50 psi of compression when pulling also. gas was drained and is brand new. it was working fine last time it was used. I have tried starting it without the water line or spray wand hooked up and no difference. After about 10 or 15 pulls, can smell gas when I am trying to


Hello dave, the problem is compression to low,you need 60 to 130 lbs to run engine,check for blown head gasket,or bad rings,or a stuck open valve,hope this helps,, ... Briggs & Stratton Pressure Washers

My GE Profile model PDWT180R10SS after it goes through a complete cycle it keeps water on the bottom.And I have checked drain for blockage and it is clear.This is not very old it's just a few month's old and I did read the manuel that came with the dishwasher.It does read that it will some water at the bottom. But I don't think it should as much that I am seeing.Thank you if you can help.


... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

We have a problem with our Miele G851 SC Plus dishwasher. We have not operated it for over three months as we were away on vacation and also because there were other issues in the kitchen due to some water flooding . Yesterday we switched on the machine and notice that the machine flashes the intake / drain light after a few minutes into the cycle and stops working. we have checked the drain pipe for blockages and also the water pressure is good. I disconnected the machine drain from the


Www.miele.ca/miele/canada/OperatingInstructions/.../G851%2005431311.pdf\015\012\015\012\015\012\015\012 ... Dishwashers

I just purchased a Simpson Megashot V3000 Pressure Washer and noticed the engine would stop running every time I released the wand trigger. Also, water was constantly spraying out of a valve underneath the unit - I assume it's some type of pressure release valve but there is no mention of it in the owners manual. I am thinking about returning it to Costco for a refund.


... Simpson Pressure Washers

SHX46B I have a 4 year old Dishwasher that filled up with clean water on it's own and leaked on the floor. There appears to ba a float switch switch on the very bottom of the unit that runs the pump if this happens. It won't stop until I remove the water caught in the plastic base on the very bottom of the unit. Drain is clear and this machine has worked fine until now. I'm thinking it may be a bad or leaky fill valve but how can I check?


... Bosch 24 in. SHU66C02 / SHU66C06 Built-in Dishwasher

I have a Husky pressure washer with a Honda 2600psi engine. Problem is, no water will come from the pressure hose. I connected the water w/out the pressure hose and water flows thru strongly. I then connected the pressure hose w/out the wand and water flowed thru the hose fine. When I connect the wand and pull the trigger, nothing. I have replaced the wand and that was not the problem. Please help.


Check the quick disconnect to the wand these are spring operated and can get stuck ... Pressure Washers

Hi, have a kenwood tabletop dishwasher,problem their is no water coming thru rotater,i thought may be pump, but feel need to check for poss blockage first,how do i remove this. otherwise all seems ok,


... Kenmore 24 in. 16222 Built-in Dishwasher

Water will not drain. Could be a food blockage. Machine will not start any new cycle. Have checked filter....I think...


If the water doesn't drain from your dishwasher, check these:\015\012\015\012Drain line/air gap--A clog in this part is the usual\015\012reason that a dishwasher doesn't drain. Remove the drain line to clear\015\012any debr ... Bosch Dishwashers

Proline Logic diswasher won't pump out water. Checked the following:- No blockage Pump works OK Pressure switch appears to work OK What other faults could cause this problem.


... Dishwashers

Top "spinner" has some water flow but doesnt spin. Doesnt seem to be enough pressure to get it moving, would the pump be on the way out , i have checked all holes for blockage and also ran some cleaner through machine.


Hi,That problem can have many and varied solutions...I have tried to put together in this tip the most common and easiest to checkout problems. For many of the spray arm problems the ... Asko D1776 Stainless Steel Built-in Dishwasher

My dishwasher wont drain the water , I have had a plumber check the pipe that it drains from and their may be a blockage - any suggestions to clear it


Replace the drain drian line if there is a blockage ... Dishwashers

Kenmoore Quiet quard 3 Model #665.74363K1 Serial #FS3502091 The unit will not drain properly. When in drain mode, it will drain slowly when diconnected from the disposal and lowerd to floor, and drains even slower at disposal level, or hooked to disposal. Disposal nipple is clear. I removed the hose and flushed it out with high pressure, found no blockages, hose flows freely and did not fix the problem. The motor is turning and seems to pump water fine, all wands are truning with powerfull spray


... Kenmore Dishwashers

Not cleaning my dishwasher goes thought all it's cycles,but when it is done the dishes are still greasy and the top dishes are still dirty.i have checked the water pressure the psi is 64. i have also cleaned all the wands and drain.can you please give me something less to do.my dishwasher is only 3 yrs old. i have not been able to use it in about a year know.


Check the wash arms make sure that they can spin ... open in mid cycle check water level and arm spin...also check water temp... hope it helps ... LG 24 in. LDS 5811ST Stainless Steel Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1812 seconds