Having problems with your Dishwashers ?

The water was turned off while the dishwasher was running and now it seems to be stuck and not progressing through the cycle


Answers :

Switch of the plug switch and try. Or add water from the front by opening the door and run the cycle.
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Bosch Aquasensor Dishwasher SGS5302AU/12 not working. Not progressing in cycle. Seems to be stuck on pump out water cycle. I have tried reset buttons and turned power on and off.


... Bosch Dishwashers

Bosch Aquasensor Dishwasher SGS5302AU/12 not working. Not progressing in cycle. Seems to be stuck on pump out water cycle. I have tried reset buttons and turned power on and off.


... Bosch Dishwashers

The water was turned off while the dishwasher was running and now it seems to be stuck and not progressing through the cycle


Switch of the plug switch and try. Or add water from the front by opening the door and run the cycle. ... Dishwashers

My Omega Eurolux Dishwasher (mode: DW211P/1) won't stop cycling, It sems to get stuck during the wash cycle and continues for hours, until I turn it off. If I turn the dial to rinse it rinses fine. It doesn't seem to heat the water at all, there is no steam when I open the door. I have put a new heating element in, but this doesn't seem to be heating up at all. When I open the door mid wash cycle the element is cold to touch.


... Dishwashers

My dishwasher dial will turn but not by itself and it won't go through a cycle, it seems to be stuck on a wash cycle. I can turn it off but it has standing water in it because the cycle didn't finish.


... Kenmore 15529 Built-in Dishwasher

Bosch SHU4302 WITH REPAIRED PC BOARD has been working fine for several years now seems stuck in rinse/drain mode and is not quite pumping cabinet dry. I have removed the screens and located the small impeller at bottom below cover. The impeller rotates as though it has multiple spring loaded stop positions. When I turn on the unit and open the door water is trickling from the sprayer arms at low pressure. It seems stuck in rinse mode and will not advance cycles or reset when shut off.


... Bosch Dishwashers

DISHWASHER WONT GO INTO WASH CYCLES,WHEN I PUSH START GOES CANCEL/DRAIN,CAN HERE PUMP RUNNING THEN IT WILL TURN OFF,THERE IS NO WATER IN THE BOTTOM,SEEMS LIKE STUCK IN DRAIN CYCLE


... Whirlpool GU2300XTS 24 in Builtin Dishwasher

My KitchenAid KDI-20 dishwasher won't cycle - each part of the cycle seems to work ok, but we manually have to turn the timer knob to get the cycle to progress. Repairman didn't want to come o


... KitchenAid Dishwashers

I have a GE 24 in. ZBD0710KSS Stainless Steel Built-in Dishwasher. We turned it on last night and this morning found it on, hot, and making beeping noises. It seemed to have gotten stuck in the dry cycle. I have turned the breaker off. The inside did get hot, because a small aluminum cup turned from aluminum color to black. What should I check?


... GE 24 in. ZBD0710KSS Stainless Steel Built-in Dishwasher

Good morning, I have a F&P dishdrawer ds605i (i think!) single drawer intergrated front. I dont know whats happened to it. The last cycle it decided not to empty the water out, so i manually emptied it. Now it seems stuck. All it does is run the fan. i can't start a new cycle. The start/pause button allows me to open and close the door as normal and i can hear the lid opening and closing.......... I have tried turning it off for a day at the wall switch. I have also noticed i can


Hi \015\012I guess the model no. you have sent is not correct,however given bellow are links from where you can troubleshoot your problem to your dishwasher which is related to your issue:-\015\012 ... Dishwashers

Our 2470scvi has caused all of our glassware to turn white. we use very little soap and we always use rinse aid. It seems to me that it is not rinsing properly. It actually has a sound for about 10 seconds that sounds like a motor is stuck.. This sound occurs twice in each cycle. It seems to wash ok but not great of which I would expect for a supposedly top of the line machine. This problem has always happened and the machine is 3 years old.Is this normal for a miele? If so its not the machine w


Hello macit. I do not blame you one bit for being disgusted about this machine. Let's do this. Empty it out and pour in 2 fulll cups of white cider vinegar. Close the door. Let the hot water run into the kitchen sink until it is as hot as it wil ... Dishwashers

Dishwasher model KUDI01IL, KUDI01DL, KUDI01FL, KUDC01TM.rnLock was on and figured out from the manual how to turn it off. After fixing that issue, now the DW runs and runs on the heavy cycle. Finally just had to stop it. It seems like it is stuck in that portion of the cycle.


... KitchenAid 24 in. KUDI01DL - Multiple Color Built-in Dishwasher

Dishwasher was stuck on rinse cycle, now it will not progress forward on any cycle. Tried turning off and on via power socket but no change.


First, make absolutely sure that the debris trap at the bottom of the machine is absolutely clear, the outlet hose is not kinked or obstructed, and drain it feeds into is unobstructed.If all those things prove to be fine, then the fault most likely l ... Whirlpool 24 in. ADG6552 Built-in Dishwasher

Hello, on my hja8630 dishwasher,seems like it is stuck on the drian cycle. if u stop the cycle it still runs the only way 2 stop it draining is 2 turn the power off. please help


Hi.The problem is the water level switch. It is stuck in high level and does not detect that water has finished draining.Most dishwashers have a floater switch located on one side at the bottom of the machine. In that ca ... Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher

HELP!!. Have an old smeg dishwasher - SNZ10. We turn it on, and it goes, but the dial never moves on through the cycles - it just stays stuck wherever you have turned it to. Does seem to be heating and water coming in. Husband grumpily doing dishes by hand! HELP!!


After a while thje dial on Dish Washers, wear out and jam, It sounds like it needs a new Timer, However if it's old, I would replace the Dish Washer. ... Smeg CSU2001 Built-in Dishwasher

CDA Dishwasher CW 195 Not working, turns on, can hear the cycle start, then seems to get ''stuck'' water in the bottom of dishwasher but not on any of the crockery.


... Dishwashers

The dishwasher seems to of got stuck on its cycle. when we turn it on it hums quietly but won't do anything else. Any ideas?


I assume you have a knob that turns and that is how you turn it on and have it go through it's cycles??? If that is the case there is a small motor that after you turn the d/w on continues to rotate the knob and makes your d/w go through it's cycle. ... Dishwashers

My dishwasher dial/knob seems to be stuck,ie not moving to do a wash cycle but it will take in water and if i manually turn dial it will release water.whirlpool mod no. dw621/1 bw series 600


... Whirlpool Dishwashers

We lost power as our dishwasher was running. When power was restored it seems to be stuck in the drain cycle. We have tried turning the unit off and back on and also holding the start button for 5 seconds.The 4 lefthand lights blink on and off and the right hand lights are steady. It is a model D1996.


Try to unplug it or turn off the circuit at the electric box.............wait ten minutes or so and plug it in and try again..................the program needs to be reset in that manner sometimes....... ... Dishwashers

I have a Whirlpool DU1048 that started out with a blinking clean light. I reset the dishwasher by pressing the heated dry and normal buttons twice. That worked the clean light stopped blinking. The problem now is the dishwasher seem to be stuck in the wash cycle. I finally have to turn it off after over an hour washing. Is this possibly a heating element problem? is that user replaceable?


... Dishwashers

Problem to turn on the KitchenAid dishwasher, model #: KUDP02FRSS1. I have this machine for over 2 years. After one year, sometimes, I cannot touch the touchpad to select some option of the cycles and options. Shutoff the power, and wait for few hours, it seems to work. Unfortunately, now the only cycles I can turn on is "Heavy Duty" and I can not hit Start to start the cycle. The other option on the touch pad I can select is the "Cancel". I turned off the power this time for 2 days and it seems


Your touchpad is likely faulty. Sometimes called a control panel. You can get parts, manual, pictures, part numbers, and more at partselect.com or repairclinic.com ... Dishwashers

Problem to turn on the KitchenAid dishwasher, model #: KUDP02FRSS1. I have this machine for over 2 years. After one year, sometimes, I cannot touch the touchpad to select some option of the cycles and options. Shutoff the power, and wait for few hours, it seems to work. Unfortunately, now the only cycles I can turn on is "Heavy Duty" and I can not hit Start to start the cycle. The other option on the touch pad I can select is the "Cancel". I turned off the power this time for 2 days and it seems


The electronic control board is most likely the issue. I would replace the pab that controls the dishwasher functions. The control board controls the cycles and the wash time selection as well as the on/off function of the dishwasher. ... Dishwashers

Hi, The machine will not complete a cycle. I think it may have started when the power was turned off at the mains during a cycle. Symptoms are : - You can turn machine on, select a program, press start button, close door, machine appears to begin cycle as normal, water seems to load, then 2 minutes later drains, and 1 minute or so after that the machine beeps 3 times to indicate cycle is finished. Dishwasher tablet door never opens, dishes not cleaned. Have tried : - cleaning filters; - turn


It is likely the dishwasher is locked in some diagnostic program.\015\012If you provide the dishwasher model no. then I can try to find out the keys you need to press to get it out from it. ... Whirlpool Dishwashers

I have a Jade RJDW2470A dishwasher which was re-branded Jade. (It is a Maytag product.) It get's stuck between cycles and will run forever unless I manually advance the dial to the next cycle. It seems to get stuck around the "rinse" cycle and the soap door does not open until after I advance it past that cycle.


... Jade RJDW2470A Free-standing Dishwasher

Loud hum and wash cycle doesn't seem to turn on


... Bosch 24 in. SHU5305UC Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1365 seconds