Having problems with your Dishwashers ?

Breville KM1 Antony Worrall Thompson Food Mixer

\015 Hi there,I've had a Breville KM1 Antony Worrall Thompson Food Mixer for 3 years. Was working fine, until recently, it stopped working, it would start then make a juddery noise and come to a halt. I opened it up and found that the one of the turning wheel (nearest to the motor) or turbine had broken. the little inscription on the metal bit on it says: IKO JAPANTA820Z. Where do I find this part? please help me, thanks\015

Answers :

Hi, This might sound a bit strange but did you ever fix your food mixer, if not do you still have the beater, and ballon whisk attachments as i have the same machine but iam missing these parts. maybe you would consider saleing them if you do.
\015\012Thanks
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Breville KM1 Antony Worrall Thompson Food Mixer


Hi, This might sound a bit strange but did you ever fix your food mixer, if not do you still have the beater, and ballon whisk attachments as i have the same machine but iam missing these parts. maybe you would consider saleing them if you do.\ ... Dishwashers

Hi, I have a breville food processor its about 7 years old - silver, anthony worral thompson one. I broke the dough blade over the weekend, is it possible to get a replacement - grey plastic blade?


... Breville Food Processors Chopper & Shaker BFP50

I have lost my manual for my Breville plantery mixer BEM800 wld you have please.


... Breville Food Mixer BEM800

Need a large processing bowl for my Breville BFP800XL food processor.


Try sending a email to the company they will generaly be able to get you a replacement for a small fee ... Breville Sous Chef Food Processor

Dishwasher drain is hooked to a food disposer and until recently the unit worked fine. Last week following a cycle a couple of inches of water did not drain out. All food is removed from dishes, silverware, etc. prior to loading and the food trap in the bottom is completely clear. I ran the unit empty through a Lightwash cycle and afterwards the water level (that which didn't drain out) looked to be the same as before. The dishwasher is run 2-3 times weekly whereas the food disposal is


Hi, The I don't think the problem is with the loop and the 32" above the floor.If the dish washer was removed from one house to another, did *********** ever have a dish washer in the house before that he replaced this one with? The reason I am aski ... Dishwashers

I wash/scrub all the dishes before putting them in and they come out with food stuck on them!!! I do not have an external/removable food catcher. Where is the food coming from?


The food might be coming form from the food catcher itself.The catcher might be broken,and the food that was caught in it at the time is now dislodging with each load.Now,if you check it and it is, you should get someone into see it right away.Hope i ... GE Dishwashers

Kitchenaid dishwasher My kitchenaid dishwasher is leaving food particles all over the top rack dishes. There seems to be some food in the bottom under the washer arm. How do I remove the washer arm and filter to clean out the food


... KitchenAid KUDS01IJ - Multiple Color Dishwasher

I have a three-year-old Sears Kenmore Elite dishwasher. I find that despite the fact that we scrape and rinse our dishes before loading the machine, after each three months of use (two loads a day) or so, I have to take the machine apart (spray tower, racks, bottom impeller, bottom screen housing, food grinder cover) and clean-out the food grinder area, for it fills-up with sludge. The sludge restricts the water flow and there isn't enough flow to turn the impellers via that steering jets.


Have you tried different detergents? Some detergents after getting wet and going through the wash cycle with the debris from the wash turns into a grease substance that grimes up in some dishwashers. Try running the machine with hot water this someti ... Dishwashers

I have a KitchenAid Sculptura dishwasher and it have been leaving food particles on the dishes. I started to take it apart, removing the bottom spray arm. I can see a lot of old food underneath. I'm having a hard time removing the next piece. There is a 1" rubber nut with a screw in the middle. Is this the next step for removal?


Hi\015\012\015\012Thanks for using FixYa. Please post back with the model no of your Kitchen Aid Sculptura Dishwasher so that I can further assist you.\015\012\015\012\015\012Thanks\015\012Ryle ... Dishwashers

We have a 12 year old kitchen aid diswasher model kudpo1ilbs2. It is not cleaning the dishes. Everything is loaded correctly and the proper cycle and soap is being used. We have had no problems until the last 2 - 3 months when a greasy food film is now appearing on the dishes. Some food is left on but not a great deal. The question is what could be wrong and what kind of cost are we talking? We are trying to make an informed decision as to whether fix or buy new. Thank you in advance


... Dishwashers

How do I remove excess food build up behind the food screen


There are foour screws securing that filter assembly across the rear \015\012inside of your dishwasher. Remove these screws and then the filter \015\012assembly. Clean it well. Now, before reinstalling it, in the center \015\012under the filter is ... GE 24 in. Profile PDW9880JSS Built-in Dishwasher

I believe there is food plugging up the drain so therefore the dishwaher doesn't fully drain. I can't reach the food from the outside. How do I get to the drain to check if it really is plugged?


Most machines piggy back to the outlet of the sink via a Y piece. Undo the hose clip from this connection and try to blow back on it. The drain filter should be removed( if it has a catching filter basket) If blowing does not work you could try backf ... Whirlpool DP940PWKQ Free-standing Dishwasher

It still has bubbles at end of cycle in the bottom and doesn't clean the dishes well anymore. It used to make a humming sound between washing that we guessed was it's food elimination system/garbage disposal which it does not do anymore. There seems to be lots of specks of food collecting lately and getting drawn into the blades.


Hi, \012 \012I have an older dishwasher also and recently my wife also complained about it not cleaning right... so me being the man I am tried in vain to clean the things... Bought new spray arms onli ... General Electric GE Profile Dishwasher 24 in Builtin Dishwasher

Food still left on plates and food still retained in washer


Hi,\015\012\015\012the reason you are getting poor wash results is the spray arms are more than likey blocked. Remove each arm and check the holes are clear of any blockages as this is where the water sprays from and cleans the dishes. ... Bosch Dishwashers

The top rack dishes are consistently left with little specks of food inside after a wash cycle. It appears to be food left from a rinse cycle, and it's inside the mugs and small bowls.


Check following:--\015\012\015\012Water-inlet\015\012valve\015\012\015\012Most cleaning\015\012problems are caused by the dishwasher not getting enough wash water, so the\015\012water-in ... Dishwashers

I followed 'Mindcell's' advice on fixing my Kenmore QuietGuard 4 dishwasher, and I managed to clear out all the food particles that have accumulated. I suspect that is probably why the middle spray arm has not been very effective. However, in my repair, as I was screwing in the star screw that holds the cover of the foodscreen (the lower most star screw), I managed to overturn it and break it. Thus, the food screen is only held by a plastic clip, and from what I can gather, pressure from a


Hello Lily - You could use the machine this way, afterall all that could happen is for the cover to come loose and end up in the bottom of the machine.\015\012\015\012That said, why not remove that broken screw with a small pair of vise g ... Kenmore 24 in. 15689 Built-in Dishwasher

Top rack of dishwasher seems to deposit particles of food on to glasses so not only are they dirty at the end of the cycle, the pieces of food particles are difficult to scrub off them. This happens with all loads of dishes, regardless of whether they are unsoiled or soiled.


Check the holes on the sprayer for the upper rack, somtimes they get pluged up and the top rack dishes wont get sprayed off. if they are pluged remove them and wash in a sink ... Dishwashers

I have a whirpool Quiet Partner III, and the top layer of glasses is not getting clean. I had a technichian out some time ago, and the problrem was caused by food debris trppaed in the filter in the wash module. He saud it was easy to clean that out, so I have removed the lower spray arm, but cannot undo the 4th screw that will allow me to take the grey round filter cover off to remove the food or paper debris. It is under the white flat pipe that delivers water to the wash module, and I cannot


I had same problem, would not clean well and fixed it. . I cracked open the door during wash cycle and used screwdriver to defeat the door lockout. The water from the bottom sprayer was only shooting half way to the top of dishwasher. To fix I remove ... Whirlpool Dishwashers

Mixer witch way does a conrod fit in an honda g100 engine, it s not a car it s a cement mixer


... Honda Pressure Washer PSI 3000

Kitchenaid dishwasher - small pieces of food are left on otherwise clean dishes. Water level comes to about 1 inch below heater coil. I ran it without dishes (or soap) and added about a quart of water so that level came to about 1/4 inch below heater and that's when I noticed food pieces on drain surfaces (nylon filter under bottom spray arm unit and circular plastic "trap" surrounding it). Spray arms holes are clear and water is hot.


It sounds as if you figured the solution out. The holes in the spray arm(s) get plugged by small debris, (tooth picks, seeds, bits of plastic like candy wrappers, etc) and the water does not reach the dishes to wash and rinse effective ... Dishwashers

Dishwasher just started leaving food residue on dishes after washing. We usually don't rinse beforehand but even when we do this it's still happening. Can I run something thru a cycle to give the washer a good clean out? I've cleaned the filter (nothing there), tried to clean the spinning arm as well as I could and looked for any other food that might be clogging things up. Dishwasher came house - think it's about 6-8 years old. Otherwise works great.


Hi,The scum, film and white residue problems have started since the reduction of phosphates in dishwasher detergents.Here is a tip that will help you to solve the problem of films, residue, and scum in your ... GE Nautilus 24" Built-in Dishwasher

Maytag Dishwasher Model MDB9100 makes loud noise before going into wash cycle. I think something's stuck in the food grinder. How do I check/access the food grinder?


... Maytag MDB9100A Dishwasher

I have a brand new GE Profile Dishwasher model PDW9280N20SS . I clean most of the food off and lightly scrub the dishes. But any left on food is generally still there after the wash cycle. In addition, there is a light coating of some sort. I use Cascade and jet dry but am not very happy with the results thus far. Any thoughts??


Make sure that the water temp coming into the machine is at least 130 f , i would start there first ... Dishwashers

The little holes in both upper and lower sprayers are clogged with bits and pieces of food. The dishwasher is about 10 years old. It has not done this before. Is there some way to clean out the sprayer mechanism? Is the part that usually grinds up the food chunks not working correctly?


If the wash and drain motor are working then the chopping blades are working.\015\012the spray arms can usually come off and be cleaned by running water back through through them.how ever a shop vac might help you with this problem as well ... Dishwashers

Trying to access food trap . I wasable to remove the water distrabution prop. but could not access the food trap to clean it out. I have a kenmore dish washer # 575( model # 17539208


Mostly it will be located near the bottom tray. Refer user manual ... Kenmore 24 in. 17032 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0284 seconds