Having problems with your Dishwashers ?

I have a 2 yearold whirlpool dishwasher DU1055XTSS3. It stopped working. We think it's the fuse or some kind of reset.


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a 2 yearold whirlpool dishwasher DU1055XTSS3. It stopped working. We think it's the fuse or some kind of reset.


... Dishwashers

Whirlpool Gold Quiet Partner Model # GU980SCGQ2 The dishwasher normal light flashes on and off continually. The dishwasher won't stop cycling now, everything seems to work normally other than it won't stop cycling. I've attempted turning off the breaker- no luck. Attempted resetting the dishwasher- no luck. Any assistance would be appreciated. Is this a problem with the control module? The thermal fuse?


... Whirlpool 24 in. GU980SCG Built-in Dishwasher

Dishwasher I have had above integrated dishwasher which is intermittently tripping the mains fuse. Power is getting to dishwasher and the washing cycles work until a certain point (not the same time) where a loud bang can be heard and the main fuse is tripped. Reset the main fuse and power still gets to the dishwasher and it works again. It has just started to trip the fuse when its not running any cycle (just when power is getting to it). I've checked the fuse on the spur and it looks ok. I hav


Its quite common for the interferance filter to fail on these models its situated in the base of the dishwasher connected to the mains block usually when they fail you can see black dust around it, ... Neff 24 in. S5456 Built-in Dishwasher

I have a whirlpool portable dishwasher model # dp940pwpq2. I think it stopped working in middle of cycle has standing water in bottom no power to front control unit door seems to close and latch properly, not sure if it's door switch or control s thermal fuse doesn't look bad any ideas?


... Whirlpool DP940PWSQ Free-Standing Dishwasher

Dear sir, after only 2 years today my dishwasher Whirlpool ADP4737 blow a fuse, after reset it worked again but did not end the program. Started a new program and 5 min before ending it was blinking F3.....


F3 error fault codeThe heating cycle is not working. The error is indicated after several electronic checks are done over a 25 minute period. Therefore if the heater heats too slowly or the heater is open circuit or indeed the electronic control ... Whirlpool Dishwashers

Whirlpool dishwasher model #DU1100XTPSB wont work and the clean button flashes 7 times and pauses, any idea? I shut the power off to it at the breaker to see if it would reset, didnt work


... Whirlpool 24 in. DU1100XTPS Built-in Dishwasher

Quiet Partner II Whirlpool Dishwasher 2 years old, used about 6 times in 2 years. Panel LED's flashing like a Christmas tree: Pots / Normal / Sani / Cancel lights all flashing Tried different resets as found on web but none work. Dishwasher was NOT being used when the flashing started. Need reset sequence if there is one.


Unusual LED or\015\012Display Readouts\015\012Open ID diodes and/or LED\015\012circuit(s) in keypad, or open\015\012ci ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

No Power My Whirlpool Dishwasher DU900PWKQO was working yesterday and now does not have power to it. Is there a reset button to press or can a dishwasher just stop working?


You probably have a bad door switch assm, there is no reset on this unit, if you have a bad door switch the unit thinks the door is open so it won't start. ... Whirlpool 24 in. DU900PCD Built-in Dishwasher

I have a Whirlpool DU1055XTSS dishwasher that completely stopped working. I took it apart, found the thermal fuse to be bad, ordered a new, then replaced it and it worked for 2 loads. Now the thermal is open again. What could be "taking it out"? Is the thermal fuse strictly a thermal or does it repsond to current? It's 2 years old, i have already replaced the heating element, the main control board, and now the thermal....twice.


Hi.If the thermal fuse is blowing, that means that there is overheating.Common causes for overheating are:Thermostat cutting off too late.Plugged element.Plugged element means that the element sta ... Whirlpool Dishwashers

My kenmore dishwasher, model 665.16473300 has stopped working. Now the lights just flash at the Smart Wash, Normal Wash, and Cancel. I've reset the power and it just comes back. I've taken the drain area apart and made sure there are no obstructions. The buttons seem to respond, as after I reset the unit (breaker), only the Smartwash button is flashing. I push cancel and then it starts flashing. So I think the buttons work, but it's locked up.


IS THE WATER TURNED ON TO THE DISHWASHER ... Dishwashers

Towards end of dishwashing cycle error code comes up and consitently beeps, can not turn off by machine buttons or reset. We have to reset by power plug. Water is left in bottom of macine, dishwashing powder is left on most things. Rinse button then works, it then drains the machine no problem. So I dont think it is the pump.


No response ... Dishwashers

I have a Whirlpool DU1055XTSS dishwasher that completely stopped working. I took it apart, found the thermal fuse to be bad, ordered a new, then replaced it and it worked for 2 loads. Now the thermal is open again. What could be "taking it out"? Is the thermal fuse strictly a thermal or does it repsond to current? thanks


Water is getting on the wiring somewhere, take it apart right after a cycle and see if you have a door leak, or the motor is going bad ... Whirlpool DU1055XTS Built-in Dishwasher

Kenmore Elite Dishwasher, model 665.15914 , blinking lights Lost power yesterday... Dishwasher ran from No 99 to 76 and stopped I tried resetting on panel....didn't work Took out fuse and put back in ..didn't work hit Normal Wash and light just blinks


... Kenmore 24 in. 17482 / 17484 / 17489 Built-in Dishwasher

I have a Maytag Quietseries 300 dishwasher that I bought new in 2004. The buttons on the control panel will not respond. That is, no lights will display when I push the buttons. It has behaved like this in the past and after several weeks of not using it suddenly it will begin working normally again. However, I think this time it has stopped working permanently. The model number is MDBTT79AWW. What do you think could be wrong? I have tried flipping the circuit breaker to reset it but no c


Hi\015\012\015\012 \015\012\015\012 \015\012\015\012Thanks for using FixYa. It seems to be the ... Dishwashers

Whirlpool DU1101 Hello, My Whirlpool DU1100 is only 1 year old. The dishes are dirtu and the soap doesn't disolve completely My husband is convinvced it is low water pressure, primarily from a leak in the sprinkler system in the park behind our house. I think it is just a clog of some kind preventing the water from getting into the dishwasher fill and/or spray arms. The maunual says you need 20 120 PS to run the dishwasher I doubt it is below 20 PS because of a leak in the park. Is there anyway


Well you should have water up to the heating element. if there is more than likly your chopper is the culprate. do you make sure that there isn't big food particles on your dishes because that is a lot of stress on that chopper and that is what help ... Whirlpool 24 in. DU1100XTP Built-in Dishwasher

I have a GE Profile Triton Dishwasher and it has worked fine for about 8 years. Suddenly it will not reset. The reset light blinks after reset but you can not choose a normal cycle afterwards. I shut of the machine by pulling the fuse box. I turned it back on but again it will not reset?


Hello, how are you?\015\012It sounds like you have a stuck key on the keypad, preventing you to push any other key.\015\012I've seen this problem many times in the past 4 years.\015\012Good luck.\015\012Ned ... GE 24 in. Profile PDW7800 Built-in Dishwasher

We have the Whirlpool dishwasher ,Model: ADG6 955. used it smoothly last night but this afternoon, it just will not start up. The green 'START" button keeps flashing and the dishwasher just does not start operation. I tried to reset it by holding onto the start button for a few seconds. The dishwasher stops and nothing more. KIndly advise


... Whirlpool Dishwashers

I have Whirlpool Quiet Partner III dishwasher, Model number GU2400XTPS3, Serial number FS1820245. I recently had the thermal fuse replaced by an authorized service repair person. My problem is that the dishwasher stops mid-cycle. I noticed that when I try to clean it in the normal cycle, the dishwasher stops with about 46 or 47 minutes remaining, and the green light flashes continuously. I have pressed the Normal and Heated Dry buttons, as well as the Sani Dry and HEated dry buttons to reset the


... Whirlpool GU2400XTP Built-in Dishwasher

Does GU3200XTS Dishwasher have a reset. Our dishwasher stopped about 45 mins left in cycle, we have replaced fuse but dishwasher does not work.


... Whirlpool 24 in. GU3200XTPS Stainless Steel Built-in Dishwasher

My whirlpool DU930PWSQO dishwasher won't start. Drain will work, other control panel lights work . Tried shutting power off/on and the heat dry - normal reset sequence but that didn't work. Any ideas?


... Dishwashers

I have a 6th sense dishwasher purchased new October 2004. It has been working properly and then has just stopped the next time I tried to use it - it will not turn on no matter what buttons I push - no response. I have checked the power out let with another appliance and that works so it is not the power supply from the power point. I can only think it must be a fuse or the controller. Can you please advise best course of action? Thanks Helen


I rang the appliance man to fix the problem.\015\012\015\012Thanks anyway Helen ... Westinghouse Dishwashers

My Whirlpool GU1500XTKQ0 dishwasher "rinse only" light is flashing, the buttons on the control panel do not work, and of course neither does the dishwasher. I have tried resetting the circuit breaker - no luck.


... Dishwashers

We recently purchased a Whirlpool ADP 4736 dishwasher, and just last night while it was working the fuse just blew, and we heard a popping sound at the back of the washer. We tried to replace the fuse, but the same problem. rnAlso, there a lot of water has collected at the bottom of the washer, although the dishes have been cleaned and dry. What could be the problem and the solution for this. All the instructions are in Polish and made in Poland. Please advise?? Many thanks Percy'


... Whirlpool 33 in. ADP6830 Free-Standing Dishwasher

My whirlpool dishwasher not working...no lights on any of the buttons...was working fine...is there a fuse or circuit that is off?


Amc henry\015\012 Yes there is a fuse or circuit breaker at the fuse panel in your home.\015\012 if circuit breaker, the breaker will be half off.. to reset turn all the way off and the on again. If it trips again your dishwasher may have ... Whirlpool Dishwashers

Whirlpool dishwasher my dishwasher seems to work fine except that it won't fill with water. what do you think is up with it?


You probably have a bad water valve. ... Whirlpool 24 in. DU900PCD Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2439 seconds