Having problems with your Dishwashers ?

Lock stuck on, light flashing, won't run - Dishwashers


Answers :

Try holding the 'Heated Dry" pad for 3 seconds to unlock the "control lock" option
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

Lock stuck on, light flashing, won't run - Dishwashers


Try holding the 'Heated Dry" pad for 3 seconds to unlock the "control lock" option ... Dishwashers

Control panel buttons don't work. Seem to be stuck in the "Lock On" mode. Can't turn off, and dishwasher won't run. When you open the door all lights go off, but as soon as you relatch the door, the "Lock On" light comes on, although sometimes it can be another light. In any case, it won't run.


... Kenmore Dishwashers

Whirlpool dishwasher model GU2-400-XTB7 Problem started with display cycling through delay times. (1 hr, 2hr, 3 hr and so on.) Was able to cancel that for short periods and then it would repeat the cycle. Was able to run dishwasher by pressing different buttons. Then it would start a cycle but did not run full cycle. Now control panel doesn't work at all. When buttons are pushed, lights do not light up and nothing happens. Is stuck in lock mode.


... Whirlpool GU2400XTP Built-in Dishwasher

Asko 1585 Dishwasher. Lately the washer has not been completing it's cycle without going into the all lights flashing mode. Usually just opening the door, closing then pushing start gets it going again. Yesterday this happened and it was restarted as described, then it go stuck in what appeared to be a drain mode - all lights flashing, drain motor running. It was in this mode for several hours and could not be stopped by any means. Pushing buttons or opening the door had no effect. Even c


Hi\015\012\015\012\015\012\015\012Thanks for using FixYa. You are right it is related to a bad control board. The\015\012control board has gone faulty and needs a replacement. Please check this recall\015\012information--- ... Asko 24 in. 1585 Built-in Dishwasher

Dishwasher will not run child lock light is flashing and the timedelay 2 hour light is also flashing


... KitchenAid 24 in. KUDI02IRBS Stainless Steel Built-in Dishwasher

"Lock on" light keeps flashing - cannot run dishwasher


Same issue..\015\012\015\012Other boards suggested heating element issue - but nothing very clear or compelte. ... Kenmore 16602 / 16604 / 16609 Built-in Dishwasher

My kenmore elite ultra wash dishwasher flashing start button 1 hr light on. And control lock flashes but does not run just beeps


... Kenmore 24 in. 16059 Built-in Dishwasher

Hotpoint LFT 114 dishwasher Cycle seems to run OK BUT water cold. No flashing of lights to indicate error, lights appear to behave as normal. Metered the heater element, not open circuit or short circuit. Metered the NTS resistance goes down as temp goes up Dismantled and checked all connections, all seem good. Ran the self test program and it seemed to get stuck in the wash stage, never seemed to move on BUT no error message. Now what, any suggesting please guys??


... Dishwashers

I cannot get my dishwasher to run. It is stuck with normal and cancel lights flashing. I cannot get them to stop or it to run. What do I do?


It sounds like the main panel circuit board is messed up....it needs to be checked and replaced if necessary. ... Dishwashers

Kitchenaid dishwasher mod#KUDS01DLSSO- runs till 54 min left on cycle in normal wash then normal light and add dish light begin to flash with 2 dashes where time should be and locks out


... KitchenAid Dishwashers

Hi, we have a Hoover HEDS668-80 dishwasher at work. The first problem we had was none of the programs would run this turned out to be a broken door lock. After replacement we managed to get one pre wash and one wash program to run, now when we try it, it starts but after 2 minutes the pre-wash and wash lights flash and the machine beeps 8 times. Can anyone help?


... LG LDF6810 Built-in Dishwasher

ADP5550 DISHWASHER RINSING LIGHT ON, START LIGHT FLASHING TWICE, BUT STUCK WILL NOT PROCEED WITH THE WASH. I HAVE PRESSED THE START BUTTON FOR 10 SECS, 30 SECS BUT THE ONLY RESPONSE IS THE PUMP ONLY RUNS FOR A FEW MINUTES AND STOPS.


This does sound like a problem with the "anti-flood" device that does detect water (leak / spill) at the base of the washer. This device is a protection device that consists of a polystirene float and a micro swithch. Once a water leak od spill is de ... Whirlpool 24 in. DU920PW Built-In Dishwasher

Kenmore dishwasher Lock On light flashing


Holding the button for four seconds will not do it, you have to hold it until the light stops blinking and\015\012will go back to normal, normall takes more than four seconds to unlock the unit, this is something\015\012the sears repair t ... Dishwashers

Whirlpool dishwasher Clean light is flashing which says check heat circuit. I've reset board a couple times and run diagnostic. Element tests okay. Light keeps going back to flashing when running dishwasher.


... Whirlpool DU1055XTS Built-in Dishwasher

Dishlex global dishwasher, stuck on eco, eco light flashes and drain pump runs


Try turning the taps on harder, I read that someone else had the same problem and this fixed it for them. ... Dishwashers

I have a Kenmore dishwasher 665.16022402 that is locked out at the board.( the clean light flashes continually & wont allow it to run) I don't have the manual to find the reset code and troubleshoot. There didn't seem to be any proublems till now.??????? any help?


... Kenmore 24 in. 16032 Built-in Dishwasher

My Ge profile Triton Dishwasher wont start when I lock it just keeps beeping and the" normal "light flashes there was something stuck in the turnstile and it stopped and beeped all night when I took it out it was left this way I have turned the power off and on and I still cant reset it any ideas it just wont reset


... GE Dishwashers

Dishwasher is stuck on with pump running and prewash light flashing


... Ariston Technologies L63SNA Stainless Steel Built-in Dishwasher

CHILD LOCK LIGHT IS FLASHING AND DISHWASHER WILL NOT RUN THROUGH A CYCLE.


... Frigidaire Dishwashers

Three year old Amanda dishwasher won't run. Normal wash light flashes continually Turn off power and cancel light flashes five seconds machine tries to run five seconds then back to flashing light.


... Dishwashers

I have a Whirlpool dishwasher model #DU920PFGQ4. The controls locked light is flashing, and when I press the air dry key for 5 seconds it won't unlock, however the cancel/drain light starts flashing. When I press the cancel key the controls lock light will stop flashing, but will resume as soon as I release the cancel key. I have tried disconnecting power for 24 hours, but as soon as I plug it back up it does the same thing. Nothing else on the control panel will work.


... Whirlpool Dishwashers

Kenmore Ultra Wash Dishwasher - Lock On Light Stuck!


... Kenmore 17252 Free-standing Dishwasher

Kenmore Ultra Wash Dishwasher Model 665.15779 LOCK ON light blinking on control panel, unable to use washer. If buttons were locked, LOCK ON light should be lit continually not flashing. If you press and hold NO HEAT DRY button to disengage lock, nothing happens. If you press the CANCEL button it begins to blink in unison with the LOCK ON light. How can I stop the light from blinking to allow button function again?


... Kenmore Dishwashers

I have a Kitchen aide dishwasher Model KUDI01ILWH6 that will not turn on..there is a control lock light on and I have tried pushing the cancel button but all that happens is the control lock light flashes 3 times and the dishwasher still wont turn on....Please , how to I disengage the control lock


... KitchenAid Dishwashers

Hi there. I'm having problems with my dishwasher. Usuaully once loaded, i push the start button, the closest green light to the start button flashes and dishwasher fills/cycle begins. Now, when i push the start button, the furthest green light from the start button flashes, you can hear the motor running but no cycle begins. No water fills the dishwasher.


... Hotpoint 23 in. BFV62 Built-in Dishwasher
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.2312 seconds