Having problems with your Dishwashers ?

My steamcleaner cause to turn off the electricity power every time i try to use it now i heard a noice followed by a smell of burn


Answers :

Hi,
The heating element of the steam cleaner is bad...the element is shorting out and causing it to shut off and now is getting hot,arcing, and causing the burning smell...

heatman101
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

My steamcleaner cause to turn off the electricity power every time i try to use it now i heard a noice followed by a smell of burn


Hi,The heating element of the steam cleaner is bad...the element is shorting out and causing it to shut off and now is getting hot,arcing, and causing the burning smell...heatman101 ... Dishwashers

I have a 3 year old GLD6200 that gets used once per week While running it this morning I heard a sizzling sound, i turned around just in time to see the control panel flicker and go dark. This was followed by a little smoke & a very distinct motor-burning smell. My first though it that it's toast - suggestions?? In searching for info on line I must admit I am dismayed at the number of negative comments about product quality & customer service after a break-down. Hope thats the exception and not


... GE 24 in. GLD6200L Built-in Dishwasher

Briggs and Stratton pressure washer will not start. I have a 6.75 hp pressure washer that is only a year old. when I pull cord it turns over but does not start. I changed plug and checked it, I have spark when pulling. I have 40-50 psi of compression when pulling also. gas was drained and is brand new. it was working fine last time it was used. I have tried starting it without the water line or spray wand hooked up and no difference. After about 10 or 15 pulls, can smell gas when I am trying to


Hello dave, the problem is compression to low,you need 60 to 130 lbs to run engine,check for blown head gasket,or bad rings,or a stuck open valve,hope this helps,, ... Briggs & Stratton Pressure Washers

Won't start The last time I used the dishwasher (built in), it smelled of burning. I turned it off and now although the lights on the control panel come on, the dishwasher itself won't run.


... Zanussi 23 in. ZDI6041 Built-in Dishwasher

After the wash & dry is complete, the next time I try to use it, won't turn on. I tried cancel and that starts and finishes but can't get any thing else to work. I turned off the circuit breaker but have to wait 6-8 hours before turning back on. Once this is done the machines runs normal again. I have to repeat this process every time I want run. Any suggestions on what might be causing this???


I have the same problem. The only temporary solution I have so far is \015\012to turn off the circuit breaker and wait between 10 & 30 minutes \015\012before resetting the breaker. The the dishwasher will work for one \015\012cycle. ... Whirlpool 24 in. GU1500XTLS Stainless Steel Built-in Dishwasher

I've tried to use this new machine 3 times. Each time it was never turned off until I pushed the cancel/drain button. Once I let it run for 2 hours before turning it off. This evening I tried the rinse only button and when I checked on it,it had switched to the normal wash cycle. Then I pushed the cancel/drain button.


If this is a new machine and it's under warranty, Have a technician come out and repair it as soon as possible. then fully test it's operation after he is done fixing it . It sounds to me as though it ... Whirlpool Gold GU2275XTV Builtin Dishwasher

The last time I used the pressure washer was running fine. A few minutes later I tried to start it up and could barely turn it over. I removed the recoil and could turn it a little easier backwards. The motor is a Honda GC190 on a karcher pressure washer and has 20 -30 hours of running time. Thanks Clint


... Karcher 2500 PSI Pressure Washer

Dishwasher will not finish/start a cycle. The washer filled with water and during the cycle I heard a pop like someone knocked something over in the kitchen. I smelled an electrical burning smell. All the lights and the buttons work on the front panel, but when I try to start I hear an electrical buzz like it is trying to start, but nothing happens and after 3 seconds the electrical buzzing stops and the lights on the panel flash. I removed the dishwasher and found that when I hit the start butt


... GE 24 in. GSD3960LSS Stainless Steel Built-in Dishwasher

My GSD3600 GE Dishwasher will not finish/start a cycle. The washer filled with water and during the cycle I heard a pop like someone knocked something over in the kitchen. I smelled an electrical burning smell. All the lights and the buttons work on the front panel, but when I try to start I hear an electrical buzz like it is trying to start, but nothing happens and after 3 seconds the electrical buzzing stops and the lights on the panel flash. I removed the dishwasher and found that when I hit


Hello Greg,\015\012\015\012Your diagnosis is pretty good, but the buzzing suggests it may be the capacitor for the pump motor that has failed rather than the pump motor itself. The capacitor phase-shifts the AC current for starting the mo ... GE 24 in. GSD3960LSS Stainless Steel Built-in Dishwasher

My dishawasher is acting like it's getting no power turn it on and nothing happens it worked fine last time i used it this time filled it turned it on and got nothing took front pannel off all wires are fine good connection not burned lose or anything took bottom kick plate off all wires are fine not chewed burnt or loose


Try to reset the system by the breaker.the breaker may be tripped it should be a ground fault breaker ... Dishwashers

For my Kudi01dl model dishwasher, the rinse light is on, but the unit will not respond to any buttons being pressed and won't turn on. When I press any buttons, two horizontal lines show in the front, but go off as soon as I let go of the button. Is there a ways to reset the unit? Everything was functioning fine the last time I used it. I use it about once a day. The problem started when I heard sounds coming from the unit, very loud motor sounds. The door was closed but I had not turned


... KitchenAid 24 in. KUDI01DL - Multiple Color Built-in Dishwasher

KUDU03STSS2 The dishwasher won't start and you cannot select a cycle. Hiting cancel twice will turn a small steady light on in the time window were the spining light normally is before a cycle starts, at which time closing the door will drain the dishwasher. Tried using the reset combos: hot wash, heat dry, hot wash, heat dry - all lights came on but nothing reset. Also tried same sequence doubling the heat dry. Unpluged for ten minutes, still nothing. Can select rinse, but unit does not start,


... KitchenAid Dishwashers

When trying to start the dishwasher, pressing the Normal wash button, the dishwasher gives a huge clunk and then it trips the circuit breaker. Upon resetting the breaker, I tried the next button over, which is Soak and Wash, and it seems to go thru the cycle fine. Another time I tried the Normal button, but put the left dial on Rinse and it started up, but it would clunk periodically and it seemed to have a 'hot' smell. I'm worried to use it - what could this be? Is there anything else I can try


Hi\015\012\015\012This is a very dangerous situation you must remove from the wall supply and desist from using, such a fault could easily make the casing "Live" and anyone touching it may be killed. You need to discover why this is happe ... Dishwashers

I have a Whirlpool dishwasher (model DU890SWKQO). I turned it on and for a few minutes only the motor was running, no water. I opened the dishwasher to stop it and turn it off, then on again. When I opened it, the was an odor (burning or heat smell) and it was foggy (steam or smoke, not sure which) inside. I am assuming I did not turn the dial correctly so it only 'clicked' on the motor. Concerned now that the dishwasher is broken or concerned that it's not safe to use. Was the steam/smoke


... Dishwashers

I have a AEG OKO_ FAVORIT 4040 dishwasher which has had very little use despite its age. The problem is that the switch that detects an over-fill is activated all the time and the pump continues to try and empty an already empty dishwasher even when the main switch is turned off, the only way to stop this is to turn it off at the power point I have had some sucess deactivating this switch by tilting the dishwasher forwards however because of the angle it sometimes overflows when filling. The ma


Hi there,This could be a problem on the control board of the unit. It could be faulty and need replacement or you may try to access the board and try to clean it.Make sure upon doing this all electrical connection to the unit ... Dishwashers

Won start Was using the pressure washer 1st time this year and started on the second pull. Ran out of gas shut-off also noticed it needed oil. Believe, I put too much oil so, I drained some and added gas. At first, there was no resistant in the pull so waited an hour and tried again. This time the resistant was there on the pull but still would not start; no attempt even to turn over. It's been a couple of days...changed the spark plug although, hardware guy said nothing was wrong with it..still


... Briggs Stratton 020273 Elite Series Portable Gas Pressure Washer

Dishwasher smoking Started cycle, everything seemed fine. Opened it to put something in and when I closed it to restart it sounded strange. Then the smoke starting pouring out of it and it smelled like something electrical burning. I immediately turned the wall switch off. It is a Kenmore, not sure of the model at this time. Is this a common occurence like if a specific part went out? Thanks for your time.


... Frigidaire 24 in. FDB1050REC Stainless Steel Built-in Dishwasher

We have a classique dishwasher (cl 6 s-2 made in italy) has been not use for a while. when we want try how is working condition , turn program swith at half way and push on in 3 minits , have a electric shorting sound. after chack found 1, forget turn on water 2, at electric wire in the boteem one small cylinder part have burn. the main supply circuit breaker in the house when the short occured.


... Dishwashers

Brand new Miele 2170/2180 dishwasher. First time we try to use it, it stops after a few minutes, the warning beep beeps incessantly, and all of the program lights are flashing. According to the manual, we should turn it off and on and then try again, which we did. The problem persisted. The manual says that this may indicate "a technical fault" and we should contact customer service. Unfortunately, they are closed for a three-day weekend. Any suggestions?


It is just possible you have a problem with the drain.if you plumbed the drain to a spigot on the sink trap, did you make sure the spigot is not blanked? the sink spigot will be blanked if it has not been used before to stop water from the sink ... Miele Dishwashers

I have a Teka DW6 55 FI Dishwasher which as the following fault, The frist 4 cycle indicator lights are on and it beeps about 6 or 7 times and the water pump is running,It then starts beeping again, all the time the pump is running.It dose empty the water.I tried holding down the program key and turning on but that didnt clear the error. Many Thanks Paul Luhman


... Dishwashers

I have a Roper RUD4000mq, I haven't used it in a long time but i recently tried to turn it on and there is a pool of water just below the black coil that won't drain. No water comes out when


... Dishwashers

Jackson jp-24b purchased this machine used, cant figure out how to work it. I flip the auto cycle on, and then the power switch. The fill light turns green and i assume water is filling up in the machine. In the meantime there are two small red external hoses that hot water comes and i currently just have those hanging in the sink. At the same time, nothing is happening during the wash cycle, the wash gauge doesnt even move only the rinse gauge. Also when i try to drain it nothing happends (begi


It needs a new drain relay box 120 volt the drain is stuck open the jp 24 were not very good machines the red lines are drain lines if you plug up the drian lines at fillup the machine will wash but now it will never drain a new drain box is not c ... Jackson JP-24B Built-in Dishwasher

Ignitors keep firing by themselves after my aunt cleaned them 24 hours ago After she did the major cleaning of the stove I used the oven and it worked fine. I lit a burner (Probably front?) and the left rear burner went pop and then all the ignitors keep firing by themselves until I shut off the circuit breaker. Now when ever the stove is turned on the igitors keep firing constantly. I tried unplugging the ignitors one at a time but they all keep firing even if the other ones are disconnected. A


My dishwasher's handle broke off ... Frigidaire Professional Series 24 in. Built-In Dishwasher Dishwasher

When dishwasher is set to begin, sensor takes very long period of time. Cycles are longer than minutes indicated. Dishwasher fills with water but does not wash. Water then drains as though cycle is complete and moves to next cycle. Then the process continues. When cycle for drying is reached, much heat is given and occasionally it smells as though there is burning. A 82 minute procedure turns into hours.


... Kenmore 24 in. 16532 - Multiple Color Built-in Dishwasher

Hello, I got Beko slim dishwasher DFS 1300, I tried to start it today and it doesn't do anything, when I opened it I found out that the bottom is filled with water, probably since the last time I used it a few days ago. The green indicator light is turning on but the process do not start. can anybody please tell me what is the problem? Thank You!


Hi\015\012\015\012 \015\012\015\012Thanks\015\012for using FixYa. The issue seems to be with the dishwasher not draining and dishwasher not draining properly or not draining at all issues\015\012ca ... Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.0981 seconds