Having problems with your Dishwashers ?

The drain cycle does not drain completely. You need to restart it 6 or 7 times before it drains completely. When it first starts you can hear it draining but it only lasts for 5 seconds and then appears to stop draining. This is a Whirlpool Quiet Partner II Model DUL200PKT1


Answers :

Hi

Thanks for using FixYa. To start with try to leave the unit unplugged for 10-15 minutes and while its unplugged check for clogs in the drain hose.
Usually, these issues are related to kinked hoses, knocked out disposer unit (if connected with the dishwasher drain hose) & clogged drain pump & filter. Some of the most common reasons include that the drain hose isn't working properly, the drain pump isn't working correctly, or possibly there is a plumbing problem in your home's drain lines. First check whether the drain is not clogged or blocked and the line is not kinked. Check all the hoses for blockages, if everything appears to be fine then it is better to use warranty (if it still has warranty) and get it replaced/repaired, if its out of warranty then it is the pump filter that should be checked. Please accept the solution if the issue is resolved or post a comment for further assistance.

Thanks

Rylee
Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

The drain cycle does not drain completely. You need to restart it 6 or 7 times before it drains completely. When it first starts you can hear it draining but it only lasts for 5 seconds and then appears to stop draining. This is a Whirlpool Quiet Partner II Model DUL200PKT1


HiThanks for using FixYa. To start with try to leave the unit unplugged for 10-15 minutes and while its unplugged check for clogs in the drain hose. Usually, these issues are related to kinked hoses, ... Dishwashers

I have an electrolux dishwasher Model # EIDW6105GS1 that for the second time has stopped working and all the lights at the top control panel are flashing...what might this mean? I removed the panel down below the door and it appeared to be a drainage problem. The first time it happend was about 1.5 yr after purchase...(No more warrenty and no extended warrenty)...I drained the water in the pan below and it worked once again. After about a month I am having the same problem.


... Electrolux EIDW6105GB 24 in Builtin Dishwasher

Smeg dishwasher model DI 612 C type 12053 good morning After selecting a program and shutting the door the drain pump starts and runs for 2 seconds then stops. The machine makes a bleep noise then the drain pump starts again running for 2 seconds then stops again and the cutting in and out process continues and the machine never reaches its selcted cycle. No alarm lights are displayed. I have filled the machine with water so that the filter is submerged and the level is


... Smeg Dishwashers

New dishwasher (Beko 2542F slimline model). Put it on for 1st time last night -when I got up this morning, the cycle which should have taken just over 2 hours hadn't finished. There's soapy water in the bottom of the machine which hasn't drained and the "wash" light is still on. Looks like the dishes are clean but hasn't moved onto the rinse/dry part. Followed instruction in manual to drain it (hold start stop button till lights flash and should drain in 45 sec) but nothing happened.


... Beko Dishwashers

On my GE Profile Dishwasher model GSD4320Y72BB, water is leaking during the rinse cycle for a about 10-15 seconds from the bottom of the drain solenoid (GE part WD21X802). The water does not seen appear to be coming from another source. Are drain solenoids known to leak water? Thanks, Bud


They can leak if there is a bad seal or they do not have a tight connection. ... Dishwashers

Frigidaire Dishwasher model # FDB520RHB2 Stopped prematurely last night while on light cycle, now will not respond at all. Noticed water at bottom of tub; tried draining manually through drain tube, removed lower arm, glass trap, and filter, and water remains; tried electronic reset by switching off breaker for several minutes; all to no avail. Electronic controls (cycle/option select) will not respond at all.


This is not a uncommon problem and it sometime's is the pc control panel but i find that it is more often the interlock ( latch assembly .) i would change // there has been a improvment and i belive this will solv ... Dishwashers

We have a Bosch dishwasher model SHV46C03UC (4-5 years old). has always run well. It now appears to be stuck on last cycle (humms). When I went to unload the dishwasher, water had not drained out of last cycle. I turned it off and on, then ran it again - same thing happened. I checked filter in bottom of dishwasher and it was clean. Any ideas?


... Dishwashers

I have a Kenmore dishwasher model #17519200. I loaded it last night as usual and closed the door. I pressed the wash cycle I wanted and pressed the start button. I heard it starting to fill with water as usual. After it filled with water it should have gone into the wash cycle mode but it just started making a buzzing noise for about a minute or two then just stopped. I pressed cancel to drain it and it drains fine. I have kept trying to re-run it but it just does the same thing I described.


... Dishwashers

I have a Kenmore dishwasher model # 66513449K900 that will not stop running. I think it is stuck on the drain cycle. I can start the dishwasher on a cycle and it appears to clean the dishes, but after the cycle is complete, it continues running and running (on the drain cycle) until you open the door. What could this be?


It is possible that the machine does not move off the cycle because there are errors or back feedback from the inputs. For the program to end the main program controller must receive the feedback so as to switch off the circuit at the end o ... Dishwashers

This is a past problem posted that I am now experiencing with my Kenmore Elite Model 655.17489300 dishwasher. Looking for any suggested solutions, Rick Past Problem: I have the same problem with my 2004 Ultra Wash Model 665...fills with water, sensing light comes, then stops for a second. Then you can hear another pump kick in (it hums) and just runs continuously but no water is spraying through the arms. When you cancel the wash, it drains perfectly. I've checked the filters, all is c


The symptoms you have mentioned could be linked to the soil sensor which some models come with. The purpose is to run the drain pump and let more water flow through inlet valve if during wash cycle the dishwasher detects soil collection in the accumu ... Kenmore 24 in. 16539 Built-in Dishwasher

My Bosch dishwasaher model SGS53 has stopped working and has water in the bottom of it , i have cleared this and checked the small impeller for blockages - this is ok. i have also checked the water inlet filters and the drain tube is clear . I have the top and left sid panel of and when i lift the red rod it allows watrer to come in but stops if i release the rod thr lever in the base of the machine int which the red rod fits appears th be at its lowse level and therefore the red rod cannot be p


... Dishwashers

I have a 8 yr old model 16879 that stops apparently during the drain cycle. At this point the lights on the panel flash in what appears to be a coded sequence. Pushing the cancel button seems to try to start the motor for draining but immediately shuts off. Do I have a controller problem or something in the motor/pump area? David


Hi,It could be either...I would tear into the drain pump first and verify that nothing is stopping it from turning, then go for the controller if that seems to be okay...\015\012Dishwasher Problems - ... Kenmore 16879 Built-in Dishwasher

My Bosch Dishwasher does not drain all the water out of the dish washer after the finishing cycle...I usually start the washer and then push the drain cycle and it starts to pump for about 10 seconds and stops and starts and pumps again for 10 seconds and stops and then pumps for about 25 seconds and stops....doing this manual drain twice empties the dishwasher of the excess water....what may the problem be?


... Bosch 24 in. SHE43C05UC Stainless Steel Free-Standing Dishwasher

After starting wash cycle the rotary dial advances to what appears to be the second phase and stops at about 1 oclock position. I replaced the timer/switch, same problem. Could I have a water temp sensing problem due to a poorly adhered sensor? I thought this may be the issue as the sensor at the water feed near the soap dispenser was loose on inspection. Model Bosch SHU4002UC/U06 Under counter Dishwasher


Check the thermostat sensor. If the sensor is faulty the amchine will not detect that the right temperature is reached and the cycle will not advance.The thermostat will read low ohms (about 1K) using a multimeter at Rx1 at ro ... Dishwashers

I have a KitchenAid KDS-17E dishwasher, which has worked well since I acquired it second-hand in 1984. Last night it ran continuously, stuck in the prewash part of fullcycle, with water being pumped through the system, and was fairly warm in the morning. It drained normally when I pressed the Cancel/drain button. I tried the machine again in full cycle. After 20 minutes it was still stuck in prewash, with the water temperature about 42 C, so I stopped it. Machine is connected to cold wate


Your problem is a bad timer.and you really got your moneys worth on this dishwasher.The timers useally go much soon than this one 7-8 years is the norm.The timer gets stuck in one position is a good sign its loseing its ability to fuction normally, ... Dishwashers

I have an Ariston dishwasher model LV 68 Duo. A few seconds after machine startup error A01 appear and machine stops working. Does anyone knows the cause of the problem?


... Dishwashers

Dishwasher fills, then may or may not start washing.. if it does it's only for a few seconds then you hear the motor only. I then hit the stop button and then it drains properly. Model # FDB1502RGS2


... Frigidaire FDB1502RGS Built-in Dishwasher

"my Siemens dishwasher model se54m355eu starts and after a few seconds stops. A 'tap' appears on the display. I have checked the filter in the incoming water pipe - which is clean. Any other suggestions?


Hi,Tap symbol indicates a water problem.Check that the water supply to the dishwasher has been turned on.Check that the water supply hose hasn't bent or kinked.Check the water supply first, see what you ... Siemens Dishwashers

Top rack items no longer clean. Bottom rack slightly dirtier than last 4 years. Model KUDPO2iRBS1. No debris appears to be blocking drain. Upper wash arm moves freely.


... KitchenAid 24 in. KUDP02IRBS Stainless Steel Built-in Dishwasher

Our Hotpoint Dishwasher Model HDA200X-73BA has two little white plastic pipe stubs poking out of the bottom of the dishwasher. During one of the cycles--(I don't think it is the drain cycle)-- some water is being released from one of these pipe stubs and then it stops and the other one runs some water. They each only run for a few seconds, but the water is just running on the floor. These little pipe stubs are about one half inch in diameter and project out of the bottom of the dishwasher about


Hello. go to the sears direct website, click on the blue link below, and enter your model number. ou can then access an excellent parts diagram which will show these stubs and what may be missing from them. Joe\015\012\015\012 ... Hotpoint Dishwashers

Smeg Dishwasher Hello I have a smeg dishwasher - built in, push button. It has stopped working - the program start and you hear it drain but that's as far as it gets, no water appears to be getting in. A couple of times the last 2 program buttons flash or the rinse light is on when we open it. let me know if you have any thoughts on this - I'd really appreciate it. thanks Diane


Replace the timer/control board ... Dishwashers

Our kenmore dishwasher... 8yrs old.least expensive model stopped draining. Husband tried fixing it and couldnt. Before we paid a repair man 75.00 dollars just to look at it...I shopped on craigslist. A lady was selling a ''6yr old kitchenaid'', that she said she paid 800.00 for and would sell to me for 100.00. She was just ''upgrading all her appliances''. Anyway...I bought it...thought Id rather put 100.00 into an 800.00 dollar kitchenaid as oppose to mine. I ran it last night for the first tim


Only if you choose to think so. I have seen old equipment in better shape that much younger vintage stuff! It depends on how much use it has had and if it has been run to the max with heavy loads to the point of making the machine beat itself up pre ... Dishwashers

Bosch sgs6302gb I have this model dishwasher and did not use it for 1 year. I started it yesterday and found that after filling the water for 10 seconds the dishwasher suddenly stopped working. The power is there but the drain sounds which it normally makes in the begining is not happpening. Kindly help


The first thing that works is the drain pump at beginning of cycle check pump for blockage, if ok check voltage to pump , if you do not understand this answer leave well alone. ... Bosch 24 in. SGS45E02 / SGS45E08 Exxcel Free-standing Dishwasher

I have a Fisher and Paykel dishdrawer model ds603. Not sure eactly what happened but my son says that the cycle stopped last evening (and only tells me this morning!). Dishes though appeared to be clean and there was a small amount of water at the bottom. I tried opeing the washer and it was hard to open as though the drawer was stuck on something. I removed the drawer and checked the rollers and they are fine. I realised then that the drawer is getting stuck on the inside lid that provides the


The best thing to do is to remove the rack,drawer completly,and close it up,see if it will come on,and run all threw the cycle.If it does,then put the rack,drawer on the track.The rollers could be,well,not snapped all the way on.It will be in that ar ... Fisher Dishwashers

We have the Whirlpool dishwasher ,Model: ADG6 955. used it smoothly last night but this afternoon, it just will not start up. The green 'START" button keeps flashing and the dishwasher just does not start operation. I tried to reset it by holding onto the start button for a few seconds. The dishwasher stops and nothing more. KIndly advise


... Whirlpool Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1627 seconds