Having problems with your Dishwashers ?

I have a SMEG PL622 dishwasher. I turned it on and went to bed. It was going all night and did not stop.


Answers :

Repair Help & Product Troubleshooting for Dishwashers

Tips for a great answer:

- Provide details, support with references or personal experience .
- If you need clarification, ask it in the comment box .
- It's 100% free, no registration required.

Suggested Questions/Answers :

I have a SMEG PL622 dishwasher. I turned it on and went to bed. It was going all night and did not stop.


... Dishwashers

Blanco bfdwc61ss dishwasher wont finish washing in any cycle...its doesnt stop, just keeps going and going...it went all night without stopping and the dial didnt move...can you advise what to do??


Please see the causes and fix it: God bless youFloat Switch\012\012\012The float switch may be hung up and this can cause the dishwasher to be stuck in a cycle. Check the ... Dishwashers

Coleman mobile home furnace...Model number DGAA077BDTB...The furnace about a month ago started going out ( flash code- Combustion Air switch stuck closed)We replaced the thermostat on the wall and it stopped doing it and ran fine then last night it stopped again ( Combustion air switch failed to close) and when i got up the furnace was working and now for the past few hours it refuses to do anything...I am on a very very tight budget...and need some idea of what is wrong and do i need a professi


I had the same errror code on my coleman furnace (3 flashes combustion air switch failed to close) but at first didnt realize there was even a light that gave codes..Anyways long story short, after searching many forums one guy mentioned about the fu ... Dishwashers

SMEG DF612S Dishwasher runs for 5 minutes then triple bleep all programme lights go on machine stops. HELP


... Smeg 24 in. DWF612SS Free-standing Dishwasher

My Smeg DWI 409c starts a cycle, but never ends. I put it on before i went to bed and it was still going the next morning. I have tried it on different programs and it does the same thing. The only program that will stop by itself is the rinse. Any ideas?


... Smeg DWI409C Slim-Line Built-in Dishwasher

I have a Triton dishwasher. Last cycle, it completed washing then started drying and started beeping and the drying light is flashing. When I finally opened the latch, the beeping stopped, but the drying light is still flashing. The dishes were clean and warm - they air dried the rest of the way. I have not been able to get the drying light to go off. I have turned the breaker off over night, and flipped back on. The dishwasher goes back to flashing washing, and then clicks to drying and th


Hi,\015\012Make sure the salt level is ok - add 1Kg of salt if you have not done it in a while, and check rinse-aid level if apliccable.\015\012\015\012If this does nothing, then remove the lower kick panel for access to a data shee ... GE Dishwashers

Maytag MDB5601AWS Dishwasher worked fine when I moved into my new home less than 2 weeks ago. It just stopped working a few nights ago and the sellers did not leave info on the dishwasher. The only buttons that light up are the buttons on the right side of the START/CANCEL button (which does not light up at all) and the LIGHT WASH button on the left side of the panel. The DELAY WASH button blinks for a while, and then all lights on the panel go off completely. No noise at all comes from the


CLICK HERE for your owners manual.\015\012\015\012If, after reading through it, You feel you h ... Dishwashers

My Smeg dishwasher DWF 64 SSE won't go onto rinse or dry


Easy one first try this to see if it helpsWater pre-heatingYour\015\012dishwasher may pre-heat the water. If so, and if the water entering the\015\012dishwasher is cool, the heater may take up to half an hour to heat the\015\012wat ... Smeg 24 in. DWF612WH Free-standing Dishwasher

Whirlpool dishwasher stops at rinse cycle and won't go


... Whirlpool 24 in. GU980SCG Built-in Dishwasher

I have a smeg dishwasher D1612.. it starts,stop ,start,stops. any suggestions.


... Smeg 24 in. STX2 Built-in Dishwasher

Smeg DI 409CA Dishwasher - Doesn't wash properly, tablet doesn't desolve and cycle lasted all night


Hi,The first thing is have a look at the instruction manual from HEREIf the dishwasher is not washing properly the ... Dishwashers

GE PDW7300 dishwasher - must slam the door shut to get a light on the panel and when the START button is pressed, it looks like the dishwasher is cycling thru a wash, but there is no water. When I press the START cycle again, it seems like it thinks its pumping the water out for a few minutes, then the light will go off. If I start it again and push really hard against the door, I can hear the water go on. But if I stop pushing the door, the water stops. The dishwasher was installed in 2001, but


... GE 24 in. Profile PDW7300G Built-in Dishwasher

Ge triton I got my GE triton about 2 years ago and it has worked fine since. For some reason, now, it won't stop running through the wash cycle. I can't get it to turn off. I push the reset button hoping it will stop and all it does is go to "sensing" then back to wash. I have to open it to get it to stop temporarily, but there is water sitting at the bottom of it. Any suggetions?


Turned the breaker off and then on again.....\015\012Works like a charm!!!\015\012Thanks ... GE 24 in. GSD6660GSS Built-in Dishwasher

I have Frigidaire FDB956RBC1 diswasher. I have to turn off the water to fix the faucet. When I turned the water back on, water did not go to the diswasher when I used it. The diswasher runs normal except with no water going into it. The water runs find at the facet. There is separate water supply underneath the sink for the faucet and the diswasher. I wonder if there is a mechanism with the dishwasher that stop the water from going into the dishwasher after the water supply been turn off. I did


FRIDG... EXPERT HERE \012\012\012Welcome to fixya\012\012Hello\012\012 \012\012 ... Frigidaire FDB956RB Built-in Dishwasher

Asko 1585 Dishwasher. Lately the washer has not been completing it's cycle without going into the all lights flashing mode. Usually just opening the door, closing then pushing start gets it going again. Yesterday this happened and it was restarted as described, then it go stuck in what appeared to be a drain mode - all lights flashing, drain motor running. It was in this mode for several hours and could not be stopped by any means. Pushing buttons or opening the door had no effect. Even c


Hi\015\012\015\012\015\012\015\012Thanks for using FixYa. You are right it is related to a bad control board. The\015\012control board has gone faulty and needs a replacement. Please check this recall\015\012information--- ... Asko 24 in. 1585 Built-in Dishwasher

Dishwasher starts fills up but then won't go onto the next cycle also when you go to open the door where it would normally stop the machine it keeps going


Please check the timer switch ... Zanussi 18 in. DCS12W Free-standing Dishwasher

Whirlpool - Quit Partner I - DU1048XTP: Start at the beginning - Dishwasher would go through most of it's wash cycle and stop and the 'Start/Resume' LED would start flashing. Would press 'Start/Resume' and wash cycle would start again and run non-stop. Would have to hit 'Cancel/Drain' to stop. Called local service tech and he said board would need to be replaced. First board he brought failed right away, second board was installed. Tech also replaced latch handle assembly because it was missing


Have you asked the technician if the water temperature is OK.\015\012\015\012Run it again and after 30 minutes cancel and see if water temperature is warm or not. If not warm enough, then likely causes are heater is faulty or if you are u ... Whirlpool Dishwashers

Smeg Dwi409c dishwasher is stopping 3 minutes into cycle with no fault lights or anything, I hear it fill with water but then stops, but I do notice the water is not draining which I assume is why it is stopping, correct me if I am wrong. Have removed the filter but still not draining. Any ideas?


... Smeg Repair Pcb / Module Dwi409c

Bosch DW SHU66C02UC/23 control unit 447325 keeps stopping and going back to 0 during wash cycle. Why


... Bosch Dishwasher Control Unit - 447325

I have a Beko DWD5410W dishwasher. It has been working well for a couple of years now. Last week is stopped during a wash cycle and now when you switch it on, it fills with water to the top of the filters (as normal?) and stops. Nothing further happens no matter how long I wait unless I switch the machine to drain mode. Do you have any idea what the problem could be or how I can go about investigating further? Many thanks in anticipation


Hi, this is a control fault that is localized in the logic sector of the control board. the logic chip which holds all wash programing is damaged. you will need to replace the control asap if possible...thank u rate me ... Dishwashers

Smeg dishwasher leaking through the door ive removed the lower door seal but dont know how it should go on happened all of a sudden and there was a desert spoon in the bottom of the dishwasher . im hoping it leaked because it dislodged the seal the seal came out easily from the outside of the dishwaser. can any one tell me how to replace it and which way it is supposed to sit model number sa425 smeg


... Dishwashers

I have a maytag mbd7600aww. When I start it, you hear the start up, water heats and fills, and then it just stops. if I used the 'delay' feature, it wouldn't start at all. When i stop it, the water runs out, but will not go through the cycles. Any suggestions? I appreciate any help you can give.


... Maytag 24 in. MDBH950AWS Built-in Dishwasher

Kenmore dishwasher has loud noise during fill. If you let it go, the washer fills. Once filled, noise stops and wash cycle continues. Sounds like plumbing does when there is air in the pipes. Not a grinding sound. Very deep pitch. Stops when the washer fills with water.


This isn't a solution but rather a comment, if the problem is happening only during the fill, then it could be the water inlet valve. Perhaps there is a soliniod going in the valve, watch to see if the fill cycle starts to dimminish over time. Does t ... Kenmore Dishwashers

I have a ge profile quietpower 7 dishwasher. its built in.cannot find manuel and cannot find the serial number anywhere on the dishwasher..i need either your help with serial number or help with why water will not go into the dishwasher. motor runs water decided it wont go in. one day worked perfect and next day stopped working.


Hi\015\012\015\012This is often caused due to the fill valve. You can ... GE Dishwashers

Dishwasher DU1100. Odd behaviour during cycle: "Washing" light goes off and sound of washing stops. "Normal" light starts blinking and "soak and scour" light comes on (it was off before). No sound from washer. This persists for at least 10 hours. After that, the lights go off. Is this normal behaviour? It would appear tha the drying cycle did not go.


No it is not normal. It appears that either the membrane switch pad has failed or the control board has failed. ... Whirlpool Dishwashers
  • Start your question with What, Why, How, When, etc. and end with a "?"
  • Be clear and specific
  • Use proper spelling and grammar
all rights reserved to the respective owners || www.a-wash.org || Terms of Use || Contact || Privacy Policy
Load time: 0.1008 seconds